• Ocean and Polar Research
• /
• v.43 no.1
• /
• pp.15-30
• /
• 2021

In this study, using 16 ORA-IP (Ocean Reanalysis Intercomparison Project) data, we investigated spatial and temporal changes of net surface heat flux in the East Asian seas and presented a new ensemble net surface heat flux index. The ensemble net surface heat flux index is produced considering the data distribution and the standard deviation of each ORA-IP. From the correlation analysis with air temperature averaged over the Korean Peninsula, ensemble net heat flux around the Korea Strait shows the highest correlation (0.731) with a 3 month time lag. For the correlation study regarding precipitation over the Korean Peninsula, it also shows significant correlation especially in winter and spring seasons. Similar results are also found in comparison with climate indices (AO, PDO, and NINO3.4), but ensemble net surface heat flux data in winter season reveals the strongest correlation patterns especially with winter temperature and spring precipitation.

• Journal of the Korean Chemical Society
• /
• v.37 no.2
• /
• pp.206-212
• /
• 1993

Syntheses and properties of zwitterionic dithiocarbamates and their nickel(Ⅱ) complexes are described. The complexes have been characterized by mass infrared and electronic absorption spectroscopy, and conductivity measurement. Ni(Ⅱ)-dithiocarbamato complexes are soluble in polar solvents such as water, methanol, and acetone etc. The possible structures were proposed on the basis of elemental analyses and physical properties.

• The Korean Journal of Ecology
• /
• v.23 no.4
• /
• pp.331-337
• /
• 2000

Fourteen different taxa of dictyostelid cellular slime molds were recovered from the alpine and subalpine zone in Mt. Paektu. In subalpine zone, six species were recovered : Dictyostelium minutum, D. brefeldianum, D. crassicaule, D. capitatum, Polysphondylium solitarium and P. pallidum. One of these species which were isolated from the soils of Larix olgensis community exhibited several distinctive features which differed from the published species. This species was designated as a new species, Polysphondylium solitarium Kang et Chang, sp. nov. When cultivated at 22~24$^{\circ}C$ on low-nutrient agar media with Escherichia coli, Polysphondylium solitarium is distinguishable from other species by the following combination of features: (ⅰ) the sorocarps with vinaceous pigmentation; (ⅱ) pseudoplasmodia radial. usually centralized and rarely subdivided; (ⅲ) the various number of whorls; (ⅳ) the spores with unconsolidated and nonconspicuous polar granules. Also, we confirmed this new species by analyzing ribosomal DNA (ITS1, ITS2 and 5.8s DNA) sequences of P. solitarium and P. violaceum.

• Journal of the Korean earth science society
• /
• v.42 no.4
• /
• pp.383-389
• /
• 2021

Several studies investigating the behavior and environmental distribution of rare earth elements (REEs) have been reviewed to determine the geochemical processes that may affect their concentrations and fractionation patterns in groundwater and whether these elements can be used as tracers for groundwater-rock interactions and groundwater flow paths in small catchments. Inductively coupled plasma-mass spectrometry (ICP-MS), equipped with an ultrasonic nebulizer and active-film multiplier detector, is routinely used as an analytical technique to measure REEs in groundwater, facilitating the analysis of dissolved REE geochemistry. This review focuses on the distribution of REEs in groundwater and their application as tracers for groundwater geochemistry. Our review of existing literature suggests that REEs in ice cores can be used as effective tracers for atmospheric particles, aiding the identification of source regions.

• Ocean and Polar Research
• /
• v.41 no.1
• /
• pp.19-34
• /
• 2019

The present study obtained universal mathematical models of all elements and characteristics regarding hook and line fishing systems. To describe the hook and line fishing systems on site we used three kinds of coordinate systems: the earth based coordinate system, natural coordinate system, and flow (velocity) coordinate system. Mathematical models presented in this article allow us to define the shape of the fishing gear, the tension of the rope at different points, hydrodynamic resistance, diameter of the hook's wire, immersion depth of the fishing hooks, distance from hooks to the ground and the required lifting force of the floats. These models allow for the performance of computer simulations regarding any kinds of hook and line gears in still water or water where flow occurs.

• Journal of the Semiconductor & Display Technology
• /
• v.18 no.1
• /
• pp.42-47
• /
• 2019

The four different polymer compounds were manufactured to make cable sheath for ship industry. Two kinds of ethylene-vinyl acetate (EVA) were selected as main matrix polymers for compounding with fire retardant, crosslinking agent, filler, plasticizer, and other additives. The properties of the four compounded materials were investigated with the contents of fire retardant, silane coated aluminum hydroxide (S-ATH). Rheology, Mooney viscosity, and tensile strength increased with S-ATH contents by reinforcing effect. With increasing fire retardant amount, fire resistance increased, but cold resistance didn't show an obvious enhancement due to polar effect of vinyl acetate in EVA.

• Economic and Environmental Geology
• /
• v.46 no.4
• /
• pp.339-344
• /
• 2013

Water vapor isotopes can be excellent tools for understanding complex mechanisms in the water cycle and atmospheric hydrological cycle and they can be applied to various fields of paleoclimatology, atmospheric science, hydrogeology, oceanography, and ecohydrology. Thus, studies of global or local transport of water vapor may be able to provide a very useful clue to better understand the movements of water and energy in the atmosphere, hydrosphere and biosphere. In this study, the isotopic compositions of water vapor have been observed for moisture transport during the passage of Typhoon Bolaven at Korea Polar Research Institute (KOPRI), Incheon, in the western part of Korea, from August 27 to August 29, 2012. In the clear sky, the isotopic compositions of water vapor at KOPRI exhibited relatively higher isotopic ratios, which were near isotopic equilibrium with sea surface water (${\delta}^{18}O$=-14‰). On the other hand, a largely depleted isotopic ratios in surface water vapor were observed in association with the passage of Typhoon Bolaven (approximately 10‰ depleted compared to the clear sky). The fact that the isotopic minima in water vapor are encountered during the onset period of the Typhoon Bolaven with increases of relative humidity, which is consistent with, so called, "the amount effect".

• Journal of the Korean earth science society
• /
• v.34 no.1
• /
• pp.28-40
• /
• 2013

This study examined the geochemical characteristics, equilibrium temperature and pressure conditions, and oxygen isotopic ratios of mantle xenoliths from the various geological sites of the Korean peninsula. The results are as follows: (1) The ultramafic xenoliths from the Korean peninsula mainly consist of typical high magnesium olivine (MgO : 49.12-50.95 wt.%, Mg value: 90.1-92.2), corresponding to worldwide Cenozoic ultramafic xenoliths in chemical compositions. (2) The pressure-temperature conditions of ultramafic xenoliths in the Korean peninsula are from 854 to $1016^{\circ}C$ and 4.6 to 24.4 kbar. (3) The oxygen isotopic ratios (${\delta}^{18}O$) for olivines in ultramafic xenoliths range from 5.06‰ to 5.51‰, which are relatively uniform oxygen isotopic values and overlapped by the values of N-MORB and upper mantle peridotite (${\delta}^{18}O$: $5.2{\pm}0.2$‰). However, olivines of the ultramafic xenoliths from the Baegdusan and Chejudo have a relatively wide ${\delta}^{18}O$ values ranging from 5.07 to 5.51‰ and 5.07 to 5.45‰, respectively. Based on the results, this study suggests that the high ${\delta}^{18}O$ signature of the Baegdusan xenoliths give a hint that ~5% of the oxygen in typical EM2 sources originally derived from recycled sediments.

• Korean Journal of Applied Biomechanics
• /
• v.31 no.1
• /
• pp.72-78
• /
• 2021

Objective: The purpose of this study was to investigate relations and effectiveness about mountain climbling exercise with different level of support surfaces by analyzing heart rate and EMG data. A total of 10 male college students with no musculoskeltal disorder were recruited for this study. Method: The biomechanical analysis was performed using heart rate monitor (Polar V800, Polar Electro Oy, Finland), step-box, exercise mat, and EMG device (QEMG8, Laxtha Inc. Korea, sampling frequency = 1,024 Hz, gain = 1,000, input impedance > 1012 Ω, CMRR > 100 dB). In this research, step-box were used to create different surface levels on the upper body (flat surface, 10% of subject's height, 20% of subject's height, and 30% of subject's hight). Based on these different conditions, data was collected by performing mountain climbing exercise during 30 seconds. Subjects were given 5 minutes of break to prevent muscular fatigue after each exercise. For each dependent variable, a one-way analysis of variance with repeated measures was conducted to find significant differences and Bonferroni post-hoc test was performed. Results: The results of this study showed that exercise intensity was reduced statistically as increased surface level on the upper body. Muscle activity of the upper rectus abdominis and biceps femoris for 30% of surface level was significantly higher than the corresponding values for flat surface. However, the opposite was found in the rectus femoris. In general, muscle activity of the lower rectus abdominis, erector spinae, external oblique abdominis, and gluteus maximus increased when surface level increased, but the differences were not significant. Conclusion: As a result, the increase in surface level of the body would change muscle activity of the upper body, indicating that different surface level of the upper body may cause significant effect on particular muscles to be more active during mountain climbing exercise. Based on results of this study, it is suggested to set up an appropriate surface level to target particular muscle to expect an effective training. It is also important to set adequate surface levels to create an effective training condition for preventing exercise injuries.

• Journal of Microbiology and Biotechnology
• /
• v.26 no.10
• /
• pp.1701-1707
• /
• 2016

Lipoxygenase (LOX) is an industrial enzyme with wide applications in food and pharmaceutical industries. The available structure information indicates that eukaryotic LOXs consist of N terminus β-barrel and C terminus catalytic domains. However, the latest crystal structure of Pseudomonas aeruginosa LOX shows it is significantly different from those of eukaryotic LOXs, including the N-terminal helix domain. In this paper, the functions of this N-terminal helix domain in the soluble expression and catalysis of P. aeruginosa LOX were analyzed. Genetic truncation of this helix domain resulted in an insoluble P. aeruginosa LOX mutant. The active C-terminal domain was obtained by dispase digestion of the P. aeruginosa LOX derivative containing the genetically introduced dispase recognition sites. This functional C-terminal domain showed raised substrate affinity but reduced catalytic activity and thermostability. Crystal structure analyses demonstrate that the broken polar contacts connecting the two domains and the exposed hydrophobic substrate binding pocket may contribute to the insoluble expression of the C terminus domain and the changes in the enzyme properties. Our data suggest that the N terminus domain of P. aeruginosa LOX is required for its soluble expression in E. coli, which is different from that of the eukaryotic LOXs. Besides this, this N-terminal domain is not necessary for catalysis but shows positive effects on the enzyme properties. The results presented here provide new and valuable information on the functions of the N terminus helix domain of P. aeruginosa LOX and further improvement of its enzyme properties by molecular modification.