• Archives of Plastic Surgery
• /
• 제38권4호
• /
• pp.383-390
• /
• 2011

Purpose: To correct the upper lip depression after the correction of unilateral cleft lip, autologous grafts such as bone, dermal, fascial grafts and fat injections or alloplastic implants are used. Transplanted bones, dermis and fascia have a tendency to be absorbed and have donor morbidity. Fat injections are absorbed inconsistently and alloplastic implants have problems such as foreign body reactions, protrusions and infections. Authors corrected the upper lip depression using conchal cartilage graft in unilateral cleft lip deformity and the results was analysed with photos. Methods: 26-unilateral cleft lip and 2-microform cleft lip cases, totally 28 cases were performed. Their mean age was 21.89 years. The male and female cases were 12 and 16, respectively. Under anesthesia (general: 18 cases and local: 10 cases), cavum conchae (n=8), cymba conchae (n=16) and whole conchae (n=4) were harvested. Transversely cut the margin of the obtained cartilage, we cut out the most bent portion and put a partial-thickness incision on concave surface in cases of excessive convexity. Then, we performed the onlay graft of the conchal cartilage via scar revision site in unilateral cleft lip and via the reconstruction site of the cupid bow in microform cleft lip. The augmentation of the upper lip was evaluated with photos. Adapting the baseline connecting between the both cheilions as a horizontal standard line, we measured the highest point among the tangents between the upper lip and nose (point a), the lowest point (point c), the middle point between a and c (point b) and the vertical line from the alare (point d) to the horizontal standard line. To assess the postoperative symmetry, we compared cleft side upper lip contour index (%) A,B,C,D=(a,b,c,d)-ch ${\times}$ 100/(ch-ch) and non-cleft side upper lip contour index (%) A',B',C',D'= (a',b',c',d')-ch ${\times}$ 100 / (ch-ch).h) Results: After the surgery, no complication was found except in one case which double layers graft performed in the cleft lip deformity, the lateral portion was protruded. The upper lip contour index, the difference of A and A' were-0.83%, and thus the mild depression was persisted. Difference of B and B', C and C', D and D' were 0.83%, 1.07%, 0.90%. There were statistically significant difference, and thus the depression of upper lip were improved generally. Conclusion: Authors performed the onlay graft of the conchal cartilage in unilateral cleft lip deformity and found that the depression of the upper lip was well corrected except the uppermost part when photogrammetrically analyzed.

• Nonlinear Functional Analysis and Applications
• /
• 제28권3호
• /
• pp.719-729
• /
• 2023

In this article, we present a new notion called "extended metric spaces of type (φ, ρ)" as a generalization of extended b-metric spaces. Also, we establish a fixed point result of a Reich-type contraction on an extended metric space of type (φ, ρ). We also provide several examples to demonstrate the significance of the established results.

• East Asian mathematical journal
• /
• 제32권5호
• /
• pp.701-716
• /
• 2016

We establish a tripled coincidence and common tripled fixed point theorem for hybrid pair of mappings satisfying new contractive condition. To find tripled coincidence points, we do not use the continuity of any mapping involved therein. An example is also given to validate our result. We improve, extend and generalize several known results.

• 대한수학회지
• /
• 제37권6호
• /
• pp.885-899
• /
• 2000

We obtain generalized versions of the Fan-Browder fixed point theorem for G-convex spaces. We define the class B of better admissible multimaps on G-convex spaces and show that any closed compact map in b fro ma locally G-convex uniform space into itself has a fixed point.

• 호남수학학술지
• /
• 제45권4호
• /
• pp.598-609
• /
• 2023

The purpose of this article is to obtain the spectrum, fine spectrum, approximate point spectrum, defect spectrum and compression spectrum of the double band matrix U (a₀, a₁, a₂; b₀, b₁, b₂), b₀, b₁, b₂≠0 on the sequence space ℓ_p (1 < p < ∞).

• 한국정보처리학회논문지
• /
• 제6권1호
• /
• pp.159-166
• /
• 1999

본 논문에서는 개인휴대통신(PCS)의 최소 규격인 J-STD-018을 기준으로 하여 수신기의 수신감도, 단일톤 둔감도, 상호변조 스퓨리어스에 의한 응답감쇄 규격에서 각각 잡음지수와 제 3고조파 차담점을 구하고 시뮬레이션을 통하여 분석하였다. 시뮬레이션 결과 수신감도 규격에서는 전체 잡음지수가 5.99dB이고 제 3고조파 차단점은 -33.979dBm이었다. 또한 단일톤 둔감도 및 상호 변조 스퓨리어스에 의한 응답감쇄 규격에는 전제 잡음지수가 0.367dBm이고 제 3고조파 차단점은 6.989 이 증가되었다. 이것은 잡음지수보다 제 3고조파 차단점이 훨씬 증가 되므로 간섭톤과 밀접한 관계가 있는 소자인 Mixer는 제 3고조파 차단점을 높게 규정하고 IF SAW 필터의 중심 주파수로부터 1.25MHz와 2.05MHz지점인 곳에 감쇄가 456dB이상 되어야 함을 보였다.

• Journal of electromagnetic engineering and science
• /
• 제4권4호
• /
• pp.143-149
• /
• 2004

This paper describes characteristics of the single-balanced low IF resistive FET mixer for the digital beam forming(DBF) receiver. This DBF receiver based on the direct conversion method is designed with Low IF I and Q channel. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(IF) considered in this research are 1950 MHz, 1940 MHz and 10 MHz, respectively. Super low noise HJ FET of NE3210S01 is considered in design. The measured results of the proposed mixer are observed IF output power of -22.8 dBm without spurious signal at 10 MHz, conversion loss of -12.8 dB, isolation characteristics of -20 dB below, 1 dB gain compression point(PldB) of -3.9 dBm, input third order intercept point(IIP3) of 20 dBm, output third order intercept point(OIP3) of 4 dBm and dynamic range of 30 dBm. The proposed mixer has 1.0 dB higher IIP3 than previously published single-balanced resistive and GaAs FET mixers, and has 3.0 dB higher IIP3 and 4.3 dB higher PldB than CMOS mixers. This mixer was fabricated on 0.7874 mm thick microstrip $substrate(\varepsilon_r=2.5)$ and the total size is $123.1\;mm\times107.6\;mm$.

• 대한기계학회논문집A
• /
• 제26권10호
• /
• pp.1961-1970
• /
• 2002

A laser scanner is widely used fur a device fur acquiring point data in reverse engineering. It is more efficient to generate a surface automatically from the line-typed data than scattered data of points clouds. In the case of a compound model, it is hard to represent all the scanned data into one surface maintaining its original line characteristics. In this paper, a method is presented to generate a surface by the segmentation of measured point data. After forming triangular net, the segmentation is done by the user input such as the angle between triangles, the number of facets to be considered as small segment, and the angle for combining small segment. B-spline fitting is implemented to the point data in each segment. The surface generation through segmentation shows a reliable result when it is applied to the models with curvature deviation regions. An useful algorithm for surface reconstruction is developed and verified by applying an practical model and shows a good tools fur reverse engineering in design modification.

• Journal of applied mathematics & informatics
• /
• 제27권1_2호
• /
• pp.183-194
• /
• 2009

In this paper, we considered the following four-point boundary value problem $\{{x"(t)+h(t)f(t,x(t),x'(t))=0,\;0<t<1\atop%20x'(0)=ax(\xi),\;x'(1)=bx(\eta)}\$. where $0\;<\;{\xi}\;<\;{\eta}\;<\;1,\;{\delta}\;=\;ab{\xi}\;-\;ab{\eta}\;+\;a\;-\;b\;<\;0,\;0\;<\;a\;<\;\frac{1}{\xi},\;0\;<\;b\;<\;\frac{1}{\eta}$. After the discussion of the Green function of the corresponding homogeneous system, we establish some criteria for the existence of positive solutions by using the generalized Leggett-William's fixed point theorem. The interesting point is the expression of the Green function, which is a difficulty for multi-point BVP.

• 대한가정학회지
• /
• 제26권2호
• /
• pp.1-13
• /
• 1988

The purpose of this study was to classify somatotype of males, to show changes of the body skin surface by the somatotype. The size of sample was 156 males between age 20 and 24. Somatotype classified into Bending somatotype, Standard somatotype, Turning over somatotype. And according to the somatotype, changing of the upper part of the body by the arm movements analyzed through gypsum experiment. The result obtained from this study were as follows; 1. the variation of the upper part of the body form by changing the am movements, by the increasing of movements, shoulder-point ws moved to be inside or upside, the anterior armpit point & armpit point were moved to the upside. 2. As a result of investigating into the rate of the expansion and contraction of the basic lines and body surface area by the arm movements, the rate of expansion and contraction of the basic lines by the arm movements, the side sea length showed the maximum rate of extension in 135 degrees, the shoulder length showed the maximum rate of contraction in 135 degrees. The rate of expansion and contraction on the body surface area by the arm movements showed the phenomenon of contraction, of items F1, F6, B1, B9 showed the phenomenon of extension, of items F3, F4, F8, F9, B8, B9. 3. According to somatotypes, items which show the significant difference were, of items f3, f8, b3, b8, F2, F7, F8, B3, B7, in all movements.