• Journal of Sensor Science and Technology
• /
• v.23 no.6
• /
• pp.388-391
• /
• 2014

The most promising application of the biofuel cells is implantable devices, so the biofuel cells should have an appropriate shape for the vascular vessel. We demonstrated the biofuel cell roll for using in tubes. MWNTs were aggregated by vacuum filtration on a nitrocellulose membrane filter, which was biocompatible and flexible. The MWNT aggregated nitrocellulose membrane used the electrodes of the biofuel cells because it was conductive as well as nanostuructured. Then, the membrane was rolled into the roll shape. The maximum power density of the biofuel cell roll was $7.9{\mu}W/cm^2$ at 153mV and 50 mM glucose. Also, the power density is expected to increase in its practical application if there is flow in the tube, which makes the transportation of fuel easy. The biofuel cell roll contacts with the wall of the tube, so flow in the tube does not disturb. Also, the biofuel cell roll has multi-layers offering more electroactive area.

• Journal of Sensor Science and Technology
• /
• v.29 no.2
• /
• pp.89-92
• /
• 2020

Polytetrafluoroethylene (PTFE) fibers are widely used in the textile industry, filter media, membrane distillation, electronic appliances, and construction. In this study, PTFE-polyethylene oxide (PEO) fibrous membranes were fabricated by emulsion electrospinning; subsequently, pure PTFE nanofibers were obtained via sintering. PTFE-PEO electrospinning solutions were prepared using different weight ratios to determine the optimized condition. As the ratio of the PEO increased, the fiber structure improved. Scanning electron microscopy and Fourier-transform infrared spectroscopy observations indicate that PEO is removed and PTFE fused gradually to form bonds among them during sintering. The obtained pristine PTFE membrane demonstrated hydrophobicity at 143.6° water contact angle and oleophilicity at 0° oil contact angle, which is known to be utilized for oil/water separation. A simple separation experiment was performed to remove oil droplets from water. The PTFE membrane exhibited good chemical stability and a high surface-area-to-volume nanofiber ratio. These excellent properties suggest that it is applicable to oil/water separation in harsh chemical environments.

• Journal of Korean Society for Atmospheric Environment
• /
• v.27 no.1
• /
• pp.50-62
• /
• 2011

Temporal trends and spatial distributions of ozone concentrations in Pohang were investigated using data measured at 4 air quality monitoring stations (i.e., Daedo, Jukdo, Jangheung, and Desong) during 2002-2006. The monthly mean ozone concentrations were highest during April and June and decreased during July and August, which follows the typical trend in the Northeast Asia region. The high springtime ozone concentration might have been strongly influenced by the enhanced photochemical ozone production of accumulated precursors during the winter under increased solar radiations. In July and August, ozone levels were decreased by frequent and severe precipitation that caused lower mean monthly solar radiation and efficient wash-out of ozone precursors. This suggests that precipitation is extremely beneficial in the aspect of ozone pollution control. High ozone concentrations exceeding 80ppb dominantly occurred in May and June during the late afternoon between 16:00~17:00. Ozone concentrations were higher in Jangheung and Daesong relative to Daedo and Jukdo, whereas total oxidants $(O_3+NO_2)$ were higher in Jangheung and Daedo. In the suburban area of Daesong, ozone concentrations seem to be considerably higher than those in urban sites of Daedo and Jukdo due to lower ozone loss by NO titration with lower local NO level.

• Journal of the Korean housing association
• /
• v.22 no.1
• /
• pp.75-84
• /
• 2011

This study examines the characteristics and the degree of inhabitant's mental against to their residential environment which was developed within the boundary of Haedo Dong in Pohang City during the 1970s and the early of 1980s and currently designated as programed site for Urban Maintenance Project. Findings from the study are as follows; First, the numbers of household occupied by lessee were greater than the numbers of household occupied by homeowner. Second, most of the lessee was living in single family household. Third, although the degree of satisfaction for their residential environment was not so good in general perspectives the degree of satisfaction of the long term residents for their residential environment was slightly higher than the others. Fourth, the degree of satisfaction for their neighborhood was the most while the degree of satisfaction for public facilities such as parks was the least. Fifth, Urban maintenance project shall be proceeded to raise re-settlement ratio of residents, to enforce a business by steps, to lead positively participation of a resident and to enlarge role of administration.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.5
• /
• pp.539-544
• /
• 2016

The aim of this study is identifying characteristics of spatial distribution using submerged debris data on the bottom of sea ground. Marine debris is classified into floating and submerged debris. These are polluting marine environment, ecology and habitat by floating and submerged. Also it takes a lot of money when it is to process the waste flowing into the ocean. In this study, it is used data of submerged debris by side scan sonar on the bottom of sea ground in Pohang port. Submerged distribution map is made to identify spatial classified characteristics of SMD(submerged marine debris) using by position and weight per area of SMD.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.28 no.1
• /
• pp.61-70
• /
• 1992

In this study, corrosion fatigue test of SAPH45 steel was performed by the use of plane bending fatigue tester in marine environment and investigated fracture surface growth behavior of base metal and heat affected zone corrosion fatigue. The main results obtained are as follows: 1) Fracture surface growth of heat affected zone (HAZ) is delayed more than that of base matel (BM), and they tend to faster in seawater than in air. 2) Corrosion sensitivity to corrosion fatigue life of HAZ is more susceptible than that of BM. 3)In the case of the corner crack by corrosion fatigue, the correlation between the propagation rate of fracture surface area(dA/dN) and stress intensity factor range(ΔK) for SAPH45 are applied to Paris rule as follows: dA/dN=C(ΔK) super(m) where m is the slope of the correlation, and is about 6.60-6.95 in air and about 6.33-6.41 in seawater respectively.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2005.04a
• /
• pp.85-89
• /
• 2005

Lineament maps are the important tools that may reveal points of groundwater recharge, flow and development. In particular, groundwater flows and yields in mountainous area, composed of crystalline rocks with many fractures, are governed mainly by the lineaments corresponding to fractures, joints and faults. Lineaments may give important information on the best distribution of wells and their management. For two districts; Pohang and Cheonan, the relationship between lineament and groundwater factors was analyzed. To compare groundwater productivity, storativity, and transmissivity of a well site along the distance to lineament, the distances to lineament was regrouped into five groups with an equal range, 100m, for the Pohang district and they are also divided into five groups with an equal range, 150m, for the Cheonan district. From the results of the Spearman Rank Correlation Analysis and Kendall Analysis for each group, the means of SPC and T of wells which are located near lineaments generally have large values. The means of SPC and T show a reverse linear relationship with a lineament distance, but the means of S shows a disperse distribution and no distinct linear relation. Result of the linear regression model between SPC and lineament length density shows that it will be effective to use the lineament length density map when finding the optimal well site on a regional scale.

• Spatial Information Research
• /
• v.14 no.1 s.36
• /
• pp.115-128
• /
• 2006

The aim of the study is to select and verify for development of groundwater resources using Geographic Information System(GIS). The water balance, land cover, forest, soil, elevation, slope, hydrogeology and lineament were analyzed. Using GIS, relationship between the data and groundwater yield data was analyzed and the groundwater resources potential map was made for selecting suitable area for groundwater development. Then groundwater resource potential map was verified using groundwater yield data. The verified result showed the good agreement between the potential map and groundwater yield data. The potential map can be used for groundwater management which is related to groundwater development.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.144.1-144.1
• /
• 2013

Recently, we have developed the local oxidization and hydrogenization method for graphene layer using atomic force microscope(AFM) tip at room temperature and ambient pressure. With this method we could create locally oxidized or hydrogenized area on the graphene layer with various size from nanometer to micrometer scale, by controlling the amplitude and polarity of the voltage supplied between conducting AFM tip and the graphene layer. We investigated the chemical states of functionalized C atoms in the graphene layer using scanning photoelectron microscopy. By measuring C 1s core level X-ray Photoemission Spectra of the C atoms and suitable fitting process carried on the measured spectra, we could obtain the fraction of oxidization and hydrogenization under various condition, and the evolution of each chemical state during thermal annealing process.

• Journal of the Korean Magnetics Society
• /
• v.21 no.6
• /
• pp.231-236
• /
• 2011

X-ray Free Electron Laser (XFEL) has been known to be a dream X-ray source opening an epoch in X-ray science with the characteristics of femtosecond pulse, perfect transverse coherence, and ultra-high brightness. Here we introduce the XFEL source shortly and report the status of the worldwide XFEL facilities, and then the experimental instrumentations for XFEL are reviewed in their conceptual classification scheme. Scientific examples and applications proposed in the research area of magnetism for XFEL are briefly mentioned. Finally are summarized the facility overview and the scientific proposals for PAL-XFEL project.