• Analytical Science and Technology
• /
• v.17 no.3
• /
• pp.278-281
• /
• 2004

The separation and concentration method of gold(III) and platium(IV) ions from other ions has been investigated using chelate resin, Amberlite IRC 718 in the mixed solution. The adsorption and desorption capacity of ions on the chelate resin in mixed solution were measured at room temperature. Using the data, gold(III) and platium(IV) ions were separated and concentrated in the ions solution.

• 대한치과보철학회:학술대회논문집
• /
• 2002.11a
• /
• pp.79-79
• /
• 2002

• Environmental Analysis Health and Toxicology
• /
• v.12 no.3_4
• /
• pp.67-73
• /
• 1997

This study was carried out to investigate the contents of heavy metals such as iron, copper, lead, cadmium, magnesium, platium in connection with water pollution in sea weed (dried laver) collected from the west, south, south- west, and east coasts of Korea. The results of the study are as follows; Iron was shown the highest value (1.280ppm) in the wild laver from the south coast. Copper was detected in larger qauntities (0.169 ppm) in green laver than in any other kinds of laver observed in this study. Lead was detected in larger quantities (0.195ppm) in the usual laver and green laver from the south-west coast as compared with the other coasts. Although cadmium and platium was also detected from every kind of laver, the concentrations were not over the allowance of the residual.

• Bulletin of the Korean Chemical Society
• /
• v.22 no.8
• /
• pp.883-888
• /
• 2001

We describe an ion-surface scattering apparatus newly developed to investigate the reactive scattering process of low-energy alkali-metal ions at surfaces. The apparatus consists of an alkali-metal ion gun that is rotatable by 360°, a quadrupole mass spectrometer (QMS) with an ion energy analyzer, a sample manipulator with a heating-and-cooling stage, and an ultrahigh vacuum (UHV) chamber that houses these components. Preliminary experimental results obtained from the apparatus are presented on angular and energy distributions of the ions scattered from clean Pt(111) and water-adsorbed Pt surfaces.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.198.1-198.1
• /
• 2010

고분자전해질 연료전지(PEMFC)의 핵심부품인 스택의 MEA는 전극과 멤브레인 전해질, GDL(Gas Diffusion Layer)로 구성되며, 전극은 Anoth극과 Cathod극으로 나뉘어 각각의 전극 특성에 적합한 전극촉매를 적용하게 된다. Anoth극과 Cathod극은 탄소 지지체 위에 원하는 사양의 희유금속이 도포되어 존재하는데 이들 희유금속은 그 희귀성으로 인해 사용 후 반드시 재사용되어야 한다. 사용된 전극에서의 희유금속 회수는 산침출, 불순물제거, 추출, 탈거 공정으로 이루어지며, 산침출 시 산화제로 사용된 NaOCl로 인한 침출용액 내의 Na+ 이온의 증가는 불순물제거 공정에 의해 반드시 제거되어야 한다. 따라서 본 연구에서는 CCG 방식으로 전극촉매를 GDL에 코팅한 MEA로부터 백금족 희유금속을 회수 시 MEA에 포함되어 있는 소량의 불순물을 제거하고자 한다.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.11a
• /
• pp.29-29
• /
• 2008

Platinum Thin films were deposited on $Al_2O_3$ by Rf magnetic Sputtering. The physical and electrical characteristics of these films were analyzed under various deposition conditions(Ar gas pressure, input power, substrate temperature.) and annealing condition. The deposition rate was increased with increasing the input power but not increased linear. In the other factor, The Pt thin films property was associated with resistance. so lower resistance had more and more good Pt thin films condition. For the purpose of this study, we will get the best Pt thin film characteristics.

• Journal of the korean Society of Automotive Engineers
• /
• v.4 no.1
• /
• pp.46-55
• /
• 1982

When an oxidizing catalytic converter which makes use of platium as a catalyst is employed by means if emission control of CO and HC gasoline engine, the effects of important factors for the purification efficiency, i.e engine speed and secondary air rate, on the reduction of CO and HC concentrations in the exhaust gas are studied experimentally. In the experiment, gasoline and LPG are used as a fuel, and the purification efficiency is examined and the results of both cases are compared with each other. The experimental results showed that the purification efficiency in the case of LPG is usually higher than that of gasoline, and the optimum values of engin speed and secondary air rate for maximum purification efficiency exist in common on both cases.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.154-157
• /
• 2006

The counter electrode widely used in DSCs (Dye-sensitized Solar Cells) is constructed of conducting glass substrates coated with Pt films, where the platium acts as a catalyst. Pt counter electrodes in DSCs are one important component. It is expected that characteristics of Pt electrodes strongly depend on fabrication process and its surface condition. In this study, Pt counter electrode surface of DSC is deposited by reactive RF magnetron sputtering under the conditions of Ar 5mtorr, RF power of 120w and substrate temperature of $100^{\circ}C$. Surface morphology of Pt electrodes was investigated by FE-SEM and AFM. And this paper shows our recent results and technology to fabricate the new designed cell with Pt electrodes deposited by sputtering method. We have achieved fill factor 65% and photoelectric conversion efficiency around 2.6% as the best results of new designed DSCs structure.

• Journal of the Korean Chemical Society
• /
• v.19 no.2
• /
• pp.104-115
• /
• 1975

The electrochemical reduction of iodine in non-aqueous media have been studied by polarography, chronopotentiometry, cyclic voltammetry and controlled potential coulometry at dropping mercury electrode and platinum, gold and amalgamated platium electrodes. In amphiprotic solvents such as methanol, ethanol, isopropanol and pyridine, iodine were reduced to iodide ions via one step reduction involving 1 electron and in aprotic solvents such as acetonitrile, dimethylformamide and dimethylsulfoxide via two step reduction involving all 3 electrons. The reductions of iodine give well defined polarograms at dropping mercury electrode and irreversible chronopotentiograms at platinum electrode, but less defined irreversible chronopotentiograms at gold and amalgamated platinum electrodes, those are all diffusion controlled. The diffusion coefficients of iodine in various solvents were estimated from the chronopotentiometric data and Sand equation.