• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.10
• /
• pp.1395-1400
• /
• 2018

EO TGP(Electro-Optical Targeting Pod) is an optical tracking system which has various functions such as target tracking and image stabilization and LOS(Line of Sight) change. Especially, it is very important to move the LOS into a interest point for joystick command. When pilot move joystick in order to observe different scene, EO TGP gimbals should be operated properly. Generally, most EOTS just operate corresponding gimbal for joystick command. For example, if pilot input horizontal command in order to observe right hand screen, it just drive azimuth gimbal at any position. But in the screen, the image dosen't move in a horizontal direction because gimbal structure is Euler angle. And image rotation is occurred by elevation gimbal angle. So we need to move Pitch gimbal. So in the paper, we designed LOS moving algorithm which convert LOS command to gimbal velocity command to move LOS properly. We modeled a differential kinematic equation and then change the joystick command into velocity command of gimbals. This algorithm generate velocity command of each gimbal for same horizontal direction command. Finally, we verified performance through MATLAB/Simulink.

• Journal of Broadcast Engineering
• /
• v.10 no.2
• /
• pp.174-181
• /
• 2005

In this paper, we proposed new fast scattered pilot synchronization techniques to reduce the burst synchronization time for the DVB-H receiving system with robustness. DVB-H terminals employ a TDM system called 'Time-Slicing' to reduce power consumption. In order to fully exploit the potential power reduction, the synchronization time for the DVB-H receiver must be very short. A typical DVB-T system uses the TPS Synchronization to determine the position of scattered pilots which are used for channel estimation, and it takes 68 OFDM symbol time. In this paper, several new fast scattered pilot synchronization techniques are proposed.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.7 no.2
• /
• pp.85-92
• /
• 2003

This paper presents an electric power generating system for stand-alone health monitoring sensor unit of bridge structure based on ambient vibration of bridge. In this paper, a novel electric power generator which has minimum effect of armature reaction is proposed. The related mechanical and electrical design equations are obtained, and a pilot generator has been implemented. In addition, the charging system for extremely low generator current is discussed, and some improvements are identified for the system. This investigation reveals that diode characteristics of rectifier is dominant factor in the charging process. Finally, both the simulation, which uses real measurement data of the Namhae bridge as input of the pilot generator, and indoor test are carried out. The results showed the applicability and effectiveness of the stand-alone vibration powered generator.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.7 no.3
• /
• pp.175-182
• /
• 2009

The spent cationic exchange resins and anionic exchange resins were separated from mixed spent exchange resins by a fluidized bed gravimetric separator. The separated resins were identified by an elemental analysis and thermogravimetric analysis. The each test sample was prepared by diluting the slurry made by wet ball milling the cationic exchange resins and the anionic exchange resins separated as a spherical granular form for 24 hours. The resulting test samples showed a slurry form of less than $75{\mu}m$ of particle size and 25,000ppm of $COD_{cr}$. The decomposition conditions of each test samples from a thermal power plant were obtained with a lab-scale(reactor volume : 220mL) supercritical water oxidation(SCWO) facility. Then pilot plant(reactor volume : 24 L) tests were performed with the test samples from a thermal power plant and a nuclear power plant successively. Based on the optimal decomposition conditions and the operation experiences by lab-scale facility and the pilot plant, a commercial plant(capacity : 150kg/h) can be installed in a nuclear power plant was designed.

• Archives of design research
• /
• v.16 no.2
• /
• pp.121-130
• /
• 2003

The diffusion expressive power means the flexibility of which creative power test spheres(fluency, originality) by Torrance is ability making the considerations, thoughts and concepts to the meaningful symbolic change. This study is willing to develop and improve program toward the diffusion expressive power and is to testify training effect of the students are majoring design with the object. The training programs composed of six levels which is based on the theory of Eskild Tjalve. And the parameters of each levels are element, function, number, arrangement, form geometric, size and have to practice 2 weeks at once by 12 weeks. For successful measuring the effective results of this study, 40 undergraduate junior students in the department of design are grouped to excercise with experimental pilot group and regulated group. The standard type of creative paper is used to evaluate the results of student's training. This study give proof that creative power of the experimental pilot and under training group is higher than the regulated and under comparison group at in the conclusion.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.5
• /
• pp.545-551
• /
• 2011

In this paper, we described a measurement method of an EIRP(Effective Isotropic Radiated Power) of a WCDMA base station using a pilot channel in line-of-sight environments. Especially we measured it in real base station environments in order to apply this method to domestic base station inspection test. Estimated EIRP results from measured value is -2 dB lower than theoretical values, which is calculated by the data of transmit antenna. The deviation of -2 dB is verified as a polarization mismatch between the base station antenna and a receiver antenna, and it can be calibrated. Therefore, we verified that our measurement method could be an effective tool to measure an EIRP in WCDMA base station inspection test.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.5C
• /
• pp.351-360
• /
• 2008

In cellular mobile radio systems with frequency reuse, the interference signals degrade the channel estimation and signal detection performance due to the low signal-to-interference ratio near coverage boundaries. When the preamble pilot sequences from different cells are orthogonal or located in disjointed positions, they can be used for multi-cell channel estimation and interference cancellation. In time-varying channels caused by Doppler spread, data pilot symbols are needed for channel estimations. However, data pilot symbols are usually located in identical positions for the overhead reduction, which degrades the channel estimation performance. In this paper, we demonstrate a significant amount of performance improvement is achieved by multiplying different pseudonoise(PN) sequences to the data pilot symbols from adjacent interference cells. In particular, for detection scheme using maximal ratio combining(MRC) and inter-cell spatial demultiplexing(ISD), quantitative performance gain of spectral efficiency for different values of Doppler frequency and interference power is presented.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.5
• /
• pp.575-582
• /
• 2007

In this paper, a 100 Watt high power amplifier has been implemented and performed evaluation, which is operating at UHF band ($470\;{\sim}\;806\;MHz$) for Digital TV repeater. To achieve increase of bandwidth and high power capability, 3-way power combiner and divider of Wilkinson type was adopted. In order to measure the fabricated 100 Watt power amplifier, the estimation technique function which makes equivalent mask was used. As a result of the measurement, the existence of pilot signal is confirmed and the signal transmitted at the rated output power 100 Watt is brought out the flat feature through 6 MHz bandwidth. and it resulted that its value was less than -47 dB at the edge of radiation channel and less than -110 dB at more than 6 MHz position from channel edge.

• Journal of Climate Change Research
• /
• v.7 no.3
• /
• pp.217-229
• /
• 2016

Increased evidences reveal that the global climate change adversely affect on the environment. Smart grid system is one of the ways to reduce greenhouse gas emissions in the electricity generation sector. Since 2013, Korea Electric Power Corporation (KEPCO) has installed smart grid station in KEPCO office buildings. The goal of this paper is two folds. One is to quantify the reduction in greenhouse gas emissions through smart grid stations installed in KEPCO office buildings as a part of pilot project. Among components of smart grid stations, this research focused on the photovoltaic power system (PV) and energy storage system (ESS). The other is to estimate the reduction in greenhouse gas emissions when PV is applied on individual houses. Results show that greenhouse gas emissions reduce 5.8~11.3% of the emissions generated through the electricity usage after PV is applied in KEPCO office buildings. The greenhouse gas emissions reduction from ESS is not apparent. When PV of 200~500 W is installed in individual houses, annual greenhouse gas emission reduction in 2016 is expected to be approximately $2.2{\sim}5.4million\;tCO_2-eq$, equivalent to 6~15% of greenhouse gas emissions through the electricity usage in the house hold sector. The saving of annual electricity cost in the individual house through PV of 200 W and 500 W is expected to be 47~179 thous and KRW and 123~451 thousand KRW, respectively. Results analyzed in this study show the environmental effect of the smart grid station. In addition, the results can be further used as guidance in implementing similar projects.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2009.10a
• /
• pp.615-616
• /
• 2009