• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.239-244
• /
• 2004

In this paper, we have developed a frequency mixer which can be used as a microwave phase conjugator in the LS band retrodirective antenna system. The mixer as a phase conjugator must have an If signal of which frequency is nearly as high as that of an RF signal, so this fact brings difficulty in the combination of input signals and the design of impedance matching circuit. The circuit configuration is chosen to be of the gate mixer using a pseudomorphic HEMT device. The operating frequencies are 4.00 ㎓, 2.01 ㎓, and 1.99 ㎓ for LO, RF, and IF, respectively. Conversion gain is measured to be 12.5 ㏈ and 1 ㏈ compression point -34 ㏈m at the LO power of -7 ㏈m. The mixer fabricated in this research is the single-ended type, where RF leakage signal appears inevitably at the If port because RF and If frequencies are almost the same. The circuit topology suggested here can be applied directly to the design of balanced-type mixers and phase conjugators.

• The Journal of Korean Academy of Prosthodontics
• /
• v.46 no.5
• /
• pp.443-454
• /
• 2008

Statement of problem: A clinically successful color match is one of the important factor to get an esthetic dental restoration. Dental shade guides are commonly used to evaluate tooth color in restorative procedure. But numerous reports have indicated that common shade guides do not provide sufficient spectral coverage of the natural tooth colors. To address issues associated with the shade guide, distinct avenues have been pursued objective spectrophotometric / colorimetric assessment. Purpose: This study compared the accuracy of tooth color selection of spectrophotometer with that of human visual determination. Three main factors were investigated, namely, the effect of light, the individual variation and the experience of the observer. Material and methods: At the first experiment, on ten patients, one operator independently selected the best matching shade to the unrestored maxillary central incisor, using a Vita Classical Shade Guide in the morning, at noon and in the afternoon. The same teeth were measured by means of a reflectance spectrophotometer. At the second experiment, on ten patients, ten operators (5 experts, 5 novices) selected and measured by the same method above at noon. At the third experiment, the results of the second experiment were divided into two groups, expert and novice, and analyzed. Results: 1. There was significant difference between visual and spectrophotometric assessment (mean ${\Delta}E$ values) in experiment 1, 2, 3 (P < .05). 2. There was no significant difference between experts and novices group, when comparing with each visual and spectrophotometric assessment (mean ${\Delta}E$ values). Conclusion: Spectrophotometer could be used to analyze the shade of natural tooth objectively. Thereby, this method offers the potential tominimize considerably the need for corrections or even remakesafter intraoral try-in of restoration. Furthermore, to achieve its advantage, both the shade-matching environment and communication between dentist and technician should be optimized with use of visual and instrumental shade-matching systems.

• Journal of Oral Medicine and Pain
• /
• v.38 no.1
• /
• pp.19-28
• /
• 2013

With Korea's rapid entry to aged society, elderly population has become a major age group both in the whole society and medical field and its importance will be constantly stressed out. Elderly population is also important in the field of oral medicine which deals with chronic and recurrent diseases in the orofacial region of non-dental origin but there exist few studies indicating epidemiology of elderly patients in this regards. This study aimed to investigate change of age distribution of new patients in a university-based dental hospital and oral medicine clinic for last decade and to investigate clinical epidemiology of elderly patients (${\geq}$ 65 years) of oral medicine clinic. This study was performed retrospectively using medical records of the new patients in Dankook University Dental Hospital in 2001 and 2011. According to the study, percentage of elderly new patients increased in both dental hospital and oral medicine clinic and degree of the increase was greater in oral medicine clinic than in the whole hospital (p=0.000). 13.5% of adult patients ${\geq}$ 18 years of oral medicine clinic were elderly patients ${\geq}$ 65 years. 83% of elderly patients were suffering from one or more systemic diseases. Although TMD was the most common reason for elderly patients who visited oral medicine clinic, oral soft tissue diseases, dry mouth, burning mouth syndrome and oromandibular dystonia was more frequently diagnosed in elderly patients compared to adult patients aged 18 to 64 years. Pain severity and interference of Brief Pain Inventory and depression and anxiety scores of Hospital Anxiety Depression Scales were higher in elderly patients than in the adult patients (p<0.05). Increase of elderly patients with chronic oral diseases and pain needs more attention of dentists and specialists of oral medicine to improvement of assessment and development of tailored management because large portion of the elderly patients have systemic diseases, polypharmacy and impaired communication, possibly restricting treatment options.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.6
• /
• pp.1083-1091
• /
• 2017

This paper describes a design of cryptographic processor supporting 224-bit elliptic curves over prime field defined by NIST. Scalar point multiplication that is a core arithmetic function in elliptic curve cryptography(ECC) was implemented by adopting the modified Montgomery ladder algorithm. In order to eliminate division operations that have high computational complexity, projective coordinate was used to implement point addition and point doubling operations, which uses addition, subtraction, multiplication and squaring operations over GF(p). The final result of the scalar point multiplication is converted to affine coordinate and the inverse operation is implemented using Fermat's little theorem. The ECC processor was verified by FPGA implementation using Virtex5 device. The ECC processor synthesized using a 0.18 um CMOS cell library occupies 2.7-Kbit RAM and 27,739 gate equivalents (GEs), and the estimated maximum clock frequency is 71 MHz. One scalar point multiplication takes 1,326,985 clock cycles resulting in the computation time of 18.7 msec at the maximum clock frequency.

• The Journal of the Acoustical Society of Korea
• /
• v.23 no.8
• /
• pp.554-561
• /
• 2004

As the technologies of semiconductor and multimedia communication have been improved. the high-quality video and the multi-channel audio have been highlighted. MPEG Audio Layer 3 decoder has been implemented as a Processor using a standard. Since the synthesis filter of MPEG-1 Audio Layer 3 decoder requires the most outstanding operation in the entire decoder. the synthesis filter that can reduce the amount of operation is needed for the design of the high-speed processor. Therefore, in this paper, the synthesis filter. the most important part of MPEG Audio, is materialized in FPGA using the method of DAULT (distributed arithemetic look-up table). For the design of high-speed synthesis filter, the DAULT method is used instead of a multiplier and a Pipeline structure is used. The Performance improvement by 30% is obtained by additionally making the result of multiplication of data with cosine function into the table. All hardware design of this Paper are described using VHDL (VHIC Hardware Description Language) Active-HDL 6.1 of ALDEC is used for VHDL simulation and Synplify Pro 7.2V is used for Model-sim and synthesis. The corresponding library is materialized by XC4013E and XC4020EX. XC4052XL of XILINX and XACT M1.4 is used for P&R tool. The materialized processor operates from 20MHz to 70MHz.

• Journal of the Korean Society of Radiology
• /
• v.11 no.7
• /
• pp.605-610
• /
• 2017

Unlike adults, cognitive ability and communication are not accurate in pediatric patients. Therefore movement due to psychological anxiety in X-ray photography is one of the factors that increase repeated irradiation. In order to minimize the rejection of X-ray and to improve the satisfaction of medical service, it is necessary to improve the environment of the radiological room to help psychological stability and to find a positive measure for reduction of radiation dose, including unnecessary. The subjects of this study were 186 pediatric patients from May to July, 2017, who were from 6 months to 36 months, The study group was set up a radiological room without auditory and visual environment changes is A group, except for changes in visual environment, the room where only auditory environmental changes were applied was group B, the auditory environment changes were excluded, and the room where only the visual environment change was applied was divided into group C, the auditory and visual environment changes were applied to the D. In group A, 10 retrospectives were obtained, 7 in group B, 5 in group C, and 2 in group D. Especially in group A and group D, statistically significant at p <0.053 In conclusion, hearing and visual environment changes affected the psychological stability of pediatric patient, and the repeated irradiation was reduced, thus improving the quality of medical services.

• Journal of the Korean Magnetics Society
• /
• v.24 no.4
• /
• pp.123-127
• /
• 2014

We developed a digital 3-axis flux-gate magnetometer for magnetic field signal measurement from warship during demagnetizing and degaussing processes. For the magnetometer design, we considered following points; the distance between magnetic field measurement station and magnetometer located under sea is about several 100 m, the magnetometer is exposed to magnetic field of ${\pm}1mT$ during demagnetizing process, and magnetometer is located under the sea about 30 m depth. To overcome long distance problem, magnetometer could be operated on wide input supply voltage range of 16~36 V using DC/DC converter, and for the data communication between the magnetometer and measurement station a RS422 serial interface was employed. To improve perming effect due to the ${\pm}1mT$ during demagnetizing process, magnetometer could be compensated external magnetic field up to ${\pm}1mT$ but magnetic field measuring rang is only ${\pm}100{\mu}T$. The perming effect was about ${\pm}2nT$ under ${\pm}1mT$ external magnetic field. The magnetometer was tested water vessel with air pressure up to 6 bar for the sea water pressure problems. Linearity of the magnetometer was better than 0.01 % in the measuring range of ${\pm}0.1mT$ and noise level was $30pT/\sqrt{Hz}$ at 1 Hz.

• Korean Journal of Social Welfare
• /
• v.38
• /
• pp.284-308
• /
• 1999

This study is about the nationwide research concerning the degree and trends of marital conflict and instability. The research samples are 1,217 married. As the result of the research, the most conflict able issues in Korean couples are on the husband-wife relations, such as habitual differences, sharing in houseworks, conflicts in the role expectation, and the communication problems. In this study, We devide the marital relationships into 4 types (A, B, C, and D) in the view of the satisfaction & instability of marriage. First, the marriage with unsatisfaction and instability (A) was portioned 8.3%, and the satisfactory & stable type (D) was portioned 68.4%. It seems the marital relationships in Korea are relatively stable. However, the portion of type B-unsatisfactory, but stable couples-is 17.1% and the type C-satisfactory, but unstable marriage 6.2%. The result implies that the indication of marital instability should consider not only the divorce rate, but also the quality of marital relationships. In other words, the intervention for the conflict couples yet not divorce is needed. The differences of conflict areas among the relational types is not so much, but the degrees on conflicts are very serious. Especially, in the areas of marital conflict, love issues and personal value system affect the division of relational types of marriage most. It means the interaction factors are the most important variables about maintaining the marital relations with stable and satisfaction.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.2
• /
• pp.306-316
• /
• 2016

In this paper, an NMOS-diode eFuse OTP (One-Time Programmable) memory cell is proposed using a parasitic junction diode formed between a PW (P-Well), a body of an isolated NMOS (N-channel MOSFET) transistor with the small channel width, and an n+ diffusion, a source node, in a DNW (Deep N-Well) instead of an NMOS transistor with the big channel width as a program select device. Blowing of the proposed cell is done through the parasitic junction formed in the NMOS transistor in the program mode. Sensing failures of '0' data are removed because of removed contact voltage drop of a diode since a NMOS transistor is used instead of the junction diode in the read mode. In addition, a problem of being blown for a non-blown eFuse from a read current through the corresponding eFuse OTP cell is solved by limiting the read current to less than $100{\mu}A$ since a voltage is transferred to BL by using an NMOS transistor with the small channel width in the read mode.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.11 no.1
• /
• pp.56-67
• /
• 1999

It is desired to use a domestically manufactured ocean data buoy for the long-term operational ocean monitoring. The ocean data buoy manufacturing technology was introduced through the research cooperation with the Qingkong University of Taiwan. The introduced ocean data buoy system was further expanded and improved for more efficient application for the marine environmental monitoring in Korea. The size of the ocean data buoy is 2.5 m in diameter, which is smaller compared to the NOAA's 3.0 m discus buoy to allow easy land transportation and ocean deployment as well. From the dynamic response test of the buoy carried out numerically, it was shown that the measurement of waves with period greater than 4 seconds is acceptable. The measurement and control system of the data buoy were improved to increase the number of measuring parameters, to reduce power consumption and to enhance better data analysis and management. Each component of the improved data buoy system was described in detail in this paper. Water quality sensors of water temperature, salinity, DO, pH and turbidity were added to the system in addition to the marine meteorological sensors of wind speed and direction, air temperature, humidity, air pressure and wave. Inmarsat satellite communication system is used for the real-time data telemetry from the buoy deployed offshore. A field performance test of the improved and domestically manufactured buoy was carried out for a month at the open sea off Pohang together with DatawelI's Wave-rider buoy to compare the wave data. The results of the test were satisfactory.