• Korean Journal of Radiology
• /
• v.22 no.4
• /
• pp.502-512
• /
• 2021

Objective: To objectively and subjectively assess and compare the characteristics of monoenergetic images [MEI (+)] and polyenergetic images (PEI) acquired by dual-energy CT (DECT) of patients with breast cancer. Materials and Methods: This retrospective study evaluated the images and data of 42 patients with breast cancer who had undergone dual-phase contrast-enhanced DECT from June to September 2019. One standard PEI, five MEI (+) in 10-kiloelectron volt (keV) intervals (range, 40-80 keV), iodine density (ID) maps, iodine overlay images, and Z effective (Z_eff) maps were reconstructed. The contrast-to-noise ratio (CNR) and the signal-to-noise ratio (SNR) were calculated. Multiple quantitative parameters of the malignant breast lesions were compared between the arterial and the venous phase images. Two readers independently assessed lesion conspicuity and performed a morphology analysis. Results: Low keV MEI (+) at 40-50 keV showed increased CNR and SNR_{breast lesion} compared with PEI, especially in the venous phase ([CNR: 40 keV, 20.10; 50 keV, 14.45; vs. PEI, 7.27; p < 0.001], [SNR_{breast lesion}: 40 keV, 21.01; 50 keV, 16.28; vs. PEI, 10.77; p < 0.001]). Multiple quantitative DECT parameters of malignant breast lesions were higher in the venous phase images than in the arterial phase images (p < 0.001). MEI (+) at 40 keV, ID, and Z_eff reconstructions yielded the highest Likert scores for lesion conspicuity. The conspicuity of the mass margin and the visual enhancement were significantly better in 40-keV MEI (+) than in the PEI (p = 0.022, p = 0.033, respectively). Conclusion: Compared with PEI, MEI (+) reconstructions at low keV in the venous phase acquired by DECT improved the objective and subjective assessment of lesion conspicuity in patients with malignant breast lesions. MEI (+) reconstruction acquired by DECT may be helpful for the preoperative evaluation of breast cancer.

• Journal of Sensor Science and Technology
• /
• v.5 no.3
• /
• pp.101-108
• /
• 1996

The silicon $p^{+}-n$ junction diodes were fabricated. The fabricated wafers were treated by single or double annealing steps. Single annealing process was performed by diffusion of either Au or Pt into the wafer under the oxygen or nitrogen ambient at $800{\sim}1010^{\circ}C$. Second annealing step involved additional annealing of the single annealed wafer under the oxygen ambient at $800{\sim}1010^{\circ}C$ for one hour. Electrical characteristics of the diodes were investigated to evaluate the effect of the annealing treatments. In the case of single annealing under nitrogen ambient at $1010^{\circ}C$ for one hour, the amount of leakage current of Pt diffused diode was 75 times larger than that of Au diffused one. The optimum processing condition to achieve high speed silicon $p^{+}-n$ junction diodes from this study was obtained when Pt diffused wafer(treated under the nitrogen ambient at $1010^{\circ}C$ for one hour) was secondly annealed in an oxygen ambient at $800^{\circ}C$ for one hour. The resulting leakage current of two step annealed diodes were remarkably reduced to 1/1100 of the single annealed one. The diode characteristics such as recovery time, breakdown voltage, leakage current, and forward voltage were 4ns, 138V, 1.72nA, and 1V, respectively.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.32 no.3
• /
• pp.252-255
• /
• 1999

The quality characteristics of the Korean traditional salt-fermented fish sauces, the traditional anchovy sauce (TAS) and the sandlance sauce(TKS) were evaluated comparing to the commercial anchovy sauce (CAS) and sandlance sauce (CKS). The acidity was higher in TKS than in TAS, whereas the contents of VBN, total-N and amino-N were higher levels in TAS. In color values, L and b values in TAS were generally higher than those in TKS, whereas a and ${\Delta}E$ values were higher in TKS. The contents of total free amino acids in TAS and TKS were $12.40\;g\%$ (w/v) and $9.549 g\%$ (w/v), respectively. The contents or six amino acids, alanine, glutamic acid, leucine, isoleucine, valine and Iysine were higher in TAS, whereas the contents of arginine, glutamic acid, leucine, alanine and valine were higher in TKS. Nucleotides such as IMP and hypoxanthine were principal components in both TAS and TKS. The nitrogen related compounds, TMAO, TMA and total creatinine were determined to be $108.8\;mg\%$ (w/v), $60.5\;mg\%$ (w/v), $62.4\;mg\%$ (w/v) in TAS, and those in TKS were $60.1\;mg\%$ (w/v), $24.1\;mg\%$ (w/v), $67.6\;mg\%$ (w/v), respectively.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.05a
• /
• pp.51-54
• /
• 1996

This paper reports the studies of the inversion layer mobility in p-channel Si MOSFET's under hot-carrier degradated condition. The validity of relationship of hot carrier degradations between the surface effective mobility and field effect mobility and are examined. The effective mobility(${\mu}$$\_$eff/) is derived from the channel conductances, while the field-effect mobility(${\mu}$$\_$FE/) is obtained from the transconductance. The characteristics of mobility curves can be divided into the 3 parts of curves. It was reported that the mobility degradation is due to phonon scattering, coulombic scattering and surface roughness. We are measured the mobility slope in curves with DC-stress [V$\_$g/=-3.1v]. It was found that the mobility(${\mu}$$\_$eff/ and ${\mu}$$\_$FE/) of p-MOSFET's was increased by increasing stress time and decreasing channel length. Because of the increasing stress time and increasing V$\_$g/ is changed oxide reliability and increased vertical field.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.4
• /
• pp.99-105
• /
• 1997

The new classified model for N-p heterojunction diode is derived and used extensively in analyzing the current-voltage(I-V) characteristics of the HBTs. A new classification method is presented in order to simplify I-V equations and easily applied to the modeling of HBTs. This classification method is characterized by the properties of devices such as high level injection, the thickness of one or both bulk regions, the surface recombination and the generation-recombination. The simulation results using the proposed model agree well with the experimentally observed I-V behaviors and show good efficiencies in its application to HBTs with respect to mathematical formulation.

• Journal of the Institute of Electronics Engineers of Korea TE
• /
• v.39 no.1
• /
• pp.31-36
• /
• 2002

Low energy boron ions were implanted into the preamorphized and crystalline silicon substrates to form 0.2${\mu}m$ $p^+-n$ junctions. The rapid thermal annealing(RTA) was used to annihilate the crystal defects due to implantation and to activate the implanted boron ions, and the furnace annealing was employed to reflow the BPSG(bolo-phosphosilicate glass). The implantation conditions for Gepreamorphization were the energy of 45keV and the dose of 3$\times$1014cm-2. BF2 ions employed as a p-type dopant were implanted with the energy of 20keV and the dose of 2$\times$1015cm-2. The thermal conditions of RTA and furnace annealing were $1000^{\circ}C$/10sec and $850^{\circ}C$/40min, respectively. The junction depths were measured by SIMS and ASR techniques, and the 4-point probe was used to measure the sheet resistances. The electrical characteristics were analyzed via the leakage currents of the fabricated diodes. The single thermal processing with RTA produced shallow junctions of good qualities, and the thermal treatment sequence of furnace anneal and RTA yielded better junction characteristics than that of RTA and furnace anneal.

• Journal of Sensor Science and Technology
• /
• v.15 no.3
• /
• pp.192-198
• /
• 2006

In this study, the light addressable potentiometric sensors (LAPS) with $Si_{3}N_{4}/SiO_{2}/Si$, and $Ta_{2}O_{5}/SiO_{2}/Si$ structures were fabricated. The penicillinsae was immobilized on the devices to hydrolyze the penicillin using self-assembled monolayer (SAM) method. Then response characteristics according to the penicillin concentrations were measured and compared. The measuring system was simplified by using LabVIEW. The pH response characteristics of fabricated devices are 56 mV/pH ($Si_{3}N_{4}$ sensing membrane) and 61 mV/pH ($Ta_{2}O_{5}$ sensing membrane). The sensitivity of sensor by enzyme reaction result of the enzyme reaction were 60 mV/decade and 74 mV/decade for $Si_{3}N_{4}/SiO_{2}/Si$ and $Ta_{2}O_{5}/SiO_{2}/Si$ structure, respectively, in the range of $0.1\;mM{\sim}10\;mM $of the penicillin concentration.

• Food Science and Biotechnology
• /
• v.18 no.5
• /
• pp.1100-1108
• /
• 2009

Lactic acid bacteria (LAB) isolated from various fruits and vegetables were screened in order to determine appropriate fermentation starters for manufacturing functional fermented onion juice. From the initial screening test comprising more than 700 isolated LAB, 16 isolates were selected based on their acid production rate. Among the selected isolates, the fermentation broth of KC-007 exhibited the highest electron donating and nitrite scavenging activities, with values at pH 1.2 of 95.6 and 68.7%, respectively. From the overall results obtained in this study, we finally selected the bacterium KC-007 as a fermentation starter. This bacterium was identified and named as Pediococcus pentosaceus based on its morphological and physiological characteristics, carbon-utilization pattern (as assessed using an API 50CHL kit), and molecular genetic characteristics (as assessed using the nucleotide sequence of the 16S rRNA gene). The optimal temperature, pH, and starter inoculation concentration (v/v) required for growth of the isolated strain were $40^{\circ}C$, pH 4.0-6.0, and 2%(v/v), respectively.

• Laboratory Medicine Online
• /
• v.1 no.2
• /
• pp.100-104
• /
• 2011

Background: Malaria is a problematic disease in Korea, and microscopic examination of Giemsa-stained blood smear has been used as the gold standard for its diagnosis. However, this technique is time-consuming and has low sensitivity in samples with low numbers of malarial parasites (<20 parasites/μL). Here, we evaluated the performance characteristics of the LG Advansure^TM Malaria P.f./P.v. real-time QPCR (LG life sciences, Korea). Methods: Blood samples from 173 persons who visited Korea University Ansan Hospital were evaluated. QPCR was performed in 73 malaria patients and 100 healthy subjects by using the LG Advansure Malaria P.f./P.v. real-time QPCR^R kit, and the results were compared with those of microscopy. The detection limit of this kit was determined by serial dilution of Plasmodium-infected blood with normal blood (blood not infected with Plasmodium). Results: Among the 73 patients that were microscopically confirmed to have malaria (Plasmodium vivax infection, N=70, P. falciparum infection, N=3), 69 patients were diagnosed with P. vivax infection and 3 were diagnosed with P. falciparum infection by LG Advansure^TM Malaria P.f./P.v. realtime QPCR. Both the tests indicated absence of infection in the 100 healthy subjects. The detection limit of LG Advansure^TM Malaria P.f./P.v. real-time QPCR was 0.1 parasite/μL. Conclusions: LG Advansure^TM Malaria P.f./P.v. real-time QPCRis a very sensitive and specific technique and can be used as a confirmatory test for malaria.

• Applied Chemistry for Engineering
• /
• v.32 no.5
• /
• pp.516-523
• /
• 2021

A study using selective catalytic reduction (SCR) was conducted in conjunction with ammonia as a reducing agent for controlling nitrogen oxides, a typical secondary inducer of fine dust in the atmosphere. For NH₃-SCR experiments, a commercial catalyst of V/W/TiO₂ only and also V/W-Sb/TiO₂ catalyst with Sb were used, and phosphorous durability was confirmed. As a result of NH₃-SCR experiments, it was confirmed that the addition of Sb to V/W/TiO₂ had durability against phosphorous. In addition, the physical and chemical properties were comparatively analyzed through BET, XPS, H₂-TPR, NH₃-TPD, and FT-IR analysis. From the anaylsis results, when Sb was added to V/W/TiO₂ catalyst, P was also added resulting in the formation of SbPO₄ and the generation of VOPO₄ was suppressed. The phosphorous durability was confirmed by maintaining the redox characteristics of the catalyst before P was added.