• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 2006.04a
• /
• pp.505-506
• /
• 2006

• Journal of Environmental Health Sciences
• /
• v.22 no.2
• /
• pp.43-57
• /
• 1996

To characterize worker's exposure to glass fibers, to find the correlation between airborne total dust concentrations and fiber concentrations and to recommend an appropriate evaluation method for worker's exposure to fibrous dusts in glass wool industry, we carried out this study. Average respirable fiber levels at five factories were 0.013-0.056 f/cc, and fairly below the OSHA PEL, 1 f/cc. A factory showed the lowest airborne fiber level, 0.013 f/cc, which was different significantly from those of other factories of which average fiber concentration was 0.046 f/cc. The cutting and grinding operations of insulation products resulted in higher airborne fiber cocentrations than any other processes(p<0.05). To characterize airborne fiber dimension, fiber length and diamter were determined using phase contrast microscope. The geometric means of airborne fiber lengths were $42-105 \mu m$. One factory had airborne fibers whose length distribution(GM = $105 \mu m$) was different from those of other factories(GM = $42-50 \mu m$). The percentages of respirable fibers less thinner than 3 gm were 38.9-90.9% at four factories, and two factories of them had the higher percentages than others. The findings explain for variation of airborne fiber diameters between factories. On the other hand, between the processes were the difference of fiber-length distributions observed. The cutting and grinding operations showed shorter fiber-length distributions than the fiber forming one. However, fiber-diameter distributions or respirable fiber contents were similar in all processes. The airborne fiber concentrations and the dust concentrations had relatively weak correlation(r=0.25), thus number of fibers couldn't be expected reliably from dust amount. Fiber count is appropriate for assessing accurate exposures and health effects caused by fibrous dusts including glass fibers. Ministry of Labor have established occupational exposure limit to glass fibers as nuisiance dust, but should establish it on the basis of respirable fiber concentration to provide adequate protection for worker's health

• Publications of The Korean Astronomical Society
• /
• v.27 no.4
• /
• pp.237-242
• /
• 2012

We have performed a systematic study of interstellar dust grains in various environments of galaxies. AKARI has revealed the detailed properties of dust grains not only in star-forming regions but also in regions not relevant to star formation, some of which are found not to follow our old empirical knowledge. Because of its unique capabilities, AKARI has provided new knowledge on the processing of large grains and polycyclic aromatic hydrocarbons (PAHs). For example, we detect PAHs from elliptical galaxies, which show unusual spectral features and spatial distributions, demonstrating importance of material processing in the interstellar space. We find that copious amounts of large grains and PAHs are flowing out of starburst galaxies by galactic superwinds, which are being shattered and destroyed in galactic haloes. We discover evidence for graphitization of carbonaceous grains near the center of our Galaxy, providing a clue to understanding the activity of the Galactic center. We review the results obtained from our AKARI program, focusing on the processing of carbonaceous grains in various environments of galaxies.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.15 no.4
• /
• pp.175-194
• /
• 2013

Collection of data for this study was conducted by 271 questionnaire responded by the consumers of purchasing anti-allergy bedding products, and analysed statistically using SPSS. Research results through the questionnaire, it was determined to be the cause of allergic disease consumers most house dust mites. Recognition and recognition of house dust mite habitat, bedding called the most recognized. The anti-allergic bedding purchase motives and intelligence recommendations salesman recommendations and store display products that have the greatest impact. Highly educated respondents were more important role in the salesperson's recommendations and famous brand awareness to purchase. Higher income level of the respondents buy anti-allergic bedding for allergy symptoms allergy preventive and mitigation efforts. Quality ratings sewing, color, laundry management was more important in women than in men. The ages 20 to 30 showed that respondents think that more important than plush and brand. More than 40, laundry convenience is more important. Sewing and laundry management respondents of high school or less. Properties for the anti-allergic bedding satisfaction in women than in men, laundry, storage convenience, to prevent dust skimp on the effects of satisfaction was convenient. 30-40s for light weight than satisfaction, high durability and anti-allergic effect on satisfaction was higher than 20 respondents more than 50 respondents. Than 20 respondents more than 40 respondents also appeared to be more about the durability that meets. Anti-allergic bedding was soft to the touch, warmth, dust Blow out prevention effects, anti-allergic performance satisfaction of the properties has a positive effect on repurchase intent. It were also identified as important anti-allergic bedding inclined to the performance of a soft feel and anti-allergic recommended.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.5
• /
• pp.107-114
• /
• 2010

Understanding of reflectance of solar concentrators is important for assessing concentration performance. However inaccurate data about refractive indices of constituent materials and dust accumulation on the surface often prevent figuring out reflectance variations. The current study proposes an approach calculating concentrator reflectance based on the refractive index of glass obtained from reflectance and transmittance measurements. This approach improved accuracy of solar-averaged reflectance from 2.9% to 0.4% compared to the use of existing reference data. Reflectance variations with incidence angles are negligible up to $60^{\circ}C$ at various glass thicknesses. When concentrators are contaminated with dust during 2 months specular reflectance loss of vertically exposed concentrators is less than 7%. However for horizontally exposed concentrators the loss significantly increases up to 40% while dependence of reflectance on incidence angles becomes strong. Measurements of hemispherical reflectance indicate that 80 percentage of the loss comes from scattering rather than absorption by dust. Data of refractive index and reflectance provided in the current study will help estimate or model the concentrated solar flux.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.6
• /
• pp.343-349
• /
• 2014

It is summarized that potential causes of performance degradations and failure mechanisms of crystalline silicon photovoltaic (PV) modules installed in Middle East area. In addition, we also reviewed current PV module qualification test (IEC 61215) and the methods for detection of wear-out fault. The failure of PV modules in the extreme environmental conditions such as deserts is mainly due to high temperature, humidity, and dust storms. In particular, cementation phenomenon caused by combination of sand and moisture leads to rapid degradation in the performance of PV modules. In order to evaluate and guarantee the long term reliability of PV modules, specific qualification tests such as sand dust test, salt mist test and potential induce degradation test considering operating environment of PV module should be carried out.

• Journal of the Korean Institute of Gas
• /
• v.17 no.4
• /
• pp.33-38
• /
• 2013

A study was carried out on the effect of particle size (mean diameter) on magnesium dust explosion. Experimental investigations were conducted in a 20-L explosion sphere, using 10 kJ chemical ignitors. Explosion tests were performed with three different dusts having mean diameter (38, 142, $567{\mu}m$) and the dust concentrations were up to $2250g/m^3$. The lower explosion limits(LEL) of magnesium dusts were about $30g/m^3$ at $38{\mu}m$ and $40g/m^3$ at $142{\mu}m$. LEL tended to increase with particle size and this means that the explosion probability of magnesium dust decreased with increase of particle size. The maximum explosion presssure ($P_m$) and $K_{st}$ (Explosion index) decreased with the increase of particle size. For magnesium powder of $567{\mu}m$, however, the explosive properties were not observed in the 5 kJ ignition energy.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.25 no.3
• /
• pp.346-354
• /
• 2015

Objectives: This study was conducted to evaluate the changes and regional differences of mortality and morbidity particularly respiratory system diseases in the area of exposure to coal dust(Ansim area, Dong-gu, Daegu). Methods: The authors analyzed secondary data(cancer registration data, mortality data, and health insurance data) for respiratory system diseases. We calculated age standardized incidence ratio(SIR), mortality ratio(SMR), and health care utilization ratio(SHR) using those data. Results: There were no significant differences between Ansim area(or Dong-gu, Daegu) and the control area for cancer registration data and mortality data. In the results for the health insurance data, significant increased SHR in asthma was observed compared to the control area. Conclusions: Although confounders such as selection bias were not clearly ruled out, our findings reveal increased asthma SHR in the area of exposure to coal dust. Further prospective studies are required to clarify the increasing respiratory disease due to exposure to coal dust.

• Applied Science and Convergence Technology
• /
• v.26 no.6
• /
• pp.218-222
• /
• 2017

This study was conducted to remove $NO_x$, which is the main cause of fine dust and air pollution as well as acid rain. $NO_x$ was tested using 3% NO (diluted in He) as a simulated gas. Experiments were sequentially carried out by oxidizing NO to $NO_2$ and absorbing $NO_2$. Especially, we focused on the changes of NO oxidation according to both oxidant ($NaClO_2$) concentration change (1~10 M) and oxidant pH change (pH = 1~5) by adding HCl. In addition, we tried to suggest a method to improve $NO_2$ absorption by conducting $NO_2$ reduction reaction with reducing agent (NaOH) concentration (40~60%). It was found that NO removal efficiency increased as both concentration of oxidant and flow rate of NO gas increased, and NO decreased more effectively as the pH of hydrochloric acid added to the oxidant was lower. The $NO_2$ adsorption was also better with increasing NaOH concentration, but the NO removal efficiency was ~20% lower than that of the selective NO reduction. Indeed, this experimental method is expected to be a new method that can be applied to the capture and removal of fine dust caused by air pollution because it is a method that can easily remove NO gas by a simple device without expensive giant equipment.

• Journal of the Korean Solar Energy Society
• /
• v.25 no.3
• /
• pp.37-45
• /
• 2005

Higher requirement of advanced building design code and the development of construction technique have resulted in more thermal and air tight buildings. This has caused the sick building syndrome in a indoor air quality has been relatively getting worse. A new concept with a solar fresh air heating and electrostatic precipitator or called as STCC(Solar Transpired Collector and Cyclone) has been proposed to solve this IAQ issue. This paper describes the assessment study of STCC system under different outdoor airflow rates. The experiment was carried out under real condition with 30CMM STCC system test facility. Incense smoke was used to study the particle concentration decay trends under outdoor airflow rates 0CMM, 10CMM, 20CMM, 30CMM, with applied voltages of 5kV and 15kV for collecting and discharging electrodes of an Electrostatic Precipitator. Result shows that the particle decay increases by increasing the outdoor airflow rates. The collection efficiency, dust cleaning effectiveness(P) and application area calculation result comparisons have also been studied. This factors could be used to estimate how a dust of indoor air quality(IAQ) and removed for a building space with a STCC system.