• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.2
• /
• pp.103-110
• /
• 2008

When there is uncertainty in topological rate of change, motility model and terrain condition, the performance severely degrades in MANET. The concept of transition of routing protocol on the fly according to the network parameters such as coverage, connectivity and mobility etc. may counterbalance the problems stated above. The mathematical modeling of feedback parameters has been derived, and the architecture for the multi-routing protocol system providing an adaptation from one routing protocol to another is also investigated. This paper is extensively devoted on the analysis of mobility, connectivity and their effects on the network and finally transition into another routing protocol according to them.

• Journal of Advanced Navigation Technology
• /
• v.23 no.2
• /
• pp.104-113
• /
• 2019

There are keen competitions among the air operators to recruit competent pilots, which could be adversely affect the safe operation of aircraft. This study is aimed to identify the correlation between the flight experience of the pilot of the air transport operator and competency on visual approach operation. About 2,400 sets of flight training data of several pilots of an air transport operator was analysed for this study. The analysis showed that most captains were able to make stabilized visual approach regardless of his/her flight experience of any type of aircraft, while the first officers were able to make a stabilized visual approach with more than 1,500 hours of flight experience for each rated type of aircraft. This should be considered during making policies for the supply and demand of pilots for the safe operation of air transport.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2007.11a
• /
• pp.311-314
• /
• 2007

Aerodynamic characteristics of an insect-type flapping wings were carried out to obtain the design parameters of Micro Hovering Air Vehicle. A pair of wing model was scaled up about 200 times and applied two pairs of 4-bar linkage mechanism to mimic the wing motion of a fruit fly(Drosophila). To verify the Weis-Fogh mechanism, a pair of wings revolved on the 'Delayed Rotation'. Lift and drag were measured in conditions of the Reynolds number based on wing tip velocity of about 1,200 and the maximum angle of attack of 40$40^{\circ}$. Inertia forces of a wing model were also measured by using a 99.98% vacuum chamber and subtracted on measured data in air. In the present study, high lift effect of Weis-Fogh mechanism was appeared in the middle of upstroke motion.

• Journal of Internet Computing and Services
• /
• v.7 no.5
• /
• pp.135-145
• /
• 2006

This paper presents a novel approach to real-time recognition of 3D environment and objects for intelligent robots. First. we establish the three fundamental principles that humans use for recognizing and interacting with the environment. These principles have led to the development of an integrated approach to real-time 3D recognition and modeling, as follows: 1) It starts with a rapid but approximate characterization of the geometric configuration of workspace by identifying global plane features. 2) It quickly recognizes known objects in environment and replaces them by their models in database based on 3D registration. 3) It models the geometric details on the fly adaptively to the need of the given task based on a multi-resolution octree representation. SIFT features with their 3D position data, referred to here as stereo-sis SIFT, are used extensively, together with point clouds, for fast extraction of global plane features, for fast recognition of objects, for fast registration of scenes, as well as for overcoming incomplete and noisy nature of point clouds. The experimental results show the feasibility of real-time and behavior-oriented 3D modeling of workspace for robotic manipulative tasks.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.16 no.6
• /
• pp.95-109
• /
• 2006

Elliptic Curve Cryptosystem (ECC) is suitable for resource-constrained devices such as smartcards, and sensor motes because of its short key size. This paper presents an efficient multi-scalar multiplication algorithm which is the main component of the verification procedure in Elliptic Curve Digital Signature Algorithm (ECDSA). The proposed algorithm can make use of a precomputed table of variable size and provides an optimal efficiency for that precomputed table. Furthermore, the given scalar is receded on-the-fly so that it can be merged with the main multiplication procedure. This can achieve more savings on memory than other receding algorithms. Through experiments, we have found that the optimal sizes of precomputed tables are 7 and 15 when uP+vQ is computed for u, v of 163 bits and 233 bits integers. This is shown by comparing the computation time taken by the proposed algorithm and other existing algorithms.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2006.05a
• /
• pp.15-18
• /
• 2006

The test result of mat concrete applying both hydration heat difference and insulation curing method on new construction of Cheongju university educational building are summarized as following. Both fresh concrete and compressive strength properties were satisfied In aimed value. Setting time of concrete incorporating 15% of fly ash(FA) retarded 1.2 hour than control concrete. Temperature history of mali concrete indicated that the highest temperature of center was exhibited at $126^{\circ}C$ after 51 hours while the highest temperature of upper section was $10.6^{\circ}C$ after 46 hours. Temperature Difference between center and surface was managed at less than $6^{\circ}C$ during whole curing period. In addition the temperature of upper section secured more than $3.3^{\circ}C$ while the temperature of outside was indicated at less than $-10^{\circ}C$. Maturity by parts of construction secured more than $30^{\circ}C$ DD higher than outside at 3 days. The more number of times, applying insulation curing method by double bubble sheets, increased, the higher economic effect was secured. Overall it was clear that applying both double bubble sheets and hydration heat difference method on this new construction can resist hydration heat crack, early frost demage and strength decrease. It also significantly contributed quality improvement of cold weather concreting

• Korean journal of applied entomology
• /
• v.60 no.2
• /
• pp.247-254
• /
• 2021

An outbreak of the onion thrips, Thrips tabaci, was observed in welsh onion cultured in greenhouse during winter season (Jan ~ Feb). The thrips was identified using DNA barcode. Weekly occurrence was around 240 ~ 700 adults per trap. Trap color gave significant influence on the capture efficiency with a preference on yellow compared to blue sticky trap. Subsequently, most (> 90%) onions exhibited a damage symptom induced by the thrips. This outbreak was observed only in a specific area but not in nearby greenhouses. This discontinuous occurrence pattern was further investigated by analyzing flight behavior through in- and out- door tests. About 1.5 mm-body length adults could jump up to about 5 cm and fly up to 2 m in altitude, which was the top of the greenhouse. This suggested their migrating potential to nearby (< 2 m) greenhouses. However, few were detected in the neighboring places probably due to physical hindrance with low temperatures between greenhouses. This is reasoned why the onion thrips forms a patch distribution among greenhouses during winter season.

• Proceedings of the Ginseng society Conference
• /
• 1998.06a
• /
• pp.270-280
• /
• 1998

Ginseng is one of the most widely used medicinal plants, particularly in East Asian countries. Certain fractions or purified ingredients of ginseng have been shown to exert inhibitory effects on growth of cancer cells in culture or on tumorigenesis in experimental animals. Moreover, a recent epidemiologic study reveals that ginseng intake is associated with a reduced risk for environmentally related cancers such as esophageal, gastric, colorectal, and pulmonary tumors. Heat treatment of Panax ginseng C. A. Meyer at the temperature higher than that applied to the conventional preparation of red ginseng yielded a mixture of saponins with potent antioxidative properties. Thus, the methanol extract of heat-processed ginseng (designated as'NGMe') attenuated lipid peroxidation in rat brain homogenates induced by ferric ion or ferric ion plus ascorbic acid. Furthermore, the extract protected against strand scission in f Xl 74 supercoiled DNA Induced by UV photolysis of H2O2 and was also capable of scavenging superoxide generated in vitro by xanthine/xanthine oxidate or in differentiated human promyelocytic leukemia (HL-60) cells by the tumor promoter,12-0-tetvade- canoylphorbol-13-acetate (TPA). Since tumor promotion is closely linked to oxidative stress, we have determined possible anti-tumor promotional effects of NGMe on two-stage mouse skin tumorigenesis. Topical application of NGMe onto shaven backs of female ICR mice 10 min prior to TPA significantly ameliorated skin papillomagenesi s initiated by 7,12-dimethylbenz (a) anthracene (DMBA).'Likewise, TPA-induced epidermal ornithine decarboxylase activity and elevation of tumor necrosis factor-a were suppressed signifies%fly by NGMe pretreatment. NGMe topically applied onto surface of hamster buccal pouch 10 min before each topical application of DMBA inhibited oral carcinogenesis by 76olo in terms of multiplicity. Taken together, these results suggest that processed Panax ginseng C. A. Meyer has potential cancer chemopreventive activities.

• Advances in concrete construction
• /
• v.8 no.3
• /
• pp.225-237
• /
• 2019

Although applying self-consolidating concrete (SCC) in many modern structures is an inevitable fact, the high consumption of cement in its mixing designs has led to increased production costs and adverse environmental effects. In order to find economically viable sources with environmentally friendly features, natural pozzolan pumice and blast furnace slag in 10-50% of replacement binary designs have been investigated for experiments on the properties of fresh concrete, mechanical properties, and durability. As a natural pozzolan, pumice does not require advanced equipment to prepare for consumption and only needs to be powdered. Pumice has been the main focus of this research because of simple preparation. Also to validate the results, in addition to the control specimens of each design, fly ash as a known powder has been evaluated. Moreover, ternary mixes of pumice and silica fume were investigated to enhance the obtained results of binary mixes. It was concluded that pumice and slag powders indicated favorable performance in the high percentage of replacement.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.1A
• /
• pp.155-163
• /
• 2008

On the construction site with trends of large scale, high rise and specialization, testing construction of high performance concrete, superior to conventional concrete, is continued to increase. For bridge construction, application of full staging method is gradually decreasing due to noise, dust, and prolonged construction period. Recently, precast construction, which is optimized to urban environment and shorter work period, gains popularity significantly. In bridge structure, overcrowding arrangement of bar is used to ensure its safety. For the manufacturing of overcrowding arrangement of bar, High flowing self-compacting concrete, which is superior to conventional concrete in flowability and compacting property, should be implemented. In this study, the application of blast-furnace slag and fly ash to binary and ternary blended system on the High flowing self-compacting concrete for bridge structure with overcrowding arrangement of bar is evaluated by flowability in accordance with the first class regulations of Japan Society of Civil Engineering (JSCE).