• Journal of Power Electronics
• /
• v.13 no.6
• /
• pp.1042-1050
• /
• 2013

This paper presents a study of maximum power point tracking (MPPT) for photovoltaic arrays with only one current sensor. Initially, a review of MPPT methods with only a current sensor is performed with extension for a variety of dc/dc converters. Furthermore, the same topology is developed to achieve better performance in the presence of sensor offset and environmental noise. The proposed method is robust, cost effective, and behaves well dynamically and in the steady state. After a theoretical analysis of presented approach, its validity and effectiveness are verified by simulation and experimental results.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 2004.07a
• /
• pp.474-474
• /
• 2004

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.101-102
• /
• 2006

Similar to Orthogonal Frequency Division Multiplexing (OFDM), a Single Carrier with Frequency Domain Equalization (SC-FDE) system is computationally efficient since equalization is performed on a block of data in the frequency domain. In coherent QAM schemes, the mean phase rotation error caused by the residual carrier frequency offset may lead to serious degradation. When the frequency equalizer is combined with the mean phase error tracking algorithm, its performance can be enhanced noticeably.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.2C
• /
• pp.170-183
• /
• 2002

This paper proposes an efficient frequency and symbol synchronization structure which could solve problems of the conventional methods to implement DVB-T receive modem which adopted OFDM transmission method. The main considerations of frequency synchronization algorithms are that the frequency tracking performance is not stable enough, and lots of symbols are required, especially when the decimal part of normalized frequency offset (which original frequency offset is divided by the subcarrier spacing) is around $\pm$0.5 to solve these problems, we propose an efficient frequency offset is divided by the subcarrier spacing) is around $\pm$0.5 by using the average of coarse synchronization over several symbol. Also, we suggest a new symbol synchronization structure which is easy to implement without performance degradation in multipath fading channel with only coarse symbol synchronization by making window offset to the range of guard interval in contrast to the conventional structure of dividing symbol synchronization in fine and coarse mode during synchronization. By extensive simulation, we have shown the superiority of the proposed schemes.

• Journal of Sensor Science and Technology
• /
• v.11 no.5
• /
• pp.255-262
• /
• 2002

Human retina is able to detect the edge of an object effectively. We designed a CMOS vision chip by modeling cells of the retina as hardwares involved in edge detection. There are several fluctuation factors which affect characteristics of MOSFETs during CMOS fabrication process and this effect appears as output offset of the vision chip which is composed of pixel arrays and readout circuits. The vision chip detecting edge information from input image is used for input stage of other systems. Therefore, the output offset of a vision chip determine the efficiency of the entire performance of a system. In order to eliminate the offset at the output stage, we designed a vision chip by using CDS(Correlated Double Sampling) technique. Using standard CMOS process, it is possible to integrate with other circuits. Having reliable output characteristics, this chip can be used at the input stage for many applications, like targe tracking system, fingerprint recognition system, human-friendly robot system and etc.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.7
• /
• pp.552-558
• /
• 2014

In this paper, we propose a side-peak cancellation technique of composite binary offset carrier (CBOC) signals for e-navigation. First, we divide a CBOC sub-carrier into several sub-carrier pulses, and then, observe that CBOC autocorrelation is the sum of multiple sub-correlation functions. Finally, we propose a novel correlation function with no side-peak and a sharp main-peak by combining the sub-correlation functions to improve the positioning accuracy. From numerical results, we confirm that the proposed correlation function with a sharp main-peak provides a better positioning performance than the conventional correlation functions in terms of the tracking error standard deviation.

• The Journal of the Korea Contents Association
• /
• v.9 no.7
• /
• pp.76-85
• /
• 2009

UWB signal with high resolution capability can be used to estimate ranging and positioning in wireless personal area network. The node works on its local clock and the frequency differences of nodes have serious affects on ranging algorithms estimating locations of mobile nodes. The low rate UWB, IEEE802.15.4a, describes asynchronous two way ranging methods such as TWR and SDS-TWR working without any additional network synchronization, but the algorithms can not eliminate the effect of clock frequency differences. Therefore, the mechanisms to characterize the crystal difference is essential in typical UWB PHY implementations. In high rate UWB, characterizing of crystal offset with tracking loop is not required. But, detection of the clock frequency offset between the local clock and remote clock can be performed if there is little noise induced jitter. In this paper, we complete related ranging equations of high rate UWB based on TWR with relative frequency offset, and analyze a residual error in the ideal equations. We also evaluate the performance of the relative frequency offset algorithm by simulation and analyze the ranging errors according to the number of TWR to compensate coarse clock resolution. The results show that the relative frequency offset compensation and many times of TWR enhance the performance to converge to a limited ranging errors even with coarse clock resolutions.

• Journal of Advanced Navigation Technology
• /
• v.12 no.4
• /
• pp.341-349
• /
• 2008

In this paper the Coefficient Tracking Synchronization Algorithm is proposed for the compensation and the suitability of the fast channel fluctuation OFDM in the WAVE(Wireless Access in Vehicular Environments) system. The in progress of standardization WAVE process, IEEE802.11p's physical layer is considered on the coexistence of fading and Frequency offset of OFDM channel to find the system performance ability and the comparing examination which is taken on the proposed method of Coefficient Tracking Synchronization Algorithm and the performance efficiency. Through the simulation result we also can see that the proposed system improves the channel estimation ability and offers an extra efficiency if compared to the existing method.

• Transactions of the Korean Society of Machine Tool Engineers
• /
• v.16 no.6
• /
• pp.71-78
• /
• 2007

There have been continuous efforts to automate welding processes. This automation process could be said to fall into two categories, weld seam tracking and weld quality evaluation. Recently, the attempts to achieve these two functions simultaneously are on the increase. For the study presented in this paper, a vision sensor is made, and using this, the 3 dimensional geometry of the bead is measured in real time. For the application in welding, which is the characteristic of nonlinear process, a fuzzy controller is designed. And with this, an adaptive control system is proposed which acquires the bead height and the coordinates of the point on the bead along the horizontal fillet joint, performs seam tracking with those data, and also at the same time, controls the bead geometry to a uniform shape. A communication system, which enables the communication with the industrial robot, is designed to control the bead geometry and to track the weld seam. Experiments are made with varied offset angles from the pre-taught weld path, and they showed the adaptive system works favorable results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.1A
• /
• pp.73-81
• /
• 2012

In this paper, we propose a high-speed synchronization method for Digital Radio Mondiale (DRM) receivers. In order to satisfy the high-speed synchronization requirement of DRM receivers, the proposed method eliminate the initial sampling frequency synchronization process in conventional synchronization methods. In the proposed method, sampling frequency tracking is performed after integer frequency synchronization and frame synchronization. Different correlation algorithms are applied to detect the first frame of the Orthogonal Frequency Division Multiplexing (OFDM) demodulation symbol with sampling frequency offset (SFO). A frame detection algorithm that is robust to SFO is selected based on the performance analysis and simulation. Simulation results show that the proposed method reduces the time spent for initial sampling frequency synchronization even if SFO is present in the DRM signal. In addition, it is verify that inter-cell differential correlation used between reference cells is roubst to the effect of initial SFO.