• The Journal of Korean Institute of Communications and Information Sciences
• /
• 제31권2A호
• /
• pp.103-109
• /
• 2006

OFDM system has a disadvantage of sensitiveness about the effect of the frequency offset caused by the discord of oscillators in transmitter and receiver. The frequency offset can be divided into integral part and decimal part. Although the frequency offset of integral part do not effect orthogonality between subcarriers, it makes the bit error probability become to 0.5 because of circular transient among transmitted data symbols. This paper proposes a new estimation scheme of the frequency offset of integral part by Maximum Likelihood (ML) demanding only one training symbol in multipath fading channel environment. This proposed scheme not only can reduce the number of training symbol but do not increase the complexity and it shows the better performance by simulation.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• 제14권2호
• /
• pp.111-116
• /
• 2001

Poly-Si TFT's(Polysilicon thin filmtransistors) have been actively studied due to their applications in active matrix liquid crystal displays and active pull-up devices of CMOS SRAM's. For such applications, the leakage current has to be in the range of sub-picoampere. However, poly-Si TFT's suffer from anomalous high leakage currents, which is attributed to the emission of the traps present at gain boundaries in the drain junction. The leakage current has been analyzed by the field emission via grain-boundary traps and thermionic field emission over potential barrier located at the grain boundary. We found that the models proposed before are not consistent with the experimental results at far as drain-offset poly-Si TFT's we fabricated concern. In this paper, leakage current of drain-offset poly-Si TFT's with different offset lengths was studied. A conduction model based on the thermionic emission of the tunneling electrons is developed to identify the leakage mechanism. It was found that the effective grain size of the drain-offset region is important factor in the leakage current. A good agreement between experimental and simulated results of the leakage current is obtained.

• Journal of Broadcast Engineering
• /
• 제16권1호
• /
• pp.85-95
• /
• 2011

In this paper, we propose an alternative carrier phase independent timing recovery method for VSB receivers. The Gardner algorithm may not estimate a timing offset in VSB systems when the residual carrier phase offset is contained in the signal. We use the conjugate multiplication of received signals for cancelling out the carrier phase offset. Then Gardner algorithm is employed for extracting the spectral line. The proposed method generates a consistent timing error even in the presence of the carrier phase offset.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• 제6권3호
• /
• pp.71-76
• /
• 2007

The fatalities of pedestrian account for about 40.0% of all fatalities in Korea 2005. Vehicle-Pedestrian accident generates trajectory of pedestrian. In pedestrian involved accident, the most important data to inspect accident is throw distance of pedestrian. The throw distance of pedestrian can be influenced by many variables. The variables that influence trajectory of pedestrian can be classified into vehicular factors, pedestrian factors, and road factors. Vehicular factors are the frontal shape of vehicle, impact speed of vehicle, the offset of impact point. Many studies have been done about the relation between impact speed and throw distance of pedestrian. But the influence of the offset of impact point was neglected. The influence of the offset of impact point was analyzed by Working Model, and the trajectory of pedestrian, dynamic characteristics of multi-body were analyzed by PC-CRASH, a kinetic analysis program for a traffic accident. Based on the results, the increase of offset reduced the throw distance of pedestrian. However box type vehicle just like bus, the offset of impact point did not influence the throw distance of pedestrian considerably.

• Proceedings of the KIEE Conference
• /
• 대한전기학회 1996년도 하계학술대회 논문집 C
• /
• pp.1582-1584
• /
• 1996

The polycrystalline silicon thin film transistors (poly-Si TFT) are the most promising candidate for active matrix liquid crystal displays (AMLCD) for their high mobilities and current driving capabilities. The leakage current of the poly-Si TFT is much higher than that of the amorphous-Si TFT, thus larger storage capacitance is required which reduces the aperture ratio fur the pixel. The offset gated poly-Si TFTs have been widely investigated in order to reduce the leakage current. The conventional method for fabricating an offset device may require additional mask and photolithography process step, which is inapplicable for self-aligned source/drain ion implantation and rather cost inefficient. Due to mis-alignment, offset devices show asymmetric transfer characteristics as the source and drain are switched. We have proposed and fabricated a new offset poly-Si TFT by applying photoresist reflow process. The new method does not require an additional mask step and self-aligned ion implantation is applied, thus precise offset length can be defined and source/drain symmetric transfer characteristics are achieved.

• Journal of Advanced Navigation Technology
• /
• 제9권2호
• /
• pp.140-146
• /
• 2005

In this paper, we proposed the frequency offset compensation algorithm and tracking algorithm which could improve the accumulated phase error for HDR-WPAN system. The proposed frequency offset compensation technique estimated each sample phase error by autocorrelation characteristics of CAZAC sequence, estimated phase error multiple each sample in a symbol, and finally compensated for the frequency offset. After frequency offset compensation using two steps, coarse and fine frequency offset, tracking algorithm have to use to compensate for the accumulated phase error. Because there is no pilot symbol in payload, more phase rotation occurred in received signal constellations due to the accumulated phase error as the payload length increase. Tracking algorithm compensates for a cumulative phase error ${\theta}$ between payload data.

• Special Issue of the Society of Naval Architects of Korea
• /
• 대한조선학회 2008년도 특별논문집
• /
• pp.1-9
• /
• 2008

This report contains the results of structural analysis for the verification of the optimum offset range on the top of T-Bar with stiffener and BKT using at DSME Offset range as $6.0{\sim}10.0mm$ based on the 3-D FE analysis and experimental results of angie type stiffener as described in Annex 1 has been used as yard standard over ten (10) years under all Classification approval. Recently, Owner and Class have requested the confirmation for the misalignment based on the Yard's Standard so that a couple of locations for LNGC and LPGC has been investigated the structural strength by FE method using the offset ranges from 0.0 to 18.0 mm.

• Journal of the Korean Graphic Arts Communication Society
• /
• 제28권2호
• /
• pp.101-116
• /
• 2010

Last printing market is changing to high-quality color prints for web offset printing. But, color image reproduction based on the relative sheet-ped printing compared to the way, web offset printing are falling. Moreover, it's difficult to maintain the quality of the web offset print. The reason is the worker's decision to rely on. Therefore, the quality of prints was no difference in uniformity and objectivity. We have thought the reason, that the physical properties of inks such as fluidity, viscosity and tack. In addition, varies depending on the physical properties of paper, such as thickness, smoothness, roughness and porosity. Therefore, we studied the properties of ink and paper on the relations between the properties used IGT printability tester. This study of domestic web offset printing inks and papers on the relationship between physical properties and printability were studied. So, to improve printability will be used as the basis resources for web offset printing.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• 제58권2호
• /
• pp.285-291
• /
• 2009

In this paper, comparative analysis of offset voltage PWM method and $V_{max}-V_{mid}$ PWM method for three-phase matrix converter is addressed by using a simple analytical and graphical method. Offset voltage PWM method calculates PWM patterns in terms of offset voltage and variable slope of carrier, and it simplifies matrix converter modulation algorithm significantly. $V_{max}-V_{mid}$ PWM method generates patterns by using two phases and maintaining a remaining phase to base phase, and it is implemented in the industrial products. The most important performance criterion of modulation method is a magnitude of current ripples and it is analytically modelled. The graphical illustration of theses complex multivariable functions make per-carrier cycle and per fundamental cycle behavior of two PWM methods understood. Two modulation methods are analysed with the analytical formulas and graphics, and the analysis shows offset voltage PWM method is superior to $V_{max}-V_{mid}$ PWM method with respect to input current ripples and output voltage ripples.

• Journal of electromagnetic engineering and science
• /
• 제4권2호
• /
• pp.72-78
• /
• 2004

In this paper, we evaluate the performance of the digital modulation schemes described in the APCO Project 25 FDMA specifications which can be used for applying the ultra-narrowband technology to the current domestic simple two-way radio systems, and discuss difficulties in the DSP implementation of the systems. We analyze the effect on the systems' BER performance of receiver non-matched filter and frequency-offset between the transmitter and receiver oscillators. And we present a frequency offset compensation method for improving the system performance. The results of performance analysis showed that the CQPSK of APCO Project 25 using non-matched filter degraded the BER by 0.5～1.0 ㏈ comparing with PI/4 DQPSK using matched filter. In the event of 2 % frequency offset, about 1 ㏈ performance loss was produced at the BER of $$10^{-3}TEX>. With the frequency-offset compensation method implemented in the systems using phase recovery scheme of PSK synchronization detection, the performance degradation of about 1.0 ㏈ was occurred at the BER of $$10^{-3}TEX> for 10 % of frequency offset. The proposed method can be used for the improvement of system performance.