• Journal of IKEEE
• /
• v.24 no.3
• /
• pp.853-858
• /
• 2020

This paper proposes a 2-ch DC-DC converter for OLED display with immunity against RF noise inserted from communication device. For RF signal immunity, an input voltage variation reduction circuit that attenuates as much as the input voltage variation is embedded. The boost converter for positive voltage V_POS operates in SPWM-PWM dual mode and has a dead time controller to increase power efficiency. The inverting charge pump for negative voltage V_NEG is a 2-phase scheme and operates in PFM using VCO to reduce output ripple voltage. Simulation results using 0.18 ㎛ BCDMOS process show that the overshoot and undershoot of the output voltage decrease from 10 mV to 2 mV and 5 mV, respectively. The 2-ch DC-DC converter has power efficiency of 39%~93%, and the power efficiency of the boost converter is up to 3% higher than the conventional method without dead time controller.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2007.05a
• /
• pp.33-38
• /
• 2007

This paper presents a experimental evidence of the generation of the earth potential and communication line noise from the electric railway. There is a critical measurement err in case of measuring the electrical power induced noise voltage and degree of cable balance in the field of earth potential generated. As a results, it has been found that the conventional cable has more noise immunity than shielded cable near the railway where the earth current flows through the sheath layer.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.9 no.3
• /
• pp.148-152
• /
• 2009

Recent CMOS technology scaling has seriously eroded the bit-line noise immunity of register files due to the consequent increase in active bit-line leakage currents. To restore its noise immunity while maintaining performance, we propose and evaluate a $256{\times}40$-bit register file incorporating dual-$V_t$ bit-lines with a boosted gate overdrive voltage in 65 nm bulk CMOS technology. Simulation results show that the proposed bootsrapping scheme lowers leakage current by a factor of 450 without its performance penalty.

• International Journal of Computer Science & Network Security
• /
• v.23 no.3
• /
• pp.139-143
• /
• 2023

In this article we propose using mathematical models of signals in wireless communication systems with autocorrelation reception of modulated ultra-wideband signals. For the transmission of information content, the method of positional-time coding is used, in which each information bit is encoded by hundreds of ultrashort pulses that arrive within a certain sequence. Comparative analysis has shown that the best noise immunity of the systems considered in this paper is the communication system, which uses the time separation of the reference and information signals.

• ETRI Journal
• /
• v.16 no.1
• /
• pp.35-43
• /
• 1994

In this paper, the robustness of the artificial neural networks to noise is demonstrated with a multilayer perceptron, and the reason of robustness is due to the statistical orthogonality among hidden nodes and its hierarchical information extraction capability. Also, the misclassification probability of a well-trained multilayer perceptron is derived without any linear approximations when the inputs are contaminated with random noises. The misclassification probability for a noisy pattern is shown to be a function of the input pattern, noise variances, the weight matrices, and the nonlinear transformations. The result is verified with a handwritten digit recognition problem, which shows better result than that using linear approximations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.7
• /
• pp.805-814
• /
• 2012

Intermittent or periodic signals with undulating amplitudes of mobile devices cause interference noise at audible frequency to the sound system which is installed nearby. In this regard, it is recently issued that the intermittently transmissions of LTE mobile phones cause the interference noises with sound systems, similar to that of GSM mobile phones. For retaining the immunity to noises, a national regulation KN20 suggests a 1 kHz AM 80 % and a CDMA modulation signal as reference signals for immunity test of sound and television broadcast receiver. In this paper, the effects of interference noises of AM and CDMA are compared with those of GSM and LTE, and the improvement of reference signal for national immunity test of sound systems is suggested. It is recommended to delete the CDMA modulation signal from reference signals for immunity test because it hardly cause interference noise with sound systems. On the other hand, it is desirable to select the modulation signal of LTE instead of CDMA as a reference signal for immunity test of sound system and television broadcast receiver because many people use the LTE service and it is analysed that the LTE signal causes considerable interference noises.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.5
• /
• pp.74-82
• /
• 2015

As the complexity of an electronic device and the reduction of its operating voltage is progressing, susceptibility test of the chip and module for internal or external noises is essential. Although the immunity compliance of the chip was served with IEC 62132-4 Direct Power Injection method as an industry standard, in fact, EM immunity of the chip is influenced by their Power Domain Network (PDN). This paper evaluates the EM noise tolerance of a PLL and compares their noise transfer characteristics to the PLL on various PCB boards. To make differences of the PDNs of PCBs, various PCBs with or without LDO and with several types of capacitors are tested. For evaluation of discrepancies between EM characteristics of an IC only and the IC on real boards, the analysis of the noise transfer characteristics according to the PDNs shows that it gives important information for the design having robust EM characteristics. DPI measurement results show that greatly improved immunity of the PLL in the low-frequency region according to using the LDO and a frequency change of the PLL according to the DPI could also check with TEM cell measurement spectrum.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.05a
• /
• pp.425-431
• /
• 1999

We develope plasma monitoring system which detect plasma signals and store them for Laser welding quality evaluation and analysis using photo detector. The most fundamental and important aspects in such a system are signal restoration fidelity, noise immunity and noise cancelation capability. In this paper, we propose implementation method using distribute processing structure and hybrid digital communication for high noise cancelation capability, immunity and signal fidelity which are poorly presented in other researches. Lab experimental results and welding experimental results show a effectiveness of proposed method and plasma data is stored with 256 kbps without any communication error. we are implementing various welding defect recognition algorithm in this system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.2
• /
• pp.234-241
• /
• 2000

During the EFT immunity test, the fast transient voltage is injected to the power or signal line. The radiated noise from these lines influences the near-by EUT, and consequently, the reliability of the test result can be jeopardized. The measured data of the field strength and wave shape of the noise were compared with the result of the mathematical analysis using transmission line model. When the tests were performed by the conditions the same as stated in IEC 61000-4-4, the results showed that the magnitude of the radiated electric field strength was about 2.4KV/m, and it can cause severe interference to the intended operation of EUT.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.10
• /
• pp.181-189
• /
• 2007

This paper presents a experimental evidence of the generation of the earth potential and communication line noise from the electric railway. There is a critical measurement err in case of measuring the electrical power induced noise voltage and degree of cable balance in the field of earth potential generated. As a results, it has been found that the conventional cable has more noise immunity than shielded cable near the railway where the earth current flows through the sheath layer.