• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.4
• /
• pp.696-706
• /
• 2007

Multiprocessor system on chip (MPSoC) platform has set a new innovative trend for the System on Chip (SoC) design. With the rapidly approaching billion transistors era, some of the main problem in deep sub-micron technologies characterized by gate lengths in the range of 60-90 nm will arise from non scalable wire delays, errors in signal integrity and un-synchronized communication. These problems may be addressed by the use of Network on Chip (NOC) architecture for future SoC. Most future SoCs will use network architecture and a packet based communication protocol for on chip communication. This paper presents an adaptive wormhole routing with proactive turn prohibition to guarantee deadlock free on chip communication for NOC architecture. It shows a simple muting architecture with five full-duplex, flit-wide communication channels. We provide simulation results for message latency and compare results with those of dimension ordered techniques operating at the same link rates.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.7
• /
• pp.1873-1893
• /
• 2023

The development of lightweight, low energy and small-sized sensors incorporated with the wireless networks has brought about a phenomenal growth of Wireless Sensor Networks (WSNs) in its different fields of applications. Moreover, the routing of data is crucial in a wide number of critical applications that includes ecosystem monitoring, military and disaster management. However, the time-delay, energy imbalance and minimized network lifetime are considered as the key problems faced during the process of data transmission. Furthermore, only when the functionality of cluster head selection is available in WSNs, it is possible to improve energy and network lifetime. Besides that, the task of cluster head selection is regarded as an NP-hard optimization problem that can be effectively modelled using hybrid metaheuristic approaches. Due to this reason, an Improved Coyote Optimization Algorithm-based Clustering Technique (ICOACT) is proposed for extending the lifetime for making efficient choices for cluster heads while maintaining a consistent balance between exploitation and exploration. The issue of premature convergence and its tendency of being trapped into the local optima in the Improved Coyote Optimization Algorithm (ICOA) through the selection of center solution is used for replacing the best solution in the search space during the clustering functionality. The simulation results of the proposed ICOACT confirmed its efficiency by increasing the number of alive nodes, the total number of clusters formed with the least amount of end-to-end delay and mean packet loss rate.

• Journal of KIISE
• /
• v.43 no.11
• /
• pp.1233-1244
• /
• 2016

In the IoT network environments for LLNs(Low power and Lossy networks), IPv6 Routing Protocol for Low Power and Lossy networks(RPL) has been proposed by IETF(Internet Engineering Task Force). The goal of RPL is to create a directed acyclic graph, without loops. As recommended by the IETF standard, RPL route recovery mechanisms in the event of a failure of a node should avoid loop, loop detection, DIO Poisoning. In this process, route recovery time and control message might be increased in the sub-tree because of the repeated route search. In this paper, we suggested RPL route recovery method to solve the routing overhead problem in the sub-tree during a loss of a link in the RPL routing protocol based on IoT wireless networks. The proposed method improved local repair process by utilizing a route that could not be selected as the preferred existing parents. This reduced the traffic control packet, especially in the disconnected node's sub tree. It also resulted in a quick recovery. Our simulation results showed that the proposed RPL local repair reduced the recovery time and the traffic of control packets of RPL. According to our experiment results, the proposed method improved the recovery performance of RPL.

• Journal of the Korea Society of Computer and Information
• /
• v.18 no.1
• /
• pp.63-71
• /
• 2013

In the Cluster-Based Routing Protocol (CBRP) a cluster header in each cluster should be elected. The cluster headers consume energy much more than other member nodes do because they manage and operate all of mobile nodes in their cluster. The traditional CBRP elects a cluster header without considering the remaining electric energy of each node. So, there exist problems that the cluster header has short average lifetime, and a new cluster header should be elected again frequently. In this paper, we propose the improved protocol which prolongs the lifetime of the cluster header, decreases the problem of re-electing the cluster header and enhances the stability of the path. In order to achieve this, when a cluster header is elected in a cluster, the remaining electric energies of all the nodes are compared with one another, and the node with the highest energy is elected as the cluster header. Also, the node with the second highest energy is elected as the second header. If the elected cluster header is unable to perform the role of the cluster header any more because the remaining energy level goes low, it sends a beacon message to neighbor member nodes, then the second header will serve as the cluster header.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.1
• /
• pp.703-712
• /
• 2015

This paper proposes the UIGRP, which can tackle the problem of the network disconnection and packet transmission delay caused by turning vehicles frequently in an urban intersection. The UIGRP was designed as follows. First, it calculates the direction of vehicles using the moving direction of vehicles and the location of a destination. Second, it makes the RSU measure the density of an urban intersection. Third, the TGF Algorithm in the UIGRP decides the data transmission paths by setting as an intermediate node, not only the vehicle that is moving in the direction where a destination node is located, but also the node that has the highest density. The TGF algorithm using a moving direction and density minimizes or removes the occurrence of local maximum problems that the existing Greedy Forwarding algorithm has. Therefore, the simulation result shows that UIGRP decreases the occurrence of local maximum problems by 3 and 1 times, and the packet transmission time by 6.12 and 2.04(ms), and increases the success rate of packet transmission by 15 and 3%, compared to the existing GPSR and GPUR.

• The Journal of the Korea Contents Association
• /
• v.9 no.8
• /
• pp.49-56
• /
• 2009

In this paper, we propose a method of energy level, node degree and selection information based CDS(Connected Dominating Set) construction algorithm for more efficient routing in ad-hoc wireless networks. Constructing CDS in ad-hoc wireless network, it is necessary to make more efficient algorithm that is faster, more simple and has low power consumption. A CDS must be minimized because nodes in the CDS consume more energy in order to handle various bypass traffics than nodes outside the set. It is better not to reconstruct CDS after constructing the most efficient CDS. To overcome this problem, we proposed the CDS construction algorithms based on EL+ND+Sel method. We compared and estimated the performance in each situation of EL + ND and EL + ND + Sel.

• Journal of KIISE:Information Networking
• /
• v.31 no.2
• /
• pp.123-130
• /
• 2004

Routing and wavelength assignment(RWA) problem is an important issue in optical transport networks based on wavelength division multiplexing(WDM) technique. It is typically solved using a combination of linear programming and graph coloring, or path selection based graph algorithms. Such methods are either complex or make extensive use of heuristics. In this paper we propose a novel and efficient approach which basically obtains the maximum edge disjoint paths (EDPs) for each source-destination demand pair. And those EDPs obtained are stored in Lookup Table and used for the update of weight matrix. Routes are determined in order by the weight matrix for the demand set. The comprehensive computer simulation shows that the Proposed algorithm uses similar or fewer wavelengths with significantly less execution time than bounded greedy approach (BGA) for EDP which is currently known to be effective in practice.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.11A
• /
• pp.979-986
• /
• 2005

In optical networks, traffic demands often demonstrate periodic nature for which time-overlapping property can be utilized in routing and wavelength assignment (RWA). A RWA problem for scheduled lightpath demands (SLDs) has been solved by combinatorial optimal solution (COS) and graph coloring, or heuristic sequential RWA (sRWA). Such methods are very complex and incurs large computational overhead. In this paper, we propose an efficient RWA algorithm to utilize the time disjoint property as well as space disjoint property through fast grouping of SLDs. The computer simulation shows that our proposed algorithm indeed achieves up to $54\%$ faster computation with similar number of wavelengths than the existing heuristic sRWA algorithm.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.6
• /
• pp.1096-1101
• /
• 2004

By a tremendous expansion of Internet users, there's a number effects that cause the phenomenon of bottlenecked switching packets from routers. In order to tear down this problem, distributed system is applicable to almost every highly performed router systems. The main processor of distributed system, which manages routing table, commands IPC to delivering the forwarding table line processor that eases functionalities of the router. This makes the system having wired-speed forwarding function based on the hardware so that the performance of the network can be enhanced. Therefore, IPC, which assign a part of router, is necessary to exchange data smoothly and the constitution of IPC using Ethernet is widely adapted as a method for saving investment. In this paper, R-IPC mechanism improve the packet-processing rate over 10% through changed from defect of conventional Ethernet IPC, that is, 2 layer processing to TCP/IP or UDP/ IP into 1 layer processing for efficient packet forwarding.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8B
• /
• pp.657-667
• /
• 2012

In the MPR selection algorithm of Optimized Link State Routing (OLSR), each node selects own MPRs independently, so most of nodes are selected to MPR at least once. To cope with this problem, the MPR candidate selection algorithm was proposed. The MPR candidate selection algorithm can reduce the number of MPRs, but the efficiencies of route and connectivity decline due to decreased number of MPRs. So, in this paper, we propose the Significant Multi-Point Relay (S-MPR) selection algorithm which can enhance the performance of ad hoc network by improving the MPR selection algorithm of OLSR. In proposed S-MPR selection algorithm, each node selects the most important node to S-MPR to guarantee the connectivity then selects remaining MPRs in MPR candidates. So proposed S-MPR selection algorithm can reduce the overhead of many MPRs without decline of routing performance. To show the performance gain of proposed S-MPR selection algorithm, we simulate the proposed S-MPR selection algorithm by using OPNET.