• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05c
• /
• pp.83-87
• /
• 2002

Plasma enhanced chemical vapor deposited (PECVD) silicon nitride ($SiN_X$) is widely used as a gate dielectric material for the hydrogenated amorphous silicon(a-Si:H) thin film transistors (TFT's). We investigated $SiN_X$ films were deposited PECVD at low temperature ($300^{\circ}C$). The reaction gases were used pure nitrogen and a helium diluted of silane gas(20% $SiH_4$, 80% He). Experimental investigations were carried out with the variation of $N_2/SiH_4$ flow ratios from 3 to 50 and the rf power of 200 W. This article presents the $SiN_X$ gate dielectric studies in terms of deposition rate, hydrogen content, etch rate and C-V, leakage current density characteristics for the gate dielectric layer of thin film transistor applications. Electrical properties were analyzed through high frequency (1MHz) C-V and current-voltage (I-V) measurements. The thickness and the refractive index on the films were measured by ellipsometry and chemical bonds were determined by using an FT-IR equipment.

• Applied Chemistry for Engineering
• /
• v.7 no.3
• /
• pp.473-480
• /
• 1996

Synthesis of n-perfluorooctanesulfonyl fluoride(n-PFOSF), which is valuable precursor perfluoro-chemicals, was studied by electrochemical fluorination(ECF). Of prime concern was to investigate the cyclic voltamograms of Ni electrode in anhydrous hydrogen fluoride(AHF) with and without the reactants and to measure fluorine evolution potential. In a batch cell, chronoampherometric electrolysis and various chemical analysis such as GC, GC/MS and IR were used to understand the amphere change of electrode and the reaction paths. Fluorine equilibrium potential was found to be about 2.8V(vs. $Cu/CuF_2$) from the cyclic voltammograms and decay curves of anode potential in AHF. In batch processes, the ECF proceeded in two distinguished steps. The first step proceeded electrochemically and the second one chemically. Under 7V(vs. $Cu/CuF_2$), amount of crude products was proportional to the applied anode potential. Above 7V(vs. $Cu/CuF_2$), it had a hundred percentage with weight ratio of reactants and productivity of PFOSF was almost constant.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.1
• /
• pp.7-13
• /
• 2014

A cationic ester type surfactant, namely N-2-hydroxy-3-(2-hydroxyacetoxy) proply-N,N-dimethyldodecylaminium chloride(HPDA) was synthesized and confirmed by FT-IR and $^1H$-NMR spectroscopy. Surface tensions on the diluted aqueous solutions of the synthetic compounds were measured and evaluated critical micelle concentration. Surface tension was 33~34 dyne/cm in the range of $10^{-3}{\sim}10^{-2}mol/L$ and critical micelle concentration(c.m.c) value was $8.5{\times}10^{-3}mol/L$ by surface tension method. Emulsifying properties of the synthetic surfactant(HPDA) and Sodium lauryl sulfate (SLS), tetradecyl trimethyl ammonium bromide (TTAB) was tested. As a results, synthetic glycolic acid ester type compounds(HPDA) has been confirmed as a good emulsifier. The foaming power and stability of synthesized ester type surfactant was measured by Ross-Miles method.

• Journal of the Korean Chemical Society
• /
• v.55 no.4
• /
• pp.590-593
• /
• 2011

A novel organotin(IV) complex has been prepared from $Bu_2SnCl_2$ and the N, O and S donor ligand, 5-(p-dimethylaminobenzylidene) rodanine (HL). The ligand is deprotonated in the presence of a base and the complex with the general formula $SnBuCl_2L$ is formed. This complex was fully characterized by IR, $^1H$ NMR and $^{119}Sn$ NMR and elemental analysis. Spectroscopic data indicate the ligand is coordinated through the oxygen atom to the tin and the coordination number of four is supported by $^{119}Sn$ NMR data in solution.

• Proceedings of the Korea Contents Association Conference
• /
• 2008.05a
• /
• pp.24-27
• /
• 2008

As shown in Wikipedia, tagging or cross-linking through major key-words improves the readability of documents. Recently, the Semantic Web rises the importance of social tagging as a key feature of the Web 2.0 and Tag Cloud has emerged as its crucial phenotype. In this paper we provides an efficient method of automated keyword tagging based on controlled term collection, where the computational complexity of O(mN) - if pattern matching algorithm is used - can be reduced to O(mlogN) - if Information Retrieval is adopted - while m is the length of target document and N is the total number of candidate terms to be tagged. The result shows that IR-based tagging speeds up 5.6 times compared with fast pattern matching algorithm.

• Fire Science and Engineering
• /
• v.24 no.1
• /
• pp.116-121
• /
• 2010

The present study has been performed to investigate the ignition characteristics of a n-dodecane fuel droplet on the hot surface. Simplified bench scale test setup was built to examine the effect of air flow on the ignition temperature of fuel droplet. IR pyrometric sensor was used to measure the surface temperature, the measured temperature using IR pyrometer was directly compared with k-type thermocouple. The ignition of n-dodecane fuel droplet was divided into two stage - cool flame and hot flame - with the air flow rate except the case of air flow rate 3.0 lpm. The ignition temperature and probability was greatly affected by the air flow rate and the MHSIT of the present study was about $300^{\circ}C$ for air flow rate of 0.5 lpm.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.9
• /
• pp.2057-2060
• /
• 2009

Conducting poly-N-isopropylacrylamide-N-vinyl carbazole (PNI-nvc) copolymers were synthesized via in situ deposition technique by dissolving different weight percentages of N-vinyl carbazole (10, 20, 30, and 40%). The structural morphology and FT-IR studies support the interaction between PNI and N-vinyl carbazole. The temperaturedependent DC conductivity of PNI-nvc was studied within the range of 300 ${\leq}\;T\;{\leq}$ 500 K, presenting evidence for the transport properties of PNI-nvc. The DC conductivity of PNI-nvc copolymers signifies the future development of new nanocopolymers that acts as a multifunctional material.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.12
• /
• pp.2235-2240
• /
• 2007

3-Aryloxy methyl-4-(N-pyrazin-2'yl carboxamido)-5-mercapto-1,2,4-triazoles (3a1-a14) were prepared starting from potassium dithio carbazinates (2a1-a14). These triazoles were then employed in the synthesis of 3-aryloxy methyl-4-(N-pyrazin-2'yl carboxamido)-5-hydrazino-1,2,4-triazoles (4a1-a14). All the newly synthesized compounds were characterized by analytical, IR, NMR spectral studies. The compounds were screened for their antibacterial, antifungal, anti-inflammatory and analgesic properties. Most of the compounds have shown significant antifungal activity while few have shown excellent anti-inflammatory and analgesic activity. An attempt is made to study the structure activity relationship (SAR).

• Journal of the Korean Chemical Society
• /
• v.29 no.3
• /
• pp.247-251
• /
• 1985

Dichloro cobalt(III) complex of a flexible tetradentate ligand of ethylenediamine-N,N'-di-S-${\alpha}$-propionic acid (eddp) has been prepared via the air-oxidation technique. Only ${\Delta}$-cis isomer has been yielded showing high stereoselectivity of the eddp ligand. Elemental analysis, ir, nmr and electronic absorption spectra have been used to characterize the complex and the absolute configuration of the complex is assigned by means of the nmr spectroscopy.

• YAKHAK HOEJI
• /
• v.49 no.2
• /
• pp.162-167
• /
• 2005

Synthetic method for the selective N-monoalkylation of anilines using alkyl halides and triethylamine under room temperature was described. The corresponding N-alkyl anilines were obtained in good yields with minor quantities of dialkylated products. Anilines 2a-m and 3a-m were identified using NMR and IR. A series of 2a-m and 3a-m has been synthesized from aniline, toluidines, ethylanilines, aminoacetophenones, phenetidines. Formation of anilines was undertaken with dropping of alkylhalides at room temperature in methanol (or ethanol) for 3 hours~5 days. Selectivity on the monoalkylation was relatively high. Synthetic ratio of monoalkylated and dialkylated product was 94 : 6 in case of maximum monoalkylation.