• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.2
• /
• pp.702-721
• /
• 2012

In the DVB-T2 system with a multiple-input single-output (MISO) transmission mode, Alamouti coded orthogonal frequency division multiplexing (OFDM) signals are transmitted simultaneously from two spatially separated transmitters in a single frequency network (SFN). In such systems, each transmit-receive link may have a distinct carrier frequency offset (CFO) due to the Doppler shift and/or frequency mismatch between the local oscillators. Thus, the received signal experiences dual CFOs. This not only causes dual phase errors in desired data but also introduces inter-carrier interference (ICI), which cannot be removed completely by simply performing a CFO compensation. To overcome this problem, this paper proposes an iterative detection with dual phase errors compensation technique. In addition, we propose a successive-iterative ICI cancellation technique. This technique successively eliminates ICI in the initial iteration by exploiting pre-detected data pairs. Then, in subsequent iterations, it performs a fine interference cancellation using a priori information, iteratively fed back from the channel decoder. In contrast to previous works, the proposed techniques do not require estimates of dual CFOs. Their performances are evaluated via a full DVB-T2 simulator. Simulation results show that the DVB-T2 receiver equipped with the proposed dual phase errors compensation and the successive-iterative ICI cancellation techniques achieves almost the same performance as ideal dual CFOs-free systems, even for large dual CFOs.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.05a
• /
• pp.1443-1448
• /
• 2006

The reduction of the vehicle interior noise has been the main interest of NVH engineers. The driver's perception on the vehicle noise is affected largely by psychoacoustic characteristic of the noise as well as the SPL. In particular, the HVAC sound among the vehicle interior noise has been reflected sensitively in the side of psychology. Even though the HVAC noise is not louder than overall noise level, it clearly affects subjective perception in the way of making a diver become nervous or annoyed. Therefore, these days a vehicle engineer takes aim at developing sound quality as well as reduction of noise. In this paper, we acquired noises in the HVAC from many vehicles. Through the objective and subjective sound quality evaluation with acquiring noises caused by the vehicle HVAC system, the simple and multiple regression models were obtained for the subjective evaluation 'Pleasant' using the sound quality metrics. The regression procedure also allows you to produce diagnostic statistics to evaluate the regression estimates including appropriation and accuracy. Furthermore, the neural network model were obtained using three inputs(loudness, sharpness and roughness) of the sound quality metrics and one output(subjective 'Pleasant'). And then the models were compared with correlations between sound quality index outputs and hearing test results for 'Pleasant'. As a result of application of the sound quality index, the neural network was verified with the largest correlation of the sound quality index.

• Journal of Korean Vacuum Science & Technology
• /
• v.4 no.2
• /
• pp.47-49
• /
• 2000

We report on the fabrication and characterization of InGaN/GaN multiple quantum well light emitting diode (LED) with a highly transparent Pt ohmic contact as a current spreading layer. The value of light transmittance of a Pt thin film with a thickness of 8 m on p-GaN was measured to be 85% at 450nm. The peak wavelength and the full-width at half-maximum (FWHM) of the emission spectrum of the LED at 20 mA were 453 m and 23 m, respectively. Pt-contacted LEDs show good electrical properties and high light-output efficiency compared to Ni/Au-contacted ones. These results suggest that a Pt thin film can be used as an effective current spreading layer with high light-transparency.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.5
• /
• pp.1938-1962
• /
• 2015

Security of information during transmission is a major issue in this modern era. All of the communicating bodies want confidentiality, integrity, and authenticity of their secret information. Researchers have presented various schemes to cope with these Internet security issues. In this context, both steganography and cryptography can be used effectively. However, major limitation in the existing steganographic methods is the low-quality output stego images, which consequently results in the lack of security. To cope with these issues, we present an efficient method for RGB images based on gray level modification (GLM) and multi-level encryption (MLE). The secret key and secret data is encrypted using MLE algorithm before mapping it to the grey-levels of the cover image. Then, a transposition function is applied on cover image prior to data hiding. The usage of transpose, secret key, MLE, and GLM adds four different levels of security to the proposed algorithm, making it very difficult for a malicious user to extract the original secret information. The proposed method is evaluated both quantitatively and qualitatively. The experimental results, compared with several state-of-the-art algorithms, show that the proposed algorithm not only enhances the quality of stego images but also provides multiple levels of security, which can significantly misguide image steganalysis and makes the attack on this algorithm more challenging.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.3A
• /
• pp.240-247
• /
• 2004

In order to transmit data at high speed in the wireless environment, OFDM is selected as the transmission method of various high-speed wireless communication system since it has the advantage to deal easily the serious selective frequency fading channel by the multiple path. We evaluate STBC-OFDM and linear STBC-OFDM combining with a class of recently proposed linear scalable space-time block codes and OFDM in MIMO channel environments, and demonstrate the performance for spatial multiplexing and diversity gain. The codes are able to use jointly transmit diversity in combination with spatial multiplexing, and achieve spatial and temporal diversity. Frequency diversity of frequency selective channels can be utilized by combining the linear STBC and OFDM. Simulation results are shown to demonstrate the better performance of proposed approach in comparison with STBC-OFDM.

• Journal of Chest Surgery
• /
• v.25 no.1
• /
• pp.49-56
• /
• 1992

Total 20 cases of reoperation for mitral vavular disease, which had been performed during the period from May 1983 till October 1991, were reviewed. This study contained 1 case of previous balloon valvuloplasty and 1 case of death with bleeding from right ventricle during sternal reenrty. The average time intervals between reoperation and previous operation was 19 years in closed mitral commissurotomy[n=4], 7 years and 2 months in mitral valve replacement[n=10], 1 year and 8 months in mitral valvuloplasty[n=4], 3 years and 10 months in open mitral commissurotomy [n=2]. The cause of reoperation in closed mitral commissurotomy was progression of the disease, and residual stenosis with progression was the cause in open mitral commissurotomy cases. Technical failure might be the cause in the cases of valvuloplasty. In prosthetic valve replacement group the causes of reoperation were primary failure. Also two cases of suggested valve thrombosis and one case of failure of tricuspid annuloplasty was noted in prosthetic valve replacement group. The used valves for reoperation were Ionescue-Shiley in 3 cases, Bjork-Shiley in 6 cases, St. Jude Medical in 2 cases and CarboMedics in 8 cases. The mortality rate was 20%[n=4] and the causes of death were low output syndrome in 1 case, multiple organ failure in 2 cases and bleeding in 1 case during sternal reentry. During follow up 1 case of sudden death was observed.

• The Journal of the Korea Contents Association
• /
• v.10 no.12
• /
• pp.290-299
• /
• 2010

This study aims to evaluate the efficiency of superior appraisal corporations using DEA(Data Envelopment Analysis). DEA is known as a method for evaluating relative efficiency of organizations with multiple inputs and outputs. We used CCR-O and BCC-O DEA models to evaluate relative efficiency of superior appraisal corporations. Input variable is number of appraisers, output variables are total sales and net income. Total of 13 appraisal corporations in Korea were selected for this study, and the data were collected from financial reports for 2008 fiscal year. The result of this study is summarized as follows. First, the average of superior appraisal corporation's technical efficiency score is about 88.3% by applying CCR-O model. Second, the average of superior appraisal corporation's pure technical efficiency score is about 90% and scale efficiency score is about 98.2% by applying BCC-O model. According to the result of DEA, the cause of inefficiency is pure technical efficiency.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.1
• /
• pp.211-216
• /
• 2012

Control Theory for continuous-time system has been well developed. Due to the development of computer technology, digital control scheme are employed in many areas. When delays are in control systems, it is hard to control the system efficiently. Delays by controller-to-actuator and sensor-to-controller deteriorate control performance and could possibly destabilize the overall system. In this paper, a new approximated discretization method and digital design for control systems with multiple state, input and output delays and a generalized bilinear transformation method with a tunable parameter are also provided, which can re-transform the integer time-delayed discrete-time model to its continuous-time model. Illustrative example is given to demonstrate the effectiveness of the developed method.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.47 no.3
• /
• pp.22-28
• /
• 2010

Adaboost is well known for a representative learner as one of the kernel methods. Adaboost which is based on the statistical learning theory shows good generalization performance and has been applied to various pattern recognition problems. However, Adaboost is basically to deal with a two-class classification problem, so we cannot solve directly a multi-class problem with Adaboost. One-Vs-All and Pair-Wise have been applied to solve the multi-class classification problem, which is one of the multi-class problems. The two methods above are ones of the output coding methods, a general approach for solving multi-class problem with multiple binary classifiers, which decomposes a complex multi-class problem into a set of binary problems and then reconstructs the outputs of binary classifiers for each binary problem. However, two methods cannot show good performance. In this paper, we propose the method to solve a multi-target classification problem by using radial basis function of Adaboost weak classifier.

• Journal of the Korean BIBLIA Society for library and Information Science
• /
• v.22 no.4
• /
• pp.301-315
• /
• 2011

DEA(Data Envelopment Analysis) is useful to measure the relative efficiency of organizational units where the presence of multiple inputs and outputs. This study applied DEA-CCR and DEA-BCC to evaluate the technical, pure technical, and scale efficiency of 29 university libraries. The input variables were number of books, print edition expenses, building space, staff, number of seats. As output variables we estimated: reader visits, number of borrowed items, number of visitors. It was found out that number of libraries with 100% relative efficiency among 29 libraries were 13. Also the results shows that main reason of inefficiency was from scale rather than from pure technical. Many inefficient libraries were operations of increasing return to scale.