• Proceedings of the KIPE Conference
• /
• 2008.06a
• /
• pp.481-483
• /
• 2008

본 논문은 다양한 종류의 전원을 구비해야 하는 다중출력 전원 시스템을 위한 영전류 스위칭 LLC 공진형 Post-regulator를 제안한다. 기존의 LLC 공진형 컨버터는 정밀한 다중 출력을 얻기 위해 추가의 DC/DC 컨버터가 구성되었고, 이는 전력 변환 효율 감소 및 제조 원가 상승의 단점을 갖고 있다. 제안된 컨버터는 각 소자의 내압 및 전류 스트레스가 작고, 요구되는 출력 당 1 개의 보조 스위치만으로 구현되므로 저가격화에 유리하다. 또한 전력이 전달되는 시점의 공진 전류의 초기값을 가변함으로서 정밀하게 제어되는 다중 출력 전압을 획득할 수 있고, 각 전압의 출력 순서 제어도 가능한 장점이 있다. 뿐만 아니라, 독립된 공진탱크를 이용하기 때문에 공진탱크 설계가 용이하며, 최근 전자 제품의 추세인 슬림화의 요구에 부응할 수 있다. 또한, 제안된 Post-regulator의 모든 전력 스위치는 ZCS가 가능하므로 스위칭 손실을 최소화 할 수 있다. 최종적으로 본 논문에서 제안한 영전류 스위칭 LLC 공진형 Post-regulator를 제작하고, 고찰된 실험결과를 제시하여 제안된 컨버터 및 전원시스템의 우수성과 이론적 분석의 타당성을 검증한다.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.9B
• /
• pp.745-750
• /
• 2008

In a cognitive radio based system, quality of service (QoS) for the secondary user must be maintained as much as possible even while that of the primary user is protected all he time. In particular, switching wireless links for the secondary user during the transmission of multimedia data causes delay and information loss, and QoS degradations occur inevitably. The efficient resource management scheme is necessary to support the seamless multimedia service to the secondary user. This paper proposes a novel frequency selection method based on Multi-Criteria Decision Making (MCDM), in which uncertain parameters such as received signal strength, cell load, data rate, and available bandwidth are considered during the decision process for the frequency selection with the fuzzy set theory. Through simulation, we show that our proposed frequency selection method provides a better performance than the conventional methods which consider the received signal strength only.

• Journal of Power Electronics
• /
• v.18 no.2
• /
• pp.558-572
• /
• 2018

In addition to its modular nature, a Hybrid Modular Multilevel Converter (HMMC) assembled from half-bridge and full-bridge sub-modules, is able to block DC faults with a minimum number of switching devices, which makes it attractive for high power applications. This paper introduces a control strategy based on the Root-Least Square (RLS) algorithm to estimate the capacitor voltages instead of using direct measurements. This action eliminates the need for voltage transducers in the HMMC sub-modules and the associated communication link with the central controller. In addition to capacitor voltage balancing and suppression of circulating currents, a fault tolerant control unit (FTCU) is integrated into the proposed strategy to modify the parameters of the HMMC controller. On advantage of the proposed FTCU is that it does not need extra components. Furthermore, a fault detection unit is adapted by utilizing a hybrid estimation scheme to detect sub-module faults. The behavior of the suggested technique is assessed using PSCAD offline simulations. In addition, it is validated using a real-time digital simulator connected to a real time controller under various normal and fault conditions. The proposed strategy shows robust performance in terms of accuracy and time response since it succeeds in stabilizing the HMMC under faults.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1846-1850
• /
• 2005

This paper presents a constrained-based routing (CBR) algorithm called, Dynamic Possible Path per Link (D-PPL) routing algorithm, for MultiProtocol Label Switching (MPLS) networks. In MPLS on-line routing, future traffics are unknown and network resource is limited. Therefore many routing algorithms such as Minimum Hop Algorithm (MHA), Widest Shortest Path (WSP), Dynamic Link Weight (DLW), Minimum Interference Routing Algorithm (MIRA), Profiled-Based Routing (PBR), Possible Path per Link (PPL) and Residual bandwidth integrated - Possible Path per Link (R-PPL) are proposed in order to improve network throughput and reduce rejection probability. MIRA is the first algorithm that introduces interference level avoidance between source-destination node pairs by integrating topology information or address of source-destination node pairs into the routing calculation. From its results, MIRA improves lower rejection probability performance. Nevertheless, MIRA suffer from its high routing complexity which could be considered as NP-Complete problem. In PBR, complexity of on-line routing is reduced comparing to those of MIRA, because link weights are off-line calculated by statistical profile of history traffics. However, because of dynamic of traffic nature, PBR maybe unsuitable for MPLS on-line routing. Also, both PPL and R-PPL routing algorithm we formerly proposed, are algorithms that achieve reduction of interference level among source-destination node pairs, rejection probability and routing complexity. Again, those previously proposed algorithms do not take into account the dynamic nature of traffic load. In fact, future traffics are unknown, but, amount of previous traffic over link can be measured. Therefore, this is the motivation of our proposed algorithm, the D-PPL. The D-PPL algorithm is improved based on the R-PPL routing algorithm by integrating traffic-per-link parameters. The parameters are periodically updated and are dynamically changed depended on current incoming traffic. The D-PPL tries to reserve residual bandwidth to service future request by avoid routing through those high traffic-per-link parameters. We have developed extensive MATLAB simulator to evaluate performance of the D-PPL. From simulation results, the D-PPL improves performance of MPLS on-line routing in terms of rejection probability and total throughput.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.11
• /
• pp.1689-1700
• /
• 1993

WDM(Wavelength Division Multiplexing) based-on fixed wavelengths is a new means of utilizing the bandwidth of optical fibers. In this Paper, an improved virtual topology called "(a, $\beta$,${\gamma}$) ShuffleNet " is introdced for designing large-scale WDM switches. The proposed one is an architecture created by vertically stacking x planes of a ($\beta$,${\gamma}$) ShuffleNet in parallel via $\beta$r nodes called "bridge nodes" so that N-by-N(N=(x*$\beta$${\gamma}$*${\gamma}$) switching is achieved based on the self-routing algorithm for each ($\beta$,${\gamma}$) ShuffleNet. With the topological parallelism, in contrast to the conventional virtual topologies, the diameter of 2${\gamma}$ hops can be fixed and high utilization and performance are provided while N increases. Such a scalability characteristic allows to design a growable broadband switch. As for the delay, we show that the traffic locality, due to the topological feature. result in low delay characteristics.lay characteristics.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.13 no.2
• /
• pp.186-191
• /
• 2003

Skills in tracing of the MR divide into following, approaching, avoiding and warning and so on. It is difficult to have all these skills learned as neural network. To make this up for, skills consisted of each module, and Mobile Robot was controlled by the output of module adequate for the situation. A mobile Robot was equipped multi-ultrasonic sensor and a USB Camera, which can be in place of human sense, and the measured environment information data is learned through Modular Neural Network. MNN consisted of optimal combination of activation function in the Expert Network and its structure seemed to improve learning time and errors. The Gating Network(GN) used to control output values of the MNN by switching for angle and speed of the robot. In the paper, EN of Modular Neural network was designed optimal combination. Traveling with a real MR was performed repeatedly to verity the usefulness of the MNN which was proposed in this paper. The robot was properly controlled and driven by the result value and the experimental is rewarded with good fruits.

• Journal of IKEEE
• /
• v.2 no.2 s.3
• /
• pp.270-277
• /
• 1998

As the network technologies advance, the control systems progress from a centralized architecture to a distributed one. However, these control systems were designed mostly based on the general-purpose operating systems(OS) and have many problems for assurance of a real-time property required for plant processing fields. Therefore, the control systems far a plant process upon real-time OS hare been increased gradually. In this paper, the real-time OS emphasizes on the realization of real-time processing capability, reliability of real-time response, and multi-processing functionality which are prerequisites for a distributed control system. And on the basis of this OS, the number of executable loop and logic, the functions of main plant processing, was analyzed and its validity was also evaluated. The system in this paper was designed not to effect on processing data while online, and the time spent on switching was measured.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.39 no.7
• /
• pp.1-11
• /
• 2002

This paper proposes that an efficient routing entry sending method between routing controller FE. based on this method, we organize IP VPN support method based on MPLS network and design MPLS-VPN service control module, MPLS-VPN processing, VPN group configuration and LSP setup processing. We evaluate the performance about the VPN based on proposed MPLS, at the result of evaluation. We figure out that based on proposed IPC method, lost packets number reduces and delay increases more slowly in case of VPN based on MPLS comparing with the VPN based on ATM which has rapid delay increasement. Therefore we confirm that the VPN based on MPLS has high speed of packet processing and high utilization of buffers through the performance evaluation.

• Journal of the Korean Magnetics Society
• /
• v.13 no.3
• /
• pp.115-120
• /
• 2003

We have developed laser micro-machining technology for fabrication of the micro thin-film inductors. After the thin layers of FM/M/FM films were coated to the silicon substrate by using the conventional sputtering method, the new laser machining was applied to the patterning process that used to be carried out by the semiconductor lithography procedure. A CW Nd:YAG laser operating in TEM$\sub$00/ mode was actively Q-switched to obtain the very short pulse of 200 ns. The laser micro-machining process with pulse energy and repetition rate have been optimized as 5 mJ/pulse and 5 kHz, respectively, to obtain the line resolution as fine as 20 $\mu\textrm{m}$.

• Journal of The Korean Astronomical Society
• /
• v.52 no.6
• /
• pp.227-233
• /
• 2019

We report the performance of the 13.7-meter Taeduk Radio Astronomy Observatory (TRAO) radio telescope. The telescope has been equipped with a new receiver, SEQUOIA-TRAO, a new backend system, FFT2G, and a new VxWorks operating system. The receiver system features a 16-pixel focal plane array using high-performance MMIC preamplifiers; it shows very low system noise levels, with system noise temperatures from 150 K to 450 K at frequencies from 86 to 115 GHz. With the new backend system, we can simultaneously obtain 32 spectra, each with a velocity coverage of 163 km s^-1 and a resolution of 0.04 km s^-1 at 115 GHz. The new operating system, VxWorks, has successfully handled the LMTMC-TRAO observing software. The main observing method is the on-the-fly (OTF) mapping mode; a position-switching mode is available for small-area observations. Remote observing is provided. The antenna surface has been newly adjusted using digital photogrammetry, achieving a rms surface accuracy better than 130 ㎛. The pointing uncertainty is found to be less than 5" over the entire sky. We tested the new receiver system with multi-frequency observations in OTF mode. The aperture efficiencies are 43±1%, 42±1%, 37±1%, and 33±1%, the beam efficiencies are 45±2%, 48±2%, 46±2%, and 41±2% at 86, 98, 110, and 115 GHz, respectively.