• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.985-988
• /
• 2005

The international standards of high-rate WPAN (Wireless Personal Area network) are under development by IEEE802.15 WPAN TG3 (Task Group 3). The study area of TG3 mainly consists of three parts: high rate physical and media access control layer in 2.4GHz ISM (Industrial Scientific Medical) non licensed frequency band; an alternative high rate physical layer by using UWB (Ultra Wide Band); and another alternative high rate physical layer based on millimeter wave. This paper describes the standardization trends of UWB and millimeter wave.

• Journal of the Korean Ceramic Society
• /
• v.40 no.4
• /
• pp.350-353
• /
• 2003

Millimeter-wave dielectric ceramics have been used like applications for ultrahigh speed wireless LAN because it reduces the resources of electromagnetic wave, and Intelligent Transport System (ITS) because of straight propagation wave. For millimeterwave, the dielectric ceramics with high quality factor (Q$.$f), low dielectric constant($\varepsilon$), and nearly zero temperature coefficient of resonant frequency ($\tau$) are needed. No microwave dielectric ceramics with these three properties exist except Ba(Mg$\_$1/3/Ta/sub1/3/)O$_3$ (BMT), which has a little high s: In this paper, alumina (Al$_2$O$_3$) and fosterite (Mg$_2$SiO$_4$), candidates for millimeter-wave applications, were studied with an objective to get high q$.$f and nearly zero $\tau$$\_$f/ For alumina ceramics, q$.$f more than 680,000 GHz was obtained but it was difficult to obtain nearly zero Qf. On the other hand, for forsterite ceramics, q$.$f was achieved from 10,000 GHz of commercial for sterite to 240,000 GHz of highly purified MgO and SiO$_2$ raw materials, and $\tau$$\_$f/ was reduced a few by adding TiO$_2$ with high positive $\tau$$\_$f/.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.45 no.12
• /
• pp.41-46
• /
• 2008

We report a high gain D-band(110 - 140 GHz) MMIC drive amplifier based on $0.1{\mu}m$ InGaAs/InAlAs/GaAs metamorphic HEMT technology. The amplifier shows an excellent $S_{21}$ gain characteristic greater than 10 dB in a millimeterwave frequency of 110 GHz, Also the amplifier has good reflection characteristics of a $S_{11}$ of -3.5 dB and a $S_{22}$ of -6.5 dB at 110 GHz, respectively The high performances of the MMIC drive amplifier is mainly attributed to the characteristics of the MHEMTs exhibiting a maximum transconductance of 760 mS/mm, a current gain cut-off frequency of 195 GHz and a maximum oscillation frequency of 391 GHz.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.19 no.1
• /
• pp.197-202
• /
• 2019

A small millimeter-wave tracking radar power supply must provide stable power with minimal ripple noise and the switching frequency noise of the DC-DC converter must have a real-time self-test capability through on-the-fly monitoring without causing false alarms and ghost In this study, we developed a multi-output switching power supply with output power of more than 80% (@ 100% load) and 10 output power by adopting + 28VDC input for application to small millimeter wave tracking radar, DC-DC converter is applied for large power output and multi-output flyback method is applied for the remaining small power output. The test results show that 85% efficiency efficiency is achieved under 100% load condition.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.1
• /
• pp.85-95
• /
• 2012

In this thesis, we develop a spectral analysis scheme to eliminate the spurious peaks generated in HRR Millimeterwave Seeker based on FMICW system. In contrast to FMCW system, FMICW system generates spurious peaks in the spectrum of its IF signal, caused by the periodic discontinuity of the signal. These peaks make the accuracy of the system depend on the previously estimated range if a band pass filter is utilized to eliminate them and noise floor go to high level if random interrupted sequence is utilized and in case of using staggering process, we must transmit several waveforms to obtain overlapped information. Using the spectral analysis one of the schemes such as IAA(Iterative Adaptive Approach) and SPICE(SemiParametric Iterative Covariance-based Estimation method) which were introduced recently, the spurious peaks can be eliminated effectively. In order to utilize IAA and SPICE, since we must distinguish between reliable data and unreliable data and only use reliable data, STFT(Short Time Fourier Transform) is applied to the distinguishment process.