• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2006년도 하계학술대회 논문집 Vol.7
• /
• pp.194-195
• /
• 2006

Aluminum oxide films directly grown on n-type 6H-SiC(0001) substrates were fabricated by RF magnetron sputtering system. Metal-insulator-semiconductor(MIS) C-V properties with aluminum oxide thin films showed hysteresis and f1at band voltage shift. The dielectric constant of the film calculated from the capacitance at the accumulation region was about 5. Typical gate leakage current density of film at room temperature was the order of $10^{-9}\;A/cm^2$ at the range of within 2MV/cm. The breakdown did not occur at the film within the measurement range.

• 전자통신동향분석
• /
• 제38권6호
• /
• pp.52-61
• /
• 2023

With semiconductor scaling approaching the physical limits, devices including CMOS (complementary metal-oxide-semiconductor) components have managed to overcome yet are currently struggling with several technical issues like short-channel effects. Evolving from the process node of 22 nm with FinFET (fin field effect transistor), state-of-the-art semiconductor technology has reached the 3 nm node with the GAA-FET (gate-all-around FET), which appropriately addresses the main issues of power, performance, and cost. Technical problems remain regarding the foundry of GAA-FET, and next-generation devices called post-GAA transistors have not yet been devised, except for the CFET (complementary FET). We introduce a CFET that spatially stacks p- and n-channel FETs on the same footprint and describe its structure and fabrication. Technical details like stacking of nanosheets, special spacers, hetero-epitaxy, and selective recess are more thoroughly reviewed than in similar articles on CFET fabrication.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제1권4호
• /
• pp.216-231
• /
• 2001

Several methods for improving device yields and characteristics have been studied by IC manufacturers, as the options for programming components become diversified through the introduction of novel processes. Especially, the sequential repair steps on wafer level and package level are essentially required in DRAMs to improve the yield. Several repair methods for DRAMs are reviewed in this paper. They include the optical methods (laser-fuse, laser-antifuse) and the electrical methods (electrical-fuse, ONO-antifuse). Theses methods can also be categorized into the wafer-level(on wafer) and the package-level(post-package) repair methods. Although the wafer-level laser-fuse repair method is the most widely used up to now, the package-level antifuse repair method is becoming an essential auxiliary technique for its advantage in terms of cost and design efficiency. The advantages of the package-level antifuse method are discussed in this paper with the measured data of manufactured devices. With devices based on several processes, it was verified that the antifuse repair method can improve the net yield by more than 2%~3%. Finally, as an illustration of the usefulness of the package-level antifuse repair method, the repair method was applied to the replica delay circuit of DLL to get the decrease of clock skew from 55ps to 9ps.

• 전기전자학회논문지
• /
• 제13권4호
• /
• pp.23-27
• /
• 2009

실리콘 기판 상에 MBE (molecular beam epitaxy)로 형성된 GaSb 기반 p-channel HEMT 소자를 제작하기 위하여 오믹 접촉 형성 공정과 식각 공정을 연구하였다. 먼저 각 소자의 절연을 위한 메사 식각 공정 연구를 수행하였으며, HF기반의 습식 식각 공정과 ICP(inductively coupled plasma)를 이용한 건식 식각 공정이 모두 사용되었다. 이와 함께 소스/드레인 영역 형성을 위한 오믹 접촉 형성 공정에 관한 연구를 진행하였으며 Ge/Au/Ni/Au 금속층 및 $300^{\circ}C$ 60초 RTA공정을 통해 $0.683\;{\Omega}mm$의 접촉 저항을 얻을 수 있었다. 더불어 HEMT 소자의 게이트 형성을 위한 게이트 리세스 공정을 AZ300 현상액과 citric산 기반의 습식 식각을 이용하여 연구하였으며, citric산의 경우 소자 구조에서 캡으로 사용된 GaSb와 베리어로 사용된 AlGaSb사이에서 높은 식각 선택비를 보였다.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2016년도 제50회 동계 정기학술대회 초록집
• /
• pp.128.1-128.1
• /
• 2016

Nitrided-metal gates on the high-${\kappa}$ dielectric material are widely studied because of their use for sub-20nm semiconductor devices and the academic interest for the evanescent states at the Si/insulator interface. Issues in these systems with the Si substrate are the electron mobility degradation and the reliability problems caused from N defects that permeates between the Si and the $SiO_2$ buffer layer interface from the nitrided-gate during the gate deposition process. Previous studies proposed the N defect structures with the gap states at the Si band gap region. However, recent experimental data shows the possibility of the most stable structure without any N defect state between the bulk Si valence band maximum (VBM) and conduction band minimum (CBM). In this talk, we present a new type of the N defect structure and the electronic structure of the proposed structure by using the first-principles calculation. We find that the pair structure of N atoms at the $Si/SiO_2$ interface has the lowest energy among the structures considered. In the electronic structure, the N pair changes the eigenvalue of the silicon-induced gap state (SIGS) that is spatially localized at the interface and energetically located just above the bulk VBM. With increase of the number of N defects, the SIGS gradually disappears in the bulk Si gap region, as a result, the system gap is increased by the N defect. We find that the SIGS shift with the N defect mainly originates from the change of the kinetic energy part of the eigenstate by the reduction of the SIGS modulation for the incorporated N defect.

• 한국전기전자재료학회논문지
• /
• 제33권5호
• /
• pp.427-431
• /
• 2020

In this research, we evaluated the electrical properties of polycrystalline-gallium-oxIde (Ga₂O₃) thin films grown by mist-CVD. A 500~800 nm-thick Ga₂O₃ film was used as a channel in a fabricated bottom-gate MOSFET device. The phase stability of the β-phase Ga₂O₃ layer was enhanced by an annealing treatment. A Ti/Al metal stack served as source and drain electrodes. Maximum drain current (I_D) exceeded 1 mA at a drain voltage (V_D) of 20 V. Electron mobility of the β-Ga₂O₃ channel was determined from maximum transconductance (g_m), as approximately, 1.39 ㎠/Vs. Reasonable device characteristics were demonstrated, from measurement of drain current-gate voltage, for mist-CVD-grown Ga₂O₃ thin films.

• 한국진공학회지
• /
• 제11권4호
• /
• pp.230-234
• /
• 2002

고온 급속 열처리를 행한 $LiNbO_3Si$/(100) 구조를 가지고 여러 가지 전극을 사용하여 금속/강유전체/반도체 커패시터를 제작하였으며, 제작한 커패시터의 비휘발성 메모리 응용 가능성을 확인하였다. MFS 커패시터의 C-V 특성 곡선에서는 LiNbO$_3$박막의 강유전성으로 인한 히스테리시스 특성이 관측되었으며, 1 MHz C-V 특성 곡선의 축적 영역에서 산출한 비유전율은 약 25 이었다. Pt 전극을 사용하여 제작한 커패시터에서는 인가 전계 500 kV/cm 범위에서 $1\times10^{-8}$ A/cm 이하의 우수한 누설전류 특성이 나타났다. midgap 부근에서의 계면 준위 밀도는 약 $10^{11}\textrm{cm}^2$.eV 이었으며, 잔류분극 값은 약 1.2 $\muC/\textrm{cm}^2$ 였다. Pt 전극과 A1 전극 모두 500 kHz 주파수의 바이폴러 펄스를 인가하면서 측정한 피로 특성에서 $10^{10}$ cycle 까지 측정된 잔류 분극 값이 초기 값과 같았다.

• 한국항행학회논문지
• /
• 제18권4호
• /
• pp.364-370
• /
• 2014

본 논문에서는 트렌치 게이트 MOSFET에 적용을 위한 고 신뢰성을 갖는 트렌치 형성기술과 고품격의 제조기술을 제안하였다. 이는 향후 전력용 MOSFET 에 널리 적용이 가능하다. 트렌치 구조는 DMOSFET에서 셀 피치크기를 줄여서 Ron 특성을 개선하거나 대다수 전력용 IC에서 전력용 소자를 다른 CMOS(Complementary Metal Oxide Semiconductor) 소자로부터 독립시킬 목적으로 채용된다. 마스크 레이어를 사용하여 자기정렬기술과 산화막 스페이서가 채용된 고밀도 트렌치 MOSFET를 제작하기 위한 새로운 공정방법을 구현하였다. 이 기술은 공정 스텝수를 감소시키고 트렌치 폭과 소오스, p-body 영역을 감소시킴으로써 결과적으로 셀 밀도와 전류 구동성능을 증가시키며 온 저항의 감소를 가져왔다.

• Journal of Information Display
• /
• 제10권4호
• /
• pp.149-157
• /
• 2009

Reported herein is the architecture for a nonvolatile n-type memory paper field-effect transistor. The device was built via the hybrid integration of natural cellulose fibers (pine and eucalyptus fibers embedded in resin with ionic additives), which act simultaneously as substrate and gate dielectric, using passive and active semiconductors, respectively, as well as amorphous indium zinc and gallium indium zinc oxides for the gate electrode and channel layer, respectively. This was complemented by the use of continuous patterned metal layers as source/drain electrodes.

• Transactions on Electrical and Electronic Materials
• /
• 제11권4호
• /
• pp.155-165
• /
• 2010

As a promising candidate to replace the conventional floating gate flash memories, polysilicon-oxide-nitride-oxidesilicon (SONOS)-type nonvolatile semiconductor memories have been investigated widely in the past several years. SONOS-type memories have some advantages over the conventional floating gate flash memories, such as lower operating voltage, excellent endurance and compatibility with standard complementary metal-oxide-semiconductor (CMOS) technology. However, their operating speed and date retention characteristics are still the bottlenecks to limit the applications of SONOS-type memories. Recently, various approaches have been used to make a trade-off between the operating speed and the date retention characteristics. Application of high-k dielectrics to SONOS-type memories is a predominant route. This article provides the state-of-the-art research progress of high-k dielectrics applicable to SONOS-type nonvolatile semiconductor memories. It begins with a short description of working mechanism of SONOS-type memories, and then deals with the materials' requirements of high-k dielectrics used for SONOS-type memories. In the following section, the microstructures of high-k dielectrics used as tunneling layers, charge trapping layers and blocking layers in SONOS-type memories, and their impacts on the memory behaviors are critically reviewed. The improvement of the memory characteristics by using multilayered structures, including multilayered tunneling layer or multilayered charge trapping layer are also discussed. Finally, this review is concluded with our perspectives towards the future researches on the high-k dielectrics applicable to SONOS-type nonvolatile semiconductor memories.