• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제49권4호
• /
• pp.226-232
• /
• 2000

In magnetic systems, distribution of electromagnetic force density causes mechanical deformation, which results in noise and vibration. In this paper, Korteweg-Helmholtzs energy method and equivalent magnetic charge method are employed for comparison of their resulting distributions of force density. The force density from the Korteweg-Helmholtzs method is expresses with two Maxwell stresses on the inside and the outside fo magnetic material respectively. The other is calculated using the magnetic Coulombs law. In the numerical model of an electromagnet, their numerical results are compared. The distributions by the two methods are almost the same. And their total forces are also shown to be the same to the one calculated from the conventional Maxwell stress tensor. But the magnetic charge method is easier and more efficient in numerical calculation.

• Journal of Magnetics
• /
• 제19권1호
• /
• pp.72-77
• /
• 2014

This paper proposes an indirect fault detection method for an onboard degaussing coil system, installed to reduce the underwater magnetic field from the ferromagnetic hull. The method utilizes underwater field signals measured at specific magnetic treatment facilities instead of using time-consuming numerical field solutions in a three-dimensional space. An equivalent magnetic charge model combined with a material sensitivity formula is adopted to predict fault coil locations. The purpose of the proposed method is to yield reliable data on the location and type of a coil breakdown even without information on individual degaussing coils, such as dimension, location and number of turns. Under several fault conditions, the method is tested with a model ship equipped with 20 degaussing coils.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 제38회 하계학술대회
• /
• pp.997-998
• /
• 2007

This paper deals with analytical solution concerning the image method using the magnetic charge instead of 3D FEA(finite element analysis) in the slotless single air-gap motor. The theory of analytical method and the design procedures are introduced. The reliability and validity of proposed analytical solution are verified through the comparison with the results of commercial 3D FE software. In addition, calculation time between proposed analytical solution and 3D FEA is compared. Finally, characteristics, such as Back-EMF and phase resistance, between calculated and experimental results are compared. From the verification with 3D FEA and experimental results, it is proved that presented analytical method provided very effective and precise results.

• 한국자기학회지
• /
• 제20권3호
• /
• pp.100-105
• /
• 2010

본 논문에서는 강자성 선체에 존재하는 영구자화 분포에 기인한 자기장 신호를 예측하고자 연속체역학에 기반을 둔 매질민감도법과 등가 자기 모델을 결합한 역문제 해석 기법을 제시한다. 이를 위하여 3차원 자기전하 모델과 2차원의 등가 자기쌍극자 모델을 구축하였고 각각의 등가모델에 맞는 매질민감도 공식을 유도하였다. 매질민감도법은 자기전하나 자기쌍극자 변화에 대한 목적함수의 1차 미분정보를 제공하고 설계변수의 개수에 영향을 받지 않기 때문에 최적해를 빠른 시간에 도출할 수 있다. 제안된 해석 기법의 타당성을 검증하기 위해서 실험을 통해 측정된 자기장 신호와 각각 등가모델에 의한 역문제 해석을 통해 얻어진 예측치를 비교하였다.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제1권3호
• /
• pp.289-294
• /
• 2012

In this paper, the three-dimensional magnetic field created by non-periodic magnet arrays is calculated analytically. The analytical expression of the magnetic field is derived by using a magnetic charge model. The influence of ferromagnetic boundaries is formulated with an image method. Finally, we compare the results determined by analytical calculations to those from a finite element simulation.

• Journal of Mechanical Science and Technology
• /
• 제18권4호
• /
• pp.640-648
• /
• 2004

This paper describes a new magnetization method for non-destructive testing with magneto-optical sensor (denoted as MO sensor) which have the following characteristic : high observation sensitivity, independence of the crack orientation, and precise imaging of a complex crack geometry such as multiple cracks. When a magnetic field is applied normally to the surface of a specimen which is significantly larger than its defects, approximately the same magnetic charge per unit area occurs on the surface of the specimen. If there is a crack in the specimen, magnetic charge per unit area has the same value at the bottom of the crack. The distribution of the vertical component of the magnetic flux density, B$\_$Z/, is almost uniform over the no-crack area (denoted as B$\_$Z,BASE/), while the magnetic flux density is smaller in the surroundings of the crack(denoted as B$\_$Z,CRACK/) If B$\_$Z, BASE/ is a bit larger than the saturated magnetic flux density of the MO sensor (B$\_$s/) , then small magnetic domains occur over the crack area and a large domain over the non-crack area because B$\_$Z,CRACK/ is smaller than B$\_$s/.

• 한국자기공명학회논문지
• /
• 제9권1호
• /
• pp.67-73
• /
• 2005

$^{27}AI$ triple quantum magic angle spinning (3QMAS) NMR spectra of several mordenite (MOR) sample were simulated with the point charge model method and compared with experimental 3QMAS spectra. Signal positions from different tetrahedral (T) sites in 3QMAS spectra are mainly governed by local structures of T sites such as T-O-T angles and T-O bond lengths. When preparation methods, cations in addition to Si/Al rations vary, the local structures of T sites in MOR change enough to alter signal patterns in 3QMAS of MOR. This inhibits to study the of Al distribution variation over 4 different T sites in mordenite during process such as dealumination by 3QMAS spectra.

• Journal of Magnetics
• /
• 제17권1호
• /
• pp.27-32
• /
• 2012

Transcranial magnetic stimulation requires an electric field composed of dozens of V/m to achieve stimulation. The stimulation system is composed of a stimulation coil to form the electric field by charging and discharging a capacitor in order to save energy, thus requiring high-pressure kV. In particular, it is charged and discharged in capacitor to discharge through stimulation coil within a short period of time (hundreds of seconds) to generate current of numerous kA. A pulse-type magnetic field is formed, and eddy currents within the human body are triggered to achieve stimulation. Numerous pulse forms must be generated to initiate eddy currents for stimulating nerves. This study achieved high internal pressure, a high number of repetitions, and rapid switching of elements, and it implemented numerous control techniques via introduction of the half-bridge parallel load method. In addition it applied a quick, accurate, high-efficiency charge/discharge method for transcranial magnetic stimulation to substitute an inexpensive, readily available, commercial frequency condenser for a previously used, expensive, high-frequency condenser. Furthermore, the pulse repetition rate was altered to control energy density, and grafts compact, one-chip processor with simulation to stably control circuit motion and conduct research on motion and output characteristics.

• 한국자기학회지
• /
• 제21권5호
• /
• pp.174-179
• /
• 2011

지금까지 자성체에 미치는 전자기력을 계산하기 위해서는, 맥스웰 응력법, 가상변위법, 자하법, 자화전류법등이 널리 사용되어 왔으며, 이들은 자성체 덩어리 전체에 미치는 전자기력을 계산하는 데 있어 모두 정당한 결과를 가져온다고 보고 있다. 그러나 전자기력 밀도식의 완전한 형태에 대해서는 아직 까지도 논란이 있으며, 각 방법에 의한 표면 전자기력 밀도는 식과 수치해석 모두 다른 결과를 보인다. 본 연구는 전자기력밀도를 체적력으로 국한하여 가상공극법을 적용하였을 때, 모두 같은 형태의 식으로 도출이 됨을 해석식이 존재하는 모델을 통하여 보여준다. 즉, 가상공극 개념을 적용할 경우, 체적력 전자기력 밀도식의 통일 가능성을 보여 주는 것이다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.25-27
• /
• 1998

In this paper electromagnetic force and its distribution are analyzed on the nonlinear magnetic materials by Finite Element Method. Most of magnetic materials have the nonlinear characteristic, which considerably effects on the magnetic system. And it is necessary to know its distribution at the every Part of the magnetic material in order to design the, magnetic system considering noise, vibration and strain characteristic. The results are obtained by Maxwell stress. virtual work and magnetic charge method and compared with one another.