• Plant Journal
• /
• v.15 no.4
• /
• pp.30-35
• /
• 2019

To meet both increasing social demand for reduction of fine dust and the strengthened air pollutant emission standards, this paper indicated performance enhancement of FGD with structural constraints in 500 MW coal fired thermal power plant's. Through modifying internal facilities for flue gases to make swirl in the absorption tower, it made turbulence and increased the efficiency of material transfer, the reaction area and time with the limestone slurry. Therefore, it could reduce dust and enhance the performance of collecting the SO₂. As a result, desulfurization efficiency was improved from 91.61% to 98.43% and dust removal efficiency was improved from 77.4% to 87.08%. Emission density is 7.85 ppm of SO₂ and 4.67 mg/㎥ of dust. This is a level that satisfies emission limit of 25 ppm of SO₂ and 5 mg/㎥ of dust which are the air pollutant emission standards of 2023. The performance enhancement method of this study is expected to be effectively applied to other coal-fired power plants with similar constraints.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.13 no.3
• /
• pp.109-117
• /
• 1999

In this paper, improved lamp type ownizer( ILO ), which utilizes the superposition of lamp type ownizer( LO ) and surface discharge operation, is designoo and manufactured for the purpose of characteristic improverrent of an LO employoo for installation of environrrent improverrent and good health using Ultraviolet(U.V.) photochemical reactions Irethoc1s. The ownizer consists of 2 types( LO and ILO ), and owne concentration, owne generation and owne yield were investigated in accordance with discharge power and quantity of suwlioo gas. The results of owne concentration, owne generation and owne yield were ILO > LO. So, owne generation characteristics of the lamp type ownizer were improved. At a discharge power of 19[W], owne concentration, owne generation, and owne yield of the ILO are each improvoo than LO 124[%] at the gas flow $1[\ell/min]$ and 143[%] at the gas flow $1[\ell/min]$. The maximum values of owne concentration, owne generation and owne yield were found as 712[ppm], 128[mg/h] and 6750[mg/kWh] respectively.tively.

• Journal of Korea Soil Environment Society
• /
• v.4 no.3
• /
• pp.3-15
• /
• 1999

This paper includes the basic experimental results performed for developing an innovative and technologically feasible process wherein gaseous ozone, a powerful oxidant. is injected directly into vadose zone by which in-situ chemical degradation of semi- or, non-volatile petroleum product such as diesel fuel is derived. As ozone gas injected continuously(50mL/min, 119.0$\pm$6.1mg/L) into soil packed columns artificially contaminated with diesel fuel(initial concentration 1,485mg-DRO/kg/soil), the removal rates at the inlet and outlet point of 14hrs-operated column are 87.9% and 100.0%, respectively. On the other hand, soil vapor extraction system showed less than 30% of removal rates of residual diesel both at the inlet and outlet samples under the same experimental conditions which confirms the limited treatability of SVE in diesel contaminated soil.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.14 no.2
• /
• pp.59-67
• /
• 2000

In this paper, an ozonizer, which can supply individual and superposed silent discharge using three-phase voltage has been designed and manufactured. The ozonizer consists of 3 electrodes(Central Electrode, Internal Electrode and External Electrode and External electrode) and 2 gaps (gap between Central Electrode and Internal Electrode, gap between Internal Electrode and External Electrode). Ozone is generated according to voltage supplying method to each electrode by individual silent discharge and three-phase superposed discharge. The characteristics of ozone generation were investigated with variation of discharge power and the flow rate of supplied gas (O2). In case of individual silent discharge, the maximum values of ozone concentration, ozone generation and ozone yield were obtained between internal electrode and external electrode, and its values were 2300[ppm], 570[mg/h] and 745[g/kWh] respectively. Each maximum value was 5039[ppm], 1773[mg/h] and 851[g/kWh] respectively, when three-phase superposed silent discharge was employed. Therefore, characteristics of ozone generation with three-phase voltage are improved compared with single-phase voltage because silent discharge is generated continuously.

• Journal of Plant Biotechnology
• /
• v.30 no.3
• /
• pp.263-267
• /
• 2003

This study was conducted to evaluate the effect of thidazuron(TDZ) on shoot proliferation and growth from axillary buds of 20-years-old Corylopsis coreana. Shoots proliferation was effectively achieved on WPM(Woody Plant Medium) supplemented with 0.03∼0.1mg/L TDZ. The highest shoot number(6.5$\pm$0.7) was obtained on 0.1mg/L TDZ treatment. On the TDZ medium shoots formed as clusters less than 1cm in height and therefore needed to subculture on GA$_{3}$ containing medium to induce elongation. In consecutive cultures, phenolic compounds were excreted at the proximal part of the explants and inhibited growth of the explants. Growth inhibition by the compounds was overcome using liquid and paper bridge culture system. About 60％ of the elongated shoots rooted on half- strength MS medium containing IBA. Generally, IBA was mire effective on in vitro rooting than NAA with optimal range of 0.5mg/L to 1.0mg/L. Rooted plantlets were transferred in an artificial soil(vermculite) and acclimatized in high humidity greenhouse condition. Survival rate differed greatly depending on rooting types of the explants. Two types of rooting were observed. The first type was direct rooting from the explants. The second type was callus formation followed by rooting from the callus. The explants showing the 1st type rooting survived can be multiplicated in vitro by TDZ treatment followed by elongation with GA$_{3}$ and rooting with IBA.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.4
• /
• pp.279-285
• /
• 2017

In this paper, the resonator with a parallel plate capacitor is newly proposed around sub-microwave frequency band and applied to earlobe for non-invasive glucose monitoring the human biological tissue. The capacitor including the earlobe as dielectric material is connected to inductive slot in the ground plane of the microstrip line. Based on the simulation, one port resonator circuit is designed and fabricated as a prototype. Three step glucose concentration levels(0, 250, 500 mg/dL) was tested, and its reflection coefficients($S_{11}$) were measured. Owing to high Q resonator more than 100, resonant frequency shift of about 9 MHz per glucose level of 250 mg/dL has been successfully measured. This proves that the proposed sensor is applicable to a blood glucose sensor.

• Journal of KIISE:Information Networking
• /
• v.29 no.3
• /
• pp.224-232
• /
• 2002

The routing protocols designed for wired networks can hardly be used for mobile ad-hoc networks due to limited bandwidth of wireless transmission and unpredictable topological change. Recently, several routing protocols for mobile ad-hoc networks have been proposed. However, when these protocols are applied to support real time services like multimedia transmission, they still have problems in ad-hoe networks, where the topology changes drastically. In this paper, we propose a new route selection algorithm which selects the most reliable rouse that is impervious to route failures by topological changes by mobile hosts. For reliable route selection, the concept of virtual zone (stable lone and caution zone) is proposed. The lone is located in a mobile node's transmission range and determined by mobile node's mobility information received by Global Positioning System (GPS). The proposed algorithm is applied to the route discovery procedure of the existing on-demand routing protocol, AODV, and evaluated by simulation in various traffic conditions and mobility patterns.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.4 no.2
• /
• pp.61-65
• /
• 1971

It is well known that shellfish absorb and accumulate heavy metals in the water environment. When the concentration of the heavy metals in the water is above guideline, we find abnormal accumulation of them in the body of shellfish. This study on green oysters is an instance showing the relationship between the abnormal accumulation of heavy metal and industrial wastewaters containing it. The influence of the industrial wastewaters upon shellfish has been discussed from the statistical, physiological, and saprobiensystematic points of view, and the author wants to make clear of the absorption and accumulation mechanism of the heavy metals and physiological situation. This paper deals with the copper-contents in the meat of oysters which were collected in Changhang Bay and Daechun area, the latter being not supposed to be influenced by the water of the Kum River during the period from October 1970 to february 1971. The mean value of the copper contents in oysters caught at the sampling station in the Changhang Bay area is ranged from 851.5 to 143.1mg Cu/kg wet base, and that of Daechun area varied from 13.0 to 27.4mg Cu/kg wet base, so an evident difference is seen at a significance of $0.1\%$. It appears that one of the environmental factors making copper concentrated in the oysters of the Changhang area is due to the copper-contaning slug being discharged into the sea water by the Changhang Ore Refinery.

• Clean Technology
• /
• v.19 no.4
• /
• pp.446-452
• /
• 2013

In this paper, the wet mixing method was introduced to prepare spinel lithium manganese oxide (LMO) with $Li_2CO_3$ and $MnCO_3$. The physical properties of the resulting lithium manganese oxide were characterized by the XRD and SEM. The adsorption properties of LMO for $Li^+$ were investigated by batch methods. The maximum adsorption capacity of lithium was calculated from Langmuir isotherm and found to be 27.25 mg/g. The LMO are found to have a remarkable lithium ion-sieve property with distribution coefficients ($K_d$) in the order of $Ca^{2+}$ < $K^+$ < $Na^+$ < $Mg^{2+}$ < $Li^+$, which is promising in the lithium extraction from seawater.

• Journal of dental hygiene science
• /
• v.18 no.3
• /
• pp.147-154
• /
• 2018

This study aimed to evaluate the antimicrobial effects of Acanthopanax sessiliflorum fruit (ASF; Ogaza) extracts on Streptococcus mutans and Streptococcus sobrinus, which are agents that cause dental caries, and on Streptococcus mitis and Streptococcus salivarius, the microbial flora of the oral cavity. The ASF extracts obtained using 70% ethanol were fractionated in the order of ethyl acetate and n-Butanol, concentrated under reduced pressure, and lyophilized to give powdery solvent extracts. The antimicrobial activity of ASF extracts from each solvent was examined using the disk diffusion method. As a result, only those extracts obtained using an ethyl acetate solvent showed antimicrobial activity. These extracts were selected, and the minimum inhibitory concentration was measured by disk diffusion method at various extract concentrations. Results showed a minimum inhibitory concentration of 32 mg/ml. The viable cell count was measured to confirm the minimum bactericidal concentration. Results showed a minimum bactericidal concentration of 64 mg/ml. In the cytotoxicity test using normal human dermal fibroblast cells, the absorbance value of the test group was similar to that of the control group at 0.64, 1.28, and 6.4 mg/ml. The bacteria and their colonies were examined using a scanning electron microscope. Boundaries between the antimicrobial activity region and non-antimicrobial activity region were observed around the paper disk, which was immersed in the extract with 32 mg/ml concentration. Bacterial colonization was not observed in the area with antimicrobial activity. This finding suggests that ASF extracts can inhibit the growth of some microorganisms in the oral cavity, in addition to the effects of these extracts known to date. In particular, ASF extracts may be used as a preparation for preventing dental caries by adding the extract to the toothpaste or oral mouthwash.