• Journal of the Korea Society of Computer and Information
• /
• v.3 no.3
• /
• pp.107-112
• /
• 1998

In this paper, filter designed and produced to use hi-Z low-Z filter which is easy to produce microstrip line and uses space less than used stub filter. This filter has very short electrical length of lines, that is Bl＜$\pi$/4, lowpass prototype series inductor replaced high impedance line section and shunt capacitance replaced low impedance line section. Replaced each section designed microstrip lines and effective permittivity of the given microstrip calculated and each section width and length calculated dna filter used design. Designed filter compared the theory value of touchstone with the experiment value of real produced filter and an analyzed response charictristic.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.51 no.1
• /
• pp.32-38
• /
• 2002

This paper describes a development of a portable physical activity monitoring system using two accelerometers to quantify physical activity. The system hardware consists of two piezoresistive accelerometers, amplifiers with gain of 30, lowpass filters with cut-off frequency of 15Hz, offset control circuits, one-chip microcontroller and flash memory card. In order to evaluate the performance of the system we acquired 3 channel data at 32 sample/sec from body-fixed accelerometers in chest and right upper leg. And then the acquired data were processed by MatLab on personal computer. We tried to distinguish not only fundamental actions which are steady-state activities such as standing, sitting, and lying but also dynamic activities with walking, up a stairway, down a stairway, and running. Five subjects participated the evaluation process which compare the video data with the measured data. As a result, the activity classification rate of 90.6% on average was obtained. Overall results showed that the steady-state activities could be classified from the low component of 3-axis acceleration signal and dynamic activities could be distinguished from frequency analysis using wavelet transform and FFT. Finally, we could find that this system can be applied to acquire and analyze the static and dynamic physical activity data.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.4
• /
• pp.286-292
• /
• 2006

This paper presents the design of a low-voltage wide-band switched-capacitor (SC) filter for wireless communication receiver applications. The filter is the 5th-order Elliptic lowpass filter. With the clock frequency of 50MHz implying that an effective sampling frequency is 100MHz with double sampling scheme, the cut-off frequency of the filter is programmable to be 1.25MHz, 2.5MHz, 5MHz and 10MHz. For low-power systems powered by a single-cell battery, the SC filter was elaborately designed to operate at 1.2V power supply. Simulation result shows that the 3rd-order input intercept point (IIP3) can be up to 27dBm. The filter was fabricated in a $0.25-{\mu}m$ 1P5M standard CMOS technology and measured frequency responses show good agreement with the simulation ones. The current consumption is 34mA at a 1.2V power supply.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.25 no.11
• /
• pp.1527-1534
• /
• 2001

Phase averaged velocity fields in the near wake region behind a square cylinder have been (successfully) obtained using randomly sampled PIV data sets. The Reynolds number based on the flow velocity and the vertex height was 3,900. To identify the phase information, we examined the magnitude of circulation and the center of peak vorticity. The center of vorticity was estimated from lowpass filtered vorticity contours (LES decomposition) adopting a sub-pixel searching algirithm. Due to the sinusoidal nature of firculation which is closely related to the instantaneous vorticity, the location of peak voticity fits well with a sine curve of the circulation magnitude. Conditionally-averaged velocity fields represent the barman vortex shedding phenomenon very well within 5 degrees phase uncertainty. The oscillating nature of the separated shear layer and the separation bubble at the top surface are clearly observed. With the hot-wire measurements of Strouhal frequency, we found thats the convection velocity changes its magnitude very rapidly from 25 to 75 percent of the free stream velocity along the streamwise direction when the flow passes by the recirculation region.

• Journal of Advanced Navigation Technology
• /
• v.16 no.2
• /
• pp.227-233
• /
• 2012

This paper presents a bandpass fitler of GPS and WLAN band based on LTCC. The structure of bandpass fitler consists of a Butterworth lowpass fitler and highpass filter using CRLH (Composite Right/Left-Handed) transmission line. Using green sheet with dielectric constant 7.2, we fabricated the bandpass filter that satisfied GPS and WLAN band characteristics. We are implemented the bandpass filter at center frequency 1.5 GHz (GPS) and 2.4 GHz (WLAN). Its insertion loss are 1.66 dB at GPS and 3.20 dB at WLAN respectively.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2001.05a
• /
• pp.759-761
• /
• 2001

한반도 동해의 외해역(울릉도) 및 내해역에서(포항 및 묵호)의 조사된 T/P 해면자료와 TG해면자료간의 상관성이 각각 어떻게 나타나는가를 파악하기 위하여 본 연구를 수행하였다. 이때의 1992년 10월부터 1997년 12월까지 관측된 T/P자료와 TG자료를 각각 이용하였다. 본 연구로부터 우리는 다음과 같은 몇 가지 결과를 알 수 있었다. 1) 비교적 조석의 영향이 우세한 내해역에 위치한 포항 및 묵호가 외해역에 위치한 울릉도에 비해서 낮은 상관성을 보였다. 이러한 큰 차이는 M2, S2, Kl 분조 등에 의한 조석변형 때문에 발생하는 현상이다. 이것은 주로 T/P자료에 기인하는 조석오차이다. 2) 조석변형 때문에 발생하는 신호는 해양신호와 관계없는 잘못된 거짓신호로서 이를 제거하기 위해서는 lowpass filter를 적용하는 것이 좋다. 대체로 외해역의 경우는 60일, 120일, 180일, 200일의 필터를 순차적으로 처리함에 따라 상호 두 자료간의 유의성이 점차적으로 개선되는 것을 알 수 있었으나, 내해역의 경우에는 거의 유의성이 개선되지 않는 것으로 나타났다. 3) 200일의 필터를 처리했을 때, 외해역에 위치한 울릉도는 상관값이 0.91로 매우 높은 유의성을 보였고, 그리고 내해역에 위치한 포항 및 묵호는 각각 0.58 및 0.65로서 울릉도에 비해서 상대적으로 낮은 유의성을 보였다.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.24 no.7
• /
• pp.525-536
• /
• 2014

In this paper, GUI program for microspeaker system simulation program was developed and verified through closed box, vent box and 6th order bandpass enclosure system. By using the pseudo loudspeaker model concept, TS parameters and rear volume of microspeaker were identified. Their suitabilities were proved by comparing test results with simulations of electrical impedance and sound pressure response curves for the three box types; closed box, vent box and 6th order bandpass box. Also, MSSP was found to be effective regardless of the microspeaker's shape, either circular or rectangular shape. MSSP can be used for the microspeaker system simulation, and can give a general prediction of such as; sound pressure level curve, electrical impedance, diaphragm velocity and displacement curve according to multiple design parameters; diaphragm mass, compliance, force factor, front and rear volume, front and rear port's diameter and length.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.24 no.7
• /
• pp.537-548
• /
• 2014

In this paper, horn loudspeaker modeling was suggested, investigated and verified through comparison of test results and simulation ones based on input electrical impedance curves and acoustic sensitivity ones. First, Thiele Small parameters of horn driver were identified by using pseudo loudspeaker model concept and verified in case of both closed and open horndriver. Second, cone-shaped horn models were investigated and compared with input acoustic impedance curves for real horn(cone angle $6.6^{\circ}$) and short horn(cone angle $27.9^{\circ}$). It showed that Leach model for cone horn was well described to test results, which were electrical impedance and acoustic sensitivity, compared to Lemaitre one. To represent horn system model good approximation in wide frequency range, mass correction filter and lowpass filter were adopted and consequently showed good fitted to test results.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.3
• /
• pp.539-557
• /
• 2013

A novel multifocus image fusion algorithm based on NSCT is proposed in this paper. In order to not only attain the image focusing properties and more visual information in the fused image, but also sensitive to the human visual perception, a local multidirection variance (LEOV) fusion rule is proposed for lowpass subband coefficient. In order to introduce more visual saliency, a modified local contrast is defined. In addition, according to the feature of distribution of highpass subband coefficients, a direction vector is proposed to constrain the modified local contrast and construct the new fusion rule for highpass subband coefficients selection The NSCT is a flexible multiscale, multidirection, and shift-invariant tool for image decomposition, which can be implemented via the atrous algorithm. The proposed fusion algorithm based on NSCT not only can prevent artifacts and erroneous from introducing into the fused image, but also can eliminate 'block effect' and 'frequency aliasing' phenomenon. Experimental results show that the proposed method achieved better fusion results than wavelet-based and CT-based fusion method in contrast and clarity.

• Journal of Biosystems Engineering
• /
• v.16 no.3
• /
• pp.272-280
• /
• 1991

The aims of this study were to investigate the feasivility of analyzing a few sorting factors such as size, coloration and defect of apples with a monochrome image processing system and to find apparent properties which could be effectively used for apple sorting. The results are summarized as follows. 1. A computer program was made to analyze the projection area, coloration and defect of an apple with a monochrome image processing system. 2. The algorithm developed to compute the projedtion area of an apple was between on the proportional relation between a given reference area and the corresponding number of pixels, and the computing time was 0.74 to 0.82 second depending on the size of apple. 3. The coloration of an apple was expressed as the ratio of the gray value of a reference color to that of a given bounded area of the stem end surface (defined as coloration index), and the computing time was about 3.0 seconds with this algorithm. 4. Defect of an apple could be isolated by lowpass filtering and image subtraction but it took about 20 seconds in computing time. 5. The coloration of the Fuji apple could be classified into 3 to 4 groups by the coloration index and also, it was found that the correlation coefficient between the indices and sugar contents was 0.74. 6. The coloration index obtained from a given bounded area of the stem end side of the Fuji apple could represent the coloration of total surface with a correlation coefficient of 0.922.