• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.5
• /
• pp.453-460
• /
• 2013

The surface roughness and heat transfer enhancement devices are known to increase the performance of a flat plate soar collector. This study includes the experiments on the effect of the several heat transfer enhancement devices inserted in duct to simulate the flat-plate solar collector. Experiment was basically at a constant heat flux on the upper duct wall. Inserted heat transfer enhancement devices are Chamfered rib $10^{\circ}$, Chamfered rib $20^{\circ}$, Rib & Groove and Rib & Dimple. Reynolds number is in the range of 2,300 to 22,000 which corresponds to turbulent regime. With the heat transfer enhancement devices, heat transfer would increase by the secondary flow and the increase of the heat transfer area. Pressure drop also increases with the insertion of the enhancement devices. Rib & Dimple model is the best in heat transfer enhancement, however, Chamfered rib $10^{\circ}$ model is the lowest in the pressure drop. Considering the heat transfer enhancement simultaneously with low pressure drop increase, performance factor was the best for the Chamfered rib $10^{\circ}$.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.39 no.11
• /
• pp.1175-1181
• /
• 2015

A heat insulating material used in the industrial site normally derives its heat insulating performance by using a low thermal conductivity material such as glass fiber. In case of the metal insulation for nuclear power plant, in contrast, only TP 304 stainless steel foil having high thermal conductivity is the only acceptable material. So, it is required to approach in structural aspect to ensure the insulation performance. In this study, the design factors related to the metal insulation internal structure were determined considering the three modes of heat transfer, i.e., conduction, convection, and radiation. The analysis of heat flow was used to understand the ratio of the heat transfer from each factor to the overall heat transfer from all the factors. Based on this study, in order to minimize the convection phenomenon caused by the internal insulation, a multiple foil was inserted in the insulation. The increase in the conduction heat transfer rate was compared, and the insulation performance under the three modes of heat transfer was analyzed in order to determine the internal geometry.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.2 no.3
• /
• pp.99-106
• /
• 1998

The performance of the turbofan engine, a medium scale civil aircraft which has been developing in Rep. of Korea, was analyzed and the control scheme for optimization the performance was studied. The dynamic and real-time linear simulation was performed in the previous study The result was that the fuel scedule of the step increase overshoot the limit temperature(3105 $^{\cire}R$) of the high pressure turbine and got small surge margine of the high pressure compressor. Therefore a control scheme such as the LQR(Linear Quadratic Regulator) was applied to optimizing the performance in this studies. The linear model was expected for designing controller and the real time linear model was developed to be closed to nonlinear simulation results. The system matrices were derived from sampling operating points in the scheduled range and then the least square method was applied to the interpolation between these sampling points, where each element of matrices was a function of the rotor speed. The control variables were the fuel flow and the low pressure compressor bleed air. The controlled linear model eliminated the inlet temperature overshoot of the high pressure turbine and obtained maximum surge margins within 0.55. The SFC was stabilized in the range of 0.355 to 0.43.

• Elastomers and Composites
• /
• v.46 no.1
• /
• pp.45-53
• /
• 2011

The effect of the silane coupling agent, bis(triethoxysilypropyl)tetrasulfide (TESPT), on mechanical properties of a silica-filled NBR compound for oilseal was investigated. Curing behavior and crosslinking density of the compounds were measured using ODR (oscillating disk rheometer) and swelling ratio in toluene. UTM (universal testing machine) and shore A hardness tester were used in order to study the characteristics of mechanical properties of original vulcanizates and aged ones with heated air and ASTM No. 3. oil. Recovery of elasticity which influences the performance and service life of oilseal was investigated by giving bending deformation to vulcanizates in aging condition. After bending aging test, recovery distance was measured and calculated angle of recovery from it. TR (temperature retraction) test was performed on these vulcanizates to determine the low temperature recovery behavior. Wear resistance was measured by Taber type abrasion tester. In addition, SEM was used to characterize the morphology of the worn surface of vulcanizates. The result showed that addition of TESPT into silica-filled compound improves not only compound flow-ability, interaction between NBR and silica and crosslinking density, but also hardness, 100% modulus, recovery of elasticity, wear resistance, heat resistance and ASTM No.3 oil resistance of vulcanizates.

• Plant Journal
• /
• v.14 no.3
• /
• pp.29-34
• /
• 2018

In this study, the output and thermal efficiency of Taean Integrated Gasification Combined Cycle Plant were calculated by using the manufacturer's basic design data and the performance correction factor for each atmospheric temperature, and the actual performance was measured at summer and winter representative points. The results were compared with the calculated values to verify their validity. The thermal efficiency is the highest at around $15^{\circ}C$ and lower at lower temperature and higher temperature. This is similar to that of natural gas Combined Cycle Power Plant, but the thermal efficiency has drastically decreased due to the increase of power consumption of the air separation unit at relatively high temperature. The output is highest in the range of 5 to $15^{\circ}C$, and is kept almost constant at below $5^{\circ}C$ and declines above $15^{\circ}C$. The reason why the output does not increase at low temperatures is that the torque limit of the shaft is activated by the increase of the flow rate due to the nitrogen injection of the gas turbine combustor. In order to improve the performance in the future, efforts should be made to improve the power generation output and to reduce the power consumption of the air separation unit in summer.

• Archives of Pharmacal Research
• /
• v.28 no.8
• /
• pp.948-955
• /
• 2005

Glomerular mesangial cells (GMCs) in diverse renal diseases undergo cell proliferation and/or hypertrophy, and gangliosides have been reported to play an important role in modulating cell structure and function. This study compared the effects of transforming growth $factor-\beta\; (TGF­\beta1)$ and the effects of the application of exogenous gangliosides on GMCs and investigated whether the application of exogenous gangliosides regulated cellular proliferation and hypertrophy. Human GMCs were cultured with exogenous gangliosides and $TGF-\beta1$ in a media containing $10\%$ fetal bovine serum and in a media without the fetal bovine serum. Exogenous gangliosides biphasically changed the proliferation of human GMCs (0.1-1.0 mg/mL). A low concentration (0.1 mg/mL) of gangliosides mainly increased the number of human GMCs, whereas cellular proliferation was significantly reduced by raising the concentration of exogenous gangliosides. $TGF-\beta1$ greatly reduced the number of human GMCs in a concentration­dependent manner (1-10 ng/mL). Serum deprivation accelerated the gangliosides- and $TGF­\beta1-induced$ inhibition of mesangial cell proliferation to a greater extent. Gangliosides (1.0 mg/ mL) and $TGF-\beta1$ (10 ng/mL) both caused a significant increase in the incorporation of $[^3H]leucine$ per cell in the serum-deprived condition, whereas it was completely reversed in serum­supplemented condition. Similar results to the $[^3H]leucine$ incorporation were also observed in the changes in cell size measured by flow cytometric analysis. These results show that exogenous gangliosides modulate cell proliferation and hypertrophy in cultured human GMCs, and these cellular responses were regulated differently based on whether the media contained serum or not. Results from the present study raise new possibilities about the potential involvement of gangliosides in the development of mesangial cell proliferation and hypertrophy.

• Korean Journal of Environment and Ecology
• /
• v.32 no.3
• /
• pp.274-288
• /
• 2018

This study investigated the environmental factors and fish assemblage in 42 wetlands between spring and autumn of 2017 to evaluate the fish distribution and deduce the management strategy for improving biodiversity in created wetlands located at the Nakdong River basin. The investigation identified a total of 30 fish species and found that the most of wetlands were dominated by exotic fishes such as Micropterus salmoides and Lepomis macrochirus. Fish species such as Rhinogobius brunneus, Opsariichthys uncirostris amurensis, Zacco platypus were less abundant in the area with high density of Micropterus salmoides (static area) because they preferred the environment with active water flow. The pattern analysis of fish distribution in each wetland using the self-organizing map (SOM) showed a total of 24 variables (14 fish species and 10 environmental variables). The comparison of variables indicated that the distribution of fish species varied according to water depth and plant cover rate and was less affected by water temperature, pH, and dissolved oxygen. The plant cover rate was strongly associated with high fish density and species diversity. However, wetlands with low plant biomass had diversity and density of fish species. The results showed that the microhabitat structure, created by macrophytes, was an important factor in determining the diversity and abundance of fish communities because the different species compositions of macrophytes supported diverse fish species in these habitats. Based on the results of this study, we conclude that macrophytes are the key components of lentic freshwater ecosystem heterogeneity, and the inclusion of diverse plant species in wetland construction or restoration schemes will result in ecologically healthy food webs.

• Journal of Aquaculture
• /
• v.21 no.1
• /
• pp.1-6
• /
• 2008

We determined the effects of dietary supplements for lactic acid bacteria(LAB) such as Lactobacillus brevis(Lb) and Lactobacillus plantarum(Lp) in juvenile rockfish Sebastes schlegeli cultured in flow-through system for 10 weeks. The experimental diets contained $10^4cfu/g,\;10^6cfu/g\;and\;10^8cfu/g$ level each LAB(Lb-4, Lb-6, Lb-8 or Lp-4, Lp-6, Lp-8), respectively. The effects of LAB supplementation was determined by various factor such as weight gain(WG), specific growth rate(SGR), feeding efficiency(FE) and blood assay. For rearing experiment, Lp-8 treatment had significantly high growth rate than control diet treatment. However, all Lb treatment had no significance effect with control diet treatment. In case of the blood assay, hematocrit(Ht) and hemoglobin(Hb) of fish were not affected by LAB supplemental levels. On the other hand, total cholesterol in plasma of Lb-8, Lp-6 and Lp-8 treatments were significantly low than the control diet treatment. We verified the influence of LAB which was originated from species specificity and amount in diet. Consequently, the dietary supplementation as $10^8cfu/g$ level of L. plantarum could be of help for growth enhancement to the juvenile rockfish.

• The Korean Journal of Mycology
• /
• v.34 no.1
• /
• pp.1-6
• /
• 2006

In order to select a suitable bioreactor type for the submerged cultivation of Ganoderma applanatum, both growth characteristics and polysaccharides production were compared among four different types of bioreactor. These include an external-loop type air-lift bioreactor (ETAB), a balloon type air bubble bioreactor (BTBB), a column type air bubble bioreactor (CTBB) and a stirrer type bioreactor (STB). The mycelial biomass produced from the reactors were in decreasing order: ETAB ($7\;g/{\ell}$) > BTBB ($6.2\;g/{\ell}$) > STB ($6\;g/{\ell}$) > CTBB ($5\;g/{\ell}$). Maximal soluble exopolysaccharides ($1\;g/{\ell}$) and endopolysaccharides (2.7%) were also obtained from ETAB. Thus, the ETAB was most suitable for submerged culture of G applanatum mycelium. Based on the results, ETAB was chosen for further detailed study. The most effective aeration rate for the mycelial growth in ETAB ranged from 0.05 to 0.1 vvm. For the maximal production, the mycelium at the initial growth stage needed low aeration rate to reduce cell damages by fluid flow. However, as the mycelia grew, the culture became viscous and thus needed higher aeration. The molecular weight of exopolysaccharides obtained from the culture grown in ETAB was higher than that from the culture grown in other bioreactors.

• Journal of Fisheries and Marine Sciences Education
• /
• v.18 no.3
• /
• pp.293-301
• /
• 2006

This study was undertaken to prolonging the freshness in Squid(Todarodes pacificus) on the effects of ice storage methods(tap water ice, electrolytic water ice) using stainless diaphragm electrolytic instrument and also test an efficiency of instrument. Basically, stainless diaphragm electrolytic instrument studied for changes of pH on difference water flow and ampere. The lower water flower and higher ampere made low pH on acid part of electrolytic instrument. Squid samples were stored in tap water ice, acid part of electrolytic water and base part of electrolytic water and used in studying the changes of VBN and skin color through storage. Acid water had strong sterilization effects and VBN was lower levels of acid water than the others. Base water had not sterilization effects. Tap water ice storage was more sterilizing effects than base water ice storage but less effects than acid water ice storage. Lightness of Squid skin showed getting decrease at storage of ice water of all storage methods but acid water ice storage showed more retarding than the other two storage. From these results, it could be suggested that acid electric water ice storage is effective in extendance the shelf-life of squid at chilled storage.