• Resources Recycling
• /
• v.31 no.5
• /
• pp.42-51
• /
• 2022

Aggregate resources in Korea are expected to run out owing to an increase in development demand and construction investment. Recycled concrete aggregates (RCA), extracted from waste concrete, have a lower quality than natural aggregates. However, RCA can produce concrete similar in quality to the normal concrete by aggregate pretreatment, use of admixtures, and quality control. RCA are most suitable for use in precast concrete products such as sidewalk blocks and revetment blocks. Herein, the feasibility of producing revetment blocks using recycled aggregate concrete (RAC), similar in quality to normal concrete, was analyzed. The amount of RCA was varied, and moderate high early strength cement and steam curing were used to produce the concrete test blocks. In the block test, the load resistance characteristics of the blocks were evaluated to determine optimal RAC and glass fiber reinforced polymer (GFRP) rebar compositions. Thus, the variable that reduced the cement content was determined at the same level as that of natural aggregate concrete by the control of steam curing. In the concrete block test, although this depends on the reinforcement ratio, the RAC block exhibited the same or better performance than a normal concrete block. Therefore, the low quality of RCA in RAC is no longer a problem when concrete mixing and curing are controlled and appropriate reinforcement is used.

• Nuclear Engineering and Technology
• /
• v.26 no.1
• /
• pp.54-62
• /
• 1994

The hydraulic properties of domestic natural clay/crushed rock mixture suggested as a candidate backfill material for the low and intermediate level waste repository were investigated. The dry density-water content relationship was studied to define an optimum water content that gives a maximum attainable dry density at constant compaction pressure. The hydraulic conductivities of clay/crushed rock mixture as a function of clay content were also measured. As the clay content decreased, the maximum attainable dry density increased and the optimum water content became more distinct. However the attainable density is not significantly sensitive to water content. The hydraulic conductivities of the mixture increased from 5 $\times$ 10$^{-12}$ m/s to 7 $\times$ 10$^{-10}$ m/s with clay content decreasing from 100 wt.% to 25 wt.% at dry density of 1.2 Mg/㎥. In case of dry density of 1.5 Mg/㎥, they maintain the lower values of 5 $\times$ 10$^{-12}$ m/s even at 25 wt.% clay content. The concept of effective clay dry density was suggested to estimate the hydraulic conductivity of the mixture. It was shown that the effective clay dry density concept can explain welt the hydraulic conductivities of the mixtures with various dry density and crushed rock content.

• Tunnel and Underground Space
• /
• v.31 no.4
• /
• pp.243-269
• /
• 2021

Since the early 2010s, the social importance of research and practical projects targeting deep geological disposal of high-level nuclear waste, underground CO₂ storage and characterization of deep subsurface by borehole investigation has been increasing. In this regard, there is also a significant increase in the need for in situ test technology to obtain quantitative and reliable information on the hydraulic characteristics of deep rock mass. Through years of research and development, we have independently set up Deep borehole Hydraulic Test System (DHTS) based on the key apparatuses designed and made with our own technology. Using this system, high precision constant pressure injection tests were successfully completed at the two 1 km boreholes located in Mesozoic granite and sedimentary rock regions, Gyeongju. During the field tests, it was possible to measure very low flow rate below 0.01 l/min with micro flow rate injection/control module. In this paper, the major characteristics of DHTS are introduced and also some results obtained from the high precision field tests under the deep and low permeable rock mass environment are briefly discussed.

• Journal of the Korean Ceramic Society
• /
• v.53 no.1
• /
• pp.116-121
• /
• 2016

The amount of carbon dioxide ($CO_2$) released while producing building materials is substantial and has been targeted as a leading contributor to global climate change. One of the most typical methods of reducing $CO_2$ in building materials is the addition of slag and fly ash, like pozzolan material another method is to reduce $CO_2$ production by developing carbon negative cement. MgO-based cement from the low-temperature calcination of magnesite required less energy and emitted less $CO_2$ than the manufacturing of Portland cements. It is also believed that adding reactive MgO to Portland-pozzolan cements can improve their performance and also increase their capacity to absorb atmospheric $CO_2$. In this study, basic research on magnesia cement using $MgCO_3$ and magnesium silicate ore (serpentine) as the main starting materials, as well as blast furnace slag for the mineral admixture, was carried out for industrial waste material recycling. In order to increase the overall hydration activity, $MgCl_2$ was also added. In the case of the addition of $MgCl_2$as accelerating admixture, there was a promoting effect on the compressive strength. This was found to be due to the production of needle-like dense Mg-Cl hydrates. Mgnesia cement has a high viscosity due to its high specific surface area therefore, when the PC-based dispersing agent was added at a level of more than 1.0%, it had the effect of improving fluidity. In particular, the addition of $MgCl_2$ in magnesia cement using $MgCO_3$and magnesium silicate ore (serpentine) as main starting materials led to a lower expansion ratio and an increase in the freeze-thaw resistance finally, the addition of $MgCl_2$ as accelerating admixture led to good overall durability.

• Journal of the Korean Institute of Landscape Architecture
• /
• v.38 no.5_2
• /
• pp.186-193
• /
• 2010

The purpose of this study was to survey the citizens for their satisfaction with the outdoor landscape lighting in Gyeongju Historic Areas registered as UNESCO World Cultural Heritage in November 2000 and thereupon, provide for some basic data useful to the design of the outdoor landscape lighting for the cultural properties. As a result of examining the conditions of the outdoor landscape lighting in Wolseong Zone of Anapji, Banwolseong, Dongbu Sajeokji, Cheomseongdae and Gyerim, there were found 391 lighting fixtures of 12 types in Anapji, 138 lightings of 4 types in Banwolseong, 38 lightings of 6 types in Cheomseongdae, 28 lightings of 3 types in Dongbu Sajeokji and 54 lightings of 5 types in Gyerim. As a result of analyzing citizens' satisfaction with the outdoor landscape lighting, it was found that citizens were satisfied more or less with the nightscape image changed by the outdoor landscape lighting; their satisfaction scored 3.836 on average for Anapji on a 5-point Likert type scale, 3.516 for Banwolseong, 3.446 for Dongbu Sajeokji, 3.650 for Cheomseongdae and 3.479 for Gyerim. However, citizens' satisfaction with the originality of the nightscape was generally low: 3.055 for Anapji, 2.914 for Cheomseongdae, 2.877 for Banwolseong, 2.847 for Gyerim and 2.665 for Dongbu Sajeokji. On the other hand, since most of the lighting fixtures were installed as inserted lights or floodlights, the color tones of light source were relatively highly distinctive, but the peripheral spaces around the cultural properties were rather dark, which means that citizens were feeling inconvenient more or less for using the amenities such as bench or waste box. All in all, their satisfaction with the outdoor landscape at the sample zone at night scored 2.981, lower than the normal level.

• Journal of environmental and Sanitary engineering
• /
• v.16 no.4
• /
• pp.77-89
• /
• 2001

The research is intended to evaluate the soil pollution quality of Chungbuk province with Soil Network which is executed every year. The survey executed with Soil Network in 1999 represented that the soil quality of Chungbuk province was relatively good as the average concentrations of contaminants in soil were Cd: 0.146 mg/17g, Cu: 3.143 mgHg, As: 0.636 mg/kg, Hg: 0.012 mg/kg, Pb): 4.505 mg/kg, $Cr^{+6}$ not detected, and the average pH was 6.1. The reckoned soil Pollution score (SPS) of Chungbuk province has been shown much low SPS distribution in the range from 1.6 to 141.7, average 31.0. However, it has been represented relatively high SPS distribution at Chungju, Tanyang, and Chinchon, respectively, It also huts represented high SPS distribution not only at agricultural area and waste area for the Pollution sources but at a paddy field and dry field for land use. The classification of soil pollution class(SPC) based on soil pollution score(SPS) was SPC 1 under 100 of SPS at 212 areas which were 98.6% of total 215 areas and SPC 2 over 100 of SPS at only three area left. There was no area exceeding soil pollution value among the whole Soil Network areas investigated, and the whole average for each items was much lower level th퍼n soil Pollution value was. When the average concentration of heavy metals and the average pH in soil of Chungbuk province are compared with the natural contents of that in Korea, the research is concluded that the average concentration of heavy met is relatively similar to the natural contents of that and the average pH in soil of Chungbuk province is a little higher than the natural contents of that. From this method, soil quality of most of the Soil Network area was estimated to be healthy.

• Journal of Energy Engineering
• /
• v.15 no.3 s.47
• /
• pp.146-153
• /
• 2006

A performance test of the stainless steel based sintered metal filter was conducted on the low and intermediate level radioactive waste (LILW) vitrification process. The applicability of the metal filter was based on the test results as well. The baseline pressure drop of the metal filter was evaluated similar to the ceramic filter. During the test, when the flow rate of off-gas was $110Nm^{3}/h$, the total baseline pressure drop was shown as $92mmH_{2}O$. The total pressure drop was attributed to the filter media and the residual dust layer and the value of each was $25mmH_{2}O\;and\;67mmH_{2}O$ respectively. The SEM-EDS spectrum and micrograph of the metal filter specimen showed, no corrosion and no physical damage both at the skin membrane and at the support layer. And most of the baseline pressure drop was caused by the deposition of dust on the surface of the membrane. In conclusion, even though the filter exposure time was short at the test, the performance of the stainless steel based metal filter was acceptable for the treatment of LILW vitrification process.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.46 no.5
• /
• pp.626-637
• /
• 2013

We measured the grain size, ignition loss (IL), chemical oxygen demand (COD), acid volatile sulfide (AVS) and trace metals (Al, Fe, Cu, Pb, Zn, Cd, Cr, Mn, Hg, and As) of intertidal surface sediment collected from 11 islands (62 stations) in the southern region of Jeollanam Province. The objective of this research was to evaluate the organic matter and trace metals contaminations of sediments from coastal island tidal flats. Surface sediment texture was characterized as follows: mud, sandy silt, muddy sand, and slightly gravelly sand facies. The finer sediments are mainly dominated in the northern part of each island. The concentrations of IL, COD, AVS and some trace metals (Al, Fe, Zn, Cr, Cu, and Hg) were higher in the northwestern part of Wan Island and the area between Gogeum and Sinji Islands, and were associated with relatively finer sediment, as compared to other locations. The concentrations of Mn, Pb, Cd, and As were higher in the northwestern and southeastern parts of Geoguem and Pyungil Islands, but were not correlated with mean grain size. Based on sediment quality guidelines (SQGs), the concentrations of trace metals were lower than the values of effect range low (ERL), used in United States, and threshold effects level (TEL), used in Korea, with exception of As. Similarly, the intertidal sediments were moderately contaminated with As, based on the the enrichment factor (EF) and the geoaccumulation index ($I_{geo}$). The high concentration of As in intertidal sediments from this study region may be due to the input of naturally or artificially contaminated submarine groundwater, contaminated waste from seaweed aquaculture operations and/or land-based seaweed processing facilities. Further studies are needed to identify the sources of As in this study region, and to determine the effects of As contamination on coastal ecosystem.

• Journal of Animal Environmental Science
• /
• v.8 no.2
• /
• pp.87-98
• /
• 2002

This study was conducted to determine nutritional values of different sources of food residues(FR) released in autumn and to compare them with nutrient requirements on NRC standard feeding system of swine. Hospital or cafeteria FR contained more cooked rice and side dishes residues and less vegetable residues and fruit peel, resulting in higher energy and lower fiber contents, compared to apartment complex FR, which had opposite patterns to these results. Chemical composition between hospital and cafeteria FR was almost similar. Salt(NaCl) content was more than 9 folds of NRC swine requirement, but much lower than the maximum tolerant level. Essenial and non-essential amino acids profile was similar among FR sources. Hospital or cafeteria FR protein had a similar pepsin digestibility to soybean meal protein. Apartment complex FR protein, however, had a much lower pepsin digestibility. When NRC nutrient requirements are considered, FR in swine diets could satisfy requirements of protein and all the essential amino acids, 75${\sim}$111% of digestible or metabolizable energy, and most of the major and minor minerals. All the FR contained extremely low levels of toxic heavy metals, indicating that they are completely safe from these toxic substances. It was concluded that hospital or cafeteria FR could be a nutritionally excellent and balanced feed source for swine.

• Korean Institute of Interior Design Journal
• /
• v.25 no.4
• /
• pp.68-79
• /
• 2016

The purpose of this study is to provide a reference for stage space planning in modern theaters by analyzing and understanding stage components in terms of spatial composition, purposes, and correlation between them, and collecting various opinions from stage managers an directors. The findings are as follow: the determination of the size of proscenium arch is crucial, and it needs to be considered not only with the genre of the performance and the number of seats, but also with the size of the stage facility. The two-dimensional size of proscenium arch affects the scale of stage area in three-dimensional way; the size of main stage comes from the width of the arch, and the length of set battens comes from the stage width, and so on. The height of the arch affects the elevation of gridiron, and the height of the building itself ultimately. The number and length of the set battens are directly linked to the size of the winch room, and so is the number of the winches to the Mcc panel room. The 1st level gallery supplying power to lighting equipment needs to be wide enough for staffs to work with various equipments effectively and safely. Degree of practical usage of under-stage machinery turned out to be very low. In order to cut unnecessary waste and cost, the characteristics of the theater must get set first, and experts who know how stage works need to get involved in planning stage.