• Journal of the Korean Institute of Telematics and Electronics
• /
• v.19 no.1
• /
• pp.14-19
• /
• 1982

A differential amplifier has been designed and fabricated using aluminum-gate PMOS technology, Only enhaneement-mode MOSFET's are used in the circuit and the dimensions of transistors have been determined using simulation program MSINC. The fabricated integrated circuit with +15V and -l5V power supplies shows an open-loop DC voltage gain of 42 dB, a common mode rejection ratio (CMRR) of 50 dB, and a Power consumption of 20mW.

• The Journal of Engineering Research
• /
• v.3 no.1
• /
• pp.171-180
• /
• 1998

The low cost fiber ring laser can be tuned by controlling polarization states within the loop. In this paper, we investigate its operating principle and verify the performance through an experiment. This ring laser consists of a polarization controller and an intracavity polarizer for the wavelength tuner and semiconductor optical amplifier for the gain medium. It is seen that the lasing wavelength may be tuned through the range of 1540~1560 nm as a polarization controller and a polarizer are adjusted.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2003.11a
• /
• pp.389-393
• /
• 2003

This paper describes the design of enhanced TSSI RF Power Detector which has wide dynamic range using switch and Log amp. This Power Detector consists of low and high gain loops, and they adaptively switched by output DC voltage which is proportioned to input power level. Because Power Detector needs to separate the channel, so architecture is heterodyne system having 70MHz intermediate frequency. This proposed RF Power Detector is settle to the satisfaction of Closed loop power control system for W-CDMA optic repeater, and the obtained dynamic range cover the higher than 50dB.

• Proceedings of the KIEE Conference
• /
• 2006.04a
• /
• pp.93-95
• /
• 2006

In many control system applications, the system designed must not only satisfy the damping and accuracy specifications, but the control must also yield performance that is robust to external disturbance and parameter variations. We have shown that feedback in conventional control systems has the inherent ability of reducing the effects of external disturbance and parameter variations. Unfortunately, robustness with the conventional feedback configuration is achieved only with a high loop gain, which is normally detrimental to stability. The design of intelligent, autonomous machines to perform tasks that are dull, repetitive, hazardous, or that require skill, strength, or dexterity beyond the capability of humans is the ultimate goal of robotics research. This paper prove the robust control using Analog Adaptive Resonance Theorv(ART2) Algorithm about case study.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.56 no.12
• /
• pp.2240-2246
• /
• 2007

Optically coupled linear isolation amplifier requires special care to avoid oscillation in actual applications. In this paper methods to analyze the frequency characteristics of the amplifier are proposed to reveal the cause of oscillation and to provide design guidelines. The loop gain of the amplifier obtained through the equivalent circuit model shows that the phase margin is too small to ensure stable operations. Methods to get non-oscillatory response are proposed and the resulting frequency responses are analyzed. The common method adding a small capacitor to the amplifier is shown to degrade the frequency bandwidth. The frequency response of output voltage explains the need of filter capacitor in output stage. The usefulness of the method is verified through experiments.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1775-1776
• /
• 2008

This paper presents a adaptive fuzzy control suitable for motion control of multi-link robot manipulators with uncertainties. When joint velocities are available, full state adaptive fuzzy feedback control is designed to ensure the stability of the closed loop dynamic. If the joint velocities are not measurable, an observer is introduced and an adaptive output feedback control is designed based on the estimated velocities. To reduce the number of fuzzy rules of the fuzzy controller, we consider the properties of robot dynamics and the decomposition of the unknown input gain matrix. The proposed controller is robust against uncertainties and external disturbances. The validity of the control scheme is demonstrated by computer simulations on a two-link robot manipulator.

• Proceedings of the KIEE Conference
• /
• 2015.07a
• /
• pp.177-178
• /
• 2015

This paper proposes a power smoothing scheme of a doubly-fed induction generator. The proposed scheme aims to mitigate system frequency deviation caused by the variable wind. To achieve this, a dynamic droop loop is used and its gain changes with rate of change of frequency so that it can release a large amount of kinetic energy at the initial stage of a frequency event. The performance of the proposed scheme was investigated in a model system with high wind penetration using EMTP-RV simulator. The test results indicate that the scheme can smooth the output power by absorbing or releasing the output power under a varying wind condition.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.7 no.5
• /
• pp.465-471
• /
• 2002

This paper presents a novel PID speed controller for industry servo applications. Considering the speed loop delay, it allows an automatic controller bandwidth/gain setup with the bandwidth of current controller. In addition, the proposed design nile gives uniformly satisfactory performance and the motor speed stays on a desired response curve with minimal oscillation and settling time. This approach can be applied in conjunction with the cascaded position controller which is widely used in practice.

• Proceedings of the KIPE Conference
• /
• 2002.07a
• /
• pp.360-363
• /
• 2002

In the resonant converters which can provide high efficiency and high power density, the resonant voltage stress is about $4\~5$ times the input voltage. It needs the power switch with high ratings. This is a reason why the conduction loss is increased. In this paper, it proposes the alternately zero voltage switched forward, flyback multi resonant converter topology for reducing the voltage stress using alternately zero voltage switching technique. And the proposed AT forward MRC Is experimentally considered about the loop gain with HP4194A network analyzer

• Proceedings of the KIPE Conference
• /
• 1998.10a
• /
• pp.7-10
• /
• 1998

Because of simple control algorithm and easy implementation, the conventional PI controller has been widely used in industrial application. But, it is very difficult to find the optimal PI control gain. Therefore, in improperly tuned PI controller or parameter variation, to obtain optimal performance, the novel PI controller, which consist of conventional PI controller and 4-rule based fuzzy logic, are presented in this paper. The novel PI controller which exhibits a stabilizing effects on the closed-loop system, has good robustness regarding the improperly tuned PI controller or parameter variation. The simulations are performed to verify the capability of proposed control method on induction motor.