• The Korean Journal of Zoology
• /
• v.11 no.3
• /
• pp.85-91
• /
• 1968

Artificial and natural radioactivity in airborne, rain-out and fallout dusts in Seoul district in the period of 1963-1967 were studied by measuring gross-activity and by analyzing nuclides by means of $\\gamma$-spectrometry. Short-lived radium and thorium decay products give rise to most of the airborne activity unless the fission product concentration is extremely high and it is likely to be said activity remaining after a few days is attributable to fission products. Of seven Chinese nuclear explosions performed at Lop Nor, Sinkiang Province, two exhibited the activity of extremely high concentration of fission product and reached Seoul district around 30 hours after the explosion. The activity was followed by a sudden decrease in less than a week, in contrast to the long-lasted activity of low concentration originating from the huge tests performed by the United States and the USSR in 1956-1962. The radioactive environmental contamination in Seoul district, due to the Chiness nuclear test explosions, largely depends on the height above the earth at which the nuclear explosion is performed and the type of nuclear device as well as the weather system at the time and immediately after the explosion, especially the jet stream in middle latitude in the upper troposphere.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.2
• /
• pp.195-202
• /
• 2018

As a rule, geological disposal is considered a safe method for final disposal of high-level radioactive waste. However, some long-lived fission products like $^{99}Tc$ and $^{129}I$ contained in spent nuclear fuel are highly mobile as less sorbing anionic species in the subsurface environment and can mainly cause exposure dose to the ecosystem by emission of beta rays in the hundreds of keV range. Therefore, if these two nuclides can be separated and converted with high efficiency into radioactively unharmful nuclides, this would have a positive effect on disposal safety. One candidate method is to transmute these two nuclides in nuclear reactors into short-lived nuclides or into stable nuclides. For this purpose, it is necessary to evaluate which reactor type is more efficient in burning these two nuclides. In this study, the simulation results of nuclear transmutation of $^{99}Tc$ and $^{129}I$ in light water reactor (PWR), heavy water reactor (CANDU) and fast neutron reactor (SFR, MET-1000) are compared and discussed.

• Nuclear Engineering and Technology
• /
• v.38 no.6
• /
• pp.459-482
• /
• 2006

A geochemical approach to the long-term safety of waste disposal is discussed in connection with the significance of actinides, which shall deliver the major radioactivity inventory subsequent to the relatively short-term decay of fission products. Every power reactor generates transuranic (TRU) elements: plutonium and minor actinides (Np, Am, Cm), which consist chiefly of long-lived nuclides emitting alpha radiation. The amount of TRU actinides generated in a fuel life period is found to be relatively small (about 1 wt% or less in spent fuel) but their radioactivity persists many hundred thousands years. Geological confinement of waste containing TRU actinides demands, as a result, fundamental knowledge on the geochemical behavior of actinides in the repository environment for a long period of time. Appraisal of the scientific progress in this subject area is the main objective of the present paper. Following the introductory discussion on natural radioactivities, the nuclear fuel cycle is briefly brought up with reference to actinide generation and waste disposal. As the long-term disposal safety concerns inevitably with actinides, the significance of the aquatic actinide chemistry is summarized in two parts: the fundamental properties relevant to their aquatic behavior and the geochemical reactions in nanoscopic scale. The constrained space of writing allows discussion on some examples only, for which topics of the primary concern are selected, e.g. apparent solubility and colloid generation, colloid-facilitated migration, notable speciation of such processes, etc. Discussion is summed up to end with how to make a geochemical approach available for the long-term disposal safety of nuclear waste or for the performance assessment (PA) as known generally.

• Nuclear Engineering and Technology
• /
• v.48 no.2
• /
• pp.304-317
• /
• 2016

An accelerator-driven system consists of a subcritical reactor and a controllable external neutron source. The reactor in an accelerator-driven system can sustain fission reactions in a subcritical state using an external neutron source, which is an intrinsic safety feature of the system. The system can provide efficient transmutations of nuclear wastes such as minor actinides and long-lived fission products and generate electricity. Recently at Kyoto University Research Reactor Institute (KURRI; Kyoto, Japan), a series of reactor physics experiments was conducted with the Kyoto University Critical Assembly and a Cockcrofte-Walton type accelerator, which generates the external neutron source by deuteriu-metritium reactions. In this paper, neutronic analyses of a series of experiments have been re-estimated by using the latest Monte Carlo code and nuclear data libraries. This feasibility study is presented through the comparison of Monte Carlo simulation results with measurements.

• Corrosion Science and Technology
• /
• v.5 no.6
• /
• pp.201-205
• /
• 2006

HYPER(Hybrid Power Extraction Reactor) is the accelerator driven subcritical transmutation system developed by KAERI(Korea Atomic Research Institute). HYPER is designed to transmute long-lived transuranic actinides and fission products such as Tc-99 and I-129. Liquid lead-bismuth eutectic (LBE). Has been a primary candidate for coolant and spallation neutron target due to its appropriate thermal-physical and chemical properties, However, it is very corrosive to the common steels used in nuclear installations at high temperature. This corrosion problem is one of the main factors considered to set the upper limits of temperature and velocity of HYPER system. In this study, a parametric study for a corrosion model was performed. And a preliminary corrosion model was also developed to predict the corrosion rate in isothermal Pb and LBE flow loops.

• Journal of Radiation Protection and Research
• /
• v.8 no.2
• /
• pp.15-35
• /
• 1983

High voltage paper-electrophoresis of fission products from 24 hour neutron-irradiated and 150 days-decayed 90% highly enriched uranyl nitrate solution has been carried out by using the specially designed migration apparatus. The separation of Zr-95 and Nb-95 from the other fission products is possible under the migration condition of 0.1 $M-HClO_4$ (pH=0.85), 0.05 M-HCl+0.09M-KCl (pH=0.9), 0.1M-HCl (pH=1.1) and 0.01 M-HCl (pH=2.0). Zr-95 and Nb-95 are separated out at+1cm from the fiducial point. The separation of Zr-95 and Nb-95 from each other is possible under the migration condition of 0.1 $M-HClO_4$, 0.05 M-HCl+0.09 M-KCl, 0.1 M-HCl and 0.1 M-HAc+0.1 M-NaAc (pH=4.68) together with 2% ammonium oxalate. Nb-95 is separated out at $-6{\sim}-7cm$ from the fiducial point and Zr-95 at $+1{\sim}-lcm$. The separation of Ru-103 from the other fission products is possible under the migration condition of 0.025 $M-Na_2CO_3+0.025\;M-NaHCO_3$ (pH=10.0), 0.01M-$Na_3PO_4$ (pH=11.7) and 0.1 M-NaOH (pH=13.2). Ru-103 migrates towards the anode -6cm, -4cm and -3cm, respectively.

• Journal of Radiation Protection and Research
• /
• v.10 no.1
• /
• pp.3-13
• /
• 1985

The sorption behavior of some typical fission products such as Cs-137, long-lived radionuclide; Ce-144, rare-earth element; and Co-60, corrosion product on zeolite A, zeolite F-9 (faujasite) and amorphous zeolite was determined with the salt concentrations, 0.01 M- to 2.0 M- nitric acid and ammonium nitrate, and the shaking time, 15 minutes interval from 15 minute to 90 minute. Kd values were obtained through the batch experiment. In conclusion, the optimal conditions for isolation and removal of the typical radionuclides are as following: zeolite, amorphous zeolite; concentration, $0.01\;M-HNO_3\;and\;0.1\;M-NH_4NO_3$; pH4; shaking time, one hour; the most effective species, Cs-137.

• Nuclear Engineering and Technology
• /
• v.43 no.2
• /
• pp.149-158
• /
• 2011

Metal waste generated from the pyroprocessing of 10 MtU of spent fuel was classified by comparing the specific activity of a relevant radionuclide with the limit value of the specific activity specified in the Korean acceptance criteria for a lowand intermediate-level waste repository. A Korean Optimized Fuel Assembly design with a 17${\times}$17 array, an initial enrichment of 4.5 weight-percent, discharge burn-up of 55 GWD/MtU, and a 10-year cooling time was considered. Initially, the mass and volume of each structural component of the assembly were calculated in detail, and a source term analysis was subsequently performed using ORIGEN-S for these components. An activation cross-section library generated by the KENO-VI/ORIGEN-S module was utilized for top-end and bottom-end pieces. As a result, an Inconel grid plate, a SUS plenum spring, a SUS guide tube subpart, SUS top-end and bottom-end pieces, and an Inconel top-end leaf spring were determined to be unacceptable for the Gyeongju low- and intermediate-level waste repository, as these waste products exceeded the acceptance criteria. In contrast, a Zircaloy grid plate and guide tube can be placed in the Gyeongju repository. Non-contaminated Zircaloy cladding occupying 76% of the metal waste was found to have a lower level of specific activity than the limit value. However, Zircaloy cladding contaminated by fission products and actinides during the decladding process of pyroprocessing was revealed to have 52 and 2 times higher specific activity levels than the limit values for alpha and $^{90}Sr$, respectively. Finally, it was found that 88.7% of the metal waste from the 17${\times}$17 Korean Optimized Fuel Assembly design should be disposed of in a deep geological repository. Therefore, it can be summarized that separation technology with a higher decontamination factor for transuranics and strontium should be developed for the efficient management of metal waste resulting from pyroprocessing.

• Nuclear Engineering and Technology
• /
• v.47 no.1
• /
• pp.47-58
• /
• 2015

Four recycling scenarios involving pyroprocessing of spent fuel (SF) have been investigated for a 600-MWe transmutation sodium-cooled fast reactor (SFR), KALIMER. Performance evaluation was done with code system REBUS connected with TRANSX and TWODANT. Scenario Number 1 is the pyroprocessing of Canada deuterium uranium (CANDU) SF. Because the recycling of CANDU SF does not have any safety problems, the CANDU-Pyro-SFR system will be possible if the pyroprocessing capacity is large enough. Scenario Number 2 is a feasibility test of feed SF from a pressurized water reactor PWR. Thefsensitivity of cooling time before prior to pyro-processing was studied. As the cooling time sensitivity of cooling time before prior to pyro-processing was studied. As the cooling time increases, excess reactivity at the beginning of the equilibrium cycle (BOEC) decreases, thereby creating advantageous reactivity control and improving the transmutation performance of minor actinides. Scenario Number 3 is a case study for various levels of recovery factors of transuranic isotopes (TRUs). If long-lived fission products can be separated during pyroprocessing, the waste that is not recovered is classified as low- and intermediate-level waste, and it is sufficient to be disposed of in an underground site due to very low-heat-generation rate when the waste cooling time becomes >300 years at a TRU recovery factor of 99.9%. Scenario Number 4 is a case study for the recovery factor of rare earth (RE) isotopes. The RE isotope recovery factor should be lowered to ${\leq}20%$ in order to make sodium void reactivity less than <7$, which is the design limit of a metal fuel.

• Nuclear Engineering and Technology
• /
• v.34 no.1
• /
• pp.42-59
• /
• 2002

In order to transmute long-lived radioactive nuclides such as transuranics(TRU), Tc-99, and I- l29 in LWR spent fuel, a preliminary conceptual design study has been performed for the accelerator driven subcritical reactor system, called HYPER(Hybrid Power Extraction Reactor) The core has a hybrid neutron energy spectrum: fast and thermal neutrons for the transmutation of TRU and fission products, respectively. TRU is loaded into the HYPER core as a TRU-Zr metal form because a metal type fuel has very good compatibility with the pyre- chemical process which retains the self-protection of transuranics at all times. On the other hand, Tc-99 and I-129 are loaded as pure technetium metal and sodium iodide, respectively. Pb-Bi is chosen as a primary coolant because Pb-Bi can be a good spallation target and produce a very hard neutron energy spectrum. As a result, the HYPER system does not have any independent spallation target system. 9Cr-2WVTa is used as a window material because an advanced ferritic/martensitic steel is known to have a good performance under a highly corrosive and radiation environment. The support ratios of the HYPER system are about 4∼5 for TRU, Tc-99, and I-129. Therefore, a radiologically clean nuclear power, i.e. zero net production of TRU, Tc-99 and I-129 can be achieved by combining 4 ∼5 LWRs with one HYPER system. In addition, the HYPER system, having good proliferation resistance and high nuclear waste transmutation capability, is believed to provide a breakthrough to the spent fuel problems the nuclear industry is faced with.