• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.47 no.11
• /
• pp.69-76
• /
• 2010

From the present paper we researched about the design of 4-Way Wilkinson divider with waveguide to stripline transition which used to split the LO signal with equi-amplitude and equi-phase in the X-Band Monopulse radar RF front-end. The monopulse radar front end operating in the X-Band is composed of 3 waveguide reception mixers which down convert sum, azimuth and elevation signal to IF and one SSB waveguide mixers which generate X-Band test signal. It is required the 4-way divider with low loss, equi amplitude and equiphase splitting the LO signal to provide the LO signal to each mixer consisting RF frontend. In this paper we designed and fabricated the 4-Way Wilkinson divider with waveguide transition to divide the LO signal into equi-amplitude and equi-phase. The fabricated Wilkinson divider have the insertion loss 6.8dB, VSWR 1.06~1.28, and phase balance maximum 4.5degree for each output ports.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.11 s.102
• /
• pp.1106-1113
• /
• 2005

This paper presents a dual-band mixer for multi-standards of IEEE 802.1la/b/g using a single local oscillator, so as to improve the defects of legacy systems. Those systems have duplicate local oscillators and mixers to handle dual band signals, increasing complexity of system and power loss. The proposed circuit shows 11.6 dB, 16.8 dB of conversion loss and 8.77 dBm, 12.5 dBm of IIP3(Input 3rd Intercept Point) for respective bands when the two RF inputs of 2.452 and 5.260 GHz are down-converted to the identical 356 MHz If frequency. The RF-LO isolations are measured 36 dB, 41 dB at each frequencies and over 50 dB of LO-IF isolations are achieved at all cases.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.25 no.2
• /
• pp.144-150
• /
• 2022

The on-board processor of satellite synthetic aperture radar(SAR) generates transmission signal by digital signal processing, converts it into an analog signal. At this time, the transmission signal generated from the baseband requires the frequency modulation to convert it to the high-frequency band in order to improve the stability. General frequency modulation method using local oscillator(LO) causes IQ imbalance due to phase error/magnitude error and these error reduce performance of SAR. To generate transmission signal without phase/magnitude error, this paper suggests design method of the frequency modulation method using digital to analog converter(DAC) at on-board SAR. For design, this paper analyzes the characteristic of DAC mode and uses pre-compensation filter. To analyze the proposed method performance, performance index are compared with IQ imbalance signals. This method is suitable for on-board SAR using fast sampling DAC and has the advantage of being able to solve IQ imbalances.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.1
• /
• pp.74-79
• /
• 2002

The EM(Engineering Model) VCO(Voltage Controlled Oscillator) is nonlinear designed for LO(Local Oscillator) of Ka-band satellite transponder. The microstripline coupled with dielectric resonator is implemented as a high impedance inverter to improve the phase noise, and the quality factor of resonant circuit can be transferred to active device with the enhanced loaded quality factor. The developed VCO has the oscillating tuning range of 9.7965~9.8032 GHz for the control voltage range of 0~12 V. This VCO requires the DC power of 8 V and 17 mA. The phase noise characteristics are -96.51 dBc/Hz @10 KHz and -116.5 dBc/Hz @100 KHz, respectively. And, the output power of 7.33 dBm is measured.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.2
• /
• pp.89-95
• /
• 2003

In this paper, we have designed and fabricated high conversion gain Q-band active sub-harmonic mixers for a receiver of millimeter wave wireless communication systems. The fabricated active sub-harmonic mixer uses 2nd harmonic signals of a low local oscillator (LO) frequency. The fabricated mixer was successfully integrated by using $0.1{\;}\mu\textrm{m}$GaAs pseudomorphic high electron mobility transistors (PHEMTs) and coplanar waveguide (CPW) structures. From the measurement, it shows that maximum conversion gain of 4.8 dB has obtained at a RF frequency of 40 GHz for 10 dBm LO power of 17.5 GHz. Conversion gain from the fabricated sub-harmonic mixer is one of the best reported thus far. And a phase noise of the 2nd harmonic was obtained -90.23 dBc/Hz at 100 kHz offset. The active sub-harmonic mixer also ensure a high degree of isolations, which are -35.8 dB from LO-to-IF and -40.5 dB from LO-to-RF, respectively, at a LO frequency of 17.5 GHz.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.18 no.7
• /
• pp.944-950
• /
• 1993

Diodes and GaAs have been commonly used in a mixer design until recently. However, diodes are not preferred to use at the front-end of DBS receiver due to the conversion loss large noise. HEMT has larger conversion gain and better noise characteristics comparing with GaAs MESFET. This paper describes the design procedure, structure, and performance of a mixer, utilizaing HEMT designed by OKI Co. . A mixer configuration in which the local oscillator(LO) signal is applied to the gate is used. When the LO power is 0.01 dBm, the conversion gain of 3.7dB is obtained at IF and the 3 dB bandwidth is 400MMz.

• Proceedings of the KIEE Conference
• /
• 2008.05a
• /
• pp.153-156
• /
• 2008

본 논문은 Local oscillator의 2차 harmonic 신호를 이용하고 Dual gate FET 형태를 이용한 이중대역 주파수 혼합기 설계에 대한 연구 이다. 기존의 회로 구조는 두 대역을 처리하기 위해 각각 두 개의 국부 발진기와 혼합기를 사용함으로 인하여 구조의 복잡함과 큰 전력 손실이라는 단점을 가지고 있었다. 본 연구는 하나의 주파수 혼합기로 두 개의 대역에서 동시에 적용할 수 있는 Concurrent 이중 대역 설계 연구를 하였다. ISM(Industrial Science Medical) 대역 인 912MHz, 2.45GHz의 RF 입력과 455.5MHz, 1224.5MHz의 LO 입력 신호에서 동일한 IF인 1MHz로 하향변환 했을 때 모의실험 결과 변환이득은 각각 7dB, 12dB로 이고 RF-LO 격리도는 -29dB, -24.7dB가 나왔다. 또한 두 입력 단에서의 반사손실의 -15dB 이상을 얻었다. 또한 각각의 대역에서 잡음지수는 8.5dB, 6.26dB이다.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.5
• /
• pp.97-102
• /
• 2018

In this paper, W-band Waveform Generator for compact radar has been designed and fabricated. DDS (Direct Digital Synthesizer) is applied to generate CW (Continuous Wave) and FMCW (Frequency Modulation Continuous Wave) waveform at high speed. We designed two LO (Local Oscillator) paths for functions of distance delay and distance tracking tests at the prpposed system without extra test equipment. Two mode selections are provided by switch. It is observed that fabricated waveform generator performs -91 dBc/Hz phase noise at offset 1 kHz and -63.2 dBc spurious. Proposed W-band Waveform Generator is expected to apply for W-band compact radar transceiver module.

• Journal of electromagnetic engineering and science
• /
• v.2 no.2
• /
• pp.117-123
• /
• 2002

This paper describes the design for the resistive FET mixer with low If for the 4-Ch DBF(Digital Beam Forming) receiver This DBF receiver based on the direct conversion method is generally suitable for high-speed wireless mobile communications. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(If) considered in this research are 2.09 GHz, 2.08 CHz and 10 MHz, respectively. This mixer is composed of band pass filter, a low pass filter and a DC bias circuit. Super low noise HJ FET of NE3210S01 is considered in design. The RE input power, LO input power and Vcs are used -10 dBm, 6 dBm and -0.4 V, respectively. In the 4-Ch resistive FET mixer, the measured If and harmonic components of 10 MHe, 20 MHz and 2.087 CHz are about -19.2 dBm, -66 dBm and -48 dBm, respectively The If output power observed at each channel of 10 MHz is about -19.2 dBm and it is higher 28.8 dBm than the maximum harmonic component of 2.087 CHz. Each If output spectrum of the 4-Ch is observed almost same value and it shows a good agreement with the prediction.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.6
• /
• pp.959-968
• /
• 2000

In this paper, a low phase noise frequency synthesizer used to TX local oscillator in BWLL RF tranceiver is presented. The phase-locked stable 25GHz-band frequencies in BWLL TX LO are obtained by using 2 GHz baseband frequency synthesizer, sixth-harmonic frequency multiplier and frequency doubler at 12 GHz band frequency input. The 25 GHz band frequency synthesizer presented in this paper has 3-output frequencies at 24.92 GHz, 25.10 GHz, 25.26 GHz. At 24.92 GHz frequency the synthesizer has 0.44 dBm output power and shows -87.93 dBc/Hz(a 10 KHz), -109.54 dBc/Hz (a100 KHz) phase noise characteristics .