• Transactions of the Korean Society of Mechanical Engineers
• /
• v.12 no.4
• /
• pp.847-864
• /
• 1988

The main purpose of this study is to investigate the local velocity acceleration in a boundary layer diffusion flame over a flat plate. In order to know the effect of separation on the local velocity acceleration, two typical cases, flows with and without separation, are considered. For these cases, flow visualization using paraffine smoke tracers has been made. Mean velocity and r.m.s. value of fluctuating velocity are measured by using a laser Doppler velocimeter. In addition, measurements of time-mean concentration and time-mean temperature have been made. Time-mean density profiles have been obtained from the data of concentration and temperature. The obtained results are summarized as follows : (1) In the case without separation, the local velocity acceleration is clearly observed near the visible flame zone for all flow conditions. On the while, in the case with serration, the local velocity acceleration is observed only at low free stream velocity and high fuel injection velocity. As increasing the free stream velocity or decreasing the fuel injection velocity, it is not distinctly observed in the mean velocity profile. (2) The r.m.s. value of fluctuating velocity is significantly decreased by combustion in the case with separation. But in the case without separation, the r.m.s. value is increased near the visible flame zone in comparison with cold flow. In both cases, the peak value of r.m.s. appeared just at the visible flame zone, where the mean velocity gradient is not too high.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2003.10a
• /
• pp.243-249
• /
• 2003

The head-on collision of two solitary waves are examined using a boundary element method. Attachment, detachment times and alplitudes and maximum run-up times and amplitudes are computed. Consolidation times show local minimum value if two waves are of equal amplitudes are colliding. Attachment times show local maximum value if the amplitudes of two waves are the same. The detachment time show local maximum if two wves are the same. The detachment amplitude show local minimum values if the amplitude e(=a/h) is greater than 0.3.

• Journal of Korean Society for Quality Management
• /
• v.37 no.3
• /
• pp.123-139
• /
• 2009

This study examines the relative efficiency of 34 local public medical centers in Korea. In order to concretely grasp the causes of inefficiency and suggest improvement solutions, the desirable set point was established based on the actual value which needs to be improved. As a result of analysis, we determined that output must be increased while input is held constant in order to improve effectiveness through the actual value and set point. Efficiency cannot be achieved if input is augmented solely to increase output. Also, to increase output, the medical centers need to improve their quality without increasing any input for customer visits and hospitalizations. Further, in order to strategically promote effectiveness and efficiency of local public medical centers, these medical centers must focus on input resource and patient interchange through the mutual cooperation with local private hospitals and university medical centers.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2009.10a
• /
• pp.972-974
• /
• 2009

This paper presents smart regional contrast enhancement technique of partitioned image for local dimming backlight on small-sized mobile display to reach two goals. One is to save the power consumption, and the other to improve contrast ratio of display image. Recently new advanced method is proposed, named local dimming method, that backlight LED is positioned on backside of the display panel. So it is important to partition an image by sub blocks and then post-processing independantly. This means regional contrast enhancement. After partitioning, we compare the mean luminance(Y) value of each sub-block image with the one of original whole image. If some blocks have the mean value lower than the one of whole image, they are processed with the proposed method and others are bypassed. Simultaneously the information of the processed blocks are transferred to BLC(Backlight LED Controller). And then the supply current of each backlight LED is reduced to realize the contrast ratio enhancement and at the same time to power consumption reduction. In addition, we verify this proposed method is free from blocking artifacts.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.3 no.1
• /
• pp.91-98
• /
• 1993

This study was carried out to investigate characteristic of vinyl chloride emissioned from poly vinyl chloride extrusion process and to evaluate the efficiency of local exhaust ventilation system. Before local ventilation facility was constructed in poly vinyl chloride extrusion process, the average worker exposure to vinyl chloride was 3.15 ppm, which exceeded Threshold Limit Value of American Conference of Gorvernmental Industrial Hygienists (ACGIH-TLV), 1 ppm. lt is possible that vinyl chloride residues in the poly vinyl chloride resin was released or degased due to extrusion heat. The larger the width of vinyl tube become, the higher worker exposure to vinyl chloride was. It is estimated that vinyl chloride from vinyl chloride resin increased as amount of poly vinyl chloride resin extruded in the extrusion process increased. Canopy hood was an appropriate type for poly vinyl chloride resin extrusion process. This local exhaust ventilation has fan static pressure of 7.65 inch wg($190mmH_2O$, total volumetric flowlate of 4,796 CFM ($135.8m^3$/min) and fan power requirement of 12 hp (8.952 Kw). After this local exhaust ventilation was constructed there, the average concentration of worker exposure to vinyl chloride was reduced to be 0.46 ppm, which was below the Threshold Limit Value, 1 ppm. Also, the removal efficiency rate of vinyl chloride attained by local exhaust ventilation was 85.3%. It was a statistically significant (p<0.01).

• Proceedings of the SAREK Conference
• /
• 2007.11a
• /
• pp.191-196
• /
• 2007

This paper presents the measuring technique for local heat transfer coefficients using a copper sensor in a rod bundle with mixing vanes. A copper sensor consists of a cartridge heater and four pieces of thermocouple. The Heater is located at the center of the copper sensor and thermocouples measure the surface temperature of the copper sensor. Unheated copper sensor and heated copper sensor are able to measure the local heat transfer coefficient at the position where the heated copper sensor is installed. However the entire region of a rod bundle is actually not heated, the decay of local heat transfer coefficients measured represents overestimated value rather than an actual value. The calibration curve for local heat transfer coefficients is presented using the correction factor calculated by CFD.

• 유체기계공업학회:학술대회논문집
• /
• 2002.12a
• /
• pp.363-369
• /
• 2002

Orifice meter is the most widely used flowmeter in custody transfer between KOGAS and city gas companies. Absolute pressure value is needed to calculate the gas flow of orifice metering system, but the gauge pressure transmitters are mainly used in the field. In case that the gauge pressure transmitters are used, the fixed value as standard atmospheric pressure(101.325kPa) is applied for the absolute pressure value. The real, local atmospheric pressures of each metering station are different from the standard condition as the altitude and weather conditions. In this study the flow calculation errors were quantitatively analyzed through examining the atmospheric pressures of 50 stations of KOGAS. The data for analysis are such like the time data of supplied gas amount, the altitude of each metering station, the time data of atmospheric pressures and altitudes of each weather observatory. The results showed that the local atmospheric pressures were different from the standard value and the gas flow calculation errors were distributed between $-0.024\%{\~}0.025\%$ based on the supplied gas amount in the year 1999 and 2000.

• Journal of the Korean Mathematical Society
• /
• v.38 no.6
• /
• pp.1205-1234
• /
• 2001

We consider the time local well-posedness of the Benjamin equation. Like the result due to Keing-Ponce-Vega [10], [12], we show that the initial value problem is time locally well posed in the Sobolev space H$^{s}$ (R) for s>-3/4.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.835-840
• /
• 2001

The new approach is a kind method of restoring temporary defect. Here, it is important for the defect not to occur problems of both local effect and global system. A basic concept is that it measures remaining prestress of PSC structures during the defect is restored. This study suggested new approach for measurement of remaining prestress. Two important results are obtained. First, safety problems, local stress concentration and global system, are very satisfied. Second, measurement value exists within error bound $\pm$ 1% in comparison with known value.

• Journal of the Korean Institute of Traditional Landscape Architecture
• /
• v.39 no.4
• /
• pp.77-84
• /
• 2021

This paper attempted to examine the value of private house garden as a historical garden among local cultural heritages remaining in Chungcheong-do Province. To this end, the following conclusions were drawn through the framework of value analysis in which the contents of Ji Cheng's Yuanye of China, Tachibana Toshitsuna's Sakuteiki in Japan, and HISTORIC GARDENS THE FLORENCE CHARTER 1981 were applied to target sites. First, local cultural heritage belong to unregistered cultural heritage, and a total of 616 local cultural heritages in Chungcheong-do Province were identified, and Cheongju City possesses the largest number of local cultural heritages. Most of the local cultural heritages are distributed in ancient capital or adjacent to it, and five of the local heritages are related to historical garden. Second, the target sites were old houses constructed during the Joseon Dynasty with a long history, and although there were few changes in spatial division, the scale of some gardens and outer yard spaces was reduced due to urban planning, etc. Third, the target site is Sangjihapui(相地合宜) and Inchacheui(因借體宜) in location and space division, so the space is divided according to the surrounding terrain and the landscape is naturally drawn to construct a garden. Fourth, the garden of the target site has a structural value of a garden that is Jeongihapui(精而合宜) and Gyoideukche(巧而得體) as it is subtle and naturally constructed with the garden by grasping the surrounding terrain. Fifth, for the continuous preservation of historical garden, it is necessary to strengthen the already enacted local cultural heritage ordinance, and to establish a documentary project for each spatial component and a plan for climate change.