• Korean Journal of Materials Research
• /
• v.15 no.1
• /
• pp.47-53
• /
• 2005

The E.M.F. of the galvanic cell with fused salt was measured to determine the activities of zinc at 720-860 K over the entire composition range of liquid Zn-In and Zn-Sn alloys. The cell used was as follows: $$(-)W{\mid}Zn(pure){\mid}Zn^{2+}(KCl-LiCl){\mid}Zn(in\;Zn-In\;or\;Zn-Sn\;alloy){\mid}W(+)$$ The activities of zinc in the alloys showed positive deviation from Raoult's law over the entire composition range. The activity of cadmium and some thermodynamic functions such as Gibbs free energy, enthalpy and entropy were derived from the results by the thermodynamic relationship. The comparison of the results and the literature data was made. The liquid Zn-In and Zn-Sn alloys are found to be close tn the regular solution. The concentration fluctuations in long wavelength limit, $S_{cc}(o)$, in the liquid alloy were calculated from the experimental results.

• Journal of the Semiconductor & Display Technology
• /
• v.7 no.3
• /
• pp.41-43
• /
• 2008

The electro-optical characteristics of the Liquid Crystal on Silicon (hereinafter "LCOS") micro-display on vertically alignment (VA) mode were studied depending on various cell gaps. 5 different cell gaps, such as $1.4{\mu}m,\;1.8{\mu}m,\;2.1{\mu}m,\;2.4{\mu}m$ and $2.8{\mu}m$, were selected. The reflectance-voltage (R-V) characteristics, distributions of reflected light and reflectance were calculated with 3-dimmensional LC code. At the center of cell, the smallest $1.4{\mu}m$ cell gap showed the lowest reflectance and the largest $2.8{\mu}m$ cell gap showed the highest reflectance due to the surface anchoring effect. In case of $2.1{\mu}m$ cell gap, the sum of reflectance overall cell was the highest value. Considering the reflectance and RV curve characteristic, the optimized cell gap was $2.1{\mu}m$.

• Korean Journal of Materials Research
• /
• v.10 no.5
• /
• pp.350-353
• /
• 2000

Thermotropic liquid crystalline polymer(LCP) has been used for the alignment of ferroelectric liquid crystal (FLC) molecules and the surface morphology of the resulting polymeric thin film has been observed by atomic forced microscope. The uniform alignment of FLC molecules on the surface of thermotropic LCP thin film was obtained even though microgroove structures were not formed. The contrast ratio of sample cell was about 23:1 including two polarizers and a good memory capability due to the bistability of FLC was obtained. After AC field stabilization at 20V, the typical stripe-shaped patterns appeared.

• Journal of Satellite, Information and Communications
• /
• v.10 no.2
• /
• pp.75-79
• /
• 2015

In this study, we investigated the electro-optical (EO) characteristic of fringe-field switching (FFS) mode cell by the ion beam alignment method on the a-C:H thin film. The suitable inorganic thin films for FFS cell and the aligning capabilities of nematic liquid crystal (NLC) using the new alignment material of a-C:H thin film were studied. An excellent voltage-transmittance (V-T) and response time curve of the ion beam aligned FFS-LCD was observed with oblique ion beam exposure on the a-C:H thin films. Also, the V-T hysteresis characteristics of the ion beam-aligned FFS-LCD with IB exposure on the a-C:H thin films is almost the same as that of the rubbing-aligned FFS cell on a polyimide surface.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.16 no.11
• /
• pp.1008-1013
• /
• 2003

We have studied the effect of black matrix (BM) according to the dielectric anisotropy of liquid crystals (LCs) for a homogeneously aligned LC cell driven by fringe-electric field. The results show that for a LC with positive dielectric anisotropy (+LC) there is a large transmittance change when using a conductive BM, whereas the transmittance change is low for a LC with negative dielectric anisotropy (-LC). The conductive BM existing on top substrate produces vertical electric field, which makes the LC molecules be tilt upward from the substrate and have small twist angle for the +LC. However, for the -LC the conductive BM affects the LC distribution only slightly due to characteristic of the -LC orienting perpendicular to the field. Therefore, for the +LC the electro-optic characteristics are strongly dependent on conductivity of the BM on top substrate in a homogeneous liquid crystal cell driven by fringe-electric field.

• Transactions on Electrical and Electronic Materials
• /
• v.10 no.1
• /
• pp.16-19
• /
• 2009

We have studied the liquid crystal alignment properties for various alignment methods on the homogeneous polyimide surface. Suitable liquid crystal alignment for one-side alignment cell on the polyimide surface by all alignment method was observed. Highly pre-tilt angle of the NLC for both-side rubbing cell was measured. But, low pre-tilt angle of the NLC for one-side ion beam and UV irradiation cell was observed. We consider that the pre-tilt angle of NLC for one-side ion beam and UV irradiation on the PI surface is lower than that of the PI surface with rubbing. Also, the suitable transmittance-voltage curves for the one-side rubbing TN-LCD on the PI surface with one-side UV irradiation were measured. Also, good response time characteristics of the one-side rubbing TN-LCD on the polyimide surface with one-side UV irradiation can be measured.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.8
• /
• pp.2633-2636
• /
• 2011

A new type of ionic liquid based on N-(3-aminepropyl)imidazolium iodide, called IIQAI, which consists of imidazolium and quaternary ammonium salt, and APII-(hydroxyethyl, propyl, hexyl) were synthesized and used as ionic liquid in dye-sensitized solar cells. APII-hexyl is solid, whereas IIQAI, APII-(hydroxyethyl, propyl) are viscous liquids. The synthesized ionic liquid showed relative thermal stability compared to the commercial ionic liquid of DMII. Among them, IIQAI was more stable than the other ionic liquid because of the two salt groups. APII-hydroxyethyl, which contains two hydroxyl groups, showed low viscosity with good flow. New types of ionic liquids were examined by $^1H$-NMR spectroscopy, thermo gravimetric analysis (TGA). IIQAI enabled a solar energy conversion efficiency of 6.3%, which is slightly higher than that of the referenced (DMII, 6.2%).

• Journal of Information Display
• /
• v.9 no.4
• /
• pp.11-14
• /
• 2008

A highly efficient organic light-emitting diode (OLED) with an in-cell polarizer made of an imprinted liquid crystalline polymer (LCP) layer doped with dichroic dye molecules is presented. The in-cell polarizer was found to be capable of effectively polarizing the emission light of the OLED and of significantly improving the luminance through the periodic microstructures fabricated using an imprinting method. This type of OLED with an imprinted in-cell polarizer is useful for efficient light source applications in liquid crystal displays (LCDs).

• Journal of Information Display
• /
• v.9 no.2
• /
• pp.22-27
• /
• 2008

We propose an optical configuration of a vertical alignment (VA) liquid crystal (LC) cell to eliminate the light leakage in the diagonal direction. VA LC cell has an excellent contrast ratio in the normal direction due to the no phase-retardation. However, change of the phase-retardation occurs in all directions, which causes the light leakage and deteriorates the characteristics of the dark state. We designed the LC cell structure composed of multiple combinations with two A-plates and two C-plates in order to achieve wide viewing property on the Poincare sphere. From calculations, we show that the proposed structure can improve the viewing angle characteristics by compensating for the light leakage in all directions.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1700-1702
• /
• 1996

Solid oxide fuel cell(SOFC) is an electrochemical energy device which converts the free energy of fuel gas directly to electric energy. SOFC has several diratinct advantages over other types of fuel cells: no use of noble metals, no requirement of a reformer, no problem of liquid electrolyte management, and no problem of corrosion by liquid electrolyte. In this study, we have investigated the cell components and the single cell of the planar SOFC fabricated by composite plate process, in which green films of electrolyte, anode and cathode were co-fired. The planar SOFCs were tested and the cell performance characteristics wag evaluated by using electrochemical methods.