• Journal of information and communication convergence engineering
• /
• 제19권4호
• /
• pp.269-275
• /
• 2021

Light-emitting diodes (LEDs) are modulated using a square wave pulse sequence for flicker prevention and dimming control in visible light communication (VLC). In a VLC transmitter, the high and low bits of the non-return-to-zero (NRZ) data are converted to two square waves of different frequencies, which continue for a finite time defined by the fill ratio in an NRZ bit time. As the average optical power was kept constant and independent of data transmission, the LED was flicker-free. Dimming control is carried out by changing the fill ratio of the square wave in the NRZ bit time. In the experiments, the illumination of the LED light was controlled in the range of approximately 19.2% to 96.2% of the continuous square wave modulated LED light. In the VLC receiver, a high-pass filter combined with a latch circuit was used to recover the transmitted signal while preventing noise interference from adjacent lighting lamps.

• Journal of information and communication convergence engineering
• /
• 제6권2호
• /
• pp.192-197
• /
• 2008

High-speed harmonic optical modulation-demodulation schemes are presented and a possibility of the schemes for applying to high-speed light wave transmission system is tested at microwave frequency range. An example of this concept is as follows : Light wave is modulated succeedingly through cascaded optical modulators by a sub-carrier to produce a modulated light wave at harmonic frequency which is higher than the feasible frequency of the individual modulators. For demodulation of the base-band signal, the high frequency optical sub-carrier is down-converted by the same kind of optical modulator with the same concept of harmonic modulation.

• Journal of information and communication convergence engineering
• /
• 제13권1호
• /
• pp.50-55
• /
• 2015

We report design and simulation of a two-dimensional (2D) silicon-based nanophotonic crystal as an optical insulator to enhance the light emission efficiency of light-emitting diodes (LEDs). The device was designed in a manner that a triangular array silicon photonic crystal light insulator has a square trench in the middle where LED can be placed. By varying the normalized radius in the range of 0.3-0.5 using plane wave expansion method (PWEM), we found that the normalized radius of 0.45 creates a large band gap for transverse electric (TE) polarization. Subsequently a series of light propagation simulation were carried out using 2D and three-dimensional (3D) finite-difference time-domain (FDTD). The designed silicon-based light insulator device shows optical characteristics of a region in which light propagation was forbidden in the horizontal plane for TE light with most of the visible light spectrum in the wavelength range of 450 nm to 600 nm.

• Current Optics and Photonics
• /
• 제7권2호
• /
• pp.136-146
• /
• 2023

Based on calculations using the macroscopic Maxwell's equations with mesoscopic boundary conditions, light absorption by a layered metal-insulator-metal (MIM) metamaterial system embedded in three different environments is investigated. Increasing the top metal thickness shifts the broad absorption band to lower dielectric-constant regions and longer wavelengths, for either TM or TE waves. Boosting the dielectric-layer thickness redshifts the broadband absorption to regions of larger dielectric constant. In air, for the dielectric-constant range of 0.86-3.40, the absorption of the system exceeds 98% across 680-1,033 nm. In seawater with optimized dielectric constant, ≥94% light absorption over 400-1,200 nm can be achieved; particularly in the wavelength range of 480-960 nm and dielectric-constant range of 0.82-3.50, the absorption is greater than 98%. In an environment with even higher refractive index (1.74), ≥98% light absorption over 400-1,200 nm can be achieved, giving better performance. The influence of angle of incidence on light absorption of the MIM system is also analyzed, and the angle tolerance for ≥90% broadband absorption of a TM wave is up to 40° in an environment with large refractive index. While the incident-angle dependence of the absorption of a TE wave is nearly the same for different circumstances, the situation is different for a TM wave.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1994년도 추계학술대회 논문집 학회본부
• /
• pp.382-384
• /
• 1994

Wireless communication has become a hot issue for its simplicity. Using light wave instead of micro wave has many advantages. It is simple to design a circuit because we can make a circuit with discrete components such as photo diode, photo detector, OP Amp[2]. And we can have many communication channels for we can use every frequency domain. In this paper, we design the wireless communication system and analyze the pulse signal. Then using ray tracing technology we simulate the distribution of light beam.

• Current Optics and Photonics
• /
• 제2권4호
• /
• pp.308-314
• /
• 2018

Visible light communication (VLC) is considered a strong future candidate for indoor wireless communication. However, its performance seems to be relatively unsatisfactory when compared to wireless local area network (WLAN) communication using millimeter waves. To improve the performance of VLC, numerous technologies have been proposed so far, in both electrical and optical domains. Among the proposals, optical beamforming (OB) is an optical-domain technology that can concentrate light in a specific direction or on a target spot. It can significantly improve VLC performance and can be widely used, because it does not depend on electrical modulation schemes. Therefore, this review discusses the concept, principle, and types of OB, the structure of a VLC system using OB, performance results of OB, and the combination of OB with electrical signal modulation in VLC. OB is expected to be one of the key techniques in future VLC implementations, similar to radio-frequency beamforming in millimeter-wave communication.

• 한국전자통신학회논문지
• /
• 제10권6호
• /
• pp.757-762
• /
• 2015

본 논문은 색온도가 글씨 쓰기 과제 수행과 뇌파에 미치는 영향을 알아보고자 2013년 7월부터 9월까지 초등학생 아동 24명을 대상으로 실시하였다. 색온도의 고정과 유지를 위해 준비된 실험실에서 주황색등과 백색등에 따른 과제수행시간의 측정과 뇌파를 측정하여 분석하였다. 연구 결과 알파파, 베타파, 하이베타파의 출현이 백색등에서 높게 나타났으나 과제수행 시간은 주황색등에서 유의하게 빠른 수행을 보였다. 이는 기존의 낮은 색온도는 안정과 이완에 전형적인 색온도로 여겨졌으나 심인적인 요인과 과제의 특성과 종류에 따른 다양한 활용은 학습과 작업의 능률에 긍정적인 영향을 줄 수 있음을 제시했다.

• 센서학회지
• /
• 제29권3호
• /
• pp.149-155
• /
• 2020

In this study, we employed Manchester code for illumination control and flicker prevention of the light-emitting diode (LED) used in a visible light communication (VLC) system. In the VLC transmitter, the duty factor of the Manchester code was utilized for illumination control; in the VLC receiver, the spike signal from an RC-high pass filter was utilized to recover the transmitted signal whilst suppressing the 120-Hz noise arising from adjacent lighting lamps. Instead of the clock being transmitted in a separate channel, a syncmark signal was transmitted in front of each data byte and used as the reference time for transforming the Manchester code to non-return-to-zero (NRZ) data in the receiver. In experiments, the LED illumination was controlled in the range of approximately 12-84% of the constant wave (CW) light via changing of the duty factor from 10% to 90%. This scheme is useful for constructing indoor wireless sensor networks using LED light that is flicker-free and presents capability for illumination control.

• 센서학회지
• /
• 제28권3호
• /
• pp.191-197
• /
• 2019

In this study, we propose a dimming control method for a visible light communication (VLC) system, in which the subcarrier on-off keying (OOK) modulation of Manchester code is used for data transmission. In the VLC transmitter, non-return-to-zero (NRZ) code data is transformed to Manchester code, which is OOK modulated with a subcarrier. Manchester code is used for flicker-free lighting; the duty factor is changed for dimming control, and the subcarrier is used for preventing the adjacent noise light interference. In the experiments, the dimming control was carried out from about 8%-92% of the continuous wave (CW) LED light. This configuration is simple and effective in constructing a VLC system for indoor wireless sensor networks with flicker-free illumination and dimming control capability without adjacent noise light interference.

• 센서학회지
• /
• 제30권2호
• /
• pp.99-104
• /
• 2021

In this study, we utilized the duty factor of the transition frequency modulation (TFM) for the illumination control of the light emitting diode (LED) light in visible light communication (VLC). The average optical power is linearly proportional to the duty factor in TFM waveforms. We used the transition frequencies of Na=5 and Nb=1 for the high and the low bits, respectively, of the non-return-to-zero (NRZ) data in the VLC transmitter. A resistor and capacitor high-pass filter (HPF) was used in the VLC receiver to eliminate the 120 Hz optical noise from adjacent lighting lamps and the spikes at the HPF output were used to recover NRZ data from the TFM waveform. In experiments, the illumination of the LED light was controlled in the range of 25-90% of the constant-wave optical power by changing the duty factor of the TFM waveforms.