• 대한안전경영과학회지
• /
• 제2권1호
• /
• pp.89-97
• /
• 2000

This paper shows the study for development inprocess measuring magnetic sensor for tolerance control, First, we fabricated and annealed sample amorphous ribbons which were made of ($CO_{0.94}$$Fe_{0.06}$)$_{79}$$Si_{2}$$b_{19}$ having near zero magnetostrictive. It had 12［$\mu\textrm{m}$］ of thickness, 10［mm］ of length, and 2.5［mm］ of width. Then, we measured the magnetic characteristics such as frequency dependency over impedance variation rate and position change over impedance variation. As the results of the evaluation, we found that the sample ribbons had excellent sensor characteristics. Then, we made sensors by using the sample ribbons, As the results of the measurements, it proved that the ribbon could be used as excellent magnetic sensor for which it was possible to control inprocess measurement within the tolerance range(~$\mu\textrm{m}$ ).

• Communications for Statistical Applications and Methods
• /
• 제27권1호
• /
• pp.65-77
• /
• 2020

Geometric charts are effective in monitoring the fraction nonconforming in high-quality processes. The in-control fraction nonconforming is unknown in most actual processes; therefore, it should be estimated using the Phase I sample. However, if the Phase I sample size is small the practitioner may not achieve the desired in-control performance because estimation errors can occur when the parameters are estimated. Therefore, in this paper, we adjust the control limits of geometric charts with the bootstrap algorithm to improve the in-control performance of charts with smaller sample sizes. The simulation results show that the adjustment with the bootstrap algorithm improves the in-control performance of geometric charts by controlling the probability that the in-control average run length has a value greater than the desired one. The out-of-control performance of geometric charts with adjusted limits is also discussed.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.59-72
• /
• 1999

In this thesis, we measured the Barkhausen effect of CoFeSiB amorphous ribbon and then investigated its possibility to be used as a sensor material. We used a sample of composition $($Fe_{0.06}$$Co_{0.94}$)_${0.79}$$Si_{2.1}$$B_{18.9}$ with a thickness 12[pm1, width 2.5[rnml and length 5[cm], which was fabricated by a single roll method. In order to improve magnetic characteristics of the sample, we had carried on annealing in the magnetic field and in none magnetic field. And, experimented results to the magnetic characteristics show that the ribbon has large Barkhausen jump even in weak magnetic field below 0.5[0el. From the results, we confirmed that the sample can be used as an magnetic sensor material.

• 한국산림과학회지
• /
• 제3권1호
• /
• pp.18-22
• /
• 1963

1. Objects The experiments of catalytic aharcoaling were carried out for the fallowing purposes. (1) To determine the economically desirable amount of catalytic materials to be used when a catalytic charcoaling is practiced. (2) To observe the rate of carbonization of non-treated charcoal wood when the catalytic charcoaling is proceeded in the same charcoal pit. 2. Meterials (1) Small sample chips made of oak (Q. accutissima Carr.), measured by 0.5cm in width and thickness, respectively, and 1cm in length, were used as charcoal wood in each experiment. (2) Ammonium chloride was used as a catalytic material and electric kiln as a charcoaling apparatus. 3. Experiment (1) The sample chips were put into a electric oven for three hours at the temperature $60^{\circ}{\sim}70^{\circ}C$ in order to reduce some water contents. (2) Oven dried sample chips were then soaked for an hour in solution of ammonium chloride. Three kinds of solution were prepared, that is, 2.5%, 5%, and 10%, solution in which the amount of ammonium chloride used was weighed at the rate of 0.5%, 1.0%, and 2.0% to the total weight of the sample chips, resppectivelly. (3) Soaked sample chips were put in the air for 12 hours to reduce some water contents, and then were put into electric oven for 2 hours at the temperature $105^{\circ}{\sim}110^{\circ}C$. (4) Dried sample chips were kept in a desiccator with control sample chips which were treated excarly the same process as the treated sample chips except only not using the ammonium chloride in the process of soking. (5) Sample chips kept in the desiccator were used at random in each charcoaling experiment. (6) Charcoaling in the electric kiln were carried out by using small crucibles with complete cover to reduce the amount of ash. At each charcoaling experiment four crucibles filled with sample ships, weighed about 20gr, were put into electric kiln. The charcoaling was continued for an hour at the temperature $400^{\circ}{\sim}450^{\circ}C$. (7) In order to investigate the influence given by the gases produced during the catalytic charcoaling to the rate of carbonization of non-treated sample chips, the following experiment was done. (a) A crueible was divided into two parts by inserting a fine iron net at the middle of the crucible, and then non-treated sample chips, weighed about 10gr, were put in the upper part of the crucible and treated sample chips, weighed also about 10gr, were put in the under part. (b) The crucibles filled with two kinds of sample chips were put into a electric kiln for an hour at the temperature $400^{\circ}{\sim}450^{\circ}C$. 4. Results. Results for two replications (with four crucibles in one replication) for each experiment designed are as follows : (1) The rats of carbonization of the non treated sample chips, and that of the treated sample chips with ammonium chloride at the rate of 1.5%, 1.0%, and 2.0% to the total weight of the sample chips used were averaged at 19.85%, 22.63%, 24.14%, and 26.60%, respectively. (2) The rats of carbonization of the non-treated sample chips were averaged at (a) 20.04% (0.5% treatment), (b) 20.28% (1.0% treatment), and (c) 20.61% (2.0% treatment) when the treated sample chips were carbonized in the same crucible.

• 보건행정학회지
• /
• 제19권3호
• /
• pp.27-44
• /
• 2009

The length of stay in emergency departments has been used as a quality indicator to reflect the overall efficiency of emergency care. Identifying characteristics associated with length of stay is critical to monitor overcrowding and improve efficient throughput function of emergency departments. This study examined the level of waiting time for initial assessment by physician and length of stay in emergency departments. Furthermore, we investigated the characteristics of patients' attendance associated with length of stay. An observational study was performed for a sample of 1,526 patients visiting ten nation-wide emergency departments. A structured form was designed to collect information about patients' demographics, route of admission, time and mode of arrival, triage level, cause of attendance, initial assessment time by physician, departure time, and disposition. Multiple regression analysis was performed to determine factors associated with length of stay. The average length of stay was 209.4 minutes (95% confidence interval [CI]=197.1-221.7), with a mean waiting time for initial assessment of 5.9 minutes (95% CI=5.1-6.7). After controlling for emergency department characteristics, increasing age, longer waiting times, attendance due to diseases, higher acuity, multiple diagnoses($\geq$2) and requiring admission or transfer to other health care facilities were positively associated with length of stay in emergency departments. The findings suggest that both patients' characteristics and the flow between emergency departments and parent hospitals should be taken into account in predicting length of stay in emergency departments.

• 한국병원경영학회지
• /
• 제23권3호
• /
• pp.52-62
• /
• 2018

This study aims to analyze the factors affecting in-hospital complication and length of stay in elderly patients with total knee arthroplasty. A total of 8,224 inpatients over 65 years old were selected from the national old inpatient sample data which was produced by Health Insurance Review and Assessment Service in 2016. STATA 12.0 was performed using frequency, chi-square test, t-test, ANOVA and multiple linear and logistic regression analysis. Analysis results show that ages(over 85), Charlson Comorbidity Index, district(metropolitan) for general hospitals and gender, district, beds(100-199) for hospitals are significantly influenced in-hospital complication. Statistically significant factors affecting the length of stay are gender, insurance type, depression, district, bed(300 over) for general hospitals and gender, type of insurance, Charlson Comorbidity Index, depression, district, beds(200-299) for hospitals. Based on these findings, the factors affecting in-hospital complication and length of stay were different depending on the type of medical institution. Accordingly, policymakers should analyze the differences in care behavior depending on the type of medical institution and expand policy and financial support to resolve them.

• 한국해양학회지
• /
• 제4권1호
• /
• pp.17-35
• /
• 1969

This work concerns morphological studies of the Japaness jack mackerel, Trachurus japonicus(Temminck & Schlegel). A total of 48 random samples consisting of 2669 fish is examined, representing three geographic regions, namely, Kamakura, Nagasaki, and Tottori. Preservation affects length and weight of fish considerably, but the variability after 10 days is shown to be negligible. The variability in measuring the morphometric characters due to different measures and orders is found to be significant. They are relatively small, however, compared to the variability in mean length to be expected in samples drawn from the population. Two meristic characters, namely, anal and second dorsal fin rays and three morphometric characters, namely, head length, first and second dorsal insertion distances are chosen for the study. Results of the statistical analysis reveal that differences in the selected meristic characters among samples within and between regions are found to be significant. In general, it is reasonable to state that the jack mackerel collected in Nagasaki region, on the average, have greatest number of anal fin ray and second dorsal fin ray followed by Kamakura, and Tottori regions in that order. It is found that although no significant differences in the slope of regression line are noticed, the mean differences of the selected morphometric measurements in relation to fish length are found to be significant among samples within each region. Differences in the regression coefficients as well as the adjusted sample means are found to be significant between regions. The analysis suggests that samples from Nagasaki region, on the average, have longest head length and greatest distances from snout to the insertion of first dorsal and second dorsal fins followed by Kamakura, and Tottori regions in that order.

• 보건의료산업학회지
• /
• 제10권1호
• /
• pp.39-51
• /
• 2016

Objectives : This study investigated the health care utilization patterns of workers' compensation insurance(WCI) pneumoconiosis patients with excessively long hospital stays. Methods : The discharge summary data of 3,094 WCI pneumoconiosis patients were analyzed. The study sample was divided into 3 groups based on the length of stay(LOS). Health care utilization patterns were compared among the groups with logistic regression analysis, and the LOS determinants were identified with linear regression analysis. Results : The average LOS of the 222 long stay group patients was 1,448 days. Patients in this group tended to use private general hospitals, were admitted through the emergency room and discharged without the consent of a doctor. Conclusions : Many of the long LOS patients will maintain their inpatient status for the rest of their lives. For quality of life and efficient use of health care resources, policy makers need to establish a policy that enables patients to receive outpatient care in appropriate living conditions outside the hospital.

• International Journal of Concrete Structures and Materials
• /
• 제18권1E호
• /
• pp.23-28
• /
• 2006

In this study, the general theory of fractality is discussed to provide a fundamental understanding of fractal geometry applied to heterogeneous material surfaces like pavement surface and rock surface. It is well known that many physical phenomena and systems are chaotic, random and that the features of roughness are found at a wide spectrum of length scales from the length of the sample to the atomic scales. Studying the mechanics of these physical phenomena, it is absolutely necessary to characterize such multi scaled rough surfaces and to know the structural property of such surfaces at all length scales relevant to the phenomenon. This study emphasizes the role of fractal geometry to characterize the roughness of various surfaces. Pavement roughness and rock surface roughness were examined to correlate their roughness property to fractality.

• 한국운동역학회지
• /
• 제17권4호
• /
• pp.9-16
• /
• 2007

The purpose of this study was to analyze the effects of after aquatic exercise on gait in the Falls Experienced elderly. There were one group : Fall Experienced Elderly Women(n=8). They were tested on their gait (Elapse time of each phase, Stance time of limb, Stride length, Velocity of segment). we took video and analyzed their movement using Ariel Performance Analysis System and compared gait parameters. For data analysis, mean and standard deviation scores were calculated, and correspondence sample t-test and pearson's correlation analysis were used. First, after exercise is short than before exercise on Elapse time of each phase, fall-experience subjects showed meaningful total time. Second, after exercise is short than before exercise on Stance time of limb and Stride length, fall-experience subjects showed meaningful Stride length. Third, after exercise is fast than before exercise on Velocity of segment.