• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2003년도 하계학술대회 논문집 Vol.4 No.2
• /
• pp.747-750
• /
• 2003

The microstructure and nonlinear properties of ZPCMR-based varistors were investigated with various additives. The density of varistors were gradually decreased for the same R in order of NiO, MgO, and $Cr_2O_3$, respectively. The ZPCR-based varistors were not affected by NiO and MgO additives in nonlinear properties, whereas greatly affected by $Cr_2O_3$. Among the ZPCCR-based varistors, ZPCCD varistor exhibited the highest nonlinear properties, in which the nonlinear exponent is in the range of $40.5{\sim}67.4$ and the leakage current is in the range of $1.2{\sim}2.7{\mu}A$.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제50권1호
• /
• pp.24-29
• /
• 2001

PZT thin films(4000A) have prepared onto 1737 corning glass and ITO coated glass substrates with a RF magnetron sputtering system using Pb_{1.05}(Zr_{0.52},Ti_{0.48})O_3$ceramic target, Electrical properties of PZT thin film deposited after ITO coated glass were P${\gamma}$ was decreased by 25% after 109cycles, respectively. With the RTA treatment duration and temperature increased, the crystallization of PZT thin films were enhanced, however, the leakage current density became higher. The leakage current mechanism was found to be space charge conduction by the defects and oxygen vacancies existing in PZT and PZT/bottom electrode interfaces.

• Journal of information and communication convergence engineering
• /
• 제1권2호
• /
• pp.70-73
• /
• 2003

We have studied the effects of solvents and additives in the precursor solutions on the characteristics of barium strontium titanate (BST) thin films. The solution having two solvents, ie. acetic acid for barium acetate and strontium acetate and 2-methoxyethanol for titanium isopropoxide and also having an additive of ethylene glycol shows good stability and remains homogeneous even after a month of ageing. It produces excellent BST thin film without cracks. Dielectric constant, loss tangent at 10KHz and leakage current density at 3V of the BST (70/30) thin film made from this solution are 339, 0.052 and 13.3 ${\mu}\textrm{A}$/$\texmrm{cm}^2$, respectively.

• 반도체디스플레이기술학회지
• /
• 제17권4호
• /
• pp.27-31
• /
• 2018

The effect of $NH_3$ plasma passivation on the chemical and electrical characteristics of ALD HfAlO dielectric on the InGaAs substrate was investigated. The results show that $NH_3$ plasma passivation exhibit better electrical & chemical performance such as much lower leakage current, lower density of interface trap(Dit) level, and low unstable interfacial oxide. $NH_3$ plasma passivation can effectively enhance interfacial characteristics. Therefore $NH_3$ plasma passivation improved the HfAlO dielectric performance on the InGaAs substrate.

• Progress in Superconductivity
• /
• 제4권1호
• /
• pp.59-63
• /
• 2002

10-V Josephson junction array arranged in 8 parallel stripline paths was fabricated using self-aligning and reactive ion etching techniques. These techniques were introduced in detail with aim of obtaining high-quality junctions. The array has 18,184 Josephson junctions with the area of $12\mu\textrm{m}$$\times$$38\mu\textrm{m}$. The gap voltage and minimum critical current density were about 2.7 ㎷ and ／$23 A\textrm{cm}^2$, respectively. And the critical current density and leakage current at 5 volt were about 27 $A／\textrm{cm}^2$ and $5\mu\textrm{A}$, respectively When operated in the frequency range of 76-88 ㎓, the away generated constant voltage steps up to 14-19 V. The step size near 10-V was more than 7 $\mu\textrm{A}$.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.450-453
• /
• 1999

In this paper, The relationship between device performance and channel length(1.5-50$\mu$m) in polysilicon thin-film transistors fabricated by SPC technology was Investigated by measuring electric Properties such as 1-V characteristics, field effect mobility, threshold voltage, subthreshold swing, and trap density in grain boundary with channel length. The drain current at ON-state increases with decreasing channel length due to increase of the drain field, while OFF-state current (leakage current) is independent of channel length. The field effect mobility decrease with channel length due to decreasing carrier life time by the avalanche injection of the carrier at high drain field. The threshold voltage and subthreshold swing decrease with channel length, and then increase in 1.5 $\mu$m increase of increase of trap density in grain boundary by impact ionization.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 D
• /
• pp.1651-1653
• /
• 1999

Room Temperature Vulcanizing (RTV) Silicone Rubber has been widely used to coat porcelain insulator to prevent formation water filming on insulator surface. and RTV silicone rubber has water repellency to suppress leakage current and consequent flashover. RTV silicone rubber's surface has been degradated by outdoor condition such as dust, salt, and water. etc. ESDD(Equivalent Salt Deposit Density) and leakage currents are increased by polymer surface toughness and degradation. In this paper, we investigated relations of surface toughness, ESDD, and leakage currents.

• 한국재료학회지
• /
• 제4권4호
• /
• pp.453-458
• /
• 1994

256Mb DRAM에서 박막 커패시터로의 적용을 위해서$(Ba_{0.5}Sr_{0.5)/TiO_3$(BST)박막이 RF Magnetron Sprttering방법에 의해 제조되었다. BST박막의 결정화도는 기판온도가 높아짐에 따라 증가하였고 증착된 박막의 조성은 $(Ba_{0.48}Sr_{0.48)/TiO_{2.93}$이었다. 이때 Pt/Ti장벽층은 Si의 BST계면으로의 확산을 억제하였다. 100kHz에서의 유전상수 및 유전손실은 각각 320 및 0.022이었다. 인가전계도 (Charge Storage Density)는 40fC/$\mu \textrm{m}^{2}$, 누설전류밀도(Leakage Current Density)는 0.8$\mu A/\textrm{cm}^2$ 로서 RF Matnetron sputtering방법에 의해 제조된 BST 박막이 256Mb DRAM 적용 가능함을 보였다.

• 한국재료학회지
• /
• 제5권7호
• /
• pp.816-819
• /
• 1995

저압 유기금속 화학 증탁법에 의하여 Pt/Ti/SiO$_2$/Si 기판위에 (Ba$_{1-x}$ , Sr$_{x}$)TiO/$_3$박막이 제조 되었다. 제조된 BST 박막의 결정화도는 증착온도가 증가함에 따라 (100)방향으로 우선 성장하였다. 90$0^{\circ}C$에서 증착한 BST 박막은 100kHz의 주파수에서 유전상수가 365, 유전손실이 0.052를 나타내었다. 인가전계에 따라 축전용량의 변화가 작은 상유전 특성을 보였으며 0.2MV/cm인가 전계에서 축적 전하 밀도(charge storage density)는 60fC/$\mu\textrm{m}$$^2$을, 0.15MV/cm인가 전계 영역에서 누설 전류밀도(leakage current density)는 20nA/$\textrm{cm}^2$을 나타냈다.냈다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.379-381
• /
• 2008

Generally additional leakage inductance and two clamp diodes are adopted into the conventional phase shift full bridge (PSFB) converter for reducing the voltage stress of secondary rectifier diodes and extending the range of zero voltage switching (ZVS) operation. However, since additional leakage inductance carries the ac current similar to the primary one, the core and copper loss oriented from additional leakage inductance can be high enough to decrease the whole efficiency of DC/DC converter. Therefore, in this paper, a new ZVS phase shift full bridge converter with separated primary winding (SPW) is proposed. Proposed converter makes the transformer and additional leakage inductor with one ferrite core. Using this method, leakage inductance is controlled by the winding ratio of separated primary winding. Moreover, by manufacturing the both magnetic components with one core, size and core loss can be reduced and it turns out the improvement of efficiency and power density of DC/DC converter. The operational principle of proposed converter is analyzed and verified by the 1.2kW prototype.