• Journal of the Optical Society of Korea
• /
• v.9 no.2
• /
• pp.49-53
• /
• 2005

We report a new configuration of a reflection-type confocal scanning optical microscope system for measuring the refractive index profile of an optical waveguide. Several improvements on the earlier design are proposed; a light emitting diode (LED) at 650 nm wavelength instead of a laser diode (LD) or He-Ne laser is used as a light source for better index precision, and a simple longitudinal linear scanning and curve fitting techniques are adapted instead of a servo control for maintaining an optical confocal arrangement. We have obtained spatial resolution of 700 nm and an index precision of $2\times10^{-4}$. To verify the system's capability, the refractive index profiles of a conventional multimode fiber and a home-made four-mode fiber were examined with our proposed measurement method.

• ETRI Journal
• /
• v.28 no.5
• /
• pp.545-554
• /
• 2006

A widely tunable multi-channel grating cavity laser is proposed and experimentally demonstrated. The device is implemented in Littman configuration with an echelle grating based on Rowland circle construction and realized by monolithically integrating all elements in an InP substrate. Lasing wavelength is selected by turning on an amplifier and the appropriate channel element in the array, and it is tuned by controlling light deflection electrically. The 6-channel device exhibits a tuning range of about 50 nm with a side mode suppression ratio of more than 30 dB. This is accomplished by adjusting the applied current of the dispersive element and phase control section.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.5
• /
• pp.566-568
• /
• 2003

The phosphor $CaTiO_3:Pr^{3+}$ attracts much attention as a low-voltage red phosphor because of its good chromaticity and intrinsic conductivity. The addition of Ga into this CaTiO₃:Pr led the luminance intensity to greatly enhance without the change of the wavelength for the electronic transition and the peak shape of it. The increase of the recombination rate of electron-hole pairs through the Ga ion doping, which was expected to play a role of a hole-trap center, is proposed to be one of the reasons for the enhancement of the cathodoluminescence intensity.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.9
• /
• pp.844-847
• /
• 2008

The photo leakage currents of a conventional hydrogenated amorphous silicon(a-Si:H) thin film transistor(TFT) were investigated and analyzed in case of illumination from various light sources such as halogen lamp, cold cathode fluorescent lamp(CCFL) backlight, and white light emitting diode(LED) backlight. The photo leakage characteristics showed the apparent differences in the leakage level and in the $I_{on}/I_{off}$ ratio in spite of the similar luminances of light sources. This leakage level is expected to be related to the wavelength of the lowest intensity peak from the spectral characteristics of light sources.

• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1710-1712
• /
• 2003

This paper analyzes the effects of various operating voltages on the luminous efficacy of high flux RGB LEDs. At first, their equivalent diode model are established from measurements of the V-I characteristics. Operating voltages of three types are applied to a simple LED circuit: DC, square-wave, and full-wave-rectified sine wave. As the result, DC voltage driving gives the hightest efficiency, but invokes much greater variation in the luminous flux and more shift in the peak wavelength.

• Transactions of the Society of Information Storage Systems
• /
• v.6 no.2
• /
• pp.68-73
• /
• 2010

The interest in acquiring high efficiency solar cells has been steadily increasing due to various advantages such as low-cost installation, pollution free and everlasting energy generation. In order to raise the cell efficiency, there has been a lot of effort to develop effective anti-reflection coatings. In this work, the main objective was to investigate the effects of particle size and annealing temperature of silica anti-reflection coatings to maximize the cell efficiency as well as reliability. It was shown that the light transmittance could be increased by a few percent over a certain range of wavelength using the silica coating. Also, the tribological properties of the coating could be improved through the annealing process, which led to better reliability of the coating.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.27 no.10
• /
• pp.653-656
• /
• 2014

$Cs_3Sb$ photocathode was formed by newly developed process and successive in-situ lighting devices were fabricated in a process chamber. R, G, and B phosphors were applied on the anode plate, respectively. Major parameters such as brightness, power consumption, and efficacy were measured. The wavelength of LED excitation source was 450 nm. Both high power and low power modes were applied in the measurement. Measurement values were clearly differentiated by the voltage application modes. The measured values of each parameter was good enough to be applied for general lighting source. The results showed that $Cs_3Sb$ photocathode formed in atmospheric conditions was functioning as good as the photocathode formed in UHV conditions, and thus it could be applied to advanced lighting devices.

• Journal of Korea Multimedia Society
• /
• v.21 no.12
• /
• pp.1379-1386
• /
• 2018

In this paper, we proposed eyeglass type periorbital wrinkle treatment device for reducing and improving periorbital wrinkles using near infrared LED of 850nm wavelength and galvanic current. The proposed periorbital wrinkle treatment device is equipped with a control system based on F-PCB. It consists of eight near-infrared LEDs and four indicator LEDs for treatment of right and left periorbital wrinkles. The eyeglass frame is coated with conductive material, so galvanic current can flow to the skin of periorbital wrinkle contacted to it. One male adult in the mid-40s was allowed to use the device for 10 minutes every day for 4 weeks. After 4 weeks, image analysis using optical equipment for measuring wrinkles indicated that wrinkle indexes were reduced.

• The Journal of the Korean dental association
• /
• v.57 no.3
• /
• pp.175-184
• /
• 2019

Increasing the aesthetic needs of patients and decreasing the use of amalgam had led to increased demand for dental resin composite. Thereby, light curing unit (LCU) has become an essential equipment in dental clinic. To ensure long-term prognosis of photopolymerized materials, LCU should have a uniform and consistent radiant output and an emission spectrum that includes the active wavelength range of photoinitiators. In addition, when the correct use and thorough maintenance and repair of LCU are performed, the higher success rate of restoration using photopolymerization materials will be achieved.

• Current Optics and Photonics
• /
• v.6 no.1
• /
• pp.39-43
• /
• 2022

Underwater optical wireless communication (UOWC) is a good candidate for high-speed underwater wireless communication. In this work, we compare the performance of several modulation techniques for a UOWC system consisting of a light-emitting diode (LED) with an operating wavelength of 405 nm and a Si avalanche photodiode (APD). In this work, we consider six modulation schemes: 4-quadrature amplitude modulation (QAM), 8-QAM, quadrature phase shift keying (QPSK), binary phase shift keying (BPSK), on-off keying (OOK), and 4-pulse amplitude modulation (PAM). We also consider the cases of pure water and seawater for the working conditions. Our results show that 4-QAM and 8-QAM perform the best, in terms of communication distance and transmission power efficiency, for all water types considered.