• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.4
• /
• pp.441-448
• /
• 2015

In this paper, a CPW-fed dual-band monopole antenna with two branch strips for WLAN(Wireless Local Area Networks) applications was designed, fabricated and measured. The proposed antenna is based on a CPW-feeding structure, and composed of two branch strips and then designed and tuned the length of two branch lines to obtained required frequencies bands. To obtain the optimized parameters, we used the simulator, Ansoft's High Frequency Structure Simulator(HFSS) and carried out simulation about parameters $L_5$, $L_8$, $W_3$, $W_5$, $W_9$. The proposed antenna is fabricated on the FR-4 substrate using the obtained parameters. The numerical and experiment results demonstrated that the proposed antenna obtained the -10 dB impedance bandwidth 1,095 MHz (1.57~2.665 GHz) for 2.4 GHz band and 1,680 MHz (4.99~6.67 GHz) for 5 GHz band satisfied requirement while simultaneously covering the WLAN bands. And characteristics of gain and radiation patterns are determined for WLAN operating bands.

• Journal of Institute of Control, Robotics and Systems
• /
• v.20 no.8
• /
• pp.890-894
• /
• 2014

In this paper, we derive the CRLB (Cramer-Rao Lower Bound) of effective carrier-to-noise power ratio ($C/N_0$) estimation for a GPS (Global Positioning System) L1 C/A (Coarse/Acquisition) signal under band-limited white noise jamming environments. The quality of a received GPS signal is commonly described in terms of its $C/N_0$, implying that the noise is white and thus can be described by scalar noise density. However, if some intentional interference is received to a victim GPS receiver, then the $C/N_0$ is no longer the efficacious performance indicator. The correct and straightforward measurement to analyze the receiving situation is the effective $C/N_0$. In this paper, we consider a band-limited white noise jamming whose bandwidth is 2MHz and is the same as one of the first null-to-null bandwidth of the GPS L1 C/A signal.

• Journal of IKEEE
• /
• v.20 no.3
• /
• pp.279-284
• /
• 2016

This paper presents a two stage L-band power amplifier realized with a $0.32{\mu}m$ Silicon-On-Insulator (SOI) CMOS technology. To overcome a low breakdown voltage limit of MOSFET, stacked-FET structures are employed, where three transistors in the first stage amplifier and four transistors in the second stage amplifier are connected in series so that their output voltage swings are added in phase. The stacked-FET structures enable the proposed amplifier to achieve a 21.5 dB small-signal gain and 15.7 dBm output 1-dB compression power at 1.9 GHz with a 122 mA DC current from a 4 V supply. The amplifier delivers a 19.7 dBm. This paper presents a two stage L-band power amplifier realized with a $0.32{\mu}m$ Silicon-On-Insulator (SOI) CMOS technology. To overcome a low breakdown voltage limit of MOSFET, stacked-FET structures are employed, where three transistors in the first stage amplifier and four transistors in the second stage amplifier are connected in series so that their output voltage swings are added in phase. The stacked-FET structures enable the proposed amplifier to achieve a 21.5 dB small-signal gain and 15.7 dBm output 1-dB compression power at 1.9 GHz with a 122 mA DC current from a 4 V supply. The amplifier delivers a 19.7 dBm saturated output power with a 16 % maximum Power Added Efficiency (PAE). A bond wire fine tuning technology enables the amplifier a 23.67 dBm saturated output power with a 20.4 % maximum PAE. The die area is $1.9mm{\times}0.6mm$.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.983-984
• /
• 2006

Multi-band VCO with fast response adaptive frequency calibration (AFC) technique is designed in 1.8V $0.18{\mu}m$ CMOS process. The possible operation is verified for 5.8GHz band, 5.2GHz band, and 2.4GHz band using the switchable L-C resonators for 802.11a/b/g WLAN applications. To linearize its frequency-voltage gain, optimized multiple MOS varactor biasing technique is used. In order to operate in each band frequency range with reduced VCO gain, 4-bit digitally controlled switched-capacitor bank is used and a wide-range digital logic quadricorrelator is implemented for fast frequency detector.

• Proceedings of the IEEK Conference
• /
• 2002.07a
• /
• pp.405-408
• /
• 2002

Because of superior division among sub-channels, DWT MC-CDMA is less interference with neighborhood channel. In our newly proposed multi-carrier CDMA data transmission method, lIR CMFB filter banks sharply divide sub-bands and reduces spectral overlaps among neighboring sub-channels. In experiment result, proposed filter is better ability of sub-band division than FIR filter. Since the proposed cosine modulated filter banks lIR filter having wavelet property is designed to response sharp transition band, the ISI and ICI between neighboring sub-channels can be effectively reduced. And robustness about narrow band interference of CMFB IIR MC-CDMA almost same FIR DWT MC-CDMA.

• Journal of Plant Biology
• /
• v.21 no.1_4
• /
• pp.29-32
• /
• 1978

The karyotype of Lilium cernum has been analysed by means of C-banding technique. Most of clones observed were 2n=24 chromosomes which consist of two pairs of submetacentric and ten pairs of subtelocentric chromosomes, among which two pairs of chromosomes(B and E) showed secondary constriction in the short arm. In addition to these chromosomes a small supernumerary telocentric chromosome was seen in the eight clones. Sixtyeight bands were observed in the twentytwo chromosomes of complement and one band in the supernumerary chromosome. A pair of chromosome (L) did not show any band. The bnads on the chromosome. A pair of chromosome (L) did not show any band. The bands on the chromosomes were distributed in the centromere, secondary constriction and intercalary regions of arms. Of the twelve pairs of chromosomes ten pairs showed symmetric banding patterns in each, but two pairs (I and K) showed asymmetric banding patterns.

• Proceedings of the IEEK Conference
• /
• 2000.07a
• /
• pp.163-166
• /
• 2000

The design, numerical simulation, and an experimental implementation of two-element cross-shaped microstrip line-fed printed slot array antenna for IMT-2000 at the 2.0 GHz band is presented in this paper. The proposed antenna with relative permittivity 4.3 and thickness 1.0mm is analyzed by the Finite-Difference Time-Domain (FDTD) method. It was shown that the measured 2.0 VSWR bandwidth of one-element microstrip slot antenna is from 1.42 GHz to 2.69 GHz, which is approximately 61.8% and that of two-element microstrip slot array antenna is from 1.42 GHz to 2.56 GHz, which is approximately 57.3% And it was shown that the measured gain of one-element microstrip slot antenna is 2.75 dBi and that of two-element microstrip slot antenna is 4.75 dEi. The antennas were fabricated and tested. The measured results are in good agreements with the FDTD results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.7
• /
• pp.1787-1802
• /
• 1996

In this paper, the performance for FH/CPFSK system with limiter-discriminator detection and integrage-and-dump post-detection filtering under thermal noie, partial-band noise jamming and rayleigh fading have been analyzed. The method of hard-decision diversity of which the transmitter repeated L times on different hops for each data symbol in a way to mutigate the effects of the jamming has been applied, and the receiver has been combined the L chips. Also, error-correcting code have been applied for improving performance of system. The thermal noise and partial-band noise jamming, intersymbol interference for all eight of the possible adjacent bit data patterns, and FM noise click for evaluating systems have been considered. Also optimum parameters to improve performance of FH/CPFSK system have been obtained and validities have been proved through computer simulation.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.435-440
• /
• 2002

The objective of this study is to analyze the relationship between polarimetric radar backscatters and stand characteristics over the mountainous forest area. L- and P-band full polarimetric airborne SAR data obtained in September 2000 were processed to compare with forest stand maps and ground collected stand variables. After the geometric registration of SAR image, mean radar backscatters were extracted for those ground plots where the stand parameters, such as tree height, DBH, and basal area, were measured during and after the SAR data acquisition. Preliminary analysis was focused on the topographic influence of radar backscattering under the homogeneous forest stand condition. Topographic effects, assessed by the local incidence angles, were different obvious in L-band data while it was not clear with P-band data.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.9
• /
• pp.841-848
• /
• 2016

In this paper, a microstrip-fed dual-band monopole antenna with DGS(: Defected Ground System) for WLAN(: Wireless Local Area Networks) applications was designed, fabricated and measured. The proposed antenna is based on a microstrip-fed structure, and composed of two strip lines and DGS structure and then designed in order to get dual band characteristics. We used the simulator, Ansoft's High Frequency Structure Simulator(: HFSS) and carried out simulation about parameters W2, L10, W3, and DGS to get the optimized parameters. The proposed antenna is made of $21.0{\times}36.0{\times}1.6mm3$ and is fabricated on the permittivity 4.4 FR-4 substrate. The experiment results are shown that the proposed antenna obtained the -10 dB impedance bandwidth 700 MHz(2.10~2.80 GHz) and 1,780 MHz(5.02~6.80 GHz) covering the WLAN bands. Also, the measured gain and radiation patterns characteristics of the proposed antenna are presented at required dual-band(2.4GHz band/5.0GHz band), respectively.