• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.215-216
• /
• 2006

In this paper, the antenna the with linear active phased array of $1{\times}16$ operated in DBS band was designed. The antenna was composed of sixteen radiating elements, sixteen active channels and five Wilkinson power combiners with 4-channel inputs, a digital control board and a stabilizing DC bias board. The radiating element of the array has the structure of a microstrip stack patch with a left-hand circular polarization. And, each active channel consists of a low noise ampilifier, a 3-bit digital phase shifter and a variable analog attenuator. The breadboard of linear active phased array antenna was also fabricated to test the electrical performances. The radiation patterns of the antenna were measured after correcting initial phases of each active channel in aechoic chamber. And also, the beam scanning chracteristcs of $10^{\circ}$, $20^{\circ}$, $30^{\circ}$ were measured.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.2
• /
• pp.33-39
• /
• 2013

In this paper, X/Ku band waveguide diplexers with H-plane T-junction for satellite communication systems is proposed and its characteristics is cinfirmed. Two frequency bands such as X(7.25 ~ 8.4 GHz) and Ku(12.25 ~ 14.5 GHz) can be separated by the proposed waveguide diplexers. A diplexers is normally including low pass filter, high pass filter and junction waveguide. To simplify the structure of the proposed diplexers, the proposed waveguide diplexers is using impedance matching technique on H-plane of the high pass filter without low pass filter. To use vertical and horizontal polarization, the proposed diplexers with orthomode transducer(OMT) characteristics is also designed. Therefore, it is confirmed that the proposed waveguide diplexers can be used as dual-band and dual-polarization diplexers for satellite communication feed systems.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.12 s.91
• /
• pp.1141-1146
• /
• 2004

The antenna array for receiving satellite broadcasting of Koreasat III is proposed. A cavity-backed slot antenna array is proposed to reduce feed line loss, increase the radiation efficiency, and make the feed network simple. A sub-array consists of $2{\times}4$ slot elements backed by a single cavity. By proper choice of dimensions it is shown that the proposed antenna has characteristics of the high radiation efficiency and the broad frequency bandwidth. Antenna characteristics for the array antenna with 256 elements are measured in Ku-band. A single cavity backed-sub-array has the gain of 18 dEi. The gam of the total antenna array(256 elements) is Over 33 dEi.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.5
• /
• pp.872-882
• /
• 1994

In this paper, the Low Noise Amplifier(LNA) is designed and fabricated to include a band pass filter characteristics considering the antenna system characteristics according to the transmitting and receiving signal level of communication satellite transponder. As an example, a 2-stage low noise amplifier and a 4-stage amplifier and designed, fabricated and measured at 14,0~14.5GHz of receiving frequency band. This fabricated LNA has shown the gain with very good flatness within pass-band, and its gain decreases rapidly out of band resulting in supperssion of the transmitting signal power leakage. It has shown the 20.3dB +- 0.1dB of pass-band gain, the 1.44dB +-0.04dB of noise figure and the 14dB rejection out of band(12.25~12.75GHz). The gain flatness, noise figure and group delay of this 2-stage LNA satisfactorily met the simulation results. And the fabricated 4-stage amplifier has shown the more than 42dB of pass-band gain, the +-0.25dB of flatness and the 28dB of the rejection effect for transmitting power leakage. The 2-stage LNA and 4-stage amplifier, in this paper, will bring a design margin for the input filter and also result in the system cost reduction.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.3
• /
• pp.515-522
• /
• 1994

The radiation characteristics of the conical corrugated feed horn are analyzed by the Gaussian beam mode theory. the electric field over the aperture can be expanded in terms of a set of Gaussian-Laguerre modes. It is proved that these modes are the solutions of the wave epuations for the paraxial approximation. A method, using the sum of the mode expansion coefficients instead of calculation only the fundamental mode, is presented in order to reduce the radiation pattern error. For illustrative examples, the radiation patterns of the corrugated horn antenna operting over C, Ku, and mm-wave band are calculated. Our results agree well with the results obtained by the vector potential method over each band, and also agree well with the measured value at 6.175GHz.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.11
• /
• pp.1574-1580
• /
• 2021

This paper designs and presents the results of an air network simulation radio transmission link applied with a multi-beam active phase array antenna simulator in a testbed system for verifying an air network currently underway as a technology development task. Using the Ku band, the Radio transmission link was designed in consideration of the link budget to satisfy the requirements for the system being developed. Considering short-distance links and long-distance links, the required EIRP and G/T performance scales of multi-beam repeaters and mission planes were applied to confirm the minimum and maximum link margins based on Eb/No. In this Radio Transmission Link design, the application analysis results such as rainfall availability are used to effectively establish standards when selecting the operating radius of the multi-beam relay system and related system standards.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2006.05a
• /
• pp.611-614
• /
• 2006

Resolution 122 requires to study power limitation applicable for HAPS ground stations to facilitate sharing with space station receivers in 47/48GHz bands. ITU-R Recommendation 1481-1 recommends to improve the side lobe characteristics of HAPS ground station antenna for sharing between FSS system and HAPS system. Thus, in this paper, we propose maximum allowable off-axis e.i.r.p. level of HAPS ground station antennas by considering power limitation to HAPS ground station in Resolution 122 in order to reduce unfeasible separate distance between HAPS and GSO FSS service coverage and improve the side lobe characteristics of HAPS ground station antennas in Recommendation SF.1481-1.

• Proceedings of the KIEE Conference
• /
• 2004.07c
• /
• pp.2055-2057
• /
• 2004

The Ku band that has been using for the satellite communication and broadcasting would be changed to K/Ka bands. The satellite system requires the antenna structure to fabricate low loss and small antenna that is able to be integrated with other Rf circuits for both Rx and Tx. So we should design it with dual feed antennas at K/Ka bands, high isolation between two different feeds and broadband circular polarization. This paper proposes the LTCC(Low Temperature Co-fired Ceramic) process for integration with other Rf circuits and the Axial mode of the helical antenna to satisfy those requirements.

• Electronics and Telecommunications Trends
• /
• v.21 no.5 s.101
• /
• pp.154-162
• /
• 2006

본 논문에서는 성층권 통신망(HAPS)과 기존 위성망 및 지상망과의 원활한 공유를 위해서 진행되고 있는 HAPS 시스템의 간섭경감기법에 관한 연구 동향을 분석한다. 이를위해서 2006년 6월 27일부터 7월 5일까지 개최된 ITU-R WP9B 회의를 통하여 논의된 주요 결과들을 중심으로 살펴보고자 한다. Ka 대역에서 고정업무(FS)용으로 활용가능한 HAPS 시스템의 간섭경감기법으로 5가지가 제안되었으며, 특히 본 회의에서는 디지털빔형성(DBF) 기법을 적용한 탑재안테나의 다중빔 패턴의 성능분석 결과들이 제시되었다. HAPS 시스템의 간섭경감기법으로 디지털빔 형성기법을 적용함에 있어서 그 필요성과 ITU-R WP9B에서 논의되고 있는 내용들을 중심으로 간섭경감기법 분석 결과를 기술하고 본 내용과 관련한 ITU-R에서의 향후 연구 전망 등을 살펴보고자 한다.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.53 no.9
• /
• pp.481-487
• /
• 2004

The Ku band that has been using for the satellite communication and broadcasting would be changed to K/Ka bands. The satellite system requires the antenna structure to fabricate low loss and small antenna that is able to be integrated with other Rf circuits for both Rx and Tx. So we should design it with dual feed antennas at K/Ka bands, high isolation between two different feeds and broadband circular polarization. This paper proposes the LTCC(Low Temperature Co-fired Ceramic) process for integration with other Rf circuits and the Axial mode of the helical antenna to satisfy those requirements.