• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.2D
• /
• pp.163-170
• /
• 2008

According to the rules, a crash cushion is supposed to set up products that is satisfied with the standard of a performance test after performing the car crash test by road safety facilities and management guide. For development of crash cushion, performance should be estimated through the car crash test eventually. However, there is no reasonable design method which considers passenger's safety and only depend on crash test without an alternative plan. Therefore it incurs a loss materially and takes a lot. Therefore, we are asked to create a systematic design of the crash cushion. This study shows that a scientific basis of applying single degree of freedom when it designs the crash cushion after analyzing vehicle crash test data of crash cushion and also represents design of crash cushion through single degree of freedom response spectrum using calculated by crash test data on crash cushion.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.2D
• /
• pp.235-242
• /
• 2008

Due to the lack of judgement in an information processing on road sign, older drivers usually are having a hard time driving than young group. Furthermore, according to increasing in aging population, older drivers in Korea have been growing much faster. That means research for older drivers' characteristics and the number of guide name for road sign should be needed. In accordance with suggestions, this study was carried out the number of guide names for road sign with a variety of ages from the twenties to the seventies. For the sake of this study, statistical verification was conducted to confirm a change of speed, a reading time and a misreading rate with Driving Simulator and Electrooculogram tool. As the results of study, change of speed in the age range has shown that the higher the proportion of age, the lower the rate of velocity. Also reading time in the age range with regression analysis found that the higher the proportion of age, the higher the rate of reading time by 0.106sec. Finally, a binary logistic model was used to find the main factors. As the results, 4 number of guide names for road sign have been the best of them for older driver. The result of this study verified the importance of ideal guide numbers on road sign for older driver and proved itself to be an effective method to determine the road safety for the road signs.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.6D
• /
• pp.809-817
• /
• 2008

This paper deals with the development of ViscoElastic Continuum Damage Finite Element Program (VECD-FEP++) and its verification with the results from both field and laboratory accelerated pavement tests. Damage characteristics of asphalt concrete mixture have been defined by Schapery's work potential theory, and uniaxial constant crosshead rate tests were carried out to be used for damage model implementation. VECD-FEP++ predictions were compared with strain responses (longitudinal and transverse strains) under moving wheel loads running at different constant speeds. To this end, an asphalt pavement section (A5) of Korea Expressway Corporation Test Road (KECTR) instrumented with strain gauges were loaded with a dump truck. Also, a series of accelerated pavement fatigue tests have been conducted at pavement sections surfaced with four asphalt concrete mixtures (Dense-graded, SBS, Terpolymer, CR-TB). Planar strain responses were in good agreement with field measurements at base layers, whereas strains at both surface and intermediate layers were found different from simulation results due to the complexity of tire-road contact pressures. Finally, fatigue characteristics of four asphalt mixtures were reasonably described with VECD-FEP++.

• Journal of Navigation and Port Research
• /
• v.47 no.3
• /
• pp.120-127
• /
• 2023

Maritime pilots are always exposed to unpredictable risks present in the marine environment because they are boarding ships through pilot ladders or accommodation ladders at sea. Since the pilot plays an important role in securing the safety of a ship entering or departing from a port, an injury to the pilot substantially affects the overall safety of the ship. The purpose of this study is to analyze pilot injuries and predict accidents. For this purpose, pilot injury cases are analyzed and potential situations are identified through a survey. Pilot injuries are also predicted. The survey was analyzed using the IPA (Importance-Performance Analysis) methodology, and the binomial distribution and Poisson distribution were used to predict injury trends. As a result of the study, 316.8 nearmiss occurred per pilot injury, and if the current accident management system is maintained, the probability of pilot injury occurring within 3 months is 64.4%. Based on the research results, the need for a management system to prevent pilot injuries and reinforcement of maintenance and installation for pilot ladders was suggested.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.4D
• /
• pp.485-492
• /
• 2008

This study presents a viscoelastic characterization of flexible pavement subjected to moving loads. A series of field tests have been conducted on three pavement sections (A2, A5, and A8) at the Korea Expressway Corporation (KEC) test road. The effect of vehicle speed on the responses of each test section was investigated at three speeds: 25 km/hr, 50 km/hr, and 80 km/hr. During the test, both longitudinal and lateral strains were measured at the bottom of asphalt layers and in-situ measurements were compared with the results of finite element (FE) analyses. A commercial FE package, ABAQUS was used to model each test section and a step loading approximation has been adopted to simulate the effect a moving vehicle. For viscoelastic analysis, relaxation moduli of asphalt mixtures were obtained from laboratory test. Field responses reveals the strain anisotropy (i.e., discrepancy between longitudinal and lateral strains) and the amplitude of strain normally decreases as the vehicle speed increases. In most cases, lateral strain was smaller than longitudinal strain, and strain reduction was more significant in lateral direction.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.26 no.4A
• /
• pp.753-759
• /
• 2006

To predict service life of concrete structures exposed to chloride attack, surface chloride concentration, diffusion coefficient of chloride ion, and chloride corrosion threshold value in concrete, are used as important factors. Of these, as the diffusion coefficient of chloride ion for concrete is strongly influenced by concrete quality and environmental conditions of structures and may significantly change the service life of structures, it is considered as the most important factor for service life prediction. The qualitative factors affecting the penetration and diffusion of chloride ion into concrete are water-cement (W/C) ratio, age, curing conditions, chloride ion concentration of given environment, wet and dry conditions, etc. In this paper the influence of W/C ratio and curing conditions on the diffusion characteristics of chloride ion in concrete was investigated through the chloride ion diffusion test. In the test, the voltages passing through the diffusion cell were measured by accelerated test method using potential difference, and then with the consideration of IR drop ratio the diffusion coefficient of chloride ion for concrete with different W/C ratios were estimated by Andrade's model. Furthermore, under different curing conditions formulas for the estimation of the diffusion coefficient of chloride ion have been proposed by the regression analysis considering the effect of W/C ratio and age.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.1A
• /
• pp.1-8
• /
• 2009

Stay cable is easily exposed to vibration induced rainy wind effects. There are some problems for not only unexpected vibration but also well-known vibration. An outbreak of displacement by the said effects brings damages such as over-tension of cables and barriers, fatigue of anchorages and dampers, and additional shear force variation of stiffening girders. This study suggests analytic methodology for dynamic tension variation of cables and shear force variation of stiffening girders. Additionally this study announces with dynamic problems for cable stayed bridge briefly. To realize this subject, we divide restoring force into chord component and normal component and then make up the differential equations which can satisfy physical phenomenon for each component. Finally we apply adequate functions such as sinusoidal and parabola in order to reduce these differential equations. Therefore we can meet with good results through a series of above process. As a remarkable result, CIP recommendations (2002) give inadequate solution with over 10% error. However it gives very good solution if parts of our study are reflected at the said recommendations. The fact means that CIP recommendations (2002) well-known as international standard of stay cables are not even concern about this subject yet. For verification of this study, F.E. analysis using E.C.C. with external forces was fulfilled, and the accuracy and conciseness of this study were shown.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.29 no.6A
• /
• pp.625-639
• /
• 2009

Experimental and analytical studies are performed on the mechanical behavior of concrete-filled tubular(CFT) truss girders for different f/L ratios. Bending tests are conducted on two CFT truss girder specimens to determine fundamental structural characteristics such as the strength and deformation properties. Nonlinear material models for CFT members subjected to an axial compressive force are compared in this paper by using the nonlinear finite element program, ABAQUS. Previous researchers have proposed several nonlinear stress-strain models of confined concrete. In this study, the nonlinear analyses are performed applying several stress-strain models for confined concrete proposed by Mander, Sakino, Han, Susantha and Ellobody, and the results are compared with the experimental results in terms of load-deflection and load-strain relationships. Based on the comparisons of the load-deflection relationships, the models proposed by Mander and Susantha provide a maximum load about 12.0~13.8% higher and that by Sakino gives a maximum load about 7.6% higher than the experimental results. The models proposed by Han and Ellobody give a maximum load only about 0.2~1.2% higher than the test results, showing the best agreement among the proposed stress-strain models. However, the load-strain relations predicted by the existing models generally provide conservative results exhibiting larger strains than the experimental data.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.4
• /
• pp.325-331
• /
• 2023

The navigational officer's knowledge about securing stability, an essential factor for promoting the safe operation of ships, should be improved along with advancement in ship technology, such as the large-sized ships and the appearance of autonomous ships. Accordingly, this study conducted a survey on stability, targeting navigational officers, and analyzed empirical awareness using general characteristics. Navigational officers had a high level of understanding of the stability criteria for a higher rank, but lacked the understanding of the special criteria for specific ship types. Of the total respondents, 87.6% were using a loading computer to evaluate stability. The GM scored the highest (3.891/5.000 points) as a method of evaluating stability on the ship. Further, whether the stability was secured was determined based on the GM and stability criteria. Most navigational officers replenish additional ballast water to improve the stability and use a small angle of rudder in the case of lacking stability. The results of this study are intended to be used as important data for improving education and research on operator-centered stability in the future by evaluating the empirical awareness of navigational officers on the ship stability.

• Journal of the Korean School Mathematics Society
• /
• v.26 no.2
• /
• pp.111-135
• /
• 2023

This study conducted a student-centered inquiry lesson on the similarity of figures using AlgeoMath, with student learning aspects analyzed from a communication perspective. This approach aimed to inform pedagogical implications related to teaching geometric similarity. Through utilizing AlgeoMath, students were able to visually confirm that their chosen figures were similar, experiencing key mathematical concepts such as the ratio of similarity to the area of similar figures, and congruency and similarity conditions of triangles. In the lessons applying this concept, we categorized the features of similarity learning displayed by students, as seen in the communication aspects of their exploratory activities, into 'Understanding similarity ratios', 'Grasping conditions of similarity in triangles', and 'Comparing concepts of congruency and similarity'. Through exploratory activities based on AlgeoMath, students discussed the meaning and mathematical relationships of key concepts related to similarity, such as the ratio of similarity to the area of figures, and the meaning and conditions of congruence and similarity in triangles. By improving misconceptions about the similarity of figures, they were able to develop deeper mathematical understanding. This study revealed that in teaching and learning the geometric similarity using AlgeoMath, obtaining meaningful pedagogical outcome was not solely due to the features of the AlgeoMath environment, but also largely depended on the teacher's guidance and intervention that stimulated students' thinking.