• 대한수학회보
• /
• 제53권2호
• /
• pp.541-550
• /
• 2016

In this paper, we introduce a quasi-Banach algebra of infinite matrices, which is inverse-closed in the Banach algebra B(${\ell}^2$) of all bounded operators on ${\ell}^2$.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 추계학술대회 논문집 학회본부
• /
• pp.182-185
• /
• 1996

The purpose of slate estimation in power system is to estimate the best-fit Slate variables from the measurements contaminated by various kind of noise. But because the majority of state estimation modules in EMS lack the convergence characteristics, sometimes the desirable outputs can't be obtained. So, in this paper, the new algorithm using the load now output as initial values in the state estimation calculation is proposed to guarantee the convergence. And if the load now outputs were used as the initial values in the calculation, the change in each step would be small compared to the original method using the flat start point. And the Inverse Lemma is used in the algorithm to calculate the new stale in each iteration step for reducing the calculation time. The proposed algorithm was tested on the IEEE 14, 30, 118 bus systems. Eventually, we were able to verity that the differences between the results obtained by the original method and proposed method were relatively small, and the effectiveness of the proposed algorithm increased when applied to the bigger systems.

• KIEE International Transactions on Power Engineering
• /
• 제3A권2호
• /
• pp.79-84
• /
• 2003

Unbalanced systems, such as distribution systems, have difficulties in fault locations due to single-phase laterals and loads. This paper proposes new fault locations developed by the direct three-phase circuit analysis algorithms using matrix inverse lemma for the line-to-ground fault case and the line-to-line fault case in unbalanced systems. The fault location for balanced systems has been studied using the current distribution factor, by a conventional symmetrical transformation, but that for unbalanced systems has not been investigated due to their high complexity. The proposed algorithms overcome the limit of the conventional algorithm using the conventional symmetrical transformation, which requires the balanced system and are applicable to any power system but are particularly useful for unbalanced distribution systems. Their effectiveness has been proven through many EMTP simulations.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 정기총회 및 창립40주년기념 학술대회 학회본부
• /
• pp.122-124
• /
• 1987

This paper presents a new algorithm in formulating a performance index for contingency selection method considering voltage security. Security limits defined-in terms of real power line flows and voltage magnitudes are considered in normalized subspaces where in critical contingencies are identified by a filtering algorithm using the infinite norm. Two types of limits, warning limit and emergency limit, are introduced for voltage and line flow. Usually performance indices have been constructed for real power line flows and voltages with each different criterion. This paper, however, presents a method that constructs them with the same criterion in use of the norm properties, so that we can assess security considering both of them. Rapid contingency simulation is performed using one iteration of fast decoupled load flows with LMML(Inverse Matrix Modification Lemma).

• 한국음향학회지
• /
• 제14권3호
• /
• pp.37-48
• /
• 1995

일반화된 완전최소자승법 (generalized total least squares method, GTLS)의 ARMA 시스템 식별에의 적용과 GTLS의 적응알고리듬에 대하여 논한다. 일반화된 완전최소자승법은 일별과 출력을 알고 있는 시스템식별 (system identification)문제에서, 출력이 잡음에 의하여 오염된 경우, 편이되지 않은 해를 구하기 위하여 사용되는 방법이다. 본 논문에서는 먼저 GTLS를 ARMA 시스템 식별에 적용하기 위한 formulation을 하고, 일반화된 완전최소자승법의 일반 해의 성질과 역행렬 정리 (matrix inverse lemma)를 이용하여 적응 GTLS 방법을 제안한다. 다음 제안된 방법을 통하여 시스템식별에 적용하여 그 성능을 평가한다. 또한 GTLS 알고리듬과 제안한 적응 GTLS 알고리듬의 성능을 수학적으로 해석하고 컴퓨터 시뮬레이션을 통하여 이를 검증한다.

• 대한전기학회논문지:전력기술부문A
• /
• 제51권8호
• /
• pp.409-416
• /
• 2002

This paper presents a fault location algorithm using direct 3-phase circuit analysis for distribution power networks. The unbalanced feature of distribution networks due to single phase loads or asymmetric operation prohibits us from using the conventional symmetrical component transformation. Even though the symmetrical component transformation provides us with a very easy tool in three phase network analysis, it is limited to balanced systems in utilizing its strong point, which is not suitable for distribution networks. In this paper, a fault location algorithm using direct 3-phase circuit analysis is developed. The algorithm is derived and it Is shown that the proposed method if we use matrix inverse lemma, is not more difficult then the conventional methods using symmetrical component transformation. Since the symmetrical component transformation is not used in the suggested method, unbalanced networks also can be handled with the same difficulty as balanced networks. The case study results show the correctness and effectiveness of the proposed algorithm.