• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.8
• /
• pp.69-75
• /
• 1998

We demonstrate wavelength conversion of 2.5Gb/s optical signals by four-wave mixing (FWM) in a semiconductor optical amplifier (SOA). We investigate the effect of input pump and signal powers on the coversion efficiency, optical signal-to-noise ratio (OSNR) and extinction ratio to be a measure of performance in a wavelength converter. As a result, we show that the maximum bit error rate (BER) performance can be obtained by co promising among high-vonversion efficiency (minimum Pprobe), high-OSNR (maximum Pprobe) and low-cross-gain saturation effects (Pprobe kept at least 6dB weaker than Ppump). In our experiment, we obtain optimum performance at +3 dBm pump power and -6dBm signal power. The power penalty incurred in the wavelength conversion can be minimized by careful selection of the input pump and signal powers. We show that about 0.5dB power penalty for 3.2nm wavelength coversion at 10-10 BER is achievable.

• Journal of information and communication convergence engineering
• /
• v.15 no.3
• /
• pp.187-192
• /
• 2017

Autonomous driving vehicle research demands complex road and lane understanding such as lane departure warning, adaptive cruise control, lane keeping and centering, lane change and turn assist, and driving under complex road conditions. A fast and robust road lane detection subsystem is a basic but important building block for this type of research. In this paper, we propose a method that performs road lane detection from black box input. The proposed system applies Random Sample Consensus to find the best model of road lanes passing through divided regions of the input image under HSV color model. HSV color model is chosen since it explicitly separates chromaticity and luminosity and the narrower hue distribution greatly assists in later segmentation of the frames by limiting color saturation. The implemented method was successful in lane detection on real world on-board testing, exhibiting 86.21% accuracy with 4.3% standard deviation in real time.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.52 no.1
• /
• pp.28-34
• /
• 2003

In this paper, a predistortion linearizer using series diode is proposed for linearizing the power amplifier in microwave radio systems. The power amplifier should be operated near saturation region to achieve high efficiency. But at this region, amplitude and phase distortions of the amplifier remarkably increase with the increase of input power and cause a significant adjacent channel interference. The linearizer is composed of a series diode with a parallel capacitor, which provides positive amplitude and negative phase deviations with the increasing input power. This type of linearizer using the nonlinearity of diode has improved the C/I(Carrier to Intermodulation Distortion) ratio well. By applying this linearizer to two-tone 880MHz power amplifier, adjacent channel leakage power is improved up to 5dBm.

• Transactions on Control, Automation and Systems Engineering
• /
• v.3 no.3
• /
• pp.152-158
• /
• 2001

This paper proposes a simple feedforward compensator in order to decrease the amount of undershoots and overshoots on the step response in nonminimum phase systems. The compensator makes the step type input be a ramp input with saturation for 0$\leq$t<${\alpha}$. It is shown in this paper that the compensated system has small amount of undershoot and overshoot at the price of rise time compared to the system without compensator. Also, provided the system is properly stable, the influence of the design parameter ${\alpha}$ on the step response of the nonminimum phase system is investigated in the case of Type A, and Type B undershoot, which gives a guideline for the compensator design.

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1966-1971
• /
• 2005

Though several previous anti-windup techniques have been proposed, they are limited to linear systems or friction is not considered. Thus this paper proposes a compensation scheme for input-constrained robot systems with friction to cope with the windup phenomenon and shows its effectiveness by simulations. Given a feedback linearizing controller for a robot system designed without considering its input constraint, an additional dynamic compensator is proposed to account for the constraint. The dynamic anti-windup is based on the minimization of a reasonable performance index, and properties of the resulting closed-loop are presented.

• Korean Journal of Optics and Photonics
• /
• v.5 no.2
• /
• pp.291-297
• /
• 1994

A feedback loop with bandpass filter is introduced in erbium-doped fiber amplifier to clamp the amplifier gain by lasing the amplifier at a selected wavelength. The gain and the ASE (amplified spontaneous emission) output spectra are found to be independent of input signal power and pump power variation so long as the amplifier is lasing. Also they are found to be dependent only on the overall loss of the feedback loop. Even in the case of slowly modulated large signal input, signal distortion due to gain saturation is not observed.served.

• International Journal of Fuzzy Logic and Intelligent Systems
• /
• v.2 no.3
• /
• pp.231-236
• /
• 2002

In this paper, we present an analysis and design method fur the control of input-saturated nonlinear systems with the time-delay. The target system is represented by Takagi-Sugeno (T-S) fuzzy model and the parallel distributed compensation (PDC) controller is designed to guarantee the local stability of the equilibrium point. We derive the sufficient condition for the local stability by applying Lyapunov-krasovskii theorem and this condition is converted into the LMI problem.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.500-500
• /
• 2000

In this paper, we deal wit,11 a simple tim varying feedforward compensator in order to decrease the amount of undershoots and overshoots on the step response. This compensator makes the step type input be a ramp input with saturation for 0 $\leq$ t < $\alpha$. It will be shown that the system with the feedforward compensator has small amount of undershoot and overshoot at the price of rise time. Also, provided the system properly stable, the influence of the design parameter $\alpha$ on the step response of the system with the feedforward compensator is investigated in the current paper.

• Journal of IKEEE
• /
• v.18 no.2
• /
• pp.206-213
• /
• 2014

In this note, a new robust nonlinear output feedback variable structure controller is first systematically and generally designed for the output control of more affine uncertain nonlinear systems with mismatched uncertainties and matched disturbance. A transformed integral output feedback sliding surface with a most simple form is applied in order to remove the reaching phase problems. The closed loop exponential stability and the existence condition of the sliding mode on the integral output feedback sliding surface is investigated with a corresponding output feedback control input in Theorem 1. For practical application the continuous implementation of the control input is made by the modified saturation function. The effectiveness of the proposed controller is verified through a design example and simulation study.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.6
• /
• pp.82-89
• /
• 1997

In this paper, an adaptive speed controller with an FNN(Feedforward Neural Network) is proposed for servo motor drives. Generally, the motor system has nonlinearities in friction, load disturbance and magnetic saturation. It is necessary to treat the nonlinearities for improving performance in servo control. The FNN can be applied to control and identify a nonlinear dynamical system by learning capability. In this study, at first, a robust speed controller is developed by Lyapunov stability theory. However, the control input has discontinuity which generates an inherent chattering. To solve the problem and to improve the performances, the FNN is introduced to convert the discontinuous input to continuous one in error boundary. The FNN is applied to identify the inverse dynamics of the motor and to control the motor using coordination of feedforward control combined with inverse motor dynamics identification. The proposed controller is developed for an SR motor which has highly nonlinear characteristics and it is compared with an MRAC(Model Reference Adaptive Controller). Experiments on an SR motor illustrate te validity of the proposed controller.