• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.3A
• /
• pp.325-333
• /
• 2000

The proposed RPSS(Reference Picture Segment Selection) mode is the RPS mode in picture segment of the ISD mode. The RPS mode has the weakness that it has to change the whole reference picture even if transmission error occurs only in the small part of picture. If the RPS mode is applied only to an error-occurred part and a conventional coding scheme is applied to an error-free part, the higher coding efficiency can be obtained. Simulation results show that there is the optimal number of segment which provides that best performance with given environment such as the BER(Bit Error Rate) of wireless channels, the characteristics of imput sequence, what kind of RPSS mode is used, etc. To apply the channel-adoptive RPSS mode later, the scheme which can change the number of segment without INTRA refresh and spatial error propagation is proposed in this paper.

• Current Optics and Photonics
• /
• v.1 no.4
• /
• pp.289-294
• /
• 2017

A high-performance time-division multiplexing (TDM) -based multiuser (MU) multiple-input multipleoutput (MIMO) system for efficient indoor visible-light communication (VLC) is presented. In this work, a MIMO technique based on RGB light-emitting diodes (LEDs) with selection combining (SC) is utilized for data transmission. That is, the proposed scheme employs RGB LEDs for parallel transmission of user data and transmits MU data in predefined slots of a time frame with a simple and efficient design, to schedule the transmission times for multiple users. Simulation results demonstrate that the proposed scheme offers an approximately 6 dB gain in signal-to-noise ratio (SNR) at a bit error rate (BER) of $3{\times}10^{-5}$, as compared to conventional MU single-input single-output (SISO) systems. Moreover, a data rate of 66.7 Mbps/user at a BER of $10^{-3}$ is achieved for 10 users in indoor VLC environments.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.6
• /
• pp.36-42
• /
• 1997

This paper presents a new design technique for performing high quality low bit rate image compression. A hybrid coder(HC) which combines Mean Removed Important Coefficient Selection based JPEG(MR-ICS-JPEG) and Adaptive Vector Quantization (AVQ) is proposed. A new quantization table is developed using the Important Coefficient Selection(ICS) method; the importance of each coefficient is determined using the orthonormal property of the DCT. This quantization table is applied to standard JPEG with mean removal(MR) strategy before processing. This scheme, called MR-ICS-JPEG, produces more than 2 dB enhanced performance in terms of PSNR over standard JPEG. A set of homogeneous codebooks is generated by homogeneous training vectors. Before compression, an image is uniformly divided into 8${\times}$8 blocks. Low detail regions such as backgrounds are roughly coded by AVQ while high detail regions such as edges or curves are finely coded by the proposed MR-ICS-JPEG. This hybrid coder procuces consistently about 3 dB improved performance in terms of PSNR over standard JPEG.

• Convergence Security Journal
• /
• v.19 no.4
• /
• pp.87-96
• /
• 2019

Recently, with the rapid development of video equipment and technology, tremendous video information is produced and utilized in military domain to acquire battlefield information or for effective command control. Note that the video playback devices currently used in the military domain ranges from low-performance tactical multi-functional terminals (TMFT) to high-performance video servers and the networks where the video information is transmitted also range from the low speed tactical information and communication network (TICN) to ultra-high speed defense broadband converged networks such as M-BcN. Therefore, there is a need for an efficient streaming technique that can efficiently transmit defense video information in heterogeneous communication equipment and network environments. To solve the problem, this paper proposes a Scalable Video Coding (SVC) and balanced selection algorithm based Peer-to-Peer (P2P) streaming technique and the feasibility of the proposed technique is verified by simulations. The simulation results based on our BitTorrent simulator show that the proposed balanced selection scheme outperforms the sequential or rarest selection algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.11C
• /
• pp.1066-1072
• /
• 2007

In this paper, we propose a fast multiple reference frame selection method for motion estimation and compensation in video coding. Reference frames selected as an optimal reference frame by variable block sizes motion estimation have the statistical characteristic that was based on block size. Using the statistical characteristic, reference frames for smaller block size motion estimation can be selected from reference frame which was decided as an optimal one for the upper layer block size. Simulation results show that the proposal method decreased the computations about 60%. Nevertheless, PSNR and bit rate were almost same as the performances of original H.264 multiple reference motion estimation.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.3
• /
• pp.1425-1440
• /
• 2017

In wireless communications, antenna selection (AS) is a widely used method for reducing comparable cost of multiple RF chains in MIMO systems. As is well known, most of literatures on combining AS with MIMO techniques concern linear modulations such as phase shift keying (PSK) and quadrature amplitude modulation (QAM). The combination of CPM and MIMO has been considered an optimal choice that can improve its capacity without loss of power and spectrum efficiency. The aim of this paper is to investigate joint transmit and receive antenna selection (JTRAS) in CPM MIMO systems. Specifically, modified incremental and decremental JTRAS algorithms are proposed to adapt to arbitrary number of selected transmit or receive antennas. The computational complexity of several JTRAS algorithms is analyzed from the perspective of channel capacity. As a comparison, the performances of bit error rate (BER) and spectral efficiency are evaluated via simulations. Moreover, computational complexity of the JTRAS algorithms is simulated in the end. It is inferred from discussions that both incremental JTRAS and decremental JTRAS perform close to optimal JTRAS in BER and spectral efficiency. In the sense of practical scenarios, adaptive JTRAS can be employed to well tradeoff performance and computational complexity.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.7
• /
• pp.55-61
• /
• 2004

This paper proposes an antenna selection and switching system between spatial multiplexing and diversity techniques. The proposed system overcomes spatial correlation by using antenna selection method and improve bit error performance with switching encoding nudes between a spatial multipexing encoder and a diversity encoder. Therefore, in a 4 transmit and 2 receive antenna system first, the proposed system selects 2 transmit antennas, and next, switches encoding modes between Space-Time Transmit Diversity and BLAST according to instantaneous channel information. Computer simulations showed that the proposed system improves about 2 or 3 ㏈ SNR in low correlated channel and about 3 ㏈ SNR in highly correlated channel rather than a 2 by 2 antenna switching system.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.17 no.11
• /
• pp.3204-3217
• /
• 2023

In this paper, the downlink of the multicast based spatial modulation systems is investigated. Specifically, physical layer multicasting is introduced to increase the number of access users and to improve the communication rate of the spatial modulation system in which only single radio frequency chain is activated in each transmission. To minimize the bit error rate (BER) of the multicast based spatial modulation system, a joint optimizing algorithm of antenna selection and multicast precoding is proposed. Firstly, the joint optimization is transformed into a mixed-integer non-linear program based on single-stage reformulation. Then, a novel iterative algorithm based on the idea of branch and bound is proposed to obtain the quasioptimal solution. Furthermore, in order to balance the performance and time complexity, a low-complexity deflation algorithm based on the successive convex approximation is proposed which can obtain a sub-optimal solution. Finally, numerical results are showed that the convergence of our proposed iterative algorithm is between 10 and 15 iterations and the signal-to-noise-ratio (SNR) of the iterative algorithm is 1-2dB lower than the exhaustive search based algorithm under the same BER accuracy conditions.

• Journal of Communications and Networks
• /
• v.12 no.6
• /
• pp.529-532
• /
• 2010

Multi-carrier demultiplexer/demodulator (MCDD) in an on-board processing (OBP) satellite used for digital multimedia services has two typical architectures according to the channel demultiplexing procedure: Multistage multi-carrier demultiplexer (M-MCD) or poly-phase fast Fourier transform (PPF). During the channel demultiplexing, phase and quantization errors influence the performance of MCDD; those errors affect the bit error rate (BER) performance of M-MCD and PPF differently. In this paper, we derive the phase error variances that satisfy the condition that M-MCD and PPF have the same signal to noise ratio according to quantization bits, and then, with these results, analyze the BER performances of M-MCD and PPF. The results provided here may be a useful reference for the selection of M-MCD or PPF in designing the MCDD in an OBP satellite communications system.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.4
• /
• pp.127-135
• /
• 1994

In this paper we propose an EWLD(Enhanced Weighted Levenshtein Distance) algorithm to organize code-string pattern matching linear array processor based on the mappting to an one-dimensional array from a two-dimensional matching matrix, and design a processing element(PE) of the processor, N PEs are required instead of NS02T in the processor because of the mapping. Data input and output between PEs and all internal operations of each PE are performed in bit-serial fashion. The bit-serial operation consists of the computing of word distance (WD) by comparison and the selection of optimal code transformation path, and takes 22 clocks as a cycle. The layout of a PE is designed based on the double metal $1.5\mu$m CMOS rule. About 1,800 transistors consistute a processing element and 2 PEs are integrated on a 3mm$\times$3mm sized chip.