• Journal of Korea Multimedia Society
• /
• v.22 no.9
• /
• pp.983-991
• /
• 2019

Histogram equalization method is a popular contrast enhancement technique. However, there are some drawbacks, namely, over-enhancement, under-enhancement, structure information loss, and noise amplification. In this paper, we propose an edge-enhancing histogram equalization algorithm while suppressing over-enhancement simultaneously. Firstly, over-enhancement is suppressed by clipping a transfer function, then, edge enhancement is achieved by using guided image filter. Experiments are carried out to evaluate the performance of the various HE algorithms. As a result, both qualitative and quantitative assessment showed that the proposed algorithm successfully suppressed over-enhancement while enhancing edges.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.7A
• /
• pp.755-761
• /
• 2007

In this paper the uplink single carrier scheme is proposed for wireless Internet application and its performance is evaluated in terms of PAPR (peak to average power ratio) and ABR (achievable bit rate) compared with the uplink OFDM scheme. There exist constraints regarding the signal amplification because the non-linear amplifier should be exploited instead of the linear amplifier due to its high cost of linear amplifier and power inefficiency at the WiBro terminal. Therefore characteristics in the uplink scheme design are discussed in order to maximize ABR and relieve the requirements for the amplifier specifications.

• ETRI Journal
• /
• v.23 no.1
• /
• pp.1-8
• /
• 2001

The performance of a long wavelength-band erbium-doped fiber amplifier (L-band EDFA) using 1530nm-band pumping has been studied. A 1530nm-band pump source is built using a tunable light source and two C-band EDFAs in cascaded configuration, which is able to deliver a maximum output power of 23dBm. Gain coefficient and noise figure (NF) of the L-band EDFA are measured for pump wavelengths between 1530nm and 1560nm. The gain coefficient with a 1545nm pump is more than twice as large as with a 1480nm pump. It indicates that the L-band EDFA consumes low power. The noise figure of 1530nm pump is 6.36dB at worst, which is 0.75dB higher than that of 1480nm pumped EDFA. The optimum pump wavelength range to obtain high gain and low NF in the 1530nm band appears to be between 1530nm and 1540nm. Gain spectra as a function of a pump wavelength have bandwidth of more than 10nm so that a broadband pump source can be used as 1530nm-band pump. The L-band EDFA is also tested for WDM signals. Flat Gain bandwidth is 32nm from 1571.5 to 1603.5nm within 1dB excursion at input signal of -10dBm/ch. These results demonstrate that 1530nm-band pump can be used as a new efficient pump source for L-band EDFAs.

• 한국생물공학회:학술대회논문집
• /
• 2003.10a
• /
• pp.815-820
• /
• 2003

A huge database resulted from whole genome sequencing has provided a possibility of new information that is likely to extent the scope and thus changes the way of approach for the functional assigning of putative open reading frames annotated by whole genome sequence analyses. These are mainly realized by ease, one-step identification of putative genes using genomics or proteomics tools. A major challenge remained in biotechnology may translate these informations into better ways to screen or select a gene as a representative sequence. Further attempts to mine the related whole genes or partial DNA fragment from whole genome treasure, and then the incorporation of these sequences into a representative template, will result in the use of putative genes that can be translated into functional proteins or allowed the generation of new lineages as a valuable pool. Such screens enable rapid biochemical analysis and easy isolation of the target activity, thereby accelerating the screening of novel enzymes from the expanded library with related sequences. Information-based PCR amplification of whole genes and reconstitution of functional DNA fragments will provide a platform for expanding the functional spaces of potential enzymes, especially when used mixed- or metagenome as gene resources.

• BMB Reports
• /
• v.36 no.5
• /
• pp.427-432
• /
• 2003

Jute is the principal coarse fiber for commercial production and use in Bangladesh. Therefore, the development of a high-yielding and environmental-stress tolerant jute variety would be beneficial for the agro economy of Bangladesh. Two molecular fingerprinting techniques, random-amplified polymorphic DNA (RAPD) and amplified-fragment length polymorphism (AFLP) were applied on six jute samples. Two of them were cold-sensitive varieties and the remaining four were cold-tolerant accessions. RAPD and AFLP fingerprints were employed to generate polymorphism between the cold-sensitive varieties and cold-tolerant accessions because of their simplicity, and also because there is no available sequence information on jute. RAPD data were obtained by using 30 arbitrary oligonucleotide primers. Five primers were found to give polymorphism between the varieties that were tested. AFLP fingerprints were generated using 25 combinations of selective-amplification primers. Eight primer combinations gave the best results with 93 polymorphic fragments, and they were able to discriminate the two cold-sensitive and four cold-tolerant jute populations. A cluster analysis, based on the RAPD and AFLP fingerprint data, showed the population-specific grouping of individuals. This information could be useful later in marker-aided selection between the cold-sensitive varieties and cold-tolerant jute accessions.

• Journal of information and communication convergence engineering
• /
• v.12 no.3
• /
• pp.181-185
• /
• 2014

The lifetime of a solid-state drive (SSD) is limited because of the number of program and erase cycles allowed on its NAND flash blocks. Data cannot be overwritten in an SSD, leading to an out-of-place update every time the data are modified. This result in two copies of the data: the original copy and a modified copy. This phenomenon is known as write amplification and adversely affects the endurance of the memory. In this study, we address the issue of reducing wear leveling through efficient handling of write requests. This results in even wearing of all the blocks, thereby increasing the endurance period. The focus of our work is to logically divert the write requests, which are concentrated to limited blocks, to the less-worn blocks and then measure the maximum number of write requests that the memory can handle. A memory without the proposed algorithm wears out prematurely as compared to that with the algorithm. The main feature of the proposed algorithm is to delay out-of-place updates till the threshold is reached, which results in a low overhead. Further, the algorithm increases endurance by a factor of the threshold level multiplied by the number of blocks in the memory.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.12
• /
• pp.1117-1124
• /
• 2013

As the recently soaring wireless traffic, small-cell techniques have been actively studied in order to support such a wireless demand for cellular wireless networks. This paper focuses on the inter-cell interference neutralization to resolve the main barrier for implementing small-cell cellular networks. Assuming that each message is delivered to the final destination by the help of base stations or relays, ergodic interference neutralization is proposed, which exploits the time-varying nature of wireless channels. The previous approach based on amplify-and-forward (AF) suffers from severe performance degradation in the low signal-to-noise (SNR) regime due to noise amplification. On the other hand, the proposed interference neutralization based on recently developed compute-and-forward (CF) fixes such a problem and improves the performance in the low SNR regime.

• Journal of the Korean Graphic Arts Communication Society
• /
• v.22 no.1
• /
• pp.39-52
• /
• 2004

A novel evaluation method is investigated for measuring the ability of acid amplification of acid amplifier. The method is based on the measurement of conductivity change by the acid generation according to UV radiation. It is found that the decrease of conductivity is caused by photopolymerization of epoxy monomer during UV curing process of ink film and the by the rate of UV curing. In this paper, the novel acid amplifiers were synthesized and measured thermal stability by means of DSC. It was found that mono-type acid amplifiers were more stable than di-type. It is possible to make the dynamical evaluation the curing rate of UV curable ink in curing process by this method.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.14 no.1
• /
• pp.225-232
• /
• 2010

In this study, an automated ultrasonic testing system and post signal and image processing techniques are developed in order to construct ultrasonic flaw images in weldments. Image processing algorithms are built into the flaw image processing system for the automated ultrasonic testing system. The developed signal and image analysis algorithms addressed in this study include an A-Scan data compression algorithm, ultrasonic image amplification algorithm and B-scan flaw image correction algorithm(SAFT). This flaw image processing system for the automated ultrasonic testing system can be applied to various inspection fields.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.11 no.1
• /
• pp.9-18
• /
• 2015

Numerical analysis of PSC box bridge bearings for high speed KTX train vehicles has been carried out as a virtual simulation for Ubiquitous Technology. Improved numerical models of bridge, vehicle and interaction between bridge and train are considered, where bending and torsional modes are provided, whereas the exist UIC code is applied by the simplified HL loading. Dynamic and static analysed results are compared to get Dynamic Amplification Factors (D. A. F.) for maximum deflections and bending stresses up to running speed of 500 km/h. Equation from the regression analysis for the D. A. F. is presented. Sliding distance of the bearings for various KTX running speeds is compared with maximum and accumulated distances by the dynamic behaviors of PSC box bridge. Dynamic and static simulated sliding distances of the bearings according to the KTX running speed are proved as a major parameter in spite of the specifications of AASHTO and EN1337-2 focused on the distance by temperature variations.