• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.5 s.108
• /
• pp.408-415
• /
• 2006

This paper suggests an improved system-level model of RF power amplifiers(PAs) including memory effects, and validates the suggested model by analyzing the power spectral density of the output signal with a predistortion linearizer. The original three-box(Wiener-Hammerstein) model uses input and output filters to capture RF frequency response of PAs. The adjacent spectral regrowth that occurs in three-box model can be perfectly removed by Hammerstein structure predistorter. However, the predistorter based on Hammerstein structure achieves limited performance in real PA applications due to other memory effects except RF frequency response. The spectrum of the output signal can be predicted accurately using the suggested model that changes a memoryless block in a three-box model with a memory polynomial. The proposed model accurately predicts the output spectrum density of PA with Hammerstein structure predistorter with less than 2 dB errors over ${\pm}30$ MHz adjacent channel ranges for IEEE 802.11 g WLAN signal.

• Proceedings of the Korean Information Science Society Conference
• /
• 2006.06d
• /
• pp.115-117
• /
• 2006

IEEE 802.11 표준은 채널 상태에 따라 다양한 전송 속도를 지원하며, 무선랜 환경에서 이러한 특성을 활용하는 연구들이 진행되어 왔다. 그러나, 모바일 애드 혹 네트워크 환경에서 다중전송속도를 활용하는 연구는 거의 이루어지지 않았다. 본 논문은 모바일 애드 혹 네트워크에서 동적으로 다중전송속도를 활용하여 채널 효율을 높이는 알고리즘을 제안한다. 제안 기법은 MAC 계층과 네트워크 계층 중간에 위치하며 각 계층에 독립적으로 동작한다. 라우팅 프로토콜에서 결정한 다음 홉에 더불어, 제안 기법은 더 빠른 전송 속도를 갖는 중계 경로를 탐색한다. 또한, 패킷의 크기에 따라 경쟁 부하를 고려하여 선택적으로 전송 경로를 변경한다. 모의 실험을 통한 성능 평가는 제안 기법의 우수한 성능을 입증한다.

• 한국정보통신설비학회:학술대회논문집
• /
• 2007.08a
• /
• pp.104-110
• /
• 2007

FTTH상용화, IEEE802.11n 무선랜 기술의 상용화 등과 같은 초고속 전송기술의 발전에 따라 홈네트워킹 환경 또한 급격하게 변화하고 있다. 100Mbps를 초과하는 많은 홈네트워킹 기술들의 개발로 인해 홈게이트웨이에 보다 넓은 대역의 LAN 인터페이스를 요구하게 되었고, xDSL이나 케이블모뎀 기반의 가입자망과의 대역폭 차이는 고성능의 QoS 기능을 요구하게 되었다. 이러한 통신환경을 토대로 홈게이트웨이의 기능에 대한 요구사항을 분석하고 홈게이트웨이용 스위칭 칩의 개발규격을 도출하였다. 그리고 새로운 네트워크 기반의 비즈니스 모델을 개발하고자 하는 통신사업자의 요구사항과 QoS나 IPv6등의 다양한 네트워크 요구사항을 등을 유연하게 수용할 수 있으며, 칩의 기능과 성능을 수정하 또는 추가할 수 있는 네트워크 프로세서 기반의 기가빗 스위치 칩을 개발하였다. 개발 칩은 패킷 프로세서로 Layer 4까지 의 패킷헤드를 처리하고, 2기가빗이더넷 + 6패스트이더넷 포트를 갖도록 설계하였으며, FPGA를 이용하여 스위칭 칩의 기본적인 전송기능과 성능, Flow별 패킷 분류 및 패킷 필터링, 스케쥴링 기능 등의 시험을 통하여 설계한 칩의 기능과 성능을 확인하였다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.7
• /
• pp.1397-1405
• /
• 2012

Cooperative communications play a important role in increasing frame transmission rate at wireless communication networks where frequency resource is strictly limited. In this paper, we did a research on how to select the helper nodes that are very import in cooperative communications. As a prelude study in this research field, we carried out performance comparison of three helper node selection schemes using computer simulation. The system throughput was used as the performance measure and the random way point mobility model, where every communicating nodes move around within the designated communication range, was used.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.12 s.91
• /
• pp.1152-1160
• /
• 2004

OFDM technique was adopted as the standard of IEEE 802.1 la and it has been widely used for wireless LAN, European DVB/DAB system, Korean DMB system. In the standard of IEEE 802.11a the data packet is composed of two parts, preamble and data. Preamble is composed of short pilots and long pilots, which are used for synchronization and estimation of frequency offset and channel. We can also compensate phase noise effect in the transceiver by using above pilots. The phase noise is more complicate than frequency offset and seriously affects system performance. In this paper, we newly propose CPE and ICI simultaneous compensation method to compensate phase noise generated by transceiver oscillator and compare with previous studies. As results, phase noise effect can be significantly compensated by CPE cancellation method, PNS algorithm and our proposed CPE and ICI compensation method. Especially, the proposed CPE and ICI compensation method can achieve the best BER performance compared with original OFDM, CPE cancellation method and PNS algorithm.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.10
• /
• pp.6604-6610
• /
• 2015

In this paper, an efficient Wireless Access in Vehicular Environment (WAVE) packet transmission scheme for railroad communication is proposed. WAVE communication is a wireless local area network (WLAN) based communication and it is developed to be suitable for vehicular communication. There has been a lot of study on WAVE's applicability to Intelligent Transport System (ITS). As one of main transportation methods, by using WAVE, quality of railroad communication including WLAN based Communication Based Train Control (CBTC) can be enhanced and variety of railroad communication systems can be integrated into WAVE. However, there are technical challenges to adopt WAVE in railroad communications. For the simplest single-PHY WAVE, time division alternation of 50ms between Control Channel (CCH) and Service Channel (SCH) is required. Since there are delay sensitive railroad traffic types, alternation operation of CCH and SCH may cause performance degradation. In this paper, after identifying a couple of problems based on detailed analysis, a novel packet transmission scheme under railroad environment is proposed. In order to verify if the proposed scheme meets the requirement of railroad communication, WAVE transmission is mathematically modeled.

• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.2 no.4
• /
• pp.42-51
• /
• 2003

In this paper, we are going to analyze on relation of an output spectrum along phase distortion of power amplifier in wireless LAN system, and then considered an ACPR characteristic of power amplifier and consideration of an OFDM method for this. Also, we did implementation for OFDM modulation and transmission section of an IEEE 802.11a standard to have transmission speed of the maximum 54Mbps in order to know an OFDM modulation method and relation of non-linear characteristic of power amplifier. The non-linear characteristic of power amplifier did modeling with AM-to-AM and AM-to-PM, and we analyzed an output spectrum characteristic along phase distortion composed input signal supply for power amplifier. When output spectrum analysis results phase distortion increased, and an AM-to-PM characteristic of power amplifier in 5 degrees, the output spectrum was satisfied with a demand spectrum in P1 dB, but 10-20 degrees were able to confirm what cannot be satisfied with a demand spectrum in phase distortion. Also, an output spectrum of power amplifier by frequency re-growth generated by a non-linear characteristic of power amplifier did not satisfied in P1dE. therefore, a back-off value was requested according to an AM-to-PM distortion degree, and smaller back-off value were able to know what demand became in case of modulation section that used OFDM.

• Proceedings of the Korea Information Processing Society Conference
• /
• 2015.10a
• /
• pp.387-389
• /
• 2015

IEEE 802.11e EDCA(Enhanced Distributed Channel Access)는 4개의 AC(Access Category)를 이용하여 트래픽에 따른 우선순위를 부여하고 QoS(Quality of Service)를 제공하기 위해 표준화되었다. EDCA는 이진 백오프 알고리즘을 갖는 CSMA/CA(Carrier Sense Multiple Access with Collision Avoidance) 방법을 이용한다. EDCA에서 패킷 전송에 실패할 경우 경쟁 윈도우 값은 두 배씩 증가 되고, 성공할 경우에는 최소 경쟁 윈도우 값으로 초기화된다. 따라서 경쟁 윈도우 값이 최적의 값을 유지하지 못해 많은 패킷 충돌을 야기하여 네트워크 성능을 감소시킨다. 이 문제를 해결하기 위해 기존에 제안된 논문에서는 패킷 전송 성공 후 경쟁 윈도우 값을 최소 경쟁 윈도우 값이 아닌 채널 혼잡 정도에 따라 계산된 값으로 설정한다. 그러나 이 방법은 트래픽 종류와 상관없이 같은 방법으로 동작하기 때문에 트래픽 종류에 따른 차별적 QoS를 보장하지 않는다. 또한 계산된 경쟁 윈도우 값은 현재 값에 비해 상대적으로 낮은 값을 갖기 때문에 여전히 높은 충돌율을 갖는다. 본 논문에서는 이 문제를 해결하기 위해 새로운 프로토콜을 제안한다. 제안된 방법에서는 네트워크의 혼잡 정도를 잘 반영하기 위한 새로운 경쟁 윈도우 계산 알고리즘을 제시한다. 또한 제안된 알고리즘은 트래픽 종류에 따른 QoS 보장을 위해 트래픽 종류에 따른 차별화 파라미터를 이용한다.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.22 no.2
• /
• pp.265-274
• /
• 2011

In this paper, it is studied on wide radiating slot antenna's miniaturization for ultra wide-band(UWB) technologies and notch structure to prevent interference between UWB systems and existing wireless systems for using Wi-Fi service of IEEE standards 802.11 a/n. Proposed antenna that wide slot is decreased from $\lambda/2$ to $\lambda/4$ length of resonant frequency has decreased by 72 % compared with conventional antenna. And optimized T-shaped CPW-fed stub has satisfied UWB bandwidth for 3.0~11.8 GHz. Then, creating 2-order Hilbert curve slot line in the stub's patch area, 4.9~5.6 GHz that centered frequency is 5 GHz is eliminated. Finally, the designed antenna constructed on FR4-epoxy has $20{\times}15\;mm^2$ dimension. The measured results that are obtained return loss under -10 dB through 3.2~11.8 GHz without Wi-Fi bandwidth, a linear phase characteristic, a stable group delay, and omnidirectional radiation patterns are presented.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.6A
• /
• pp.634-639
• /
• 2006

In this paper an MMIC 2-stage power amplifier is designed and fabricated for 5GHz wireless LAN applications using $0.5{\mu}m$ gate length PHEMT transistors. The PHEMT gate width is optimized in order to meet the linearity and efficiency of the MMIC power amplifier. The $0.5{\mu}m\times600{\mu}m$ PHEMT for the drive stage and $0.5{\mu}m\times3000{\mu}m$ PHEMT for the amplification stage are the optimized sizes to achieve more than 25dBc of third order IMD at the power level of 3dB back-off from the input P1dB and more than 22dBm output power under a supply voltage of 3.3V. The two-stage MMIC power amplifier is designed to be used for the both of HIPERLAN/2 and IEEE 802.11a because of its broadband characteristics. The fabricated PHEMT MMIC power amplifier exhibits a 20.1dB linear power gain, a maximum 22dBm output power, a 24% power added efficiency under 3.3V supply voltage. The input and output on-chip matching circuits are included on a chip of $1400\times1200{\mu}m^2$.