• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2009.06a
• /
• pp.899-900
• /
• 2009

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.31 no.6
• /
• pp.427-432
• /
• 2018

High-capacity secondary batteries can cause explosion hazards owing to microcurrent variations or current surges that occur in short circuits. Consequently, complete safety cannot be achieved with general protection that is limited to a mere current fuse. Hence, in the case of secondary batteries, it is necessary for the protector to limit the inrush current in a short circuit, and to detect the current during microcurrent variations. To serve this purpose, a fuse can be employed for the secondary battery protection circuit with current detection. This study aims at designing a protection device that can stably operate in the hazardous circumstances associated with high-capacity secondary batteries. To achieve the said objective, a detecting fuse was designed from an alloy of low melting point elements for securing stability in abnormal current states. Experimental results show that the operating I-T and V-T characteristic constraints can be satisfied by employing the proposed current detecting self-contained low melting point fuse, and through the resistance of the heating resistor. These results thus verify that the proposed protection device can prevent the hazards of short circuit current surges and microcurrent variations of secondary batteries.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.12
• /
• pp.1619-1625
• /
• 2018

Portable electronic devices secondary batteries can cause fire and explosion due to micro-current change in addition to the situation of short-circuit inrush current, safety can not be secured with a general operation limited current fuse. Therefore, in secondary battery, it is necessary for the protector to satisfy both the limit current type operation in the open-short-circuit inrush current and the current detection operation characteristic in the micro current change situation and for this operation, a fuse for the current detection type secondary battery protection circuit can be applied. The purpose of this study is to design a protection device that operates stably in the hazardous situation of small capacity secondary battery for portable electronic devices through the design of low melting fuse elements alloy of sensing type fuse and secures stability in abnormal current state. As a result of the experiment, I-T and V-T operation characteristics are satisfied in a the design of the alloy of the current sensing type self-contained low melting point fuse and the resistance of the heating resistor. It is confirmed that it can prevent accidents of short circuit over-current and micro current change of secondary battery.

• Journal of the Korean Chemical Society
• /
• v.11 no.1
• /
• pp.12-16
• /
• 1967

Fading of Chlorantine Fast Red 5B (C.I. Direct Red 81) on cotton fabric exposed to carbon are light was examined. It was observed that the dye had anomaly in CF curve slope, while normal in CFG one. Auther considered that the reason for discrepancy of the one with the other curve slope might be appeared from Weber-Fechner law, and derived following equation $F_v=[logC_0-log(C_0-C_0F_t/100)]{\times}100/(logC_0+b)$ where $F_t$; the proportion of dye faded after t hour exposure. $F_v$; the proportion of dye faded after t hour exposure, when a pattern is judged by visual method $C_0$; initial dye concentration. b; constant. also, the reason for increasing lightfastness with dye concentration was discussed on view of the above equation.

• Journal of Magnetics
• /
• v.14 no.1
• /
• pp.11-14
• /
• 2009

We investigated the I-V curves and differential tunneling conductance of two, CoFeB/MgO/CoFeB-based, magnetic tunnel junctions (MTJs): one with a low tunneling magnetoresistance (TMR; 22%) and the other with a high TMR (352%). This huge TMR difference was achieved by different MgO sputter conditions rather than by different annealing or deposition temperature. In addition to the TMR difference, the junction resistances were much higher in the low-TMR MTJ than in the high-TMR MTJ. The low-TMR MTJ showed a clear parabolic behavior in the dI/dV-V curve. This high resistance and parabolic behavior were well explained by the Simmons' simple barrier model. However, the tunneling properties of the high-TMR MTJ could not be explained by this model. The characteristic tunneling properties of the high-TMR MTJ were a relatively low junction resistance, a linear relation in the I-V curve, and conduction dips in the differential tunneling conductance. We explained these features by applying the coherent tunneling model.

• Bulletin of the Korean Chemical Society
• /
• v.27 no.11
• /
• pp.1832-1838
• /
• 2006

The present paper is focused on sorption concentration of silver (I) on some complex-forming ion exchangers in the initial thiocyanate form and subsequent determination of Ag(I) in the phase of anion exchanger AN-25 by diffuse reflectance spectroscopy. The sorption and kinetic characteristics of the sorbents were investigated. The apparent stability constants of thiocyanate silver complexes in the ion exchanger phase were calculated. The sorption-spectroscopic method is proposed for Ag(I) determination in aqueous solutions. The calibration curve is linear in the concentration range of 10-200 mg/L (sample volume is 10.0 mL) and the detection limit is 2 $\mu$g/mL. The presence of $Na^+,\;K^+,\;Mg^{2+}$ (macrocomponents) as well as of Ni (II), Co (II), Cu (II) do not hinder the determination of silver (I).

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1996.11a
• /
• pp.295-299
• /
• 1996

In order to investigate the relation between the microstructure and the V-I characteristics of HTSC wire, single and 19 filamentary silver-sheathed Bi2223 tapes were fabricated using the powder-in-tube method. Higher J$\_$c/ at 77.3 K(0 T) and 4.2 K(in magnetic field) can be achieved for the 19 filamentary Bi tape, comparing the single filamentary tape. However, the I$\_$c/ distribution of 19 filamentary Bi2223 tape was found to be wider by analyzing the curve obtained from 2nd differential of V-I data. This was considered to be resulted from worse uniformity of oxide filament due to severe cold working.

• Transactions on Electrical and Electronic Materials
• /
• v.18 no.6
• /
• pp.311-315
• /
• 2017

The perovskite system $(Ba^{2+}{_{1-x}}La^{3+}{_x})Fe^{3+}{_{1-t}}Fe^{4+}{_t}O_{3-y}$ (y = (1 - x --t)/2) having a composition of x = 0.0, 0.1, 0.2, and 0.3 showedean increase in $Fe^{4+}$ mole ratios with an increase in oxygen partial pressure ($N_2{\rightarrow}air{\rightarrow}O_2$), and with an increasefin s, the $Fe^{3+}$ quantity decreased and oxygen content (3-y value) increased. For each N sampls heat-treated in $N_2$ gas, a considerable weight gain, i.e.g a steadynincrease if oxygen content, was observed in the TGA data on the cooling process. The conductivity values at a constant temperature were in the order of $N_2$$O_2$; the respective log ${\sigma}$ values (${\Omega}^{-1}{\cdot}cm^{-1}$) at 323 K of the BL0 sample were -5.75 (BL0-N), -3.39 (BL0-A), and -0.53 (BL0-O). The mixed valencies of $Fe^{3+}$ and $Fe^{4+}$ ions in each sample were also confirmed by both the oxidation curve above 350 mV and the cathodic reduction curve below 200 mV from cyclic voltammetry.

• Journal of Korea Society of Industrial Information Systems
• /
• v.17 no.7
• /
• pp.51-57
• /
• 2012

This paper proposes a group key design based on ECDH(Elliptic Curve Diffie Hellman) which guarantees secure V2V and V2I communication. The group key based on ECDH generates the VGK(Vehicular Group key) which is a group key between vehicles, the GGK(Global Group Key) which is a group key between vehicle groups, and the VRGK(Vehicular and RSU Group key) which is a group key between vehicle and RSUs with ECDH algorithm without an AAA server being used. As the VRGK encrypted with RGK(RSU Group Key) is transferred from the current RSU to the next RSU through a secure channel, a perfect forward secret security is provided. In addition, a Sybil attack is detected by checking whether the vehicular that transferred a message is a member of the group with a group key. And the transmission time of messages and the overhead of a server can be reduced because an unnecessary network traffic doesn't happen by means of the secure communication between groups.

• Archives of Pharmacal Research
• /
• v.26 no.9
• /
• pp.763-767
• /
• 2003

The differences in pharmacokinetic behavior and tissue distribution of verapamil and its enantiomers were investigated in rats. In high-performance liquid chromatographic method, an achiral ODS column (150 mm $\times$ 4.6 mm i.d.) with the mobile phase consisting of methanol-water (73:30, v/v) was used for the determination of the concentration for racemic verapamil, and a Chiralcel OJ column (250 mm$\times$4.6 mm i.d.) with the mixture of n-haxane-ethanol-triethylamine (85:15:0.2, v/v/v) as mobile phase was used to determine the concentrations of verapamil enantiomers. A fluorescence detector in the analytical system was set at excitation and emission wavelengths of 275 nm and 315 nm. The differences between enantiomers were apparent in the pharmacokinetics in rats. The area under the concentration-time curve (AUC) of S-(-) verapamil was higher than that of R-(+) verapamil. The half-distribution time ($T_{1/2(\alpha)}$) of S-(-) verapamil which distributing to tissue from blood was shorter than that of R-(+) verapamil, but the elimination half-time ($T_{1/2(\beta)}$) was longer in rat following oral administration of racemic verapamil. At 1.3 h after oral administration of racemic verapamil, however, there were no significant differences between enantiomers for the distributions in major tissues such as heart, cerebrum, cerebellum, liver, spleen and kidney.