• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.11 no.6
• /
• pp.436-441
• /
• 1998

$Pt/SrTiO_3/Pb_x(Zr_{0.52}, Ti_{0.48})O_3/SrTiO_3/Si$ structure was prepared by rf-magnetron sputtering method for use in nondestructive read out ferroelectric RAM(NDRO-FEAM). PBx(Zr_{0.52}Ti_{0.48})O_3}$(PZT) and $SrTiO_3$(STO) films were deposited respectively at the temperatures of $300^{\circ}C and 500^{\circ}C$on p-Si(100) substrate. The role of the STO film as a buffer layer between the PZT film and the Si substrate was studied using X-ray diffraction (XRD), Auger electron spectroscopy (ASE), and scanning electron microscope(SEM). Structural analysis on the interfaces was carried out using a cross sectional transmission electron microscope(TEM). For PZT/Si structure, mostly Pb deficient pyrochlore phase was formed due to the serious diffusion of Pb into the Si substrate. On the other hand, for STO/PZT/STO/Si structure, the PZT film had perovskite phase and larger grain size with a little Pb interdiffusion. the interfaces of the PZT and the STO film, of the STO film and the interface layer and $SiO_2$, and of the $SiO_2$ and the Si substate had a good flatness. Across sectional TEM image showed the existence of an amorphous layer and $SiO_2$ with 7nm thickness between the STO film and the Si substrate. The electrical properties of MIFIS structure was characterized by C-V and I-V measurements. By 1MHz C-V characteristics Pt/STO(25nm)/PZT(160nm)/STO(25nm)/Si structure, memory window was about 1.2 V for and applied voltage of 5 V. Memory window increased by increasing the applied voltage and maximum voltage of memory window was 2 V for V applied. Memory window decreased by decreasing PZT film thickness to 110nm. Typical leakage current was abour $10{-8}$ A/cm for an applied voltage of 5 V.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.23 no.6
• /
• pp.989-1000
• /
• 2013

Mobile devices use VPN solution to transfer information securely through open network in mobile office environment. In this paper, we propose Pre_Buffered mechanism that improves the throughput of IPSec VPN using low performance H/W crypto Token. Pre_Buffered method precompute key stream, store them in Buffer and use them in IPSec engine for IP packet processing. Moreover, Design, analysis, and experimental results prove the efficiency and feasibility of our proposed method.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.10
• /
• pp.1409-1412
• /
• 2002

Polymeric membrane electrodes for acetate anion based on meso-(${\alpha}$,${\alpha}$,${\alpha}$,${\alpha}$)-5,10,15,20-tetrakis[2-(penta-fluorophenylurea) phenyl]porphyrin I and similar urea-functionalized porphyrins Ⅱ-Ⅳ as neutral ionophores were prepared. The membrane based on porphyrin I exhibits the best potentiometric properties in pH 6.0 rather than pH 7.0: linear stable response over a wide concentration range (6.0 ${\times}$$10^{-5}$-1.0 ${\times}$$10^{-2}$) with a slope of -59.6 mV/decade and a detection limit of log[CH3CO$O^-$] = -5.32. Selectivity coefficients obtained from the matched potential method (MPM) in pH 6.0 indicate that interferences of hydrophobic anions are very small for the membranes of porphyrins I and II having the strong withdrawing group. The electronic effect of urea-functionalized porphyrins and pH effect of buffer solutions are discussed on the potentiometric response.

• The Transactions of the Korea Information Processing Society
• /
• v.4 no.4
• /
• pp.1076-1088
• /
• 1997

Data repliciation techniques of distributed database a allocation methods occures to overhead to change together all repkicas for consistency maintenance at updates .In case of data migration horizontal or vertical fragment migration has caused to caused to increase data communication.In this paper we purpose batch proxessing method groups the associated items of table and stores temporary table assciated with file relication and migrations.This method increase the usagility of system buffer in distributed trancsaction processing with a number of data inputs and updates.After all,it improved the perform-ance of distributed transaction system by reducing disk I\O processing time and the cost of data cimmunication among local sites.

• Progress in Superconductivity and Cryogenics
• /
• v.11 no.4
• /
• pp.20-24
• /
• 2009

YBCO coated conductors (CC) on the $CeO_2$-buffered IBAD-MgO template were fabricated by metal-organic deposition (MOD) Process with Ba-trifluoroacetate and fluorine-free Y and Cu precursor materials. The precursor solution was coated on $CeO_2$-buffered IBAD MgO templates using the multiple dip-coating method, decomposed into inorganic precursors by pyrolysis up to $400^{\circ}C$ within 3 h, and finally fired at $740{\sim}800^{\circ}C$ in a reduced oxygen atmosphere. Microstructure, texture, and superconducting properties of YBCO films were found highly sensitive to both the firing temperature and time. The high critical current density ($J_C$) of $1.15\;MA/cm^2$ at 77.3K in the self-field could be obtained from $1\;{\mu}m$ thick YBCO CC, fired at $740^{\circ}C$ for 3.5 h, implying that high performance YBCO CC is producible on IBAD MgO template. Further enhancement of $J_C$ values is expected by improving the in-plane texture of $CeO_2$-buffer layer and avoiding the metal substrate contamination.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.1 s.343
• /
• pp.121-126
• /
• 2006

This paper report on the design and implementation of a 9.6kbps DSSS CDMA modem for a medium speed wireless link. The proposed modem provides a general purpose I/O interface with a microprocessor. The I/O interface consists of 8-bit data bus, chip enable, read/write, and interrupt pins. In transmit block, the 8-bit data delivered from the I/O interface buffer is converted to 9.6kbps serial data, which are spreaded into 76.8kcps with 8-bit PN code generated inside the modem by direct sequence method. An 8-bit training sequence is preceded in the data frame for data synchronization in receiver. In receiver block the PN code is synchronized from the received data spreaded to 76.8kcps and find the data timing from the 8-bit training sequence. We have used the Early-and-Late integration method. The modem has been implemented and verified using a Xilix FPGA board and has been fabricated as an ASIC CHIP through Hynir $0.25{\mu}m$ CMOS. The multiple accessing method is DSSS CDMA.

• Analytical Science and Technology
• /
• v.36 no.1
• /
• pp.44-52
• /
• 2023

This protocol clarifies a simple and precise method for measuring the activity of xanthine oxidase (XO) enzyme inhibitor. XO enzyme, which accelerates oxidative stress-related disorders through its capacity to generate hydrogen peroxide and superoxide anion radicals (O₂^•-), has been found to be inhibited by several plant extracts. Enzyme samples were incubated with a suitable buffer containing adequate amounts of xanthine as a substrate to determine XO activity. The method depends on direct measurements of uric acid and hydrogen peroxide production to test XO with and without interference. The CUPRAC reagent (Cu(Nc)₂²⁺) was used to inhibit enzyme reaction after incubation was complete. The generated urate and peroxide reduced the Cu(II)-neocuproine complex (Cu(Nc)₂²⁺) to a brightly colored Cu(I)-neocuproine complex (Cu(Nc)₂⁺), which was assessed with a spectrophotometer at 450 nm. XO activity was found to be directly related to the increased absorbance of the colored Cu(I)-neocuproine complex (Cu(Nc)₂⁺). To eliminate catalase enzyme interference, the proposed method used sodium azide and was validated against XO activity using the UV method in matched samples with t-test analysis. The proposed assay can determine XO activity with high precision, as indicated by the correlation coefficient (R² = 0.9935) from comparison with the reference protocol.

• KIPS Transactions on Computer and Communication Systems
• /
• v.12 no.7
• /
• pp.209-216
• /
• 2023

Modern HPC systems are equipped with many-core CPUs with dozens of cores. When performing parallel I/O in such a system, there is a limit to scalability due to the problem of the LRU lock management policy of the Linux system. The study proposes an improved FinerLRU to solve this problem. Our new FinerLRU improves the parallel write performance of file systems using the buffer cache through granular lock management by increasing the number of LRU locks upto the maximum number of cores. The proposed method was implemented in Linux 5.18.11, and the performance was measured on two types of CPUs, Intel Icelake Xeon and Intel Knights landing, with different characteristics, and it was found that a performance improvement of about two times can be obtained in both types of systems.

• Journal of Broadcast Engineering
• /
• v.25 no.5
• /
• pp.655-664
• /
• 2020

Free viewpoint image synthesis technology is one of the important technologies in the MPEG-I (Immersive) standard. RVS (Reference View Synthesizer) developed by MPEG-I and in use in MPEG group is a DIBR (Depth Information-Based Rendering) program that generates an image at a virtual (intermediate) viewpoint from multiple viewpoints' inputs. RVS uses the mesh surface method based on computer graphics, and outperforms the pixel-based ones by 2.5dB or more compared to the previous pixel method. Even though its OpenGL version provides 10 times speed up over the non OpenGL based one, it still shows a non-real-time processing speed, i.e., 0.75 fps on the two 2k resolution input images. In this paper, we analyze the internal of RVS implementation and modify its structure, achieving 34 times speed up, therefore, real-time performance (22-26 fps), through the 3 key improvements: 1) the reuse of OpenGL buffers and texture objects 2) the parallelization of file I/O and OpenGL execution 3) the parallelization of GPU shader program and buffer transfer.

• Journal of the Korean Wood Science and Technology
• /
• v.15 no.3
• /
• pp.34-43
• /
• 1987

This study was performed to find out the types of linkage of carbohydrates in wood cell walls. To study the structure of linkage of carbohydrates in wood cell walls, we have attempted to find out the method holocellulose preparation and optimum condition of enzyme hydrolysis in holocellulose, and fractionate oligosaccharide with products that hydrolized partly by acetolysis and deacetylation in holocellulose. We have achieved four results. These results as follow; 1. At first. we reacted in wood meal $NaClO_2$ 1g per lignin lg for one hour and then the same of quantity $NaClO_2$ for four hours. Through these experiments, we have developed new holocellulose preparation method which had low loss of carbohydrates and high effect of the delignification. 2. The optimum condition of enzyme hydrolysis of holocellulose which had lignin was 0.005M sodium acetate buffer (pH 5.0). We have achieved 7.2% reducing sugar through the procedure that reactioned 0.01g holocellulose putting enzyme 0.03g for 72 hours. It may be supposed that 5.5% of lignin contained in holocellulose prevented enzyme contaction from holocellulose and so this lignin has resulted in the low efficiency of enzyme hydrolysis. 3. We did not fractionated from oligosaccharides which were preparated by the method of acetolysis and deacetylation in holocellulose. The reason is that holocellulose having a lot of lignin prevented prefectly partial hydrolysis from the method of acetolysis and deacetylation. 4. We attempted analysis of six standard substances through HPLC apparatus having sugar pak 1 column which we have changed flow rate and the column temperature variably. These six standard substances were D-glucose, D-mannose, D-xylose, D-galactose and L-rhamnose, L-arabinose, But sugar pak 1 column was not fitted analysis of four substances because D-galactose, D-mannose, D-xylose, L-rhamnose were agreement with elution time. And so, we could not analize four standard substances with sugar pak 1 column.