• Transactions of the Korean Society of Automotive Engineers
• /
• v.23 no.4
• /
• pp.410-419
• /
• 2015

In this study, the roadability, fuel economy and emission characteristics were evaluated for a natural gas converted vehicle. The results are as follows; Not only the shortage of power was observed in stall test, but also large deterioration of acceleration performance was exposed in roadability. Compared to the original LPG system, the acceleration is 76% in start acceleration and 45 ~ 65% in overtaking acceleration, especially the decline became larger when air conditioner is at work. Furthermore, because the mapping data, which controls the injection depending on driving condition, do not match up with injection system, the failure of air-fuel ratio feedback control occurs resulting from the large gap between the required and the really supplied amount of fuel. This failure cause the exhaust gas to emit without catalytic conversion and the fuel economy based on the fuel heat value to get worse 22% in the mode test and 16% in road test respectively. In addition, the existing injection system does not secure enough fuel at the starting so that it may lead to the fail of clod start, the deterioration of hot start and inharmonic of engine at the idle after start.

• Korean Journal of Environmental Agriculture
• /
• v.28 no.2
• /
• pp.113-124
• /
• 2009

Severe sediment-laden problem has been the hot issue in Korea. It was assumed that agricultural activities and landslides were the primary causes of these problems in watersheds. The USLE-based systems have been widely used in soil erosion studies. However the GIS-based USLE modeling system has limitation in USLE L factors. In this study, the SATEEC L module was developed to reflect the slope length segmentations in the fields. The SATEEC L module was applied to the study watershed to analyze the effects of using the SATEEC L module on estimated sediment. As shown in the comparisons between SATEEC estimated sediment with SWAT values, the SATEEC GA-SDR module derives the SDR with reasonably acceptable accuracies. However, it is worthy to note that the soil erosion using the SATEEC L module for the study watershed was lower than that without using the SATEEC L module by 25%, although the SATEEC estimated sediment values with and without using L module match the SWAT sediment values with similar accuracies. This is because the SATEEC GA-SDR module estimates lower SDR in case of greater soil erosion estimation without the L module and greater SDR in case of lower soil erosion estimation with the L module. This indicates that the SATEEC input parameters, especially L factor, need to be prepared with care for accurate estimation of SDR at a watershed scale and for accurate evaluation of BMPs in the watershed.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.11 no.4
• /
• pp.1-6
• /
• 2015

In this study, energy performance of two types of food dryers which are electric heater and heat pump is studied experimentally. With drying chamber temperatures controlled at 45, 50 and $55^{\circ}C$, sliced radish is dried from an initial mass of 90 to final 7 kg. Moisture content, drying time, total power consumption, MER (moisture extraction rate, kg/h) and SMER (specific moisture extraction rate, kg/kWh) are measured and analyzed. As the drying chamber temperature is increased, drying time is shortened but energy efficiency is reduced for both types. For an electric heater dryer, the effect of chamber temperature on drying time is significant but less significant on energy efficiency. For a heat pump dryer, the dependence of chamber temperature on drying time is weak but strong on energy efficiency. Temperature levels have little effect on electric heater dryer performance but strong effect on heat pump dryer which operates on a vapor compression refrigeration cycle. The energy performance of the heat pump dryer is superior with an average SMER of 2.175 kg/kWh which is 2.22 times greater than that of the electric heater dryer with SMER of 1.224 kg/kWh.

• Journal of The Korean Astronomical Society
• /
• v.34 no.4
• /
• pp.309-311
• /
• 2001

Strong thermal X-ray emission, called Galactic Ridge X-ray Emission, is observed along the Galactic plane (Koyama et al. 1986). The origin of hot ($\~$7 keV) component of GRXE is not known, while cool ($\~$0.8 keV) one is associated with supernovae (Kaneda et al. 1997, Sugizaki et al. 2001). We propose a possible mechanism to explain the origin; locally strong magnetic fields of $B_{local}\;\~30{\mu}G$ heat interstellar gas to $\~$7 keV via magnetic reconnection (Tanuma et al. 1999). There will be the small-scale (< 10 pc) strong magnetic fields, which can be observed as $(B)_{obs} \;\~3{\mu}G$ by integration of Faraday Rotation Measure, if it is localized by a volume filling factor of f $\~$ 0.1. In order to examine this model, we solved three-dimensional (3D) resistive magnetohydrodynamic (MHD) equations numerically to examine the magnetic reconnect ion triggered by a supernova shock (fig.l). We assume that the magnetic field is Bx = 30tanh(y/20pc) $\mu$G, By = Bz = 0, and the temperature is uniform, at the initial condition. We put a supernova explosion outside the current sheet. The supernova-shock, as a result, triggers the magnetic reconnect ion, and the gas is heatd to > 7 keV. The magnetic reconnect ion heats the interstellar gas to $\~$7 keV in the Galactic plane, if it occurs in the locally strong magnetic fields of $B_{local}\;\~30{\mu}G$. The heated plasma is confined by the magnetic field for $\~10^{5.5} yr$. The required interval of the magnetic reconnect ions (triggered by anything) is $\~$1 - 10 yr. The magnetic reconnect ion will explain the origin of X-rays from the Galactic ridge, furthermore the Galactic halo, and clusters of galaxies.

• Asian-Australasian Journal of Animal Sciences
• /
• v.31 no.8
• /
• pp.1291-1300
• /
• 2018

Objective: This experiment was conducted to investigate the effects of dietary crude protein (CP) level and exogenous protease supplementation on growth performance, serum metabolites, carcass traits, small intestinal morphology and endogenous protease activity in broiler chickens reared under a tropical climate. Methods: A total of 480 day-old male broiler chicks were randomly assigned to eight dietary treatments in a $4{\times}2$ factorial arrangement. The main effects were CP level (21.0%, 19.7%, 18.5%, or 17.2% from 1 to 21 days and 19.0%, 17.9%, 16.7%, or 15.6% from 22 to 35 days) and protease enzyme supplementation (0 ppm or 500 ppm). All experimental diets were fortified with synthetic feed-grade lysine, methionine, threonine and tryptophan to provide the minimum amino acid recommended levels for Cobb 500. Results: Reducing dietary CP linearly reduced (p<0.05) growth performance, serum albumin, total protein, and carcass traits and increased (p<0.05) serum triglycerides and abdominal fat. There was no consistent effect of reducing dietary CP on morphological parameters of the intestine and on the pancreatic and intestinal endogenous protease activity (p>0.05). Protease supplementation improved (p<0.05) feed conversion ratio, body weight gain, carcass yield and intestinal absorptive surface area. Conclusion: Protease supplementation, as measured by growth performance, intestinal morphology and carcass yield, may alleviate the detrimental effects of low protein diets in broiler chickens.

• Journal of Ginseng Research
• /
• v.6 no.2
• /
• pp.154-161
• /
• 1982

To determine the effects of mulching with the hulls of rice on the growth of the ginseng plant and changes of its growing environment-soil moisture content. subterranccan temperature and soil hardness- were investigated under different light intensity such as 5%, 10%, 20%, and 30% light transmittance rate(LTR). The results obtained were as follows; 1. Soil moisture content under the shading was decreased as the increase of light intensity, whereas it was increased about 1.5% in each plot of LTR by the mulching. 2. Suberranccan temperature under the shading was increased as the increase of light intensity. It was decreased on a hot day by the mulching but increased on a cold day. 3. Soil hardness was decreased by the mulching. 4. Sprouting date of the ginseng plants was acclerated for 7 days and sprout periods were shortened for f days by mulching compared to the non-mulching treatment. 5. Missing plant rate was increased severely as the increase of light intensity more Than 20% LTR In the non-mulching plots but did not severe in the mulching plots. Missing plant rate was decreased remarkably by the mulching. The degree of decrease was larger as the increase 6f light intensity. 6. Root yield was increased in the mulching plots compared to the non$.$mulching plots. The degree of increase was larger as the increase of light intensity. The highest yield was obtained at 20% LTR with mulching.

• The Journal of Fisheries Business Administration
• /
• v.33 no.2
• /
• pp.1-29
• /
• 2002

The main objective of this research aims at analyzing efficiency of government financial transfers(GFTs) to the Korean fisheries sector, using the Linear Structural Relations model(i.e., LISERL model) and the field survey data. Most policies of GFTs tend to be implemented to protect industries with weak competitive advantages such as infant and/or primary industries. Specific policy instruments include income transfers, government loans with lower interest rates, taxes and the like. Fishing activities are made at a highly changeable natural environment of the ocean with a great amount of risk and uncertainty. Fishing households make their livelihood under the small-scale fisheries. Such fisheries and fishing households have also a relatively weak market power. Because of these fisheries characteristics most coastal states have adopted a variety of government support programs. However, despite such a huge government support, during the past several decades the world fishing communities have seen a tendency of continuous fishereis resource overexploitation. For this resason there have been hot debates over the government support policies for fisheries through OECD, FAO, WTO, and UNEP. In general, policy evaluations tend to be made on the basis of benefit-cost(B/C) analysis. However, the B/C analysis may produce results quite different from real ones primarily due to many unmeasurable effects. Thus, the authors composed simple questionaires and let fishermen, government officials and academic people answer the questions. The survery was made in several ways such as post-mail and personal/group interviews. In recent years, for analysis of policy performances and effectiveness, the LISREL model has often been used, which consists of structural and measurement eqquations. This model has a good advantage of transforming unobservable variables to observable ones so that it helps construct endogenous cause and effect relationships among relevant variables. The evaluation was done from the two aspects: policy results and policy effectiveness. The policy result evaluation showed that there is a need for improvement for policy problem perception and decision-making process, while the policy effect evaluation suggested that the policy goals were successfully achieved and social justice was improved from the perspective of the entire society as well. However, the research results showed that the GFT policies rendered little contrubtion to narrowing down the gap between GFT beneficiaries and non-beneficiaries incomes.

• Tuberculosis and Respiratory Diseases
• /
• v.43 no.2
• /
• pp.280-284
• /
• 1996

We report the first case of summer-type hypersensitivity pneumonitis(SHP) in Korea diagnosed by positive serum antibodies to Trichosporon cutaneum. Hypersensitivity pneumonitis(HP) has been commonly classified as an occupational respiratory diseases. However, evidence that sensitizing organisms can also contaminate and cause pulmonary diseases in home environment has been increasing. One such disease is SHP. In Japan, 75% of cases with HP are SHP. Even though there has been no known SHP case in Korea yet, there has been high possibility of SHPs in Korea because our country has areas which have hot and humid summer climate similar to Japan. This first case of SHP in Korea suggests that there may be another cases in Korea and nation-wide survey may be required. We report here the first confirmed case of SHP in Korea.

• Journal of the Mineralogical Society of Korea
• /
• v.23 no.4
• /
• pp.315-329
• /
• 2010

Characteristics of thermophilic bacteria and secondary materials on the pyrrhotite surface were investigated by using scanning electron microscopy (SEM). The thermophilic bacteria from an acid hot spring in Japan were incubated with pyrrhotite at $42^{\circ}C$, $52^{\circ}C$, and $62^{\circ}C$ respectively. SEM analysis of the reacted pyrrhotite showed that indigenous rod-shaped bacteria ranging from $0.4{\times}1.5{\mu}m$ to $0.3{\times}11.9{\mu}m$ in size were attached to the pyrrhotite surface at these temperatures with formation of secondary materials. Extracellular polymer substances were formed on the bacterial surface. We suggest that these polymers functioned as a capsule protecting bacteria from the extreme environment. Secondary materials such as elemental sulfur, Fe-hydroxide, S-Fe and O-P-Fe compounds were found on the pyrrhotite surface.

• 한국HCI학회:학술대회논문집
• /
• 2008.02c
• /
• pp.150-151
• /
• 2008

With the proliferation of vehicles and advancement of Information Technology, the technology of Telematics, which provides valuable services to people by collecting and analyzing the information from drivers, vehicles and Telematics environments (e.g. traffic information, road condition, weather information, etc.), has been a hot research area in IT and automotive recently. As the information technology revolution brings more and more assistance for driver information processing becomes increasing important. Therefore, drivers' workload is very essential factor for safety driving in Telematics environment. For managing drivers' workload effectively, ETRI haven been developing vehicle and driver management system which can collect data from drivers and vehicle in realtime and analyze the data to manage drivers' and vehcles' status since 2007. This technology will apply to commercial vehicle telematics such as texi or truck management system in the future for increasing driving safety. In this presentation, I would like to explain what we had developed so far and discuss future direction.