• Food Science and Preservation
• /
• v.19 no.1
• /
• pp.7-11
• /
• 2012

This study was conducted to determine the effects of the humidity and gas composition on the quality of satsuma mandarins during their heat treatment, in an effort to reduce their acidity. To come up with different humidity and gas conditions, various plastic films were used. The fruits were wrapped with an 18-${\mu}m$ high-density polyethylene (HDPE) punched film, a 30-${\mu}m$ low-density polyethylene (LDPE) film, or a 100-${\mu}m$ LDPE film just before treatment at $30^{\circ}C$ for 55 hours. After heat treatment, the titratible acidity (TA) was significantly reduced while the soluble-solid content (SSC) showed no differences, which resulted in increased SSC/TA ratios in all the treatments. The fruits that were not wrapped with a film, however, which had low RH, developed higher ethanol and acetaldehyde contents than those wrapped with an 18-${\mu}m$ HDPE punched film, which had high RH and a similar gas composition. Among the films, the higher the $CO_2$ concentration in the film was, the more the ethanol and acetaldehyde contents increased, which induced more off-flavor. It was thus concluded that high humidity and normal gas composition are favorable conditions for heat treatment to reduce the acidity of satsuma mandarins.

• Journal of Energy Engineering
• /
• v.21 no.3
• /
• pp.243-248
• /
• 2012

In this study, The report analysed the characteristics of power drop and damage of surface in solar cell through high temperature and humidity test. The solar cells were tested during the 1000hr in $85^{\circ}C$ temperature and 85% humidity conditions, that excerpted standard of PV Module(KS C IEC-61215). An analysis of the cell surface through EL(Electroluminescence), the cell has partly change of surface in yearly. Single-crystalline Solar cell efficiency is decreased from 17.7% to 15.6% and decreasing rate is 11.9%. On the other hand, Poly-crystalline Solar cell efficiency is decreased from 15.5% to 14.0% and decreasing rate is 9.3%. A comparison of the fill factor for analysis of electro characteristic in yearly, Single-crystalline Solar cell efficiency is decreased from 78.7% to 78.1% and decreasing rate is 4.7%. On the other hand, Poly-crystalline Solar cell efficiency is decreased from 78.1% to 76.7% and decreasing rate is 1.8%. Single-crystalline has more bigger power drop than poly-crystalline by the silicon purity and silicon atom arrangement. Also, FF decreasing rate has more bigger drop than efficiency decreasing rate for the reason that the damage of surface by exterior environmental factor is the more influence in cell than other reason that is decreasing FF by damage of p-n junction.

• Asian-Australasian Journal of Animal Sciences
• /
• v.21 no.11
• /
• pp.1616-1623
• /
• 2008

This study was conducted to determine the effect of hot environment and dietary crude protein level (CP) on performance, carcass characteristics, meat visual quality, muscle chemical composition and malondialdehyde (MDA) concentration of tissues in broilers. Two hundred and sixteen 21-d old Arbor Acre broilers were used in a $4\times3$ factorial arrangement and randomly reared in 4 environmental chambers and fed on 3 diets with different CP levels for 3 weeks. The results showed: (1) when air temperature (AT) rose to $33^{\circ}C$, average daily feed intake, average daily gain, carcass weight, right breast meat weight, left thigh and drumstick meat weight decreased (p<0.05) and feed conversion rate decreased (p<0.05), but the ratio of carcass to live weight and of left thigh and drumstick meat weight to carcass weight increased (p<0.05). (2) There were significant differences in pH and shear force in breast meat, and shear force, L* and a* in thigh meat (p<0.01 or 0.05) among hot environments. Dietary CP level tended to affect breast meat pH and pH and L* of thigh meat (p<0.06 or 0.09). Compared to the normal temperature ($22^{\circ}C$), low temperature ($15^{\circ}C$) and hot humid (AT $33^{\circ}C$, relative humidity (RH) 80%) treatments significantly (p<0.05) decreased the tenderness of thigh meat. L* and a* value in thigh meat under high temperature treatments, regardless of RH, were higher (p<0.05) than those under normal temperature. (3) Protein content in breast and thigh meat of broilers fed under high temperature ($33^{\circ}C$) was lower (p<0.05) than that under $22^{\circ}C$, but fat content had an adverse change. High temperature ($33^{\circ}C$) increased the moisture of breast meat significantly (p<0.05). Protein content in breast meat increased significantly (p<0.05), in which fat content had an adverse change (p<0.05), when the dietary protein rose. (4) MDA concentration in liver and breast meat under hot humid (AT $33^{\circ}C$, RH 80%) treatment increased markedly (p<0.05). (5) High humidity could sharpen the bad effect of high temperature on performance, carcass yield and choice cuts, crude protein and moisture content in breast meat. It was concluded that a hot environment could affect the performance and meat quality of broiler chicks more significantly than CP level and that high humidity would aggravate the bad influence of high temperature on the broiler.

• Korean Chemical Engineering Research
• /
• v.49 no.3
• /
• pp.352-356
• /
• 2011

In this paper, we prepared new type of hydrophilic block copolymers that exhibit the long-ranged lateral ordering in thin film. It was previously demonstrated that poly(ethyleneoxide-b-styrene) and poly(ethyleneoxide-b-metharylate-b-styrene) block copolymer thin films have a high degree of lateral ordering after solvent annealing process. In these cases, the relative humidity plays an important role in long-ranged lateral ordering. However, the origin of the humidity effect on the orders of these hydrophilic block copolymers is not fully understood. To investigate the effect of the humidity further, we prepared other hydrophilic poly(N,N-dimethylacrylamide-b-styrene)(PDMA-b-PS) block copolymers via RAFT polymerization. As with PEO-containing block copolymers, PDMA-b-PS block copolymers exhibit the long-ranged lateral ordering after solvent annealing process.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 2002.10a
• /
• pp.73-76
• /
• 2002

The temperature and humidity of dirt-walled storehouse are observed in order to verify the traditional storehouse (main material : soil) during 7days (4th. $Sep{\sim}10th$. Sep). Because the width of the daily variation of temperature is small as $2.5^{\circ}C{\sim}5^{\circ}C$, the reduction of energy supply for low temperature is expected. Because the relative humidity is high and it's variation is small ($4%{\sim}9%$), the inner humidity of dirt-walled storehouse is easily maintained above 80% is expected.

• Journal of Korean Society of Forest Science
• /
• v.42 no.1
• /
• pp.59-66
• /
• 1979

This experiment was carried out to know the effects of soil water potential of cutting bed and relative humidity on the rooting of stem cutting in the field plots. The results obtained were as follows; 1. The most number of the rooted cutting was found from 70 to 80% of relative humidity in Spring and from 90 to 100% in Summer respectively. 2. It was found that the number of rooted cutting was the least in the range of 0 to-0.006 bar of soil water potential of cutting bed in the case of Spring cutting, whereas in Summer the number of the rooted cutting was the most one in the range of -0.049 to -0.124 bar of soil water potential of cutting bed. 3. High signification was recognized between the relative humidity and the number of the rooted cutting only in the Spring cutting, but that of soil water potential and the number of the rooted cutting was found to be significant in every season.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.6
• /
• pp.609-614
• /
• 2014

In this research, results of measuring temperature and relative humidity of underground-air-heat in Jeju showed $15{\sim}18^{\circ}C$ and 70~80% each which are somewhat high compare to other regions. So the Multi-effect dehumidifying and heating Heat Pump system which has merged functions of dehumidification and heating is made to solve this problem mentioned previously. When the suction air was $15^{\circ}C$ with 60% humidity, the outcome was 1.70 on $COP_h$ and 1.797(kg/h) on total amount of dehumidification, and also showed 1.87 $COP_h$ with 1.87 total amount of dehumidification under the condition of $20^{\circ}C$ and 80% humidity of suction air. Furthermore, $COP_h$ showed increased number which is 1.87 and also total amount of dehumidification increased which was 3.269(kg/h). The highest COP can be achieved at $17^{\circ}C$ and 70% relative humidity condition.

• Journal of the Korean Society of Radiology
• /
• v.5 no.3
• /
• pp.127-134
• /
• 2011

In this paper we propose an improved PV generation systems. Improved systems for temperature and humidity controlled heating and air conditioning offers a pleasant environment within the building, set up chopper and consists of a PWM voltage type inverter. The proposed system is stable modulation for a one-chip microprocessor using the synchronous signal and control signals was treated. The proposed system is a PWM voltage type inverter and phase of the synchronous to the grid voltage to detect the system voltage and inverter output to drive the statue, so surplus power to connection was able to, certain buildings such as buildings or hospitals, temperature and humidity sensor is applied to the good dynamic characteristic could be obtained. In addition, the system was applied to the high power factor and low-frequency harmonics by maintaining the output load and grid to power to be supplied to a stable control could get a good result.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.9 no.2
• /
• pp.1-9
• /
• 2009

Water binder ratio combine high-performance concrete shrinkage of less than 0.4 to determine the transformation to a total shrinkage of water to move outside and internal consumption of moisture due to drying shrinkage and autogenous shrinkage, and then, the relative humidity changes and strain to be approached by surface physics describe the relationship between self-desiccation and autogenous shrinkage was set. To verify the self-desiccation in the humidity shrinkage and humidity measurements performed, and the research model, Tazawa, CEB-FIP model than to let the measure and the most similar results in this study based on self-desiccation model, autogenous shrinkage didn't represent the linear shrinkage by the drying shrinkage of the external moving but exponential relationships, unlike with the nature and rapid in the early age properly describes the attributes in shrinkage could see. After this research to move moisture and to reflect the shrinkage model, temperature, moisture transfer, strain analysis by multi-physics model is very similar to the results of mock-up specimen measurements performed for this research, the value measured by the internal consumption of moisture, therefore self-desiccation and a multi-physics model considering autogenous shrinkage might be relevant.

• Atmosphere
• /
• v.27 no.2
• /
• pp.119-131
• /
• 2017

We present and discuss the Tropopause Folding Turbulence Detection (TFTD) algorithm for the Korean Communication, Ocean, Meteorological Satellite (COMS) which is originally developed for the Tropopause Folding Turbulence Product (TFTP) from the Geostationary Operational Environmental Satellite (GOES)-R. The TFTD algorithm assumes that the tropopause folding is linked to the Clear Air Turbulence (CAT), and thereby the tropopause folding areas are detected from the rapid spatial gradients of the upper tropospheric specific humidity. The Layer Averaged Specific Humidity (LASH) is used to represent the upper tropospheric specific humidity calculated using COMS $6.7{\mu}m$ water vapor channel and ERA-interim reanalysis temperature at 300, 400, and 500 hPa. The comparison of LASH with the numerical model specific humidity shows a strong negative correlation of 80% or more. We apply the single threshold, which is determined from sensitivity analysis, for cloud-clearing to overcome strong gradient of LASH at the edge of clouds. The tropopause break lines are detected from the location of strong LASH-gradient using the Canny edge detection based on the image processing technique. The tropopause folding area is defined by expanding the break lines by 2-degree positive gradient direction. The validations of COMS TFTD is performed with Pilot Reports (PIREPs) filtered out Convective Induced Turbulence (CIT) from Dec 2013 to Nov 2014 over the South Korea. The score test shows 0.49 PODy (Probability of Detection 'Yes') and 0.64 PODn (Probability of Detection 'No'). Low POD results from various kinds of CAT reported from PIREPs and the characteristics of high sensitivity in edge detection algorithm.