• 한국콘텐츠학회논문지
• /
• 제19권9호
• /
• pp.135-143
• /
• 2019

본 연구의 목적은 웹드라마가 사용하고 있는 온라인 동영상 플랫폼들을 대상으로 접근단계 분석과 광고 노출빈도 측정을 통해, 동영상 플랫폼의 사용성을 개선하는 것이다. 본 연구에서는 현재 웹드라마 시장의 점유율을 확인하고 접근단계와 광고회피를 바탕으로 채널간의 비교를 실시하였다. 그 결과 최신 콘텐츠에 대한 접근단계는 2~3단계이며 접근단계로 인하여 사용성이 낮아지지 않았다. 하지만 메인페이지나 검색결과에 노출되지 않아 디렉토리 검색이 필요한 경우 5~6단계의 접근단계가 필요하였다. 광고는 모든 플랫폼에서 2개 이상의 이미지광고가 표시되며, 유튜브와 네이버tv는 동영상 플레이어 내부에서 영상시작 전 프리롤(Pre-roll) 광고를 표시하는 것을 확인했다. 위와 같은 동영상 플랫폼 정보구조 상에서 디렉토리 검색을 하는 경우 높은 접근단계와 많은 광고노출로 사용자의 이탈률이 증가하고, 재방문 빈도가 낮아질 것으로 예상된다. 이를 개선하기 위해 드롭다운(Drop-Down) 메뉴를 활용하여 접근단계를 줄이는 정보구조 개선 프로토타입을 제안한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1313-1315
• /
• 2002

This paper proposes an inverter for the grid-connected photovoltaic system based on the transformer-less inverter. This system consists of a high frequency inverter bridge, high frequency transformer, diode bridge rectifiers, a DC filter, a low frequency inverter bridge, and an AD filter. The high frequency inverter bridge switching at 20kHz is used to generate bipolar PWM pulse, which is subsequently rectified by diode bridge rectifiers to result in a full-wave rectified sine wave. Finally, it is unfolded by a low frequency inverter bridge to result in a 60Hz sine wave power output. In this paper, the control algorithm for synchronous current feedback control method and a maximum power point tracking (MPPT) method using DSP are described. And, the simulation and experimental results are shown to verify the validity of the proposed system.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(2)
• /
• pp.795-798
• /
• 2004

This paper describes a control technique for a high frequency (HF) link current-fed inverter with a single power conversion stage. The switching and control techniques for the primary full-bridge inverter and secondary cycloconverter are presented for generating a sinusoidal output voltage. The simulation and experimental results are provided to show the validity of the proposed control technique.

• 조명전기설비학회논문지
• /
• 제19권7호
• /
• pp.100-106
• /
• 2005

일반적으로 자외선(UV)을 발생하기 위한 방전등 구동용 직류 전원장치는 하드 스위칭 모드로 동작되어지는 고주파 스위칭 DC-DC 컨버터가 사용되고 있다. 구체적으로 전원장치는 전자 노이즈 장해에 의한 전자 회로의 오동작이나 각 구성 소자의 발열의 문제 등이 시스템의 신뢰성을 저하시키는 원인이 되고 있다. 그러므로 본 논문에서는 소프트 스위칭 회로 기술을 사용한 고주파 링크 DC-DC 컨버터로서 먼저 구체적으로 1차측 위상 천이 PWM DC-DC 컨버터와 제안한 2차측 위상 천이 PWM DC-DC 컨버터를 조합하여 방전등 구동용 직류 전원장치를 제안하였다. 제안하는 방전등 구동용 직류 전원장치는 시뮬레이션과 실험을 통하여 그 타당성을 서술하였다.

• Journal of Electrical Engineering and Technology
• /
• 제13권5호
• /
• pp.2074-2079
• /
• 2018

Global state space's optimal policy is used for offline controller in the form of table by using Dynamic Programming. If an optimal policy table has a large amount of control data, it is difficult to use the system in a low capacity system. To resolve these problem, controller using the compressed optimal policy table is proposed in this paper. A DCT is used for compression method and the cosine function is used as a basis. The size of cosine function decreased as the frequency increased. In other words, an essential information which is used for restoration is concentrated in the low frequency band and a value of small size that belong to a high frequency band could be discarded by quantization because high frequency's information doesn't have a big effect on restoration. Therefore, memory could be largely reduced by removing the information. The compressed output is stored in memory of embedded system in offline and optimal control input which correspond to state of plant is computed by interpolation with Inverse DCT in online. To verify the performance of the proposed controller, computer simulation was accomplished with a one link inverted pendulum.

• 전력전자학회논문지
• /
• 제26권6호
• /
• pp.437-445
• /
• 2021

This paper proposes an operating frequency design method that limits the voltage applied to aload-side converter during the initial operation of a loosely coupled resonant dual-active bridge (LCR-DAB) converter and an initial operating strategy that applies it. The LCR-DAB converter uses two wireless power transfer coils instead of the high-frequency transformer of the general DAB converter. The wireless power coil has a physical distance of several tens of millimeter or more between the two coils; thus, the LCR-DAB converter is a bidirectional isolated power conversion system that can easily achieve high insulation performance. However, for the initial operation of the LCR-DAB, if the power-side converter is operated at the resonance frequency while the load-side converter is not operating, then a very high voltage due to resonance is applied to the load-side converter, thereby causing damage to the converter. Therefore, a method that can stably charge the DC link voltage of the secondary-side converter during the initial operation is needed. This paper proposes a method to initially charge the secondary-side DC link by operating the primary-side converter at a frequency with limited voltage gain rather than at a steady-state operating frequency. The validity of the proposed frequency design method and initial operating sequence is verified through simulation and experimentation of the 1 KW LCR-DAB converter.

• Journal of Power Electronics
• /
• 제16권5호
• /
• pp.1851-1860
• /
• 2016

The traction motors in electric multiple unit (EMU) trains are powered by AC-DC-AC converters, and the DC link voltage is generated by single phase PWM converters, with a fluctuation component under twice the frequency of the input catenary AC grid, which causes fluctuations in the motor torque and current. Traditionally, heavy and low-efficiency hardware LC resonant filters parallel in the DC side are adopted to reduce the ripple effect. In this paper, an analytical model of the ripple phenomenon is derived and analyzed in the frequency domain, and a ripple control scheme compensating the slip frequency of rotor vector control systems without a hardware filter is applied to reduce the torque and current ripple amplitude. Then a relatively simple discretization method is chosen to discretize the algorithm with a high discrete accuracy. Simulation and experimental results validate the proposed ripple control strategy.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2008년도 하계학술대회 논문집
• /
• pp.508-510
• /
• 2008

In designing a LLC resonant converter, the ratio of magnetizing inductance ($L_M$) to resonant inductance ($L_R$), the inductor ratio (K) is usually considered. In high power density adapter, both adapter size and efficiency are important factors. Considering the size of adapter, high K design can be more attractive. But, wide frequency variation of high K design results in design difficulty of magnetic elements and decrease in efficiency. To solve these drawbacks, an adaptive link voltage variation (ALVV) control is proposed. With the proposed control method, the LLC resonant converter can be operated at the resonant frequency despite the output voltage variation. The control strategy and schematics are presented, and verified experimentally.

• 전력전자학회논문지
• /
• 제12권1호
• /
• pp.56-64
• /
• 2007

최근 소형, 경량화 및 저가격화를 위해 절연형 고주파링크 승압 DC/DC 컨버터가 PCS (Power Conditioning System)에 많이 적용되고 있다. 하지만, 기존 전압형 컨버터 또는 전류형 컨버터가 적용된 고주파 링크 승압컨버터는 순환전류에 따른 도통손실과 변압기 누설인덕턴스에 따른 서지전압에 의해 여러 문제점을 내포하고 있다. 이들 문제들을 개선하기위해 새로운 2차측 LLC 직렬공진컨버터를 제안했고, 이에 대한 이론적 해석과 동작파형 및 시뮬레이션을 통해 800W급 시제품을 제작하여 실험결과에 대해 서술하였다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 1999년도 전력전자학술대회 논문집
• /
• pp.595-598
• /
• 1999

A new of the automotive High Intensity Discharge(HID) lamp ballast systems is proposed. Proposed scheme is consisted of the high frequency DC-DC converter and low frequency DC-AC inverter as same as conventional HID ballast system. But this system separates ignition voltage from dc link voltage, which results to used the lower voltage rating power devices for HID lamp ballast system compared with conventional system. As a result, proposed system has a lower cost and higher efficiency.