• Proceedings of the Materials Research Society of Korea Conference
• /
• 2011.05a
• /
• pp.27.2-27.2
• /
• 2011

본 연구에서는 저저항/고투과 플렉시블 투명 전극 개발을 위해 금속 그리드가 적용된 투명 전극을 개발하였다. Lift off 공정을 도입하여 플렉시블 PET 기판 위에 Ag grid를 성막하고 이후 연속 공정이 가능한 Roll-to-Roll sputtering system을 이용하여 최적화된 ITO(40nm)/Ag(12nm)/ITO(40nm) 다층 투명 전극을 성막하였다. 제작된 플렉시블 투명 전극의 전기적, 광학적, 구조적 특성 및 기계적/전기적 안정성 평가를 위해 four-point probe measurement, Hall effect measurement, UV/Vis spectrometer, scanning electron microscopy 및 bending tester를 이용하여 각각의 특성을 분석하였다. Ag grid가 적용된 ITO/Ag/ITO 투명 전극에서 Ag의 배선 간격이 0.75 mm일 때 0.18 ohm/sq. 의 낮은 면 저항과 가시광선 영역에서 80% 이상의 높은 투과율을 나타내었으며, 이러한 저저항 및 고투과율 특성으로 인해 최적화된 배선 간격 0.75 mm에서 $538.11{\times}10^{-3}\;ohm^{-1}$의 매우 높은 figure of merit ($T^{10}/R_{sh}$) 값을 확보할 수 있었다. 기계적 응력에 따른 전기적 안정성 특성 분석 결과 5,000회 이상의 bending cycle 에서도 초기 저항 값과 유사한 전기적 특성을 나타냄으로써 Ag grid가 적용된 ITO/Ag/ITO 플렉시블 투명 전극의 기계적 응력에 따른 전기적 안정성을 확인할 수 있었다. Ag grid가 적용된 ITO/Ag/ITO 투명 전극의 투명 안테나 적용 가능성을 타진하기 위해 low band 및 high band 영역에서의 안테나 효율을 측정하였으며, 모든 영역에서 상용화된 copper 안테나와 유사한 효율을 나타내었다. Ag grid를 이용한 플렉시블 투명 전극의 저저항/고투과율 특성은 플렉시블 광전소자의 투명 안테나로의 적용 가능성을 나타낸다.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.34D no.7
• /
• pp.56-61
• /
• 1997

I $n_{0.53}$G $a_{0.47}$As/I $n_{0.52}$A $l_{0.48}$As pseudomorphic high electron mobility transistor (P-HEMT) structures were grown on semi-insulating InP substrates by molecular beam epitzxy method. The hall effect measuremetn was used to measure the electrical properties and the photoluminescence (PL) measurement was used to measure the electrical properties and the photoluminescence(PL) measurement for optical propety. By the cross-sectional transmission electron microscopy (XTEM) investigation of the V and X shape defects including slip with angle of 60.deg. C and 120.deg. C to surface in the sampel, the defects formation mecahnism in the I $n_{0.52}$A $l_{0.48}$As epilayers on InP substrates could be explained with the different thermal expansion coefficients between I $n_{0.52}$A $l_{0.48}$As epilayers and InP substrate.d InP substrate.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.216-217
• /
• 2008

Zinc-oxide films were deposited by pulsed laser deposition (PLD) technique using doped ZnO target (mixed $In_2O_3$ 0.1, 0.3, 0.6 at. % - atomic percentage) on the p-type Si(111) substrate. A little Indium has added at the n-ZnO films for the electron concentration control and enhanced the electrical properties. Also, post thermal annealed ZnO films are shown an enhanced structural and controled electron concentration by the annealing condition for the hetero junction diode of a better emitting characteristics. The electrical and the diode characteristics of the ZnO films were investigated by using Hall effect measurement and current-voltage measurement.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.1
• /
• pp.11-16
• /
• 2016

The conduction behavior and electron concentration change in a-IGZO thin-films according to the RTA (rapid thermal annealing) were studied. The electrical characteristics of TFTs (thin-film-transistors) annealed by different temperatures were measured. The sheet resistance, electron concentration, and oxygen vacancy of a-IGZO film were measured by the four-point-probe-measurement, hall-effect-measurement, and XPS analysis. The RTA process increased the driving current of IGZO TFTs but the VTH shifted to the negative direction at the same time. When the RTA temperature is higher than $250^{\circ}C$, the leakage current at off-state increased significantly. This is attributed to the increase of oxygen vacancy resulting in the increase of electron concentration. We demonstrate that the RTA is a promising process to adjust the VTH of TFT because the RTA process can easily modify the electron concentration and control the conductivity of IGZO film with short process time.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.124-127
• /
• 2003

The stochiometric $AgGaSe_2$ polycrystalline mixture of evaporating materials for the $AgGaSe_2$ single crystal thin film was prepared from horizontal furnance. To obtain the single crystal thin films, $AgGaSe_2$ mixed crystal and semi-insulating GaAs(100) wafer were used as source material and substrate for the Hot Wall Epitaxy (HWE) system, respectively. The source and substrate temperature were fixed at $630^{\circ}C$ and $420^{\circ}C$, respectively. The thickness of grown single crystal thin films is $2.1{\mu}m$. The single crystal thin films were investigated by photoluminescence and double crystal X-ray diffraction(DCXD) measurement. From the photoluminescence measurement of $AgGaSe_2$ single crystal thin film, we observed free excition ($E_x$) observable only in high quality crystal and neutral bound excition ($D^{\circ}$,X) having very strong peak intensity. And, the full width at half maximum and binding energy of neutral donor bound excition were 8 meV and 14.1 meV, respectively. By Haynes rule, an activation energy of impurity was 141 meV.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.120-120
• /
• 2009

Ga doped ZnO (GZO) transparent conductive films were deposited on the glass substrates at room temperature by facing target sputtering (FTS) method. The sputtering targets were 100 mm diameter disks of GZO($Ga_2O_3$ 3.w.t%) and Zn metal. The GZO thin films were deposited as a various $PO_2$ (oxygen gas content). Base pressure was $2{\times}10^{-6}torr$, and a working pressure was 1mTorr. The properties of thin films on the electrical and optical properties of the deposited films were investigated by using a four-point probe (Chang-min), a Hall Effect measurement (Ecopia) and an UV/VIS spectrometer (HP). The minimum resistivity of film was $6.5{\times}10^{-4}[{\Omega}-cm]$ and the average transmittance of over 80% was seen in the visible range

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.106-106
• /
• 2009

Al-doped ZnO (AZO) thin films were grown on glass substrates by co-sputtering at room temperature. We made ZnO and Al target and ZnO:Al film is deposited with sputter which has two RF gun source. The Al content was controlled by varying Al RF power and effect of Al contents on the properties of ZnO:Al film was investigated. Crystallinity and orientation of the ZnO:Al films were investigated by X-ray diffraction (XRD), surface morphology of the ZnO:Al films was observed by atomic force microscope. Electrical properties of the ZnO:Al films were measured at room temperature by van der Pauw method and hall measurement. Optrical properties of ZnO:Al films were measured by UV-vis-NIR spectrometer.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.266.1-266.1
• /
• 2016

최근 태양전지에 대한 연구가 활발하기 이루어지고 있다. 그 중 본 연구에선 태양전지에 사용될 광흡수층에 대한 연구로 광흡수층은 광흡수계수와 밴드갭의 영향을 받고 SnS가 적합한 특성을 지니고 있다고 판단하여 이에 대한 합성과 특성에 대한 연구를 진행 하였다. SnxSy 박막은 Electrochemical deposition, Spray pyrolysis deposition, Furnace를 이용하는 등 다양한 방법이 있다. 이러한 방법들은 대부분 막질이 좋지 않다고 알려져 있는데 그 중 Furnace를 이용하는 방법은 간단하며 넓은 면적에 쉽게 증착이 가능하다는 장점이 있지만 S의 양과 온도에 민감하다. 본 연구에서는 Sn과 SnO 박막을 전구체로 사용하였으며 S의 양과 온도를 조절하여 로를 이용하여 합성하였다. 이에 대한 조성 및 구조적 특성을 분석하기 위해 XRD를 전기적 특성을 확인하기 위하여 Hall effect measurement를 통하여 측정하였다.

• Journal of the Korean Ceramic Society
• /
• v.25 no.4
• /
• pp.341-348
• /
• 1988

Thin films of tin-oxide were prepared by chemical vapor deposition technique using the direct of SnCl4. Resistivity and carrier concentration of deposited SnO2 thin film were measured by 4-point probe method and Hall effect measurement. The results showed the remarkable dependence of electrical properties on the deposition temperature. As the deposition temperature increased, resistivity of deposited film initially decreased to a minimum value of ~10-3$\Omega$cm at 50$0^{\circ}C$, and then rapidly increased to ~10$\Omega$cm at $700^{\circ}C$. Electrical conductance of these films was measured in exposure to H2 gas. It was found that gas sensitivity was affected combination of film thickness and intrinsic resistivity of deposited film. Gas sensitivity increased with decrease of film thickness. Fairly high sensitivity to H2 gas was obtained for the film deposited at $700^{\circ}C$. Optimum operation temperature of sensing was 30$0^{\circ}C$ for H2 gas.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.138-138
• /
• 2009

Al, Ga and In doped ZnO thin film were prepared by faing targets sputtering as a function of oxygen gas contents at R.T. Base pressure was $2{\times}10^{-6}torr$, and working pressure was 1mTorr. The properties of thin films on the electrical and optical properties of the deposited films were investigated by using a four-point probe (Chang-min), a Hall Effect measurement (Ecopia) and an UV/VIS spectrometer (HP). The minimum resistivities of AZO, GZO and IZO thin film were $6.5{times}10^{-4}[{\Omega}-cm],5.5{\times}10^{-4}[{\Omega}-cm]$ and $4.29{\times}10^{-4}[{\Omega}-cm]$. The average transmittance of over 80% was seen in the visible range.