• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.7 no.3
• /
• pp.468-473
• /
• 2003

In this paper, for enhancement of property on a-Si:H TFTs We measure interface characteristics of ferroelectrics thin film and a-Si:H thin film. First, SrTiO$_3$ thin film is deposited bye-beam evaporation. Deposited films are annealed for 1 hour in N2 ambient at $150^{\circ}C∼600^{\circ}C$. Dielectric characteristics of deposited SrTiO$_3$ films are very good because dielectric constant shows 50∼100 and breakdown electric field are 1 ∼ 1.5 MV/cm. a-SiN:H,a-Si:H(n-type a-Si:H) are deposited onto SrTiO$_3$ film to make MFNS(Meta1/ferroelectric/a-SiN:H/a-Si:H) by PECVD. After the C-V measurement for interface characteristics, MFNS structure shows no difference with MNS(Metal/a-SiN:H/a-Si:H) structure in C-V characteristics but the insulator capacitance value of MFNS structure is much higher than the MNS because of high dielectric constant of ferroelectric.

• Korean Journal of Materials Research
• /
• v.9 no.10
• /
• pp.1006-1011
• /
• 1999

B-doped hydrogenated amorphous silicon carbide (a-SiC:H) thin films were prepared by plasma-enhanced chemical-vapor deposition in a gas mixture of $SiH_4$, $CH_4$ and $B_2H_6$. Microstructures and chemical properties of a-SiC:H films grown with varing the volume ratio of $CH_4$ to $SiH_4$ were characterized with various analysis methods including scanning electron microscopy(SEM), X-ray diffractometry(XRD), Raman spectroscopy, Fourier-transform infrared (FTIR) spectroscopy. X-ray photoelectron spectroscopy(XPS), UV absorption spectroscopy and photoconductivity measurements. While Si:H films grown without $CH_4$ showed amorphous state, the addition of $CH_4$ during deposition enhanced the development of a microcrystalline phase. By introducing C atoms into the film, Si-Si and Si--$\textrm{H}_{n}$ bonds of a -Si:H films were gradually replaced by Si-C, C-C, and Si--$\textrm{C}_{n}\textrm{H}_{m}$ bonds. Consequently, the electrical resistivity and optical bandgap of a-SiC:H films were increased with the C concentration in the film.

• Industry Promotion Research
• /
• v.3 no.2
• /
• pp.1-8
• /
• 2018

In this study, the reaction mechanism of ethane and the reaction rate equation suitable for hydrocarbon reforming were studied. Through the reaction mechanism analysis, it was confirmed that three reactions (CO2 + H2, C2H6 + H2, C2H6 + H2O) proceed during the reforming reaction of ethane, each reaction rate (CO2+H2($r=3.42{\times}10-5molgcat.-1\;s-1$), C2H6+H2($r=3.18{\times}10-5mol\;gcat.-1s-1$), C2H6+H2O($r=1.84{\times}10-5mol\;gcat.-1s-1$)) was determined. It was confirmed that the C2H6 + H2O reaction was a rate determining step (RDS). And the reaction equation of this reaction can be expressed as r = kS * (KAKBPC2H6PH2O) / (1 + KAPC2H6 + KBPH2O) (KA = 2.052, KB = 6.384, $kS=0.189{\times}10-2$) through the Langmuir-Hinshelwood model. The obtained equation was compared with the derived power rate law without regard to the reaction mechanism and the power rate law was relatively similar fitting in the narrow concentration change region (about 2.5-4% of ethane, about 60-75% of water) It was confirmed that the LH model reaction equation based on the reaction mechanism shows a similar value to the experimental value in the wide concentration change region.

• Journal of the Korean Vacuum Society
• /
• v.10 no.1
• /
• pp.104-111
• /
• 2001

B-doped hydrogenated amorphous silicon carbide (a-SiC:H) thin films were prepared by plasma-enhanced chemical-vapor deposition in a gas mixture of $SiH_4, CH_4,\;and\; B_2H_6$. Physical and chemical properties of a-SiC:H films grown with varing the ratio of $B_2H_6/(SiH_4+CH_4)$ were characterized with various analysis methods including scanning electron microscopy (SEM), X-ray diffractometry (XRD), Raman spectroscopy, Fourier-transform infrared (FTIR) spectroscopy, secondary ion mass spectroscopy (SIMS), UV absorption CH_4spectroscopy and electrical conductivity measurements. With the B-doping concentration, the doping efficiency and the micro-crystallinity were decreased and the film became amorphous when $B_2H_6/(SiH_4{plus}CH_4)$ was over $5{\times}10^{-3}$. The addition of $B_2H_6$ gas during deposition decreased the H content in the film by lowering the quantity of Si-C-H bonds. Consequently, the optical band gap and the activation energy of a-SiC:H films were decreased with increasing the B-doping level.

• Proceedings of the PSK Conference
• /
• 2003.10b
• /
• pp.202.3-202.3
• /
• 2003

Two Known compounds, syringaresinol monoglucoside(8), chimaphilin(14), together with three new compounds, (9)[mp. $106{\sim} 111^{\circ}C$, C_{29}H_{44}O_{13}$], (10)[mp. $180{\sim}182^{\circ}C$, $C_{15}H_{20}O_{9}$] and (11)[mp. $100{\sim}105^{\circ}C$, $C_{18}H_{28}O_{8}$] were isolated from the BuOH fractionof Pyrola japonics(Pyrolaceae). The structures of the known compounds were determined by chemical and spectorscopic methods. The assignments of the $^{1}H-$ and $^{13}C-NMP$ spectra of these compounds were carried out by two-dimensional $^1H-^1H-COSY$, NOESY and $^1H-^{13}C$ multiple-bond, multiplequantum spectroscopic correlation techniques. The characterization of the three new compounds is now in progress.

• Korean Journal of Food Science and Technology
• /
• v.23 no.3
• /
• pp.355-359
• /
• 1991

Effects of temperature and pH on thermal degradation of monosodium glutamate(MSG) were investigated during heating of 2% MSG solution at $100{\sim}200^{\circ}C\;and\;pH\;4{\sim}9$. The results showed that the degradation of MSG was very significantly affected by heating temperature and pH. Three hours of heating at $pH\;4\;and\;120^{\circ}C$ resulted appr. 73% MSG degradation while 3 hours at $100^{\circ}C$ decreased only 12%. The comparison study of initial rate of MSG degradation and degradation rate constants showed the highest degradation rate and rate constant and low values in the range of $pH\;6{\sim}8{\sim}$. The values of activation energy calculated from linear relationship of rate constants and 1/T were 18.3 and 9.2 kcal/mole for pH 4 and 5, respectively.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.12
• /
• pp.3745-3748
• /
• 2010

Pd(II) p-tolylamide Pd(2,6-$(Ph_2PCH_2)_2C_6H_3$)(NH($C_6H_4Me$-p)) (1) was metathetically prepared by the reaction of Pd(2,6-$(Ph_2PCH_2)_2C_6H_3$)Cl with NaNH($C_6H_4Me$-p). Treatment of 1 with carbon dioxide affords the palladium(II) carbamate Pd(2,6-$(Ph_2PCH_2)_2C_6H_3$)(OC(O)NH($C_6H_4Me$-p)) (2), quantitatively. Complex 2 reacts with HX (X = Cl, OTf) to give Pd(2,6-$(Ph_2PCH_2)_2C_6H_3$)X, $NH_2$(p-Tol) and $CO_2$. Reaction of the palladium(II) carbamate with MeI produced Pd(2,6-$(Ph_2PCH_2)_2C_6H_3$)I along with generation of methyl N-tolylcarbamate MeOC(O)NH($C_6H_4Me$-p), exclusively.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2008.06a
• /
• pp.361-362
• /
• 2008

• Journal of Sericultural and Entomological Science
• /
• v.17 no.2
• /
• pp.161-170
• /
• 1975

This study is to investigate the content of crude protein intruded in the sericin of cocoon shell and pupa by treatment of buffer solution (pH 1 to pH 13) 20 ml per 1 gram for 30 and 60 minutes at 30$^{\circ}C$, 60$^{\circ}C$ and 100${\pm}$2$^{\circ}C$, respectively. The results obtained are summarized as follows. 1. The quantity of total crude protein obtained from cocoon shell and pupa by treatment during 30 minutes at 30$^{\circ}C$ was dissolved as the largest quantity of 11.874 mg/g at pH 1 and l5.93mg/g at pH 13, but dissolved the smallest quantity 1.75g/g at pH 5 as known. and tile quantity of crude protein treated for 60 minutes is 13.437mg/g at pH 1 and 22.50mg/g at pH 13. Also, the smallest quantity is 2. 813mg/g at pH 5 as known. 2. By the treatment during 30 minutes at 60$^{\circ}C$, the dissolved largest quantity was 13.12mg/g at pH 1 and 21.875 mg/g at pH 13, but the smallest quantity is 2.375mg/g at pH 5 as known After treatment for 60 minutes at 60$^{\circ}C$, the dissolved largest quantity was 17.500 mg/g at pH 1 and 31.56mg/g at pH 13, bu the smallest quantity is 3.849 mg/g at pH 5. 3. The dissolved crude protein from the cocoon shell and pupa by treatment for 30 minutes at 100${\pm}$2$^{\circ}C$ was the largest quantity of 147.000mg/g at pH 1 and 398. 125mg/g at pH 13, but the smallest quantity is 75.00mg/g at pH 5 as known. After treatment for 60 minutes at 100${\pm}$2$^{\circ}C$, the largest quantity was 253.76 mg/g at pH 1 and 460.625mg/g at pH 13, but the smallest quantity is 139.375mg/g at pH 5 as known. 4. The dissolved crude protein from the cocoon shell and pupa was not different in quantity by treatment at 30$^{\circ}C$ or 60$^{\circ}C$. But dissolved crude protein was large quantity from cocoon shell more than pupa, as known. 5. The treatment of cocoon shell and pupa during 60 minutes at 100${\pm}$20$^{\circ}C$ was increased to the dissolved largest quantity of crude protein of 19.20％ at pH 1 and 22. 18％ at pH 13 from the cocoon shell and 6. 12％ at pH, an d 23.87％ at pH 13 from the pupa. But dissolved crude protein was increased to the larger quantity from pupa more than cocoon shell.

• Geomechanics and Engineering
• /
• v.31 no.4
• /
• pp.385-393
• /
• 2022

Previous studies postulated insignificant capillary rise (h_c) effect above the water table (H_w) for unsaturated soils. In addition, these studies utilised dry unit weight above H_w. This paper, therefore, addresses the effect of these postulations on strength where the influence of h_c using a modified upper bound approach, Discontinuity Layout Optimization (UNSAT-DLO) for a simulated soil was predicted. Two different parametric studies to model passive earth pressure and bearing capacity problems are carried out to provide an insight into the effect of capillary rise on strength. Significant increase in strength, owing to unsaturated conditions, was obtained where the maximum increase was when suction slightly less or greater than the air entry suction. On the other hand, the results showed a negative effect of h_c. For example, up to 8.24% decrease in passive thrust (P_p) was obtained at H_w=0 m when h_c rose 1 m from 0 m. To put this into perspective, this was equivalent to a decrease of about 2° in 𝜙 at H_w=0 m and h_c =0 m in order to obtain the same result at h_c =1 m. For the bearing capacity problem, the effect was seen to be higher, up to 18.4% decrease in N_𝛾 was obtained when h_c rose from 0 m to 2.5 m at H_w =0 m. In addition, the results revealed a negative influence of assigning dry unit weight above H_w or h_c.. However, considerable increase in strength was obtained when unsaturated unit weight above h_c was assigned.