• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.30 no.2
• /
• pp.41-46
• /
• 2020

The characteristics of the residual stress on the types of the substrate was investigated with adjusting the V/III ratio during GaN growth via the HVPE method. GaN single crystal layers were grown on a sapphire substrate and a GaN template under the conditions of V/III ratio 5, 10, and 15, respectively. During GaN growth, multiple hexagonal pits in GaN single crystal were differently revealed in accordance with growth condition and substrate type, and their distribution and depth were measured via optical microscopy(OM) and white light interferometry(WLI). As a result, it was confirmed that the distribution area and depth of hexagonal pit tended to increase as the V/III ratio increased. Moreover, it was found that the residual stress in GaN single crystal decreased as the distribution area and depth of the pit increased through measuring micro Raman spectrophotometer. In the case of GaN growth according to substrate type, the GaN on GaN template showed lower residual stress than the GaN grown on sapphire substrate.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.19 no.1
• /
• pp.6-10
• /
• 2009

In this paper, a selective area growth (SAG) of a GaN/AlGaN double heterostructure (DH) has been performed on r-plane sapphire substrate by using the mixed-source hydride vapor phase epitaxy (HVPE) with multi-sliding boat system. The SAG-GaN/AlGaN DH consists of GaN buffer layer, Te-doped AlGaN n-cladding layer, GaN active layer, Mg-doped AlGaN p-cladding layer, and Mg-doped GaN p-capping layer. The electroluminescence (EL) characteristics show an emission peak of wavelength, 439 nm with a full width at half maximum (FWHM) of approximately 0.64 eV at 20 mA. The I-V measurements show that the turn-on voltage of the SAG-GaN/AlGaN DH is 3.4 V at room temperature. We found that the mixed-source HVPE method with a multi-sliding boat system was one of promising growth methods for III-Nitride LEDs.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.22 no.1
• /
• pp.11-14
• /
• 2012

The AlGaN layer has direct wide bandgaps ranging from 3.4 to 6.2 eV. Nowadays, it is becoming more important to fabricate optical devices in an UV region for the many applications. The high quality AlGaN layer is necessary to establish the UV optical devices. However, the growth of AlGaN layer on GaN layer is difficult due to the lattice mismatch and difference thermal expansion coefficient between GaN layer and AlGaN layer. In this paper, we attempted to grow the LED structure on GaN template by mixed-source HVPE method with multi-sliding boat system. We tried to find the optical and lattice transition of active layer by control the Al content in mixed-source. For the growth of epi layer, the HCl and $NH_3$ gas were flowed over the mixed-source and the carrier gas was $N_2$. The temperature of source zone and growth zone was stabled at 900 and $1090^{\circ}C$, respectively. After the growth, we performed the x-ray diffraction (XRD) and electro luminescence (EL) measurement.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.24 no.4
• /
• pp.135-139
• /
• 2014

The hydride vapor phase epitaxy (HVPE) grown GaN samples to precisely measure the surface characteristics was applied to a molten KOH/NaOH wet chemical etching. The etching rate by molten KOH/NaOH wet chemical etching method was slower than that by conventional etching methods, such as phosphoric and sulfuric acid etching, which may be due to the formation of insoluble coating layer. Therefore, the molten KOH/NaOH wet chemical etching is a better efficient method for the evaluation of etch pits density. The grown GaN single crystals were characterized by using X-ray diffraction (XRD) and X-ray rocking curve (XRC). The etching characteristics and surface morphologies were studied by scanning electron microscopy (SEM). From etching results, the optimum etching condition that the etch pits were well independently separated in space and clearly showed their shape, was $410^{\circ}C$ and 25 min. The etch pits density obtained by molten KOH/NaOH wet chemical etching under optimum etching condition was around $2.45{\times}10^6cm^{-2}$, which is commercially an available materials.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.33 no.2
• /
• pp.45-53
• /
• 2023

The growth of Si on 4H-SiC substrate has a wide range of applications as a very useful material in power semiconductors, bipolar junction transistors and optoelectronics. However, it is considerably difficult to grow very fine crystalline Si on 4H-SiC owing to the lattice mismatch of approximately 20 % between Si and 4H-SiC. In this paper, we report the growth of a Si epilayer by an Al-related nanostructure cluster grown on a 4H-SiC substrate using a mixed-source hydride vapor phase epitaxy (HVPE) method. In order to grow hexagonal Si on the 4H-SIC substrate, we observed the process in which an Al-related nanostructure cluster was first formed and an epitaxial layer was formed by absorbing Si atoms. From the FE-SEM and Raman spectrum results of the Al-related nanostructure cluster and the hexagonal Si epitaxial layer, it was considered that the hexagonal Si epitaxial layer had different characteristics from the general cubic Si structure.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.29 no.11
• /
• pp.702-706
• /
• 2016

We demonstrated that self-separation FS-GaN (freestanding-GaN) was grown on MELO (maskless epitaxially lateral overgrowth) GaN template by horizontal HVPE (hydride vapor phase epitaxy). Before thick GaN grwoth, MELO GaN template was grown on patterned GaN template by MOCVD (metal organic chemical vapor deposition). The laterally overgrown GaN would consist of a continuous well coalesced layer. The mixed TDD (threading dislocation density) of seed and wing region were $8{\times}10^8cm^{-2}$ and $7{\times}10^7cm^{-2}$, respectively. After thick GaN grown by HVPE, the self-separation between thick GaN and sapphire substrate was generated at seed region. The regions of self-separation for FS-GaN and sapphire were observed by FE-SEM. Moreover, Raman results indicated that the compressive strain of seed and wing regions at FS-GaN substrate were slightly released compared to that of thick GaN grown on conventional GaN template. The optical properties of the FS-GaN substrate were examined by using PL (photoluminescence). The PL exhibited that donor bound exciton and donor acceptor pair were observed at low temperature. The effects on optical and structural properties of FS-GaN substrate have been discussed in detail.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.99-99
• /
• 2008

To grow the large diameter GaN with high structure and optical quality has been obtained by hydride vapor phase epitaxy(HVPE) method. In addition to the nitridation of $Al_2O_3$ substrate, we also developed a "step-growth process" to reduce or to eliminate the bowing of the GaN substrate caused by thermal mismatch during cool down after growth. The as-grown 380um thickness and 75mm diameter GaN layer was separated from the sapphire substrate by laser-induced lift-off process at $600^{\circ}C$. A problem with the free-standing wafer is the typically large bowing of such a wafer, due to the built in the defect concentration near GaN-sapphire interface. A polished G-surface of the GaN substrate were characterized by room temperature Double crystal X-ray diffraction (DCXRD), photoluminescence(PL) measurement, giving rise to the full-width at half maximum(FWHM) of the rocking curve of about 107 arcsec and dislocation density of $6.2\times10^6/cm^2$.

• Journal of the Microelectronics and Packaging Society
• /
• v.28 no.4
• /
• pp.25-29
• /
• 2021

This paper demonstrates the utility of the Ni-Pd and carbon-nanotube (Ni-Pd-CNT)-based nanoalloy to improve the α-Ga₂O₃ crystal quality using the halide-vapor-phase epitaxy (HVPE) method. As result, the overall thickness of the α-Ga₂O₃ epitaxial layer increased from a Ni electroless plating time of 40 s to 11 ㎛ after growth. In addition, the surface morphologies of the α-Ga₂O₃ epilayers remained flat and crack-free. The full-width half-maximum results of the X-ray diffraction analysis revealed that the ($10{\bar{1}}4$) diffraction patterns decreased with increasing nominal thickness.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.18 no.3
• /
• pp.101-104
• /
• 2008

GaN films were grown on the vertical and horizontal reactors by the hydride vapour phase epitaxy (HVPE). The structural and optical characteristics of the GaN films were investigated depending on the reactor-type. GaN epilayers were characterized by double crystal X-ray diffraction (DC-XRD), transmission electron microscopy (TEM) and photoluminescence (PL). Surface defects of two kinds of the GaN films were revealed by the wet chemical etching method, using $H_3PO_4$ acid at $200^{\circ}C$ for 8 minutes. Hexagonal etch pits were analyzed by optical microscopy and SEM. Etch pit densities were calculated to be approximately $1.4{\times}10^7$ and $1.2{\times}10^6\;cm^{-2}$ for GaN layers grown on horizontal and vertical reactors, respectively. Those results show GaN grown in the vertical reactor having a better quality of optical properties and crystallinity than that in the horizontal reactor.

• Korean Journal of Crystallography
• /
• v.5 no.1
• /
• pp.24-32
• /
• 1994

The study of (0001), (1120) and (1011) GAN epitaxy films grown on the (0001),(1012) and (1120) α-Al2O3 substrates have been investigated using the haliar vapor phaes epitaxy(HVPE) method in Ga/HCI/NH3/He system. XRD, RHEED and SEM are used for the study of the films struction and surface morphology. Chemical composition of the film surface is estimsted by XPS. The following orientation relationships are observed; (0001) GaN /(0001) Al2O3 (1120) GaN/ (1012) Al2O3 and (0001) and (1011) GaN/ (1120) Al2O3 in accordance with growth conditions. The (0001) GaN films grown on(0001) and (1120) a-Al2O3 substrates at higer temperature(1050℃) have shown two dimensional grownth mechanism. Form SEM and RHEED, the smoother surface morphology and better structure are observed for the (1011) GaN films grown on (1120) sapphire at higer temperature.