• Computers and Concrete
• /
• 제7권2호
• /
• pp.87-102
• /
• 2010

This paper discusses new capabilities developed for the Virtual Penetration Laboratory (VPL) software package to address the challenges of determining Penetration Resistance (PR) equations for concrete materials. Specifically, the paper introduces a three-invariant concrete constitutive model recently developed by the authors. The Advanced Fundamental Concrete (AFC) model was developed to provide a fast-running predictive model to simulate the behavior of concrete and other high-strength geologic materials. The Continuous Evolutionary Algorithms (CEA) automatic fitting algorithms used to fit the new model are discussed, and then examples are presented to demonstrate the effectiveness of the new AFC model. Finally, the AFC model in conjunction with the VPL software package is used to develop a PR equation for a concrete material.

• 한국지반환경공학회 논문집
• /
• 제14권3호
• /
• pp.35-40
• /
• 2013

일반적으로 동결대상지역에 설치되는 지반구조물은 동결피해에 대한 별도의 대책을 필요로 한다. 그러나 국내의 경우 터널, 옹벽 등과 같은 지반구조물에 대한 동결피해 조사 및 사례보고가 거의 이루어지지 않고 있어, 이를 저감시키기 위한 연구는 매우 미미한 실정이다. 이러한 이유로 국내의 구조물 관련 설계기준도 특별하게 이를 규정화하고 있지 않다. 본 연구에서는 터널, 비탈면, 옹벽의 동결피해에 대한 현장조사 및 1종, 2종 시설물에 대한 약 40여 년간의 지반구조물 유지관리 이력을 분석하여 구조물 설치지역의 기온에 따른 구조물의 유지관리 특성을 파악하였다. 그 결과 우리나라에서 동결깊이가 약 120cm 이상이고, 기온이 비교적 낮은 강원 산간지역 및 강원 북부, 경기 북부지역의 지반구조물은 기온이 비교적 따뜻한 타 지역과 달리 훨씬 더 오랫동안 보수보강을 필요로 하는 것으로 분석되었다. 이로부터 국내 동결피해 대상지역에 설치되는 구조물에 대한 설계기준 개정의 필요성을 제안하였다.

• Computers and Concrete
• /
• 제7권2호
• /
• pp.191-202
• /
• 2010

A laboratory investigation was conducted to characterize the constitutive property behavior of Cor-Tuf, an ultra-high-performance composite concrete. Mechanical property tests (hydrostatic compression, unconfined compression (UC), triaxial compression (TXC), unconfined direct pull (DP), uniaxial strain, and uniaxial-strain-load/constant-volumetric-strain tests) were performed on specimens prepared from concrete mixtures with and without steel fibers. From the UC and TXC test results, compression failure surfaces were developed for both sets of specimens. Both failure surfaces exhibited a continuous increase in maximum principal stress difference with increasing confining stress. The DP tests results determined the unconfined tensile strengths of the two mixtures. The tensile strength of each mixture was less than the generally assumed tensile strength for conventional strength concrete, which is 10 percent of the unconfined compressive strength. Both concretes behaved similarly, but Cor-Tuf with steel fibers exhibited slightly greater strength with increased confining pressure, and Cor-Tuf without steel fibers displayed slightly greater compressibility.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.1239-1243
• /
• 2008

On the Performance-based Design guideline techniques, many studies were not execued. Especially, some structures were studied on the evaluation of performance-based design. Geotechnical foundation on the structures are investigated in domestic and other countries.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 춘계학술대회
• /
• pp.613-616
• /
• 2007

The main structures that comprise a tidal power plant are turbine structure, sluice structure, tide embankment and gate. Since these structures are founded on seabed ground, an extensive geotechnical site investigation to evaluate the engineering properties of field soils must be conducted prior to design and construction. According to the results of geotechnical site investigation conducted at the planned site for construction of Incheon bay tidal power plant, soft ground generally lie 7 meters below the seabed surface level. This research suggests the reliable and economical design of foundations and ground improvements required for construction of main structures in Incheon bay tidal power plant, with considerations on field conditions.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.1318-1327
• /
• 2008

Geotechnical sites in urban areas may have embedded structures such as utility lines and underground concrete structures, which cause difficulties in site investigation. This study is a preliminary research to establish knowledge base for developing an optimal technique for site investigation in urban areas. Surface-wave method and resistivity survey, which are frequently adopted for non-destructive site-investigation for geotechnical sites, were investigated to characterize effects of adjacent structures. In case of surface wave method, patterns of wave propagation were investigated for typical sets of multi-layered geotechnical profiles by numerical simulation based on forward modeling theory and field experiments for small-size model tests and real-scale tests in the field. In case of resistivity survey, 3-D finite element analyses and field tests were performed to investigate effects of adjacent concrete structures. These theoretical and experimental researches for surface-wave method and resistivity survey resulted in establishing physical criteria to cause interference of adjacent structures in site investigation at urban areas.

• 한국지반신소재학회논문집
• /
• 제23권2호
• /
• pp.19-27
• /
• 2024

댐과 터널 그리고 사면 같은 지반구조물의 정기적인 계측 및 모니터링은 안전성 유지를 위해 필요하다. 국내에서는 드론과 가속도계와 같은 장비를 활용하여 지반구조물에 대한 점검 및 모니터링을 수행한다. 하지만, 드론은 구조물 및 지반 내부의 변화를 파악에 어려움이 있고, 가속도계는 일반적으로 내진 설계나 변형량 측정에만 활용되고 있다. 이에 본 논문은 가속도계를 활용하여 지반 내부 정보를 실시간 또는 정기적으로 계측하기 위해 SASW 시험 활용을 제안하였다. 제안된 방법은 SASW 시험의 해석 기법의 일부분만 활용하여 지반구조물의 강도 및 상태 변화를 추적한다. 이를 위해, SASW를 활용하여 사면, 댐 및 터널과 같은 지반구조물의 안전성을 평가한 사례들을 분석하여 기술의 적합성을 확인하였다. 또한, 현장 적용성을 높이기 위해, 복잡한 해석을 요구하는 전단 속도 프로파일을 도출하는 2차 해석보다는 분산곡선을 도출하는 1차 해석만을 활용하는 방안을 모색하였다. 본 연구에서 제안된 기술을 통해 가속도계를 활용하여 지반구조물의 지속적인 모니터링 및 유지보수가 가능할 것으로 기대된다.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2005년도 춘계 학술발표회 논문집
• /
• pp.423-430
• /
• 2005

Fire accidents in underground space may bring much loss of lives as well as properties and result in catastrophic disasters. This study aimed to manufacture the high-temperature furnace capable of simulating fire scenarios (RABT and RWS) and carry out the preliminary fire tests to evaluate fire-induced damage in underground structures. Specimens used in the fire tests were the concrete segments generally used in shield TBM tunnels. The simulated fire scenario was set to the RABT curve that is the most representative fire scenario in underground space. From the fire tests, the spalling was estimated to reach approximately 20cm from the surface exposed to fire. In addition, from the observation of core specimens obtained after fire tests, the deteriorated zone of unspalled specimens amounted to approximately 10cm from the surface of spalling.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 추계 학술발표회
• /
• pp.126-133
• /
• 2008

Geotechnical limit state design methods; LRFD of North America is an approach that estimates resistance using design model and then multiplies resistance factor by calculated resistance to reflect the uncertainty of geomaterials and design models; whereas, Eurocode of the Europe employs the partial resistance factor applied directly to each variable in the resistance equation that individual soil properties such as cohesion and angle of internal friction are applied. This discussion paper is a study on characteristic value which has globally been argued through processing of development of Eurocode 7 for geotechnical design even to the present. Estimating the characteristic value of soil properties affects not only determination of design value applied directly to design of geotechnical structures, but also economic feasibility and stability of the structures.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1999년도 가을 학술발표회 논문집
• /
• pp.371-378
• /
• 1999

A prototype computer program was developed which visualizes various kinds of geotechnical information using 3D object graphics techniques. The program integrates various kinds of geotechnical data such as surface geology map, boreholes data, geophysical data as well as man made subsurface structures. It also reads NGIS DXF map and generates digital elevation model from iso-elevation line layer of the DXF map. All the data are put into a 3D model as 3D objects. The created 3D model can be viewed and analysed in a interactive 3D way.