• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.05a
• /
• pp.55-57
• /
• 2011

TLM method to analyize receiver gain characteristic of the FZPL antenna which is operated at 12GHz and can be applied to satellite TV system, radio telescope, and Geodetic System. Some numerical results computed by TLM method are compared with Kirchhoff's approximation and PO method. As a result, receiver gain characteristic on main axis of the 12GHz FZPL antenna is shown at the front side, which means that the focal length is 15% shorter than designed focal length.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.05a
• /
• pp.977-981
• /
• 2000

Direct drive linear motors have large potential for use as high speed machine tool feed units since they can increase machining rates and improve servo accuracy by eliminating gear related machining problems. So, in this paper, characteristic of 2-axis linear motor feed unit are studied and control gain are adjusted considering positioning, velocity, acceleration and static stiffness. We confirm linear motor feed unit are affected value of control gain sensitively, because drive directly. From the experiment, this feed unit has l${\mu}{\textrm}{m}$ micro step resolution, 5.7${\mu}{\textrm}{m}$ positioning accuracy and under 60${\mu}{\textrm}{m}$ circularity.

• Journal of Auto-vehicle Safety Association
• /
• v.9 no.2
• /
• pp.26-32
• /
• 2017

This paper presents the lateral stability criteria for integrated chassis control. To determine the intervention timing of chassis control system, the lateral stability criteria is needed. The proposed lateral stability criteria is based on velocity-yawrate gain domain to determine whether vehicle is stable. If the yawrate gain violates the proposed criteria, the stability of the vehicle is considered as unstable. Characteristic velocity and critical velocity are employed to distinguish lateral stability criteria. The inside of the two boundaries is stable and the outside is unstable. If yawrate gain of vehicle violates the lateral stability criteria, the chassis control begin to intervene. To validate the lateral stability criteria, both computer simulations and vehicle test are conducted with respect to circular turn scenario. The proposed lateral stability criteria makes it possible to reduce intervention of chassis control system.

• Journal of the Semiconductor & Display Technology
• /
• v.3 no.4
• /
• pp.19-27
• /
• 2004

The characteristic evaluation of A/D converter is to measure the linearity of the converter. The evaluation of the linearity is to measure the DNL, INL, gain error and offset error in the various test parameters of A/D converter. Generally, DNL and INL are to be measured by the Histogram Test Algorithm in the DSP-based ATE environment. And gain error and offset error are to be measured by the calculation equation of the measuring algorithm. It is to propose the new Concurrent Histogram Test Algorithm for the test of the housekeeping A/D converter used in the CDMA cellular phone. Using the proposed method, it is to measure the DNL, INL, gain error and offset error concurrently and to show the measured results.

• ETRI Journal
• /
• v.29 no.1
• /
• pp.89-94
• /
• 2007

A mathematical model for the input-output characteristic of an amplifier exhibiting gain expansion and weak and strong nonlinearities is presented. The model, basically a Fourier-series function, can yield closed-form series expressions for the amplitudes of the output components resulting from multisinusoidal input signals to the amplifier. The special case of an equal-amplitude two-tone input signal is considered in detail. The results show that unless the input signal can drive the amplifier into its nonlinear region, no gain expansion or minimum intermodulation performance can be achieved. For sufficiently large input amplitudes that can drive the amplifier into its nonlinear region, gain expansion and minimum intermodulation performance can be achieved. The input amplitudes at which these phenomena are observed are strongly dependent on the amplifier characteristics.

• Journal of Power Electronics
• /
• v.19 no.5
• /
• pp.1069-1073
• /
• 2019

In this paper, an alternative non-isolated DC-DC converter with a high voltage boosting capability is proposed. Two inductors are used and one of them has its flux linkage increases during its charging period to achieve a high step-up voltage gain. Among the three integrated capacitors, one portrays the partial characteristic of the switched-capacitor technique, while the other two are connected in series across the load. With the two switches controlled using the same duty cycle, the proposed topology demonstrates the merits of a higher and wider range of step-up voltage gain when compared with recent topologies. In addition, a reduction in loss is induced and a higher efficiency is ensured with all the voltage stresses constrained within the output voltage. Operation of the proposed converter is analyzed and validated through experimental results obtained with a prototype.

• Journal of electromagnetic engineering and science
• /
• v.3 no.1
• /
• pp.1-6
• /
• 2003

In this paper, a sub-harmonic dual-gate FET mixer is suggested to improve the isolation characteristic between LO and RF ports of an unbalanced mixer. The mixer was designed by using single-gate FET cascode structure and driven by the second harmonic component of LO signal. A dual-gate FET mixer has good isolation characteristic since RF and LO signals are injected into gatel and gate2, respectively. In addition, the isolation characteristic of a sub-harmonic mixer is better than that of a fundamental mixer due to the large frequency separation between the LO and RF frequencies. As RF power was -30 ㏈m and LO power was 0 ㏈m, the designed mixer yielded the -47.17 ㏈m LO-to-RF leakage power level, 10 ㏈ conversion gain, -2.5 ㏈m OIP3, -12.5 ㏈m IIP3 and -1 ㏈m 1 ㏈ gain compression point. Since the LO-to-RF leakage power level of the designed mixer is as good as that of a double-balanced mixer, the sub-harmonic dual-gate FET mixer can be utilized instead.

• Journal of Advanced Navigation Technology
• /
• v.6 no.3
• /
• pp.251-257
• /
• 2002

Design and characteristic improvement of existing folded dipole antenna is presented to adopt W-CDMA(1.885~2.170 GHz) wideband antenna radiators. The antenna structure has +/- 45 degrees dual polarization. In order to overcome the narrow bandwidth and low gain characteristic typical of the microstrip antenna, double layered structure was employed. The antenna achieved below - 20 dB reflection coefficients each ports, - 20 dB of port isolation, above 7 dBi of gain, providing evidence that the proposed design can be used in the W-CDMA service frequency band antenna.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.12
• /
• pp.1992-1999
• /
• 2016

The plasma process is applied to various industrial fields such as high-tech IT industry, textiles and medical. Therefore, there is increasing interest in the plasma power supply, and demand for power devices of high efficiency and high power density is increased. Plasma power supply for process must solve the arc problem, when the plasma is unstable. The output capacitor is closely related to the arc problem. If the output capacitor is smaller, the damage from the arc problem is reduced. However, the small value of the output capacitor affects the operating characteristics of the power supply. In this paper, a LLC resonant converter is adopted, because it can achieve high efficiency and power density in the plasma DC power supply. However, due to the small value of the output capacitor, the converter is operated as a LLCC resonant converter. Therefore, a gain characteristic of LLCC resonant converter is analyzed by using the FHA (First Harmonic Approximation) in plasma power supply. Simulation and experimental results are presented to verify the characteristic analysis of LLCC Resonant Converter.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.246-249
• /
• 2002

In this paper, a rectangular patch antenna is miniaturized by changing tile middle of patch into narrow microstrip line except the edges of the patch where the fringing field occurs. Miniaturizing rate, gain, radiation patterns of suggested antennas were compared with general square microstrip antenna by using simulator Ensemble. As a result, it reduces the size of antenna by 30% and improves the characteristic of X pol as a advantage while it reduces gain and bandwidth.